Cavalier :: 96 - Key Started To Randomly Get Stuck In The Middle Ignition Position
Quite awhile ago my key started to randomly get stuck in the middle ignition position but it was happening very rarely and some gentle jiggling was letting me take it out easily. Well a few days ago that went from very rarely to each and every time I start the car.
Now its a tossup whenever I go somewhere whether the key will pop out like it should or I'll have to fiddle with it for anywhere up to ten minutes.
The car never has a problem starting, its only when I have arrived somewhere and need to take the key out that is an issue. I've managed to remove it every time so far but it has taken a fair amount of WD-40, jiggling the bejeezus out of the key and steering wheel and plenty of patience.
Saturn - Outlook :: 2007 XR Key Will Not Turn To Off / Stuck In ACC Position In Ignition
The key will not turn to off, stuck in acc. I have no power to the windows, sunroof, seat and seat heaters, and no brake lights, and the mirrors have no power either. I took the car to the local GM dealer who told me the ignition was not in any recall and found that the Body Control Module was bad and needed replacement.
View 5 RepliesSanta FE SM (2001-06) :: Key Stuck In Ignition On Accessories Position
I have a 2001 Santa Fe, and the key is stuck in the ignition. I can't even get it to turn to the Lock position, so it's stuck in accessories. Since I haven't had the funds to do so, I haven't gotten it checked out yet, and it's started to drain my battery. I have to jump it every single morning, so I'm wondering if there's anything I can do until I can gather up the money to fix it.
I have tried moving the steering wheel and shifting it all over the place and spraying DW-40 in there and a whole bunch of other things I've seen work for people on a bunch of different forums, but nothing works. I don't know if this matters, but before it got stuck, it would sometimes be hard to pull out or push the key into the ignition.
Santa FE SM (2001-06) :: 2003 - Ignition Stuck In Start Position
I have a 2003 2.4L 5 speed manual Santa Fe. I was parking my vehicle and removed my key as usual and realized that the car was still running. I put it into reverse rolled back and back into 1st to roll forward just to make sure I wasn't dreaming. I ended up pulling the fuel pump fuse and disconnecting the battery to turn it off.
When I replaced the fuse and reconnected the battery I was able to bump start the vehicle without the key in the car and drive it all the way home with no problem. I took apart all the plastic pieces around the Ignition and attempted to remove the cylinder but was unable to locate any sort of small button or pin to push on to remove it. Where is the release button?
What are my options here? Do I replace the cylinder first or get a new key, or is there something else that I should check first before I take it in.
Cavalier - Chevrolet - Code - Transmissions :: 2001 - P0742 Stuck Torque Converter Clutch
My girlfriend's 2001 cavalier has about 160k on it and about a week ago it started shifting harshly accelerating to highway speeds and the CEL came on along with the traction control/abs warning light. I pulled the OBD2 code and it was P0742, Torque Converter Clutch Circuit Stuck On. We took it to the transmission shop down the street the next day and they wanted $600 to diagnose. We called 'shenanigans' and decided she should take it to her regular shop. On the drive over the transmission shifted normally. Both shops noticed that the transmission cooler lines were rusty and seeping, but neither thought it was the cause of the problem. The shifting issue hasn't recurred even after a couple hundred miles during the week. She hasn't had the transmission fluid changed and doesn't know if it had been when she bought it about 80k miles ago. It seems to me that pre-emptively draining the fluid, changing the filter and refilling, especially to check for debris in the fluid, would make sense, especially if it was debris jamming the circuit that caused the error code in the first place.
View 8 RepliesChevrolet - Equinox :: 2009 - Key Sporadically Getting Stuck In AUX Position When Attempting To Turn Engine Off
I have a 2009 Chevy Equinox with a little over 50,000 miles. About a year ago the key began sporadically getting stuck in the AUX position when I attempt to turn the engine off (no problems when starting engine). The dealer installed a new ignition cylinder (which cost me $1,000) but the problem continues. When the key sticks I re-start, re-shift and re-brake and I can remove the key and turn off the engine on the first or second try. The dealer suggested that I take my foot off the brake when I remove the key but I usually have to FLOOR the brake to remove the key.
View 3 RepliesChevrolet - Cavalier :: 1996 - Transmission Is Blown - Stuck In Reverse
I have a 96 Chevy Cavalier with about 160k miles on it. Yesterday it started kicking kind of strangely from a dead stop to accelerating while in drive. This evening, after driving it both to and from work, when I backed in to a parking spot, it got stuck in reverse. The car was still pulling in drive and in reverse, it just seems like the gear shifter moves freely.
Idle seems fine, the vehicle just doesn't want to go into park or drive anymore.
Is this just as simple as the transmission being blown, or could there be another problem? Also, now that I've gotten the car turned off, it will not turn over again, since the vehicle won't shift into park.
Ford Excursion :: Ignition Switch Stuck In Off Position
None of my 4 keys will operate my ignition switch.
It's stuck in off position. Steering wheel is not locked and I have pulled pretty hard on it to see if I could get the ignition switch to turn.
I have a new switch on the way but I have to get the old one out and don't know how to get old one out if I cannot turn the switch to on position.
1997 Bravada Won't Start - Key Stuck In Ignition In Accessory Position
I have a 97 Bravada. Recently the check engine light came on and then went off. I didn't think anything of it at the time till the other day I drove it to work and back fine without any issues, then the next morning I tried starting it and nothing happened. No cranking, no interior lights, no sounds.
I tried jumping it thinking the battery was dead but that didn't work. Now my key is stuck in the ignition in the accessory position. It will not turn all the way back to release the key.
Phaeton :: Move Selector Lever To Position P - Key Stuck In Ignition
I have a European Phaeton 3.2 litre V6 (gasoline) from 2003 that is giving me some problems. When I am finished driving I put the gear lever to parking position and turn off the ignition. I then get a message "Move selector lever to position p" and the key is stuck in the ignition.
So far, I have been able to get the error message away (and with that also been able to get the key out) by starting the car and move the gear lever around. Some times I have managed by only starting the system (by not holding my foot on the brake pedal). But tonight I couldn't get it fixed after numerous tries. I then simply waited in the car, because I didn't really know what to do, and after maybe five minutes the system shut down (energy saving mode?) and I could finally get the key out.
When I tried google the error message I found some topics about it on the Touareg forums, but they got the error message while driving and it had to do with the keyless system (which my car doesn't have).
What might be causing this problem? My local VW dealer is not very used to Phaetons (I am the only on in my town with one).
Ford Ranger / B-Series :: 1996 XLT - Ignition Key Stuck In Off Position
My ignition key is stuck / locked in the off position. The first time this happened I jiggled the key while moving the wheel back and forth and it turned. The next time in the truck nothing worked. I let it roll back a bit then tried, pushed the clutch in and put it in neutral, etc it did not move. (Just had the clutch and clutch hydraulics replaced.) The wheel is locked. The key removes from the cylinder.
I know it is easy to replace the Ignition Lock Cylinder when you can turn the key in the run position. How to remove it when locked in off?
Cavalier - Chevrolet :: 2003 Won't Shift To Park And Reverse / Stuck On Neutral And Drive
I have been driving a 2003 Chevrolet cavalier and the automatic shift is stuck and can only shift to neutral and drive since Thursday morning. It wont go up to reverse and parking and down to the other 3 shifts.
This first happened last April but somehow with the right grip or pressure was able to get back to all the other shifts. Since then it happened 2-3 times as I can remember and now could be getting worse.
TrailBlazer :: 2002 Envoy SLE - Stuck In Park / Ignition Will Not Go Into Lock Position
I've recently purchased an 02 Envoy from an auction. There are a couple of issues. The main one started last night. While at the store I put the truck in park and turn off the ignition. The ignition will not go into the lock position. I messed with the key and go it to turn off. Then started the truck to leave and couldn't put the truck in gear. I messed with the shifter and was able to put into gear.
At that point the gear shifter would move from park to reverse without me pushing the break pedal. I drove home and could not turn the key all of the way off again. Moved gear selector from 1st to Park a few times and then was able to remove the key. I restarted the truck and could not move the gear selector again; however I was able to remove the key easily.
I am leaning towards replacing the "Neutral Safety Switch" on the tranny but with my symptoms, I've seen brake light switch, ignition, and solenoid at gear shift selection.
Back up lights do not work either. Since I purchased the truck, I've replaced,
-Battery
-Ignition Coil
Ford Ranger / B-Series :: 1996 B2300 - Ignition Stuck In On Position
Took my 96 B2300 2WD SE (190k) to lunch. When I went to start it back up afterwards, the key turned but no starter engaged. All the dash lights came on, and now stay on. With the key in, I can turn the ignition freely...no clicking to different positions.
It springs a little when I turn it all the way, but still no starter. When I remove the key, the dash lights stay on, etc. So, since it was on, we were able to push-start it. I've parked it on a hill for now, and will disconnect the battery when I get it home.
Accent LC (2000-05) :: 2004 - Key Stuck In Lock Position In Ignition / Wheel Locked
My 2004 Accent is stuck in the "lock" position in the ignition, and the wheel is locked and barely turns in either direction. I know this is supposed to be an anti-theft feature and I've tried all of the solutions listed here...
Turning the wheel hard and soft in either direction while holding the brake all the way down and trying to turn the key. Putting the car in neutral and then park and trying the above Disconnecting the battery for a few minutes and trying the above Jacking the car up on one side to release the tension on the pin.
My question is can I remove the spring at the bottom of the locking pin by drilling a hole in the center of the plate? I've seen a few youtube videos of this done on BMW's. It will cost me $500 minimum to replace the ignition or steering column based on quotes I got.
Cavalier - Chevrolet :: Trans Not Upshifting On Its Own When Need To Turn
So I'm driving to work this morning, 35 miles one way, and I get to my destination, or almost. 1999 Cavalier, automatic transmission, 215,000 miles.
As I get to the red light where I need to turn, it seemed as if it was not upshifting on its own. It is an automatic. I made the turn, then made another turn and as I pressed the gas, it seemed to do the same, not wanting to shift into second.
As I turned to go up to the second level of the parking lot, it gave up about 3/4 of the way up to level 2. Pressing the gas just revved the engine. I tried switching into 1, 2, back to D, even to R, but nothing worked. It is like it just gave up and decided the only thing that would work is neutral.
When I switch into gear normally, you hear that slight thud as it falls into gear, but when I try it now, nothing happens.
Cavalier - Chevrolet :: 1996 - Turn Over / Gets Close To Start But Does Not Fire Up
My 1996 Chevrolet cavalier will not start. It sat for two months while I looked for a neutral safety switch. New switch is in and brand new battery, Car does turn over. It gets close but no luck. I put new gas in. I really need to get this running before the snow flies.
View 1 RepliesCavalier - Chevrolet :: 2001 - A/C Cuts Off While Idling
My daughter says that the AC on her 2001 Chevy Cavalier cuts off when she is idling.
View 4 RepliesCavalier - Chevrolet :: 1999 - Small Explosion In The Engine And Car Doesn't Start When Turn The Key
I have an 1999 Cavalier that I got inspected in July so I'm good until next July. I had a small welding job done on the frame so it would get the inspection sticker for this year, but I'm thinking that by next year, I'll have paid enough off of my Liberty and be able to take on another car payment. In the meantime, the Cavalier has 214,000 miles on it and has something weird happening. Occasionally, I will get into the car and turn the key to start it and it makes a sound in what I think is the engine compartment.
It almost seems as if there is a small explosion in the engine and the car doesn't start. Then, I turn the key again and it starts up without a problem, no boom. This actually happened again yesterday and I'm writing now so I don't forget "how" it happened. I stopped at the school to pick up my son and shut off the car to go in. I picked him up, got in the car and that is when it happened. I had just come from my house which is a mile away, so it was a short drive to get him. I keep thinking that maybe one of the cylinders has some gas in it that is igniting when I try to start it, but not sure what could cause that. It doesn't happen all the time though, just once every couple of weeks.
Also, this car has over 200,000 miles on it and I do not believe I have ever changed the antifreeze in it. It is the orange kind that is supposed to be good up to 100,000 miles and, yes, I should have had it changed a long time ago, but I have never had any problems with it overheating or starting in the winter time so I didn't worry about it. Again, this is only once a month or maybe every few weeks, but I'll see the coolant light come on. I don't want to take this to the shop and pay them to replace the coolant, so I'm thinking I'll either do it myself. My question is...should I drain it and replace with orange coolant, green coolant, or just top it off with water?