Ford Aerostar :: 1997 - Location Of Blower Fan Motor Relay?
I'm having some trouble with the front blower fan on my 97 Aerostar 3.0, it will only intermittently work, one time we had it running, lifted up the hood on the van, checked the connection to the motor, looked good, dropped the hood and the fan immediately started working again, I'm wonder if the relay might be starting to go bad, the fan in the back works, so I'm not sure. Where the relay is for the blower motor, or what might be wrong?
View 6 RepliesFord Aerostar :: 1997 - Rear Blower Spins Fast Enough But Front Could Use A 5th Speed
Is there any way the front blower can be wired to run or spin FASTER? The rear blower in my 1997 spins fast enough but the front could use a 5th speed. I have interchanged blowers and Resistors from rear to front, but no change, both resistors and blowers are identical. I remember one time a residential a/c tech showed me how to rewire the air handler blower in my apt. to make it run faster and the result was amazing, though he did explain the life of the blower would be shortened, I never had any problem. Does the same principle apply to a 12V automotive blower?
View 14 RepliesFord A/C :: 2008 F250 - Blower Motor Quit / Just Won't Blow
Blower Motor quit, dual zone climate control system. AC will work with Recirculation mode off. Just won't blow.
Turned heater on still won't blow. Pulled and checked the following fuses: 37; 45, 37 & 15 which pulling these 3 reset the system; and pulled 24 in the battery junction box. Still not working.
Next plan is to pull Relay #1 from the battery junction box and apply 12v to see if it clicks - no click & then I'll replace it.
Monte Carlo :: 2002 SS Blower Motor Does Not Come On Occasionally
I have a problem on the blower motor and i think its something besides the blower motor going out it works fine most of the time but occasionally it does not come on when this occurs I noticed that the cruise light is flashing in the dash and when this is occurring you can push the on/off switch in the steering wheel and the light does nothing. Now whenever the blower motor works properly everything with the cruise functions properly no light in the dash and when turning on/off switch works properly also no noise coming from blower motor ( bearing ) sounds fine. would a bad BCM cause this or am i looking in wrong direction ???
View 4 RepliesAvalon 2005-12 :: 2009 - Blower Motor Speed Does Not Blow Hard On High
My blower motor does not blow hard on high. 2009 AVALON.
View 3 RepliesYaris/Scion & Vitz :: Blower Motor Will Occasionally Squeal When Fan Switched On
I've had problems with rusted bolts, a remote starter with no fob, and a question on odd keys. It rattles like a lot of other Echo's, but otherwise handles as well as I can expect.
Anyway, the blower motor will, occasionally, squeal when the fan is switched on. Most of the time, it quietens down in a minute or so. This was flagged by the auto broker when I bought the car, and he did suggest having it replaced while the car was in his shop, which I declined.
The above was taken from the 2002 Echo manual.
My question is: What's the difference between the STANDARD heater, and the TWO WAY(S) flow heater? I've looked online for a replacement blower motor, and some seem to specify a 'cold weather' version. Is there any truth in this?
Is the blower motor the whole assembly (as pictured), or does the picture show the whole blower (motor) assembly, complete with the rotary fan blades?
I figure that the squealing indicates it's just the blower motor bearings(?) about to fail. I should be able to remove the whole assembly, and replace just the motor.
Ford Aerostar :: 1997 - Heater / AC Blower Turns Off And On Randomly
Problem solved- update! Found a main vacuum line, (white one), broken right above where the oil filler tube is. I guess if the plenum door is not in the proper position, it screws with the fan? Works like a champ now even with 442,000 miles on this van! --- 1997 aerostar, 3.0. Doesn't matter what I'm using, vent, heater, or AC. When I have the fan switch "on", The fan will shut off, then turn back on whenever it feels like. I've tried turning the controls on and off in any and all ways, and still random fan goes on-off when it's turned on. Is there a sensor somewhere that could cause this? Or what?
View 6 RepliesFord Aerostar :: 1997 - Blower Vent Went Out Whilst Going Uphill?
97 Aero. Just recently experienced this weird issue. Had the AC on for a warm day and heading down the freeway at 70mph. The AC is kicking out some nice cool air. Noticed that when the van was heading up a slight grade, the air speed coming out of the vent would slowly diminish until no air came through the vents at all.
As soon as the van leveled out or started heading downhill, the vent air speed would pick back up and blow normally. This happened repeatedly. Is this a blower issue? Vent door issue? Something else? Since the van was traveling at speed, I could not tell is the blower was still blowing when I was experiencing no air out of the vents.
Ford Aerostar :: 1997 - Rear AC Stopped Working / Blower Runs Fine
97 aerostar rear ac stopped working. Blower runs fine. Checked solenoid has power and clicks when plug pulled and refitted.
Liquid line is hot to solenoid and somewhat warm after the solenoid. Return line from evap is at room temp.
Front is 40f at register. Am I looking at bad solenoid or blocked orifice tube. Solenoid is nla. Orifice not so. Still on original evaps comp etc.
Ford F-150 - 1997-2003 :: Blower Motor Resistor Location
I'm looking for information and possible photo location for the blower motor resistor. My truck has climate control. I've looked under the dash on the passenger side and behind the glove box door and I've been unable to spot the location. Do I have to remove the plastic panel behind the glove box?
View 6 RepliesFord F-150 - 1997-2003 :: Blower Motor Switch Removal?
How to remove the blower motor switch on my 99 F150 without breaking anything.
View 1 RepliesFord F-150 - 1997-2003 :: Blower Motor / Blinkers Not Working
My 99 f150 blower motor and blinkers slowly but surely went out on me. The hazards still work. I changed the flasher relay and the relay for the blower motor, and nothing. I've checked all the fuses, and checked for wire issues and nothing.
View 4 RepliesFord A/C :: 1988 - Front Blower Motor Intermittently Works
My mom has a 1988 350 Econoline van chasis that is a motorhome class C.
The front heater/AC blower motor only works when it wants to. It starts very intermittently and then shuts off then you go down the road a little more and it comes back on, it will do the same thing sitting in the driveway just idling. There is no timing it, it just turns on when it wants to and then back off again.
I checked the fuses and the fuses are fine. The blower motor when hooked up directly to the battery blows fine. When it isnt working of course there is no juice going to the blower motor through the hotwire of the blower motor, I have checked this with my volt meter.
I did replace the switch that turns the blower on in the dahs, and it didnt do the trick.
Ford Ranger / B-Series :: 1997 - Blower Motor Doesn't Work
I've got a new to me 97 Ranger that the blower has never worked in and I can't get it going. I've checked the fuse. That's good. Tested the relay. That's good. Did an ohm test on the power switch for the blower. It's open in the "OFF" position and closed in the other positions. I've got continuity through the speed selector switch. New resistor and pigtail because the other one was nasty looking. What seems odd to me is that I've only got power to the blower motor relay at one terminal with the switch on (number 30 I believe). In addition, when I test the plug for the motor itself with my test light, one of the wires (org/blk I think) has power only when the switch is off. And I ran power straight to the fan from the battery and it spun right up. What am I missing?
View 8 RepliesFord A/C :: 2003 E350 - Front Heater / AC Blower Motor Isn't Working
Recently bought a 2003 E350. The front heater/ac blower motor isn't working. I found the control switch melted and bought a new switch. Before installing it, I need to do some diagnostics. I checked the blower with a couple of jumpers ant it turns and blows. I think that leaves the blower motor resistor. Where it is on a 2003 E350? I also need to check the relay. I have a power distribution box at the front left under the hood. Is the relay there? The box is not labeled like my GM products. Which is the blower motor relay? Finally, which fuse controls the blower motor? I read it might be a 40 amp fuse. If so, that might narrow it down.
View 6 RepliesFord Ranger / B-Series :: 1997 - Heater Blower Motor Resistor Rusted
I am not great with electrical but can manage. Here's the deal, Ihave a 1997 ford ranger 2wd 2.3L 5spd with a/c 233,000 miles i just replaced the heater blower motor resistor as the old one was rusted bad as was the pig tail going to it bad that one of the terminals broke off and was rusted in the harness so i replaced the plug as well problem is i still have no fan if i jump it it works but have no power at the plug for resistor or motor and no power at the switch inside the truck I do have power to one terminal where the relay plugs in, where to look next?
View 14 RepliesSuburban :: Front Blower Motor Stopped Working On All Speeds
I own a 99 Suburban 1500 5.7. The front blower motor stopped working on all speeds so I replaced the resistor, it still did not work. I then replaced the speed selector switch and it started working fine. Three days later I smelled a slight electrical burning smell and the fan stopped working again. I plan on replacing the switch again to see if that is what went bad. Whats causing this to happen? Maybe the motor is going bad and causing the switch to short?
View 6 RepliesHonda - Odyssey :: Front Blower Motor Operating Intermittently
Front Blower Motor does not work. 2005 Honda Odyssey, EX-L130,000 miles and I expect at least 170,000 miles more.
History – Over the past four years, the front blower motor has operated intermittently. I noticed that when the weather went through large changes (warm/humid to cold/dry or vice versa), the fbm would not run. The system behaved in the manner described by Honda owners in many of the forums online. After a period of time passed, the blower would function properly again until the next weather change.
About two months ago, the blower stopped working again and it has not returned to form since. The system again displays all the usual symptoms reported on-line. The rear blower works fine.
The controls on the dash seem to be fine (display changes appropriately as I select settings, vents open and close for heat or A/C or which vents I want open). Air flows through the vents selected when I am driving – I have a passive windshield defroster!
Here are the steps that I have taken during the past week:
1.Bought a new transistor/resistor module, OEM Honda Part #79330-SDG-W41 (I checked with a local dealer for the correct part number). I installed it but there is no change in the system.
2.I found information on-line to test the T/R. I checked the old one – Thermal Cut Out is intact and the resistance between posts 3 & 4 (lower pair when installed) is 1,500 ohms. I checked the new transistor and it read out the same.
3.Fuses, relays, power to the blower, blower, ground beyond the transistor are all fine.
4.I reconnected the T/R and fbm and let the fbm lay on the car floor. I started the car with the fan on. Each time I start the car (or turned the ignition ‘On’) the fbm tries to run, but stops in an instant.
The Rat is cornered – it's in the the T/R and the control signal from the control panel to the T/R corner. If I bypass these elements, the fbm goes on and off as I select the fan On/Off from the control panel.
Ford F-150 - 1997-2003 :: Front Driver Side Wheel Bearing Blow While Doing About 70 MPH
I had my front driver side wheel bearing blow on me, out of nowhere, while doing about 70mph on my '03 Supercrew 2wd. it really destroyed my spindle and rotor. i replaced everything from the spindle out (rotor,pad,caliper,caliper mounts, bearings,etc). I packed the bearing really good and put it all back together. Well, it happened again, same thing. Doing about 70 and it just blew out of nowhere. Why it could be happening??
View 14 Replies