Ford Super Duty (1999-2016) :: Body Mount Bushings Shredded On Driver Side?
Need recommendation for replacement body mount bushing. Surprised to see the drivers side shredded. Poly replacement?
View 14 RepliesGTI 337/20th Anniversary :: Huge Clunk Sound Seems Like Coming From Under Driver Side Motor Mount
I was sitting at the stoplight in neutral when the light turned green. I pushed in the clutch and put the car in first then all of a sudden a huge CLUNK like when you take out the starter bolt without supporting the trans or motor. Then while letting out the clutch about halfway all hell broke loose. It sounded like a bunch of marbles rattling like crazy in the trans. I pushed the clutch back in then it stops until you let it back out again. The car still moves forward and reverse but with all that noise. The sound seems like it's coming from under the driver side motor mount. When I put my hand on the tranny I can feel the vibrations very well. Does this sound like the throw out bearing?
View 3 RepliesFord Excursion :: 2003 - Groaning Sound Near Driver Side?
Been noticing a new noise that would best be described as a groaning sound. Seems to be the loudest near the drivers side under the dash or floorboard area. I haven't been able to hear it from under the hood. It happens if I accelerate somewhat hard then letting off the pedal is when I hear it. Sometimes a few seconds and sometimes longer. Occasionally just letting off the accelerator at slow around town driving it will also be noticable then will stop. Oh yes, the EX is a 2003, 2wd, 6.0 with 101,000 miles.
View 7 RepliesFord Excursion :: Knocking Sound Coming From Front Driver Side
We've noticed an audible knocking that sounds to be coming from the front drivers side. It only happens at speed (over 30) and doesn't seem to be engine related. I can feel it under my resting foot while driving. I know this is vague but I think it may be enough to get started on figuring this out.
View 14 RepliesFord - Explorer :: 2001 - Rear Body Mount Bushing Replacement
2001 Ford Explorer Sport (not sport trac) 4.0l 5r55e 2wd.. Ok so I picked up a sweet deal of an explorer yesterday.
Sure enough I get her home and find out she needs both the rear body mount bushings replaced. Ok no sweat so I go to autozone...they cant find them... Ok I look in the book for replacement procedure... Nothing, To YouTube! ...nope nothing there either.
Ford :: 2006 - Motor Mount And Front Stabilizer / Rattling Noise From Driver Side Engine Compartment
My 2006 AWD LTD 500 has about 52000 miles on it; a slight rattle/clunking noise is intermittently heard on driver's side in engine compartment. Took it in to dealer who says motor mount is cracked and front stabilizer bar joints are worn and both need replacing. Car has only been driven on highways or for short trips (3-4 miles) and has had no impacts nor been driven over rough roads or run over any potholes or such. Should the motor mount be damaged? At 52K miles?? Never heard of such a thing. Ditto, the stabilizer bar joints: worn out in under 60K miles? What can I do about this? Who seek relief from? Ford warranty is, of course, over, and supplemental warrenty will only cover motor mount replacement but not stab bar. Are these parts routinely wearing out at such an early date that repair shops can reap the rewards???
View 4 RepliesFord Excursion :: 2003 - Front End Is Really Clunky
I recently got an 03 ex, only thing is front end is real clunky i know the shocks are shot so I'm doing them soon, I replaced upper n lower ball joints and new hub bearing o drivers side, all the stuff on the right side is good, don't know where this noise is coming from..
View 2 RepliesFord Super Duty (1999-2016) :: 2008 - Front Body Mount Removal?
i have a 2008 f250 4x4 i need to replace the drive side front lower body bushing and i can not get the pressed on bushing to come out what is the easiest way to get this to come apart i tried using a 4 ft pry bar and i could not get it to pop free.
View 11 RepliesGolf IV R32 :: 2004 - How To Change Engine Mount On Driver Side
Looking for some detailed instructions on how to change the engine mount on the driver's side on 2004 r32. My mechanic will work on it but he mentioned that he might have to drop the transmission but I thought that this is not necessary.
View 2 RepliesFord Super Duty (1999-2016) :: 2014 - Front Body Mount Bushing Replacement
The driver side front body mount bushing on my 2014 is gone which has the grill sitting on the bumper. I started to replace it, but the bolt is sized to the nut. ran off about 1/2 inch and that is it, it will not tighten or loosen anymore.
I cut the head off the bolt, but can not get the body high enough to remove the old bushing so i can cut the nut off flush with the rad support. Now I am trying to get the air filter box out so i can cut the top of the "nut cage" off to remove the bolt and nut out the top. but i can not figure out how it is held in.
I have the intake disconnected and the filter hat off, overflow tank hose disconnected, and two bolts holding the whole thing to the fender out, but it will still not budge. What am I missing here?
Ford Excursion :: Clunky Flutter Noise As Truck Goes Into Park
Searched and can't find anything like what I hear out of my V10. After I start the truck, say 10 seconds later, I get an inconsistent clunk type noise that I can't nail down. It like a clunk that flutters if that makes any sense. Truck has 125k on it. I've had it since 113k and noise has always been there. Im concerned as I'm soon going to be towing a travel trailer.
Also this passed week I started the truck and got a ticking noise almost like a lifter noise that would come and go. I tried changing the oil and substituting one quart of MMO. Ticking started after that. So I drained that out and put in 6.5 quarts of valvoline 10w30. Truck still runs fine down the road and I just completed a 300 mile round trip with no issues. But as soon as truck goes into park that clunky flutter noise is there.
Lexus GS 2006-11 :: Rear Bumper On Driver Side Is Loose From The Main Body
The front of the rear bumper on the driver's side is loose from the main body. The clip on the bumper is ripped from where it tore. I've gone ahead and bought the clips and everything from Lexus near me, but need to know the best epoxy or glue to reconnect the clip area on the bumper so I can apply the clips.
Is the bumper on that spot (the back side of it, not the painted exterior, if that makes sense) fiberglass.
Ford 6.0L Power Stroke Diesel :: Power Steering Lines Has Been Rubbing On Top Of Driver Side Front Shock Mount
Well about 4 days after my HPOP replacement, the ol Ford is at it again. Apparently, one of my power steering lines has been rubbing on the top of my driver side front shock mount. It let loose in a giant black plume of black smoke and grinding gears as I was pulling into the corner store. Limped her home and inspected it. From what I see, its not a terribly expensive hose and shouldn't be too terrible to replace. One thing after the other [URL] .....
View 3 RepliesFord F-150 (2004-2008) :: 2007 - Clunky Sound On The Rack And Pinion
My son has a 2007 Ford Truck F150 1/2 ton P/U 4WD 5.4L , when he turns the steering wheel left and right you can hear a clunky sound on the rack and pinion right where the steering shaft connects.
View 2 RepliesFord 6.0L Power Stroke Diesel :: Passenger Side Lower-outer Tie Rod Is Clunky
I know jack about tie rods. But what I do know is the passenger lower-outer tie rod is clunky [Right where it connects near the wheel. Jacked up the truck and moved the tire from right to left and the passenger side lower tie rod made a very obvious clunking noise right where it connects with the upper piece.
My question is, can I just replace the passenger lower arm or do I need to replace the upper [not sure what it's called] that it connects into? While under the truck I found it difficult to figure out exactly how they are joined together and taken apart? My drivers side is nice and tight, no clunking.
2005 F-250 CREW CAB 4X4
Mazda - 626 :: Dragging / Clunky Sound When Going Over 20 Mph
My Mazda 626 is making a really weird noise somewhere around the back left corner of the car (from the driver's seat). I just noticed it a couple of days ago, ironically enough, shortly after I picked it up from the mechanic for something totally unrelated!
I really only notice it when I'm going under 20mph. It's a dragging/clunky sound like something is loose. My husband checked it out briefly but didn't seem to notice anything different. I know I need to call my mechanic again, but after spending over $1,000 on repairs for both of our cars, my husband and I aren't thrilled about having to take this car back so quickly!
Camry :: 2005 - Flopping / Clunky Front Suspension Sound
Been having this problem for about a month now, and it seems like it keeps getting worse. The shocks feel like they are handling bumps ok....I feel no difference in how the car handles really.....but at lower speeds, going over bumps or pavement variations, I have a thuddy/clunky/floppy (I don't know the best way to describe it) sound coming from the suspension. I think it's from the front. I remember we had something similar to this before but it was in the rear, and I think the culprit ended up being something with the sway bar maybe? This front problem sounds much worse than the rear did though.
2005 Camry XLE 4 cyl
Ford Excursion :: Driver Side Floorboard Knocking
Whenever I cut the wheel to the left, there is a fairly loud knocking/grinding noise that I can feel through the floorboard.
Brakes have already been replaced, ball joints and tie rods inspected - no problems. Front end was greased (exception to the zirc fitting on the very top of the steering linkage). There is no modifications to the suspension (no lift) and the tires are the standard size (no rubbing in the wheel well). I do not know how long it has been since the shocks/struts were replaced but after inspection they seem to be in OK shape.
I read on this site that some owners were noticing a knocking under their floorboards too because of worn "body mounts". However, the body mounts are directly under the pedals. I don't feel any grinding or knocking under the pedals. It feels like its directly under the floorboard in front of the seat.
Could the body mounts be the issue when turning the wheel or is this something more sinister?
If its the body mount, it would be great if someone could post pics of the procedure. I have some pics that were posted from before but where to look on the underside of the truck to find the bolt/nut etc and where I put the floor jack and how high to raise the body...
2000 Excursion XLT
7.3L Diesel
149,000 miles
Ford Excursion :: Rattle In Driver Side Front Hub
I have a rattle in my drivers side front hub. I primarily hear it when I hit small bumps. With the hubs locked and in 2wd, the rattle is gone. Could this be just the hubs where replacing them with warn manuals would fix it or is it likely more involved?
View 6 Replies