Ford Excursion :: Clunky Flutter Noise As Truck Goes Into Park
Searched and can't find anything like what I hear out of my V10. After I start the truck, say 10 seconds later, I get an inconsistent clunk type noise that I can't nail down. It like a clunk that flutters if that makes any sense. Truck has 125k on it. I've had it since 113k and noise has always been there. Im concerned as I'm soon going to be towing a travel trailer.
Also this passed week I started the truck and got a ticking noise almost like a lifter noise that would come and go. I tried changing the oil and substituting one quart of MMO. Ticking started after that. So I drained that out and put in 6.5 quarts of valvoline 10w30. Truck still runs fine down the road and I just completed a 300 mile round trip with no issues. But as soon as truck goes into park that clunky flutter noise is there.
Ford Excursion :: Clunky Sound While Narrowing Down To Driver Side Body Mount?
I've got this clunky sound I am narrowing down to the drivers side body mount. The stock one has lasted 11 years. But I'm reading thread after thread about stock replacements lasting a year or so before crapping out again. I've found a few people mention the energy suspension lot, or another one that has Kevlar (daystar iirc). I googled them and found a handful of super duty owners who used the poly mounts complaining about harshness and vibration transmitted to the cab.
My truck is my dd and with my new highway tires and stock exhaust it's as quiet as it ever has been and that makes me and the family happy on long trips. I don't want to do anything to ruin that.
Camry :: 2005 - Flopping / Clunky Front Suspension Sound
Been having this problem for about a month now, and it seems like it keeps getting worse. The shocks feel like they are handling bumps ok....I feel no difference in how the car handles really.....but at lower speeds, going over bumps or pavement variations, I have a thuddy/clunky/floppy (I don't know the best way to describe it) sound coming from the suspension. I think it's from the front. I remember we had something similar to this before but it was in the rear, and I think the culprit ended up being something with the sway bar maybe? This front problem sounds much worse than the rear did though.
2005 Camry XLE 4 cyl
Lexus IS 2014+ :: Clunky / Groaning Noise Coming From Front End When Turn Steering Wheel
You can hear the clunky, groaning noise around 8 and 11 seconds when I turn the steering wheel, making a tight u-turn in an alley way.
What can it be..? I hope it has something to do with my tires since I'm getting new ones today. The current ones are pretty bald.
Quick video clip of noise...
Ford Excursion :: 2003 - Broke Front ABS Sensor Off?
I was attempting to replace the front abs sensor on my '03 Excursion 4x4 when it broke off inside the hole. I tried grabbing the plastic surrounding the magnet, but it just kept breaking off. How I can get it out?
View 5 RepliesFord Excursion :: 2003 - Front Shocks Replacement
I am looking in replacing the front shocks on my 03 excursion. It is 2w drive with the 5.4 engine. What recommendations for a smoother ride?
View 1 RepliesFord Excursion :: 2003 7.3L - Random Whirring Or Squealing Noise From The Front
I am now getting a random 'whirring' or 'squealing' noise from the front. When it starts, I feel some vibration in the steering wheel and floorboard and for sure can hear it. Starts on it own at random, sometimes when I hit a bump in the road. Stops at random, sometimes when hitting a bump in the road. Lasts for different lengths of time. Always stops when coming to a stop at about ~15 mph. Seems to change pitch ever so slightly if turning when it is 'whirring' or 'squealing'.
View 4 RepliesFord Excursion :: 2003 - Windshield Front Wiper And Sprayer Quit Working
I'm working on a 2003 that the front wiper and sprayer quit working on. The rear wiper and sprayer still work fine. We replaced the multifunction switch and no change. I would like to test the motor before we keep throwing parts at it.
View 5 RepliesFord Excursion :: 2003 - Transmission Fluid Leak Near The Front Passenger Side Of Truck
2003 Limited 6.0 130K. Just took a 1000 mile trip for spring break. While away, I noticed a small leak near the front passenger side of the truck. It is red so I assumed it was transmission fluid. It is leaking from, the best I can describe, a small housing that looks like it might be a filter near the tire (it looks like the old style canister oil filter housings). All the hoses are clean and where the hoses go into the radiator are clean. Is this an easy fix? I am a bit worried about trying to get the thing off without damaging the hoses.
View 3 RepliesFord Super Duty (1999-2016) :: 2003 Excursion - Cracked Front End Part
I was just in the middle of doing the V Code leaf spring swap and noticed a broke part where the u-bolts sit and what looks to be attached to the trac bar. The piece is broken in half and I am not sure how this happened or when. The piece is welded to the axle.
2003 Excursion 4x4 6.0...
Ford Excursion :: 2003 - Turn Signals Stopped Flashing / Front AC Now Only Blows Through Defroster Vent
I have a 2003 Excursion 7.3 2WD Limited and all of the sudden experienced a number of issues all at once.
1. Turn signals stopped flashing (hazards still flash)
2. Lost Rear back up sensors
3. Lost overhead trip computer
4. Lost Rear A/C - switch does nothing
5. Front A/C now only blows through the defroster vent
I've checked all the fuses and cant find any bad ones.
I replaced the multi-switch flasher and turn signals still dont work - only hazards.
Ford Excursion :: 2003 7.3L - Coolant Leaking From The Passenger Side Rear Hard Line By The Front Spring Hanger
On my 2003 Excursion 7.3L, I notticed I'm leaking what I think is coolant from the passenger side rear hard line by the front spring hanger. I haven't pealed the plastic loom away yet, but I did see the loom is chaffed near the spring hanger. What lines are the ones that carry coolant, and can I just cut the hard lines and replace with a section of rubber hose?
View 3 RepliesFord Transmission :: E4OD Shifting Into Reverse And Drive A Bit Clunky
I have a 94 E350 with the 460 and the E4OD trans. that has only 30K on it.
Last weekend I took it on a 250 mile trip (one way) and it ran beautiful until the final steep hill to our vacation house. It started vibrating when it went to down shift and wouldn't pick up any speed, the OD off light was blinking. When I pushed the OD button and it cleared right up. Ran beautiful until I tried to climb that same hill again (same thing happened). It showed the same symptom when I tried to back up a steep driveway during the same trip.
Now it no longer does the vibrating but now has harsh/firm up shifts. Downshifts are smooth though, but shifting into reverse and drive are bit clunky too.
The codes I pulled were KOEO 212 and 668. After I erased the codes the 668 didn't come back. But I did change the MLPS to the new updated one from Ford and its still doing it.
I also found the 40amp mega fuse under the hood was blown too, related? Could a 1/2 qt over filled trans. cause this now too? In NH I added some fluid thinking it was low because I could not get a clear reading on the dipstick but I think the level was up there.
Ford F-150 (2004-2008) :: 2007 - Clunky Sound On The Rack And Pinion
My son has a 2007 Ford Truck F150 1/2 ton P/U 4WD 5.4L , when he turns the steering wheel left and right you can hear a clunky sound on the rack and pinion right where the steering shaft connects.
View 2 RepliesFord Excursion :: Pop Noise In Front End / Left Front Wheel Grinding
Driving at hwy speeds and head a pop noise in front end. Stopped and couldn't find anything, heard it a couple of more times, still nothing found, now I have a grinding noise left front wheel. What the issue may be. 2001 Ford EX 4X4.
View 6 RepliesFord 6.0L Power Stroke Diesel :: Passenger Side Lower-outer Tie Rod Is Clunky
I know jack about tie rods. But what I do know is the passenger lower-outer tie rod is clunky [Right where it connects near the wheel. Jacked up the truck and moved the tire from right to left and the passenger side lower tie rod made a very obvious clunking noise right where it connects with the upper piece.
My question is, can I just replace the passenger lower arm or do I need to replace the upper [not sure what it's called] that it connects into? While under the truck I found it difficult to figure out exactly how they are joined together and taken apart? My drivers side is nice and tight, no clunking.
2005 F-250 CREW CAB 4X4
Ford F-150 (2004-2008) :: Truck Running Rough / Clunky Like Not Getting Gas - Fuel Pump Module?
First it was the whole spark plug debacle. Now it's the "fuel pump module". Story starts a several months back. On a moist day I was headed out and the truck ran very rough, "clunky", like it wasn't getting gas. After 15 miles and a stop truck ran fine. Didn't think much of it and truck ran fine for month or so. I was then away for a couple days and came home to find my truck wouldn't run (started briefly then died). Local mechanic thought it might be a fuel pump issue but then got truck running thinking it might have been a delayed inertia switch in front panel (I had hit a deer a week or 2 prior). Again, not thinking much of it continued to drive truck with no issues for awhile. Then one rainy morning on my way to work the truck was running very rough and "clunky" again. It died several times and finally for good.
After getting it towed to the mechanics, he figured the fuel pump was finally shot. The end to my long story is it was the fuel pump module (luckily a lot cheaper fix than the fuel pump) - half of the housing was gone (corroded away) adn moisture was shorting the pump electronics. Why, if this module is half encased in plastic do the engineers feel the need to encase the other half in metal (appeared to be cast aluminum)??!!????!! Of course it makes sense to have an electrical unit that is mounted underneath the truck where it can collect all the moisture, snow, salt from the road encased in a corrodable metal housing. No no, don't put it all in plastic, just half of the unit. MAKES PERFECT SENSE!! I thought to be and engineer took some sort of brains and common sense. Must be not at Ford. I can't be the only one with this issue and wondering WHY!!! - it must be widespread??
Mazda - 626 :: Dragging / Clunky Sound When Going Over 20 Mph
My Mazda 626 is making a really weird noise somewhere around the back left corner of the car (from the driver's seat). I just noticed it a couple of days ago, ironically enough, shortly after I picked it up from the mechanic for something totally unrelated!
I really only notice it when I'm going under 20mph. It's a dragging/clunky sound like something is loose. My husband checked it out briefly but didn't seem to notice anything different. I know I need to call my mechanic again, but after spending over $1,000 on repairs for both of our cars, my husband and I aren't thrilled about having to take this car back so quickly!
IS F (2008-2014) :: Clunky Shifting From 1st To 2nd Gear
Ok, so in M mode shifts can be a little rough from 2nd to 3rd unless I give it enough gas. It's no big deal and my car has always been like that (owned it since 9/2013). But as of yesterday, shifts have completely changed from 1st to 2nd. It is clunky, extremely quick and lurches forward every time in M mode. It has NEVER done this before and it kinda sucks.
I've read all of the threads regarding tranny fluid, belt squeak, etc. and haven't specifically found anything like this. I haven't done anything to the car except the ELF recall and an oil change about a month ago.