Ford F-150 - 1997-2003 :: Blinkers Are Not Working
Have a 1999 F-150 work truck that I bought. Of course the blinker aren't working. Flashers, wipers, H/L's all work just fine. Nothing for blinkers outside or dash indicators, either side.
Checked fuses, every time I try something and are good.
MFS. Took old one apart cleaned no change. Bought new switch no change. Have power in harness up to switch in 2 spots.
Wiring. Noticed while replacing MFS the couple wires loose on the back of harness plug. Cleaned and pushed them back into block. Making sure they are fully seated to make contact with MFS. No change. Bent contacts on switch a little for tighter connection. No change.
Replaced relay/flashers. No change. So obviously I'm overlooking something. The truck is a western truck. Hasn't been modified or messed with. Nice clean original, heck only 61000 miles. Wiring under dash looks untouched. Still has the factory AM/FM only radio.
Ford F-150 - 1997-2003 :: No Blinkers Or Brake Lights Working
I have a 1997 Ford F250. My trailer lights will work, but I have no brake lights or turn lights. I have checked all my fuses and all the fuses are good.
I was told it was probably my trailer tow relay, so I bought it at O'Reilly's, but I don't know which relay it is exactly.
I just want to know which relay number it is so I can replace it. And, if this doesn't sound right, is there something else I should be trying?
Ford F-150 - 1997-2003 :: Blinkers Not Working But Flashers Work?
Got a 2003 F150 4.6 2wd and recently the blinkers dont work. Also some how the 4wd light came on even though the truck is a 2wd. After searching it seems alto of people recommend replacing the Multi Function Switch. The truck is plain jane no tilt wheel.
Is this the MFS everyone is talking about?
Duralast/Windshield Wiper Switch (SW1977) | 2003 Ford F150 1/2 ton P/U 2WD 8 Cylinders W 4.6L EFI |
Ford F-150 - 1997-2003 :: Blower Motor Resistor Location
I'm looking for information and possible photo location for the blower motor resistor. My truck has climate control. I've looked under the dash on the passenger side and behind the glove box door and I've been unable to spot the location. Do I have to remove the plastic panel behind the glove box?
View 6 RepliesFord F-150 - 1997-2003 :: Blower Motor Switch Removal?
How to remove the blower motor switch on my 99 F150 without breaking anything.
View 1 RepliesFord A/C :: 2003 F150 - Blower Motor Stopped Working All Of A Sudden
I've read quite a few threads on this subject and came across the resistor, fuses, and relays. I have some fundamental testing procedure questions.
1. To test the resistor, it says to back probe the brown/orange wire to check for voltage. So I'm assuming I would hook up my positive lead, here?
Do I really need to hook up the black lead all the way to the negative terminal on the battery? Just with a long extension? Or is there somewhere else I can hook the black lead to? (I know, how dumb!)
2. I downloaded owners manual, but I can't seem to find a fuse or relay specifically for the blower, so what fuse and what relay is it?
3. In the Haynes manual, it says locate the blower motor relay, in the relay box under the center dash panel, where the hell is that?
4. Do I need to remove the glove box to access the resistor and blower hosting.
5. Anything else I should know?
Ford A/C :: 2003 E350 - Front Heater / AC Blower Motor Isn't Working
Recently bought a 2003 E350. The front heater/ac blower motor isn't working. I found the control switch melted and bought a new switch. Before installing it, I need to do some diagnostics. I checked the blower with a couple of jumpers ant it turns and blows. I think that leaves the blower motor resistor. Where it is on a 2003 E350? I also need to check the relay. I have a power distribution box at the front left under the hood. Is the relay there? The box is not labeled like my GM products. Which is the blower motor relay? Finally, which fuse controls the blower motor? I read it might be a 40 amp fuse. If so, that might narrow it down.
View 6 RepliesFord F-150 - 1997-2003 :: Turn Signals / Blinkers Started Off Blinking A Few Times Then Stopped Working
My blinkers started off blinking a few times then stopped working, now they don't work at all. The fuse says it goes to the brake lamps, hazards and turn signals. The hazards work as well as the brake lamps. I found the relay/flasher box and it appears the relay and flasher is the same for both the turn signals and the hazards. I checked for the wire/connector problem in the column and all looks good there. When I activate the turn signal lever I feel one click in the relay/flasher which leads me to believe the turn signal switch is working. I went ahead and replaced the relay with no results. Is the flasher internals the same for both the hazards and the turn signals or is there two independent sections inside for each?
View 4 RepliesCivic - Honda :: 2003 - Fan / Blower Motor Not Working After Rotor Replacement And Oil Change
Our 03 Civic recently went into the shop for a rotor replacement and the shop did an oil change for us while they were at it. My wife got the car back and she immediately noticed that the "AC" wasn't working. After asking a few additional questions (I'm not in the same city this week), it isn't the AC that isn't working, the fan/blower isn't turning on at all. We had the same shop check it out again and their response was that they weren't anywhere near the blower motor so this just has to be a coincidence. I could accept that but I'm still worried about a scam.
The car was in the shop just to have the rotors put on, not an oil change but they did an oil change for us anyway. (I was going to change the rotors myself but I couldn't get the caliper hangers off and it was 100+ degrees outside so I decided to have the shop mess with it), Would it be easy to sabotage the blower motor on this car?
Ford F-150 - 1997-2003 :: Blower For Heat And AC Completely Stopped Working
2003 F150 4wd with auto climate control. My blower for heat and AC completely stopped working a few weeks ago. I have checked all fuses, i replaced the relay under the dash, i replaced the blower motor control module. I supplied power to the blower motor itself and it ran fine with no noises. I ran the self test on the controller in the dash under the radio and it passed. I am not sure what else to try.
View 7 RepliesFord A/C :: Blower Motor Stopped Working - No Power
I have a Full Size 93, 5.8L Van. The blower motor has stopped working. I have checked the fuzes, ok. I have checked the Power Distrubution Box, ok. I do have power to my Aux (rear) blower. I have hot wired my blower motor, it works. I have no power to the blower motor, thermal limiter, or to the fan control switch on the dash. (Like I said, the Aux on the dash works). What else is there?
View 14 RepliesFord F-150 - 1997-2003 :: Driver Door Power Window Motor Stopped Working
My driver's door power window motor stopped working. Replaced motor (Dorman). New motor was shaky and wouldn't stop when going down. Replaced motor again (Dorman), same thing. Regulator became damaged, replaced (Dorman), smoother, still won't stop with auto button, or holding down button. At some point glass came out of regulator and track. Replaced glass. Window goes up and down smoothly, but just doesn't stop when going down and tries to keep going. I don't see a limit switch or circuit for it. I see there is a relay and a fuse for the auto down. What tells the motor to stop driving current?
View 2 RepliesFord Aerostar :: 1997 - Location Of Blower Fan Motor Relay?
I'm having some trouble with the front blower fan on my 97 Aerostar 3.0, it will only intermittently work, one time we had it running, lifted up the hood on the van, checked the connection to the motor, looked good, dropped the hood and the fan immediately started working again, I'm wonder if the relay might be starting to go bad, the fan in the back works, so I'm not sure. Where the relay is for the blower motor, or what might be wrong?
View 6 RepliesFord - Explorer :: 1999 - Heater Blower Motor Quit Working
99 Explorer Blower motor quit working. Disconnected and hot wired to a battery and blower motor worked. So I know it is in the switch and/or wiring. I need this truck everyday so going into the shop is out. Live in Northern Mn and the temp was -15 degrees. So as a temp fix what does everybody think of running a wire from the battery to a switch inside and then to the blower motor and then to a ground. Would have a inline fuse. If this will work what gauge wire and what amp fuse would you use. Its getting cold without heat.
View 4 RepliesFord Ranger / B-Series :: 1997 - Blower Motor Doesn't Work
I've got a new to me 97 Ranger that the blower has never worked in and I can't get it going. I've checked the fuse. That's good. Tested the relay. That's good. Did an ohm test on the power switch for the blower. It's open in the "OFF" position and closed in the other positions. I've got continuity through the speed selector switch. New resistor and pigtail because the other one was nasty looking. What seems odd to me is that I've only got power to the blower motor relay at one terminal with the switch on (number 30 I believe). In addition, when I test the plug for the motor itself with my test light, one of the wires (org/blk I think) has power only when the switch is off. And I ran power straight to the fan from the battery and it spun right up. What am I missing?
View 8 RepliesFord Aerostar :: 1997 XLT - Front Blower Motor Does Not Blow Occasionally
My 1997 XLT 4.0 AWD w/Rear A/C has been having a Blower Motor issue for many months. Occasionally the front blower does not blow. Banging on the Blower Motor, either from under the hood, or even from inside the van underneath the glove box, will start it up again. Once running, it continued running okay until at least the next shutdown. This has gone on throughout the summer. Sometimes a good bump in the road would start it.
Now that the winter is here, heat and defrost are more critical, so it has become a bigger problem. Furthermore, is is now almost constant, where it rarely works without a bang. So it is time to actually fix it now.
From other posts, I think it is either the Blower Motor itself, or the Control Module / Resistor. But since the control module is not located on the motor itself, where I bang, it is probably the motor. Question:
1 - What is the problem, and can I fix it with grease (elbow or actual) etc... or is replacement the proper option?
2 - Should I replace the wheel too, which is not available on RockAuto - but is on the junkyard options on eBay. Unfortunately those are often just as broken as mine. Generic Wheels are available in Auto Zone.
Ford - Taurus :: 1996 - AC Suddenly Quit / Blower Motor Stopped Working
Well, let me rephrase that, the AC works but blower motor doesn't. When you put your hand up to the vents, they're cold.
Long story short, I ran my AC on MAX on way home from work, driving time of approx. 35 minutes. I got home, showered, and got back into car to go downtown to store. It was then I discovered that the AC wasn't coming on, and it was still on max. I shut it off and turned it back on, but to no avail. I checked all related fuses, or at least what I think is related and checked my "Taurus Bible" the chilton manual. I swapped out a blower motor relay and it didn't work, but i'm not sure that relay was or was not good, it was out of a '96 E-250 at work.
So now I get out my test light. I pulled the connection from blower motor, connect it and turn on AC and light comes on. Vents are getting cooler. So I get my tool and pull the radio and climate control assembly. I pull the plug to the actual fan connection, the part that connects to the fan switch that controld fan speed. I'm getting nothing there.
Is there a relay I don't know of? I know the AC still works because vents are still getting cold, but I can't get air to move. A LONG time ago it did this but "corrected" itself. What is my next step? I'm not sure what to check next and my repair manual is leaving me in a boat with no oars.
More details of car:
1996 Ford Taurus 3.0 V6 Vulcan motor, 8th VIN is UAUTO188,000 miles
White 4 door gray interior 3 car seats
GoodYear Tires inflated to : 33lbs LF34lbs RF36lbs RR35lbs LR
Ford Escape / Hybrid :: 2010 - HVAC Blower Motor Only Seems To Be Working On 3 And 4 Position?
Blower motor only seems to be working on the 3 & 4 position? Resistor bad? What is the location?
View 1 RepliesFord Super Duty (1999-2016) :: 2012 - Blower Motor Not Working?
2012 F350 Lariat 6.7
The blower motor has quit. All fuses relays etc appeared to be ok. So I tested the connector going into the motor, I saw 13.9 volts so assumed it was a bad motor.
After removing the motor I bench tested it by connecting 12volts to one side of the connector and negative to the other. It spun up.
I re-tested the motor supply connector in the vehicle, it has 13.9 volts on the yellow wire, and 4.44 on the other. I adjusted the fan speed on the climate control, although the fan images on the display increased, there was no change to the voltages on either line.
I used the 13.9v connection on the positive terminal and a ground on the negative, the motor spins.
Is there a method for accessing codes that will display what is causing this failure?
So why do I have 4.44 volts at what should be a ground? Is this a bad resistor or is the climate control euchred.