Ford Excursion :: Front Bumper Grill Insert?
Is there a source for a insert for the tow hooks & between the fog lights?
View 2 RepliesFord Excursion :: 2002 - Front Bumper Damaged - Fix Or Replace?
So a line of panic stops on the highway last night and I lost - stopping an 8000lb rig compared to hondas, nissans, etc. Anyway I just kissed the corner of a nissan xterra and dented the steel part of my front bumper below the driver headlight. Nothing else. It is a 2002 all black limited.
I am wondering about fixing vs. buying a new bumper. A new one from the dealer is 436 and then needs to be painted.
Ford Excursion :: Removing Ranch Hand Front Bumper?
I have a Legend Ranch Hand Part# FBF991BLR front bumper. I am debating removing this as I don't really need it for my driving and the extra 450 lbs and hanging out there in the wind can't be good for the suspension and economy. Any thoughts on this? What all come off to install one of these things that I would need to replace with stock?
View 14 RepliesTouareg :: Transmission Surging When Driving On Flat Ground At A Constant Pace
This weekend I was driving home from my parents and noticed that on flat ground at a constant pace there seemed to be surging of some sort...Although I am not sure that surging is exactly what it was, but it is the best word to describe it.
Basically, if I kept my foot at an even speed (not accelerating or decelerating) I would get very subtle movement in what seemed to be either the differential or the transmission. No error codes were thrown and the battery gauge was spiked at 14 solid.
Prius C :: Back Bumper Is Really Close To The Ground?
I know this may sound weird, but lately every time I am standing behind my car, I feel like the back bumper is really close to the ground and the whole back just seems really low to the floor. I am tall but not THAT tall at 5'7" and I can easily see the top of the car when I'm standing back there...opening the trunk etc.
View 13 RepliesGolf/GTI VI :: Rear Driver Side Sits About Half Inch Lower Than Passenger Side On Flat Ground
I have a mkvi gti with all stock suspension except rear sway bar. And I'm right about to order driver gear springs. But have a question about suspension. My rear driver side of the car sits about half inch lower then then rear passenger side on a flat ground. Would this be caused by springs? Or struts? Or what. Planning on ordering the driver gear springs but what the real problem is. I want the driver gear so I'm a bit lowered but not crazy low since the roads in my home town are awful and my street I have to do figure 8's all the way down it to not hit a pot hole.
View 3 RepliesFord Excursion :: 2003 - At Start Up Ground Strap From Engine To Firewall Get Hot?
Ground strap from engine to firewall gets hot while starting and then stops getting hot, had batteries checked, replaced alternator, checked all battery connections, check all battery wire and connections, check ground from engine from block to fire wall , checked ground from battery to fender
2003 ford excursion,
Ford Excursion :: Steering Wheel Moves Back And Forth Rapidly When Driving Down The Road
My dad has a 2002 Limited X and my uncle had a '99? F350 dually. Both have this issue:
-Occasionally when driving down the road the truck will suddenly just try to veer off to one side or the other and then the steering gets really rough (The steering wheel moves back and forth rapidly. My dad has to pull off to the side of the road, completely stop and turn the wheel all the way to each side twice and it seems to correct it momentarily.
-The other issue is that when making a corner there will be a hard "thump" noise, and then the before mentioned issue occurs.
My dad has replaced all 4 ball joints, the 1 bad tie rod and has gone through a set of Warn Lockout Hubs (In less then 6 months. He had to drive around with the hubs locked in to prevent the truck from pulling due to warn out needle bearing. This somehow resulted in the passenger side Hub being internally destroyed and that wasn't even the side the bad ball joint was on.)
Ford Excursion :: 2001 - Middle Seat Stuck In Fold Flat Position
Any trick? I folded down the larger (driver's side) middle seat to get a large payload in...now it won't pop back up...no matter how much lever pushing and seat-yanking I do. It's a 2001 Limited.
View 14 RepliesFord Excursion :: How To Remove The Rear Bumper
I have a newbie question on how to remove the rear bumper? Do I disconnect the sensors first or remove the bumper and disconnect the sensors.
I read this thread : [URL] .....
But was not sure which bolt to remove? Is it all 4 on each side or 2 toward the rear of the bumper?
Ford Super Duty (1999-2016) :: Front Axle Spins While On Ground In Park
I'm trying to figure out how much of my front end I need to rebuild. 130,000 mi on the truck. About 1/2 of those miles are off road. 2008 F350 FX4. Stock. Original front wheel bearing unit and hubs. I was under the truck today and before I put it on jacks I decided to see how much play was in the front end components.
I noticed when checking out the passenger side front axle at the u-joint that I was able to spin the whole u-joint and bearing with the wheels still on the ground. I wasn't able to do the same for the driver's side. Both hubs were set to auto although I know that the ESOF doesn't work. Is this normal? Am I supposed to be able to spin the axle with the wheels on the ground?
Lexus RX 2010-15 :: Driver Seat Moves Back A Bit And When Braking Hard It Moves Forwards
My RX350 is over 4yrs old with 105k km on it. I notice lately when I drive off the seat moves back a bit and when braking hard it moves forwards. It is about quarter of an inch movement but it is noticeable. I guess it is not under warranty now. I looked under the seat but can not find where this is coming from, I am assuming it must be a loose bolt that needs to be tightened.
View 4 RepliesFord Excursion :: Engine Heater Cord In Bumper
Molding the engine block heater cord into the bumper some how or is a product out there like the 7 pin trailer harness to do it?
View 5 RepliesFord Excursion :: How To Get Lower Spring Leaf Bumper Out
I got the new ones, (as mentioned in another thread) and they're the same as the old ones. Well, the one that's still in one piece.
I guess I'm missing something very simple, but as easy as it would be to cut the old one out...how do I make room between the lower leaf and the other leaf pack to get it out?
I about hung from the lower leaf and it didn't move quite enough to give the room to remove the bumper.
Ford Excursion :: Removal Of Backup Sensors In Rear Bumper?
My Excursion had a mangled rear bumper when I bought it recently. I just bought a salvage one to replace it. I had it installed today. I want to salvage the backup sensors in the old bumper along with the license plate lights. How do these come out? They seem locked in there to me.
View 3 RepliesFord Excursion :: Addition Of Backup Sensors On Chrome Bumper Without Drilling
I'd really like to add these to The Beast, but don't want to drill through chrome. My bumper has some plastic running along the top (see pic). Just looking for info for the same bumper mounted the sensors there with success.
View 9 RepliesGolf/GTI VI :: Front Subframe Hits The Ground
Car is on airlift slam xl and on a set of bbs style 5's 17x8 et20 with 195/40 all around. problem is the front subframe hits the ground already before it completely airs out so i got some front tires still showing in the front.
View 1 RepliesFord Excursion :: 2002 - Replaced Bumper Now Reverse Sensor Stop Working?
My 2002 Excursion was rear ended. Body shop replaced the bumper. I noticed that the reverse aid was no longer working. I checked and noticed that non of the sensors were working. It was working before they replaced the bumper. If the speaker is out, would the four rear sensor still tick? I find it mighty strange, that it worked before and after the accident. Now that they've replaced the bumber, Every time it's placed in reverse, the light comes on.
View 4 RepliesPrius (2004-09) :: Front Bumper / Left Front Fender And Driver Door Replacement
Looking for info on these replacements and is there any manuals out there to assist with the process?
View 1 Replies