Ford - Explorer :: 1993 - Stuck In Forward Gear
A friend of mine at work has a 93 4wd explorer. A4ld transmission. Reverse quit working, and no matter what gear you put it in, reverse, neutral, or park, it will stay in drive. Park holds itself, but if you give it gas, it tries to pull. He says when it's in reverse, it's almost like it's stuck in reverse and forward, it wants to rock. He pulled the pan, no metal shavings, and pulled the valve body. He said the screws holding the valve body were finger tight. The gasket underneath had a small tear in it, he doesn't know if he did this pulling it out or not. He replaced those gaskets and retorqued the valve body. When he put it in reverse and topped off fluid, reverse worked. He put it in drive and it worked, but when he put it back in reverse, it stayed in drive and is staying in drive in all gear selections again. He bought this explorer new, and the transmission had never been into before.
View 3 RepliesFord - Explorer :: Transmission 5Re55 - Stuck In 3rd Gear
'98 XLT 4.0 SOHC.
First of all overdrive started to play up, the engine would flare as it went into OD and often would have several goes at it until it engaged OD. Finally it wouldn't go into OD.
Still driving it around for awhile then it went into limp home mode - stuck in 3rd gear. What it might be?
Ford - Explorer :: Gear Shift Stuck Between Park And Reverse?
I was pulling into my driveway. I put the car in park, but when i went to get out of the car, it started to roll forward. When I finally got it stopped, I tried to shift it, and it wouldn't shift to any spot. Then it became stuck in between Park and Reverse. I can't move the gear shift.
View 1 RepliesTacoma :: Code P0770 - Transmission Fault Identification
I own an '02 Toyota Tacoma v6 3.4L 4-speed automatic. After a 2-hour highway drive (not too common, small town) the other day, I started to experience transmission issues (wouldn't always switch gears properly), and the check engine light came on. My scanner indicated P0770 (Shift Solenoid E Malfunction), a transmission fault.
I've spoken with my mechanic, and I've done some research online. My understanding is that it could be a shift solenoid, the valve body, the torque converter clutch, or even just low transmission fluid.
I have owned this truck since '05/28k miles. It now has 95k miles. At about 35k, the dealership installed a new transmission (maybe the former owner was a city-driver, or something), and I had basic dealer transmission service about 30k miles ago. I have an appointment to take it to a local shop (a Ford authorized service center, that also services other makes/models) in a few days.
Except for infrequent highway driving, I don't drive the vehicle "hard" at all. I have the vehicle fully serviced by the dealer at recommended intervals. I have been advised that if this fix requires more than basic transmission service, that I should take it to the dealership (factory tools, etc).
These are some observations about the malfunction:
1) The engine/transmission is still cold (just started the engine). I shift from P to R, to back out of my driveway. The transmission seems to be "stuck" in neutral/park. 5-10 seconds pass, finally transmission engages R gear. Switching from R to D, vehicle operates normally.
2) While driving normally, I accelerate steadily from 20-40mph. The transmission hesitates before switching from 2nd-3rd gear (peaking at 3k rpm, holding steady). When I take my foot off the accelerator slightly, then re-apply it, the vehicle shifts. (EDIT: Subsequent to this same post on another forum, I have been told that first gen Tacomas often have a cold tranny 2nd to 3rd shift hesitation, and I have seen it before, but it's arguably more noticeable since this recent problem developed.)
The transmission has only 60k relatively "easy" miles on it.
Camry :: CE 2000 5S-FE With Code P0770 And High Idle Speed
Camry 2000 CE 102,xxx miles. My car died in Jan 14, after have P0770 for while, only Reverse gear work. The mechanics said the tranny need to re-build. I had him bring the tranny to tranny shop to re-build ($1650), then the code still pop up. Brought it back, they said the ECU needs to be reset. I had the car next day then that code pop up again!
They replaced the Solenoid E. The code is still there. Brought the car back, they took the tranny to rebuild it again. Drive the car for a day, the darn code pop up again, now they blamed on the ECU. Ok my mechanic guy replaced it at my own cost for part ($150) but the code is still there. This time they blamed on the high idle rpm approx. 1600-1800. My mechanic tried to fix the high idle speed so the tranny stop blaming other causes. He cleaned IAC valve, replace O-rings (I don't remember the location of them) then he said whenever he inserted the new ones, they start to crack!
Camry :: 2002 V6 Automatic Transmission - Check Engine Light Came On With Code P0770
I have a 2002 Toyota Camry V6. The warranty expired in Feb 2007. The car has only 67,000km.
The check engine light came on and the code is P0770, Solenoid E malfunction. The problem was first reported at 43,000km, when the car was still under warranty but only a transmission flush was performed and the code was reset.
I wrote Toyota and after almost two months they told me they do not cover it because is out of warranty and I do not qualify for the Goodwill program. I tried again to tell them that instead of fixing the root of the problem they temporarily covered it, but again I got a NO. No comments about the mileage, time, etc. Just the car is out of warranty and I'm out of luck.
Ford - Explorer :: 2006 - Shifting Hard Into Reverse At First Then Stuck In High Gear Or Slipping - OBD2 Codes
Tranny started acting funny recently...shifting hard into reverse at first, then last night it was like it was stuck in high gear or slipping on the way home. Limped it home and took the following codes:
P0743 TORQUE CONVERTER CIRCUIT ELECTRICAL
P0750 SHIFT SOLENOID A MALFUNCTION
P0755 SHIFT SOLENOID B MALFUNCTION
P0760 SHIFT SOLENOID C MALFUNCTION
P0765 SHIFT SOLENOID D MALFUNCTION
P0962 PRESSURE CONTROL SOLENOID A CONTROL CIRCUIT LOW
P0966 PRESSURE CONTROL SOLENOID B CONTROL CIRCUIT LOW
P0970 PRESSURE CONTROL SOLENOID C CONTROL CIRCTUT LOW
Ford - Explorer :: Hard Jerk While Changing Into 2nd Gear - Error Code P0715
The other day, my Explorer gave a hard jerk while changing into 2 (maybe 3rd?) gear. Never happened before. I was under 20 MPH & had just stared it. (My speedometer works as do all the dials.) My Check Engine light came on & when I had the code pulled it read quote "P0715."Transmission Speed Sensor circuit condition. Vehicle speed above 15 MPH while transmission output shaft speed below 60 RPM. Possible cause Failed transmission speed sensor or electrical problem"
I got a Transmission Speed Sensor, (which I haven't put in yet), and was told that this would solve the problem. My question is twofold: Is there ANY chance this is a false or misread code and the problem is something else? And could ANOTHER sensor attached to the transmission be the cause? (How many sensors are on the tranny?) All I've read about this problem, say's replacing the Transmission Speed Sensor is preceded by the SPEEDOMETER quitting, but mine works fine.
The truck is a 1997 Explorer 4x4, but I don't use 4x4. In fact I've driven it without the forward drive shaft ever since I had the BW4405 Transfer Case replaced.
Ford - Explorer :: 2002 V8 - When In Low Gear RPMs Rev High But Car Does Not Shift Up - Code PO732
My 4.65L V8 Explorer has an issue in low gear - RPMS rev high but car doesn't shift up.. eventually "catches" with a jerk but the OD Light started flashing and the Systems Screen reads Check Transmission. Light goes out and message goes away after turning car off and restarting. Had one Tech look at it - he said second gear is toast and need full transmission rebuild. Another Ford Tech looked and could just be solenoid needing replacement and advised to have a transmission service (not a flush) done....
View 2 RepliesFord F-150 (2004-2008) :: 2005 FX4 Truck Gear Shift Stuck In Park
My truck gear shift is stuck in Park (console type). I have been reading threads that discuss potential causes such as blown fuses, bad brake switch, bad brake shift interlock actuator, and even ignition switch. All fuses are okay. Before I try to get into all the other possibilities, I have a question around what the local auto parts worker suggested. He said that there is a small plastic piece that may have slipped down interfering with gear movement. This could make sense, especially since the white manual release lever doesn't seem to be moving.
View 14 RepliesFord - Explorer :: 2008 - Got Error Code P0401 With CEL?
I have a 2008 Sports Trac, with a 4.0 SOHC engine ... 165k miles. Last week my check engine (CE) light came on and the code is P0401 ... too little flow on the EGR system. I first tried cleaning the existing valve - but CE light still came on. So I replaced the old EGR valve, cleaned the SS tube from the exhaust manifold back to the EGR valve and the CE light is still on. I have not driven the truck since I replaced with the new valve ... only fired her up in the garage. Is this something that could possibly clear up given a couple of miles?
View 6 RepliesGolf IV / Jetta IV :: Error Code - Car Stuck In 3rd Gear
Damn car is stuck in 3rd gear! Hooked up scanner and the screen just says error! I have to keep the scanner in the vehicle, hooked up, just to drive the car. That's just so it'll shift as its supposed to! Now it's not letting me pull the code out, in order for me to erase it! It just keeps saying "error".
View 1 RepliesElantra MD (2010-15) :: Code P0880 - Trans Stuck In 4th Gear
I have a 2011 Elantra 1.8 automatic Gls with 133k miles. While driving approximately 70 miles per hour the car downshifted to fourth gear, and would not shift up or down. I drove the car home and found that this is called "lump mode". I checked the codes, and found P0880 tcm voltage input. I replaced the fluid temperature sensor and harness, and checked continuity through the harness. I found no problems in the harness from the tcm to the solenoid connector. I then purchased a matching tcm, but the problem persisted. If the battery cable is left off for several days the problem will disappear until the car warms up.
View 4 RepliesSonata NF (2006-10) :: 2007 - Code P2507 / Transmission Stuck In 3rd Gear
Have a 2007 Sonata limited 3.3l, have trouble code P2507 and the car is stuck in limp home mode. Already changed input and output sensors on tranny. Battery is putting out 12V and alternator is putting out 14V when running. Cleaned PCM connections and packed with dielectric grease. Not sure where to look next.
View 6 RepliesLexus GS 2006-11 :: Gear Won't Shift Past Third - Code P0751 Stuck Solenoid
I bought the car with 117k and never since my possession bothered to service it. Why? I kept putting it off well at 165k I said heck ill do it. Currently at 170k my gear wont shift past third and its reoccurring almost daily. When I first bought it it was intermittent. I think the late service messed it up. Here's the thing, aamco will open up my pan and look at my solenoids which is 250ish.
View 14 RepliesElantra XD (2001-06) :: Stuck In 3rd Gear - Code P0760 And P0755 / Malfunction Shift Solenoid B And C
I have two codes P0760 and P0755, malfunction shift solenoid B and C, today I took it to Hyundai here in queens ny, I was told that It would cost e 2684.00 to fix my issue, I can't believe that if those two codes are the problem why would it cost 2684.00 ? Where are these solenoids located?
The car feels like your one of the flintstones, it's stuck in 3rd gear and cant get out, then it jerks when it tries to shift, tranny oil is fine not burnt like if the clutches are gone.
Golf IV / Jetta IV :: 2000 - Limp Mode / Stuck In 1st Gear And Error Code Of P0730
I have 1 month left on my AAMCO rebuilt transmission. I took it in a few weeks ago when it went into "limp mode" (Stuck in 1st gear). Eventually, they got an error code of P0730, which I believe is electrical-related. All was pretty good but then today, driving @ high speed on the interstate, I could not get into 4th gear...
View 1 RepliesFord F-150 (2004-2008) :: Code P0731 - Improper Ratio For First Gear
I have a 06 f150 and about a month ago I purchased an edge evolution. Twice in the past 3 weeks my o/d light starts flashing and my truck beeps and it shows Trans Fault on the trucks display. When I use the edge to check the DTC it comes back as P0731. I am running the canned level 3 tune no changes and trucks completely stock other then the edge. Also both times I have been going about 10 mph down a hill without giving it any gas. Also both times of shut the truck off and let it sit for a bit to make sure I wasn't going to break something.
View 14 RepliesLexus GS 2006-11 :: 2008 GS460 Stuck In 1st Gear For About 10 - 15 Seconds When Accelerating From A Stop
2008 GS460 ... When accelerating from a stop sign/stop light it get's stuck in 1st gear for about 10 - 15 seconds before it shift to second gear. I notice this as the engine rev's high and is not shifting. Shifter is in Automatic and not manual mode. Happened at least 4 times in the past 2 weeks. Dealership is unable to replicate the issue and transmission checks out fine. Guess I have to wait until transmission get's stuck in gear before I can bring it back in.
View 14 Replies