Ford F-150 (2004-2008) :: Fuel Pump Driver Module

I have broken alum housing it looks bad , but still works. I can get two after market from rock auto for one 50.00 and anther for 60.00, the dealer is getting 160.00 what do I do?

View 6 Replies

Ford F-150 (2004-2008) :: Fuel Pump Module Falling Apart / Replacement?

So the fuel pump module on my truck is falling apart, and I figured I might as well replace it....

View 10 Replies

Ford F-150 (2004-2008) :: 1998 - Fuel Pump Can Be Heard Running But No Fuel Gets To Engine

5.4 L, Engine runs if primed at the intake. Fuel pump can be heard running but no fuel gets to the engine. Truck is mint and being sold real cheap due to this issue.

Fuel Pump? Filter? Both? I haven't seen the truck, a friend is considering buying it and rolling the dice it is a quick fix. Fuel is in the tank .....

View 2 Replies

F Series :: 2002 F150 4.6l - Fuel Pump Module Location On Truck?

My brothers 2002 F150 4.6l has a starting problem of when he shuts it off it will be hard to start sometimes. If he lets it sit for a while it will start right up. I did a search a looks like the fuel pump modules are subject in these trucks. The search also have them mounted on a cross member by the spare tire, this truck does not. My question is where is the fuel module located on the truck?

View 1 Replies

Ford F-150 (2004-2008) :: Running Very Rough / Shaking At Low RPMs - Truck Died

On my way into work this morning, my 06 with the 5.4 started running very rough/shaking at low rpms. I could kick it out of overdrive and it would smooth out and seemingly be fine at higher rpms.

This worked out for a couple of miles until the truck just died on me completely. The Edge is showing po351, 352, 353......358 codes. Ignition coil Primary/Secondary circuit fault on every cylinder.

I'm thinking its unlikely that every coil failed simultaneously....computer? When I try to start the truck, it will try to hit on a cylinder or two, but will not run.

View 3 Replies

Ford Excursion :: Fuel Pump Died After Rough Running Randomly

I have been chasing down what was a perceived vacuum leak...

My Ex (V10, 4x4, 217K miles) started to have an intermittent rough running/no power situation very randomly. No codes on the scanner, and no real apparent cause or condition to pin it down. I noticed what sounded like a like throttle ping...figured it was a vacuum leak someplace in the spaghetti under the hood.

I began to run down the possibilities. I have recently had the entire suspension replaced and upgraded all 4 corners to Power Stop brakes. Figured it might be something related like the classic lines to the hubs.

Replaced the vacuum lines to the hubs - ran OK for a bit, then rough start/idle/no power.
Replaced the vacuum switch for the hubs - ran OK for a bit, then rough start/idle/no power.
Replaced fuel filter - ran OK for a bit, then rough start/idle/no power.
Ordered a new vacuum reservoir...
While waiting on that, changed all 10 plugs and coils. Not. Cheap. Ran OK for a bit, then rough start/idle/no power.
Replaced IAC - ran OK for a bit, then rough start/idle/no power.

As I was getting ready to install the vacuum res, it just croaked. it would turned over like it wanted to start, but wouldn't catch.

Of course.... So, now it had to be towed and yes, the fuel pump puked and that was that. I've never had one do anything but just quit suddenly before, so lesson learned. Evidently these pump can act up for a bit before they die.

View 4 Replies

Ford 6.0L Power Stroke Diesel :: Running Rough After Putting Fuel In Truck Now Won't Start

This has me puzzled to no end. After my son had put fuel in my truck it began to run rough, and had to be towed home, and now won't start. Now the first thing I thought was that he put regular gas in. But he was sure he had not ,and the receipt from the pump indicates diesel. It was hard starting before this happened.

1st Misfortune of having gas put in instead of diesel and did your vehicle run afterwards.
2nd Here are my readings from my scangage:

Sync Yes/1, Ficm main power 48.5 v, ICV .17 (2.01 when cranking). ICP 1572. IPR 50.7.

Checked upper fuel filter for bubbles, none.
Engine oil pressure comes up immediately on cranking.

Don't know what else to check, these readings look fine to me. Only the fuel is something I'm not 100% sure of. It does smell like diesel not gasoline.

View 14 Replies

Ford 6.0L Power Stroke Diesel :: Truck Starts / Running Rough Then Die - Fuel Draining Out Of Bowl

2004 F550 with a 6.0. I had to clean out my fuel tank, replace the HFCM and filter on top of the engine. When I start the truck it will run for 30 seconds or so, start running rough then die. I opened the cap on the fuel filter housing on top of the engine to make sure the fuel was getting there. I turned the key on and the fuel bowl quickly filled up.

After a short time however, the fuel drained out. To where I do not know. I don't think this is normal as every time I've changed the upper filter on a 6.0 it is always full of fuel. Why could this one be draining out and could that be the issue why the truck dies after starting and running for a short period of time. I changed the o-ring on the cap and the new HFCM was purchased from Ford.

View 13 Replies

Passat (B6) :: Changing Fuel Pump Module?

How difficult is it to change the fuel pump module?

View 4 Replies

Ford F-150 (2004-2008) :: No Start - Fuel Pump Don't Run?

I have a 2004 f150 fx4 no start.fuel pump doesn't run. I have power at pump connector but the ground has high resistance.did visual on harness and connectors nothing found.I don't have access to a diagram to chase it any further.?

View 1 Replies

Ford F-150 (2004-2008) :: 2007 - Clunky Sound On The Rack And Pinion

My son has a 2007 Ford Truck F150 1/2 ton P/U 4WD 5.4L , when he turns the steering wheel left and right you can hear a clunky sound on the rack and pinion right where the steering shaft connects.

View 2 Replies

Ford F-150 (2004-2008) :: Truck Quit Running At Idle

This morning I drove down to unlock my gate and got out of the truck while it was idling. When I got to the gate the truck just stopped running it did not sputter or anything it was like a light switch and just shut off. I got back in the truck and tried to start it but nothing happened starter did not engage at all or even try to run. I put a new battery in it knowing that is not the problem but it will just not start or even turn over.

View 1 Replies

Ford F-150 (2004-2008) :: Brake Lights On Whilst Truck Not Running?

At 2:30am this morning I looked out my window and saw my brake lights and third brake light come on for about 5 seconds and then go off. This scenario kept repeating itself. I went to drive my truck 2007, and the brake lights remained on even when the lights were turned off when I was driving. I also need to seal the third light. Brake regulator has been replaced.

View 2 Replies

Ford F-150 (2004-2008) :: Rough Idle / Truck Wants To Stall

Let me describe this perplexing issue. I have a speratic rough idle problem. When it happens it's almost like the truck wants to stall. Once going the truck is fine. There has never been any acceleration issues, but for a short time the truck would kind of lunge off idle. It hasn't done that for quite some time. I've replaced the fuel filter. There are no vacuum leaks that I know of. I've tried higher octane fuel. I've tried injector cleaner for a month. What should the fuel pressure be and what is the test port located? Is the fuel pump in the tank? If so, whats that big log looking thing behind the gas tank that the fuel lines run to? Also, there are no MIL codes...

View 14 Replies

Ford Fuel System :: 1991 F250 XLT - Fuel Pump Will Not Stop Running

I just bought another 1991 Ford. This one is a 1/2 ton XLT Lariet with the 302 and for the first time I own a short bed. I also have a 1991 F-250 XLT with a 460 and a 8' bed.

Here is the problem, ( I think) it will not run or at least not for long. The fuel pump, which I am guessing is in the rear tank will not stop running. On the F-250 the pump stops running after a few seconds after I turn on the key.

Where should I start to find out my problem with the fuel system?

View 2 Replies

Ford F-150 (2004-2008) :: 2006 - Running Rough When Warm

History: Truck was running okay but acted like a coil was bad when under load. I changed out all the plugs with Motorcraft and put on Summit racing COPs.

After the plug and cop change the truck will run rough after it is warmed up. I changed back to the old COPs and it runs the same.

First I replaced the MAF sensor after finding many posts on here about it. No change.

I read a bunch of posts on oil causing the problem so I used 10-30w and nothing changed.

I searched for a vacuum leak with carb cleaner and couldn't find one. I removed, cleaned and reinstalled the throttle body.

When I did the plug change I disconnected the PCM without disconnecting the battery. Would this cause this type of problem?

I think this is about all the stuff I found to try in the threads that came up through searching.

View 13 Replies

Ford F-150 (2004-2008) :: 4.6L Running Rough When Accelerate Quickly

My f-150 has an intermittent rough idle and consistently runs rough when you accelerate quickly. Vehicle is not throwing any codes?

View 3 Replies

Ford Fuel System :: 1987 F150 - Fuel Pump Keep Running Even When Key Is Off

I have an 87 F150 4x4 4.9L EFI with a single tank. Fuel pumps keep running even when the key is off. I tried swapping relays but the problem still exists. The engine will start and run OK for about 15 secs. then die. I installed a new low pressure pump, high pressure pump seems to be OK. I also installed new fuel filters. I dont want to just throw parts at this truck, where do I go from here?

View 4 Replies

Ford Super Duty (1999-2016) :: 2004 - Running Rough Both At Idle And Driving - Truck Shakes A Lot At Lower RPMs

I have a 2004 SD with 5.4 that is running pretty rough both at idle and driving. Truck shakes a lot at lower rpms. I have a scan tool and had a misfire on cylinder 4 so I replaced the coil and the plug. Also replaced the idle air control valve. Plan on replacing O2 B1 S2. (One of my codes) even after replacing the coil and plug I'm still getting misfire detected from cylinder 4??? Other codes I had were misfire detected on he first 1000 revolutions. That hasn't come back though.

View 2 Replies