Ford Excursion :: 2001 - Door Ajar Switch Stuck In Open Position?
2001 excursion 4'4 V10 XLT.
One or more of my door switches is stuck in open position. Door ajar light on and interior lights on.
Interior lights stay on for about 15 min than go off.
I have sprayed all 4 doors and both rear hatch lock assemblies several times with WD40 and electrical cleaner with no improvement.
When I open drivers door there is no key chime with key in cylinder. Could the hood switch cause this issue? How do I determine which door/doors is/are the offending crimimals?
Ford Ranger / B-Series :: 1996 XLT - Ignition Key Stuck In Off Position
My ignition key is stuck / locked in the off position. The first time this happened I jiggled the key while moving the wheel back and forth and it turned. The next time in the truck nothing worked. I let it roll back a bit then tried, pushed the clutch in and put it in neutral, etc it did not move. (Just had the clutch and clutch hydraulics replaced.) The wheel is locked. The key removes from the cylinder.
I know it is easy to replace the Ignition Lock Cylinder when you can turn the key in the run position. How to remove it when locked in off?
Ford Ranger / B-Series :: 1996 B2300 - Ignition Stuck In On Position
Took my 96 B2300 2WD SE (190k) to lunch. When I went to start it back up afterwards, the key turned but no starter engaged. All the dash lights came on, and now stay on. With the key in, I can turn the ignition freely...no clicking to different positions.
It springs a little when I turn it all the way, but still no starter. When I remove the key, the dash lights stay on, etc. So, since it was on, we were able to push-start it. I've parked it on a hill for now, and will disconnect the battery when I get it home.
Ford F-150 (2004-2008) :: Key Stuck In Ignition Switch
My young lad just picked up a 2004 F150 4x4. While fixing it up we have encountered a weird problem. The key goes in , starts and runs the truck but cannot be removed, unless you unhook the battery.
View 5 RepliesFord - Ranger :: 1989 - Stuck Steering Wheel / Ignition Switch
So, I have an 89 Ford Ranger 4-wheel drive and the steering wheel is locked up (along with the ignition switch), neither of which will turn or budge. I've been told to shake steering wheel from side to side while trying to turn key--but after fifteen minutes of that (quite a workout) bupkis, nada, nothing. So, other than taking a sledge hammer to the whole truck? Is there a way to simply break loose the mechanism (I don't need the security aspect of the locking wheel/ignition, since I only use this for "farm use". But I really need it fixed.
View 9 RepliesPontiac - Grandprix :: 2001 - Ignition Switch Cannot Be Turned Back To Off Position All The Way
My wife's 2001 Gran Prix has a problem with the ignition switch, or related to the ignition switch. Intermittently (more frequently in warm weather or when the car's warm) the ignition switch can't be turned back to the 'off' position all the way, meaning the key can't be removed from the switch. We've heard from several mechanics that there are a couple problems that can cause this, and in fact had the ignition switch replaced which did not solve the problem. I understand there is a connection to the transmission or gear shift lever that may also be part of this problem in some way. There can only be so many solenoids, switches, connections, etc, related to this, I'd like to fix the problem and avoid spending money unnecessarily.
View 2 RepliesDodge - Ram :: Transmission Replaced - Now Ignition Switch No Longer Reverts To Off Position
I just bought a 2001 Dodge Ram 1500 (Magnum Series); 5.9l, 2WD, 8cyl. After 2 months the transmission went out. I bought a used transmission and had a shop install it. When I picked it up (10-3-14) the mechanic pointed out the shifter is one notch off (ie. in R position its in Park, in N position its in Reverse, etc). In addition it no longer has D1 nor D2 (putting the shift in D-D2 position results in Drive only, no power gears). The mechanic said it was something in the steering column causing the shift display to be off and had no explanation to why there were no power gears.
To make matters worse, the ignition switch no longer reverts to the Off position; the key can be removed but the switch stays On, warning alarm for key being in ignition comes On etc. I admit the ignition switch was old and the switch would sometimes not turn over before the transmission was replaced. He blamed something in the column again. So,
Q1-Is the mechanic correct there is something wrong in the column and not a misalignment he caused when he installed the replacement transmission causing the shifter to be misaligned?
Q2-Why doesn't the truck have D1-D2 gears? Do some transmissions not have these or am I missing something?
Q3-Is the most likely problem to the ignition the ignition switch or solenoid? Or could he have damaged something during the transmission installation? (I ask the latter because he took a panel off under the steering column while installing the replacement transmission.)
Saturn - Vue :: 2005 - Outlets Only Deliver Power When Ignition Switch Is In On Position
There are two 12V power outlets inside my 2005 Saturn VUE. They always have power available, whether the car is on or not. I'd like to change that. Is there an easy (or somewhat easy) way to make it so that the outlets only deliver power when the ignition switch is in the on position?
View 2 RepliesSanta FE SM (2001-06) :: Key Stuck In Ignition On Accessories Position
I have a 2001 Santa Fe, and the key is stuck in the ignition. I can't even get it to turn to the Lock position, so it's stuck in accessories. Since I haven't had the funds to do so, I haven't gotten it checked out yet, and it's started to drain my battery. I have to jump it every single morning, so I'm wondering if there's anything I can do until I can gather up the money to fix it.
I have tried moving the steering wheel and shifting it all over the place and spraying DW-40 in there and a whole bunch of other things I've seen work for people on a bunch of different forums, but nothing works. I don't know if this matters, but before it got stuck, it would sometimes be hard to pull out or push the key into the ignition.
Ford Excursion :: 2000 - Ignition Switch Going To ACC
Having problems with Ignition switch going to Acc. even with the key removed and the steering locked???
View 3 RepliesSaturn - Outlook :: 2007 XR Key Will Not Turn To Off / Stuck In ACC Position In Ignition
The key will not turn to off, stuck in acc. I have no power to the windows, sunroof, seat and seat heaters, and no brake lights, and the mirrors have no power either. I took the car to the local GM dealer who told me the ignition was not in any recall and found that the Body Control Module was bad and needed replacement.
View 5 Replies1997 Bravada Won't Start - Key Stuck In Ignition In Accessory Position
I have a 97 Bravada. Recently the check engine light came on and then went off. I didn't think anything of it at the time till the other day I drove it to work and back fine without any issues, then the next morning I tried starting it and nothing happened. No cranking, no interior lights, no sounds.
I tried jumping it thinking the battery was dead but that didn't work. Now my key is stuck in the ignition in the accessory position. It will not turn all the way back to release the key.
Cavalier :: 96 - Key Started To Randomly Get Stuck In The Middle Ignition Position
Quite awhile ago my key started to randomly get stuck in the middle ignition position but it was happening very rarely and some gentle jiggling was letting me take it out easily. Well a few days ago that went from very rarely to each and every time I start the car.
Now its a tossup whenever I go somewhere whether the key will pop out like it should or I'll have to fiddle with it for anywhere up to ten minutes.
The car never has a problem starting, its only when I have arrived somewhere and need to take the key out that is an issue. I've managed to remove it every time so far but it has taken a fair amount of WD-40, jiggling the bejeezus out of the key and steering wheel and plenty of patience.
Santa FE SM (2001-06) :: 2003 - Ignition Stuck In Start Position
I have a 2003 2.4L 5 speed manual Santa Fe. I was parking my vehicle and removed my key as usual and realized that the car was still running. I put it into reverse rolled back and back into 1st to roll forward just to make sure I wasn't dreaming. I ended up pulling the fuel pump fuse and disconnecting the battery to turn it off.
When I replaced the fuse and reconnected the battery I was able to bump start the vehicle without the key in the car and drive it all the way home with no problem. I took apart all the plastic pieces around the Ignition and attempted to remove the cylinder but was unable to locate any sort of small button or pin to push on to remove it. Where is the release button?
What are my options here? Do I replace the cylinder first or get a new key, or is there something else that I should check first before I take it in.
Phaeton :: Move Selector Lever To Position P - Key Stuck In Ignition
I have a European Phaeton 3.2 litre V6 (gasoline) from 2003 that is giving me some problems. When I am finished driving I put the gear lever to parking position and turn off the ignition. I then get a message "Move selector lever to position p" and the key is stuck in the ignition.
So far, I have been able to get the error message away (and with that also been able to get the key out) by starting the car and move the gear lever around. Some times I have managed by only starting the system (by not holding my foot on the brake pedal). But tonight I couldn't get it fixed after numerous tries. I then simply waited in the car, because I didn't really know what to do, and after maybe five minutes the system shut down (energy saving mode?) and I could finally get the key out.
When I tried google the error message I found some topics about it on the Touareg forums, but they got the error message while driving and it had to do with the keyless system (which my car doesn't have).
What might be causing this problem? My local VW dealer is not very used to Phaetons (I am the only on in my town with one).
Chevrolet - Cavalier :: 2001 - Cannot Turn Ignition Off / Key Stuck To On Position
It's a 2001 Chevy cavalier. The key is stuck and won't turn the car off. Already have tried shaking the wheel and wd-40. The wipers won't work and the gauges won't turn on until I jiggle the key.
View 4 RepliesFord Excursion :: 4WD - Driver Side Hub Seems To Be Stuck In Locked Position
The drivers side Hub seems to be stuck in Locked Position. I lifted the Wheel and when I turn it the Front Drive shaft turns and you can feel a fair amount of resistance.
I lifted the Passenger side and it spins free. I then started it and put it in 4WD and the passenger side engaged and i could not free spin the wheel. I then lifted the drivers side again and it would not spin. Turned off 4WD and it spun again but moved the shaft.
TrailBlazer :: 2002 Envoy SLE - Stuck In Park / Ignition Will Not Go Into Lock Position
I've recently purchased an 02 Envoy from an auction. There are a couple of issues. The main one started last night. While at the store I put the truck in park and turn off the ignition. The ignition will not go into the lock position. I messed with the key and go it to turn off. Then started the truck to leave and couldn't put the truck in gear. I messed with the shifter and was able to put into gear.
At that point the gear shifter would move from park to reverse without me pushing the break pedal. I drove home and could not turn the key all of the way off again. Moved gear selector from 1st to Park a few times and then was able to remove the key. I restarted the truck and could not move the gear selector again; however I was able to remove the key easily.
I am leaning towards replacing the "Neutral Safety Switch" on the tranny but with my symptoms, I've seen brake light switch, ignition, and solenoid at gear shift selection.
Back up lights do not work either. Since I purchased the truck, I've replaced,
-Battery
-Ignition Coil
Ford Excursion :: Keeping Front Hubs Locked And Switch In 2wd Position For Everyday Driving?
Is it ok to keep my front hubs locked in and the switch in the 2wd position for everyday driving? Only reason I do it is because in auto it doesn't always go into 4wd.
View 11 Replies