Ford Super Duty (1999-2016) :: Ranch Hand Bumper Hitting Fenders
I noticed today my ranch hand bumped is hitting my fenders, when I originally installed it there was about a 1/2" gap.
All the bolts are tight, however it appears the mount that's attached to the frame is flexing and becoming weak as I can grab the bumper and rock it when it used to be rock solid.
Is there anything I can buy that will reinforce the bumper mounts that are connected to the frame to support this bumper???
Right now it's bolted up with 4 bolts on each side and no additional hardware.
Ford Excursion :: Front Bumper Grill Insert?
Is there a source for a insert for the tow hooks & between the fog lights?
View 2 RepliesFord Excursion :: 2002 - Front Bumper Damaged - Fix Or Replace?
So a line of panic stops on the highway last night and I lost - stopping an 8000lb rig compared to hondas, nissans, etc. Anyway I just kissed the corner of a nissan xterra and dented the steel part of my front bumper below the driver headlight. Nothing else. It is a 2002 all black limited.
I am wondering about fixing vs. buying a new bumper. A new one from the dealer is 436 and then needs to be painted.
Ford Excursion :: Front Bumper Moves When Not On Flat Ground
My bumper is moving when my ex isn't parked on flat ground. Almost like the frame is twisting. Enough that it shifted up and cracked my grill. What could be going on? I didn't snap a pic but I'll try to get one. Get back on flat ground and it relaxes back to where it should be, flat and level.
View 6 RepliesFord F-150 (2004-2008) :: 2007 - Removing Rubber Step Off Rear Bumper?
I have an 07 King Ranch. I need to remove the rubber step off the rear bumper to paint it. Due to a typical Ford paint job it is rusting already. Can I just pull up on it ? If so should I wait for a warm day to prevent breaking the clips?
View 3 RepliesLexus IS 2014+ :: Removing Rear Bumper Reflectors?
Do you need to take off the bumper?
View 2 RepliesLexus IS 2014+ :: Removing Rear Bumper To Install Diffuser
Remove rear bumper on IS? Wanting to install a rear diffuser myself but don't know where to start in removing the bumper.
View 5 RepliesPrius C :: Removing Rear Bumper To Install Back Up Sensors
How to remove the rear bumper, I have to drill some holes to install some back up sensors. I rather not but I don't know if anything is behind there.
View 1 RepliesFord Excursion :: Single Pop Or Clunk When Make A Left Or Right Hand Turn Between 10 - 20 Mph
I have a 2000 Excursion lifted 6 inches with 35" tires on 20" Fuel wheels and i notice when I make a left or right hand turn between 10-20 mph i get a single pop or clunk from the front end.
Also one more really annoying thing while i am turning there is creaking, sounds like body flex? maybe body mounts? Any issues with ball joints?
Ford Excursion :: Freaking Heat Shield - Nasty Metallic Sound On Throttle And Making Left Hand Turns
I got a heat shield that just will not stop causing me grief. When I installed the headers and pipes I had a heat shield that was too close to the passenger side pipes. I bent it down some to clear the pipe and got rid of a nasty metallic sound I had on the throttle and making left hand turns. Well that little sound returned last week and I crawled under and looked and sure enough the heat shield was touching again.
Who knows why maybe a bit a spring sag. So yesterday I bent it down a little more. Today I start getting a nasty clunk on dips and especially when on a bump why turning. I crawl under there too look and find the same heat shield now has a huge gouge on the under side of it where the leaf spring near the rear bushing is smacking it. I'm sure Ford put it there for a good reason so hate to remove it.
First pic of the hacked up bend job I put on it.
Second pic of the gouge in the bottom of it where it's hitting.
Ford Excursion :: Removing Exhaust Hangers?
Tip for searching for "how to remove ford exhaust hangers" - these items are now among my most hated items. Very easy to install with a little lube on the hanger, but removing them especially while they are installed on a the truck is a major PITA! Spent forever today trying to pry them off and it finally dawned on me how to remove them easily. Thought I would share.....use a pitman arm puller or similar puller. Mine fit perfectly and made removing several of these (more than once) much easier.
View 6 RepliesFord Excursion :: Removing Fuel Filter?
I've been using the 'special' plastic ring tool to try and separate the lines from the filter, but with no joy. I can feel the tool compress the spring(?) on both fittings, but no matter how hard I am able to pull the lines won't come off.
View 10 RepliesFord Excursion :: How To Remove The Rear Bumper
I have a newbie question on how to remove the rear bumper? Do I disconnect the sensors first or remove the bumper and disconnect the sensors.
I read this thread : [URL] .....
But was not sure which bolt to remove? Is it all 4 on each side or 2 toward the rear of the bumper?
Ford F-150 (2004-2008) :: 2006 FX4 - Front Driveshaft Won't Turn By Hand
Some say the front drive shaft should turn by hand in 2h and some say it shouldn't.... I have an 06 FX4, with auto locking hubs (meaning if I want 4H i turn from 2H to 4H). I've been getting a terrible shake at 55mph (yes I've read the forums on that too, not my question) .
So I crawled underneath to look at rear driveshaft, u joints, etc..., and by chance I grabbed the front driveshaft to pull myself forward to check out everything else, and it didn't turn......
I twisted a little and the shafts going to both front wheels turned. Now shouldn't these turn freely in 2H?....The light to 4H never comes on when I switch it, but it is engaged (or else I'd never have gotten unstuck....several times)... Am I stuck in 4H and just didn't know? .
Ford Excursion :: Removing Of Roof Rack Rails?
Just got a mild lift done on my Ex and still wanting to park it in the garage.
If I remove the useless rails and cross bars that looks like it's still a possibility.
What to fill the holes with? Just torx screws? Anything else I need to do to prevent water leakage?
Ford Excursion :: Removing Rear Vent Window?
My passenger side rear vent window is leaking and I was gonna redo the weather stripping but I can't figure how to release the latch from the motor. It looks like a ball and socket type connection with a little wire clip in it, but I tried pulling it out and it wouldn't come out very far, and tried pushing in in more but no luck. I don't want to break the darn thing for sure.
View 9 RepliesFord Excursion :: Removing Second Row Seats - How To Get To Torque Screw
I have a 2001 excursion and am trying to remove the second row bench seat. How do you get to the back set of of torque screws? The front ones are easy to get to but the rear are under the seat trac and I haven't been able to get to them. I am pretty sure I am overlooking the obvious.
View 3 RepliesFord Excursion :: Engine Heater Cord In Bumper
Molding the engine block heater cord into the bumper some how or is a product out there like the 7 pin trailer harness to do it?
View 5 RepliesFord Excursion :: How To Get Lower Spring Leaf Bumper Out
I got the new ones, (as mentioned in another thread) and they're the same as the old ones. Well, the one that's still in one piece.
I guess I'm missing something very simple, but as easy as it would be to cut the old one out...how do I make room between the lower leaf and the other leaf pack to get it out?
I about hung from the lower leaf and it didn't move quite enough to give the room to remove the bumper.