Ford A/C :: 1996 F350 - Clutch Making A Lot Of Noise
I just got done changing a/c clutch on a 96 f-350 5.8 because it was making a lot of noise. The new one is just as bad. Would the air gap cause this? When I took it off I could see it was hitting the pulley. The gap was 0.21 is that the specs on it.
View 3 RepliesFord A/C :: 2003 - Navigator A/C Clutch Started Making Noise?
Here is what happened. I bought the truck used a few years back. The A/C clutch always made a clunking noise when it engaged first thing in the morning but then when restarting later in the day no noise. No noise either once it started up, the compressor ran quietly.
Then I recently went camping, it was just this past weekend and we had a bunch of rain. So I had on the front defrost mode on the heater for the windshield. I let the truck idle for about 15 minutes. The wife noticed that the truck was overheating (I have a Taurus fan installed and the fuse blew on the controller thats another story for another time, I got that fixed. I think it was because the clutch was trying to engage but couldnt and it made the fan controller overheat and the fuse blew) So I popped the hood and it was smoking under the hood. So I turned off the defroster and hear some noise under the hood. The AC clutch was not engaging when on the defroster mode and is making a clunking/grinding noises all the time now.
When I returned home I checked the fuse for the AC clutch and it was blown. So I replaced the fuse and it engaged the clutch by turning on the A/C, the clutch engaged and the compressor sounded fine and the clunking noise went away, it also blew cold air all the time the A/C was on, with this it looks like the compressor is fine.
Then I tried the defroster setting again to simulate what had happened at the campground and the clutch was engaging at first then started to slip and I could smell it burning. So I shut it off. The A/C clutch is still making a clunking /grinding noise noise and wont engage at all now even when turning on the AC.
So for a second opinion from all of you, does it look like I can get away with just replacing the clutch assembly? Also does the clutch assembly come with the new magnet, bearing, and plate?
Ford A/C :: Compressor Clutch Making Noise / Would Engage Or Disengage
The A/C in my truck stopped working last year, and this year I intend to fix it. I believe the problem is with the compressor clutch because it was making noise as it would engage or disengage. It was making this noise for a good year or so, and then one day the noise stopped and I have no A/C. So I am only assuming its the clutch.
View 4 RepliesFord F-150 - 1997-2003 :: AC / Clutch Bearing Making Noise - New Starter And Still Won't Start
I have a 2000 F150 XLT 5.4L truck. I noticed the AC went out about a month ago and since then I could hear the AC/Clutch bearing making noise. Well I went to start it the other day after eating dinner out and it wouldn't start. It sounds like it wants to start but it just doesn't have enough umph. I replaced the starter and charged the battery up to 100 percent. It still won't start.
If I take the belt off it will start and I checked the AC/Clutch and I can move it with my bear hands. I tried disconnecting the AC/Clutch fuse and relay but that didn't work. Is it possible that the Clutch is freezing up when I try to start it?
Ford Excursion :: Hellwig Sway Bar Making Noise?
After 2 months my hellwig sway bar is starting to make a lot of noise I've checked to make sure everything is still tight and it is. It does it on sharp corners and braking ....
View 2 RepliesGolf VI R :: Clutch Noise Making Vibrations?
Searched through old threads but didn't come across these in particular, a lot to look through so may have missed in Car has 270 miles on it.
1) When clutch is in all the way and the car is revved, I can feel it in my left foot. This can be felt when car is stationary or in motion - Is this common for MK6/R? I don't recall being able to feel this in my MKV GTI
2) When the car is in motion, I hear a knock noise right after the clutch is pressed in. I can only hear the noise if windows are open and stereo is off, and this only occurs while the car is in motion. - Is this a standard clutch noise for healthy clutch/pp/flywheel/throw-out bearing on this platform, or should there be no noises? It sounds like something I'd expect to hear with a messed up throw-out bearing.
Ford Excursion :: Truck Would Barely Drive After Making Noise
So my wife was driving my EX today... she heard a noise and then the truck would barely drive. I went and checked it and i lost the exhaust pipe between cat and muffler (right below the second row) I also found 4 bared wires that had been ripped apart.
Exhaust broke loose and wrapped around drive shaft and ripped the sensor wires apart and threw the pipe somewhere? So I am assuming that there was an oxygen sensor located on that portion of exhaust that is now lost.
I thought no big deal I will just drive to a muffler shop and get it fixed, but the Ex would barely move. So i guess i will have to tow it, how I can get the truck to run missing the pipe and sensor.
My questions are:
Is that an oxygen sensor that goes into the exhaust pipe?
If so, can i just buy the sensor and pigtail, wire it and then drive to get exhaust fixed?
Is there a way for me to drive it without wiring in a new sensor instead of paying for a tow?
2004 6.8L limited....
Lexus GX 2004-09 :: AC Clutch Shot - Making Grinding Noise
My 04 GX has about 113k on it and the A/C clutch is shot, making a ton of grinding noise when its engaged (when the A/C is on).
Need to repair or replace there unit because of this? I see online the ability to buy just the clutch pack for the A/C compressor. However Lexus and other sites want to sell me the whole A/C compressor.
Question being, can I get away with buying the clutch pack and installing it onto my OEM a/c compressor? Or do I buy a new compressor?
Golf VI R :: 2013 - Clutch Making Noise Whenever Changing Gear At Low RPM
I have a 2013 golf r and I usually shift gear at 3 rpm when driving normal but for some reason it doesn't feel right, I can hear the clutch making a weird noise whenever changing gear at a low rpm, it feels so much smoother when shifting above 4 rpm but I dont always wanna punch it so hard especially when there's always traffic from where I live. Any advice on a smoother shift at a low rpm.
View 22 RepliesCaprice :: A/C Compressor Clutch Making Lots Of Noise When Working
Pretty sure the a/c clutch on my LT1 is going - making lots of noise when working and also when not.
I've heard on some forums that this could be a bearing? Is it advisable for me to replace the entire clutch or just this bearing?
Either way, I assume I'll have to pull the clutch for which I think I'll need two special tools:
(1) clutch holder tool to break nut loose.
(2) pulley puller.
Subaru - Legacy :: 1999 - Clutch Seems To Be Slipping, Making Some Noise In 3rd And 5th
The car has about 142,000 miles. Is the clutch on this car adjustable? My repair files indicate it was "adjusted" a couple times, $40 each time. Now I think I might need a new one: it seems to be slipping, making some noise in 3rd, and in 5th.
View 2 RepliesFord Excursion :: Transmission Making A Whining Noise - Torque Converter Or Pump
I recently bought a 2001 x w 145,000 miles. The transmission was making a whining noise when i bought it but it still shifted smooth and ran great. The truck has been serviced by the local Ford dealer its entire life with dozens of routine maintenance performed. With 145,000 miles should I wait for the converter to go out and just install a new transmission. It only gets drove on the weekends to go to the lake.
View 7 RepliesChevrolet - Camaro :: 1987 - Clutch Making Rotary Grinding Noise
I have a 1987 Camaro with a 305 TPI V-8, with a 5-speed manual transmission. I rebuilt the transmission, and installed a new clutch, pressure plate, throw out bearing, and had the fly wheel ground (which the machine shop said that it took very little material off to get clean-up). When we first got the car running when the car is moving in any gear (even in neutral) with the clutch peddle down, I get a rotary grinding noise (but only about 30% of the time). If I let the clutch pedal up the noise stops immedately. The transmission shift smooly, in all gear selection. I thought that I had gotten a bad throw out bearing, so we installed an other new throw out bearing, but I get the same noise. Is there something that could cause this noise inside the transmission?
View 8 RepliesSubaru - Forester :: 2003 - Transfer Clutch Assembly Making Noise
I have a 10 year old 2003 Subaru Forester in "very good" condition....except that the transfer clutch assembly is starting to make noise and the repair shop (at the dealer) says, housing has to be replaced also. The car has 130K miles and has had all its regular maintenance for 10 years. The only major mechanical problem we've had are the head gaskets (which on this year's model were NOT part of the recall). Those were fixed 2 years ago. Some of what I see in the online chatter about transfer clutches suggests that this is a slippery slope and the next thing you know there's the "next thing" that needs to be worked on. We were hoping that the 2014 Forester would get really good mileage (this one got 30 when it was younger) but we hear it will only be 32 mpg so we're inclined to "keep waiting" if this car can be kept happy. Is a transfer clutch repair a big deal?
View 7 RepliesGolf IV / Jetta IV :: 2003 - While Shifting Making Grinding Noise - Clutch Or Engine?
noticing a few issues with my 2003 jetta 2.0 when driving/shifting....so first main thing I noticed is when shifting from 1st to 2nd gear often times it will make a grinding sound and not shift smoothly from 1st to 2nd....you have to do it real slow/gingerly ...if I short shift from neutral to 2nd its fine or if down shifting to 2nd its fine...I have changed the gear oil...other sounds idk if its my tranny or engine but if going up hill and you throw into 3rd and not going fast enough its makes a rattling sound and is sluggish I know its a old car 177,000 miles so idk just curious if this is a sign of problems?....Last thing after driving and getting home and putting into reverse gear to park it makes a noise like a chugging sound when reversing and can be finicky going into reverse.
View 1 RepliesFord Excursion :: Viscous Clutch For Fan Working?
I have never heard my fan change noise pitch since I bought the V-10 Ex four years ago. Could it be working right? It's been through plenty of hot days and idling.
View 14 RepliesFord Excursion :: A/C Clutch Cycles Intermittently?
The clutch is on 2 seconds and off 2 seconds, and there is a click up on top that clicks every 2 seconds ?..........no cold air either.
View 12 RepliesVolvo :: 1992 960 Wagon Making Moaning Noise When Making Significant Turn At Low Speed
my 1992 960 wagon with 332K miles today started making a moaning noise when making a significant turn at low speed. At first it seemed to be only when I was accelerating but if that was true, it now is doing it at any low-speed big turn. Tonight, turning around in the driveway, it added what I call juddering during the turn. So naturally I am concerned.If it is something as minor as power steering fluid I might trust a local gas station to fill it up, but probably not any more than that. (There used to be a dealer about 45" away, but they seem to be gone now, and the closest one is hours away. I am 250 miles and one week away from my own trusted mechanic, so I hope it is something like fluid!).I haven't noticed any puddles on the driveway where it is parked, but I suppose it could leak out only when the engine is on and the car is moving.
View 4 RepliesFord Excursion :: 2001 - Front End Making Crunching Sound
01 Excursion V10 4x4 230000 miles
When making slow left turns, and sometimes hitting bumps going straight at low speeds 15-35 mph I hear and feel a crunching noise right below the gas pedal floor board area. I;ve had it checked out on a lift plus sitting on the ground and no none can figure out where the crunching (or banging) noise is coming from. Ball joints & tie rods are good, had them checked.
I bought the truck a yr ago and do not know much history of the vehicle. Is does still have the stock wheels, michlin tires and suspension. Ball joints and tie rods were replaced some time ago, not sure when...