Ford A/C :: 2002 Excursion - Blower Stay On High And Wouldn't Turn Off
About a month ago I replaced my blower control module. I purchased the module from Rockauto. The first replacement module lasted about a month. I received a replacement because the blower stayed on high and wouldn't turn off. The second module only last one week, the blower once again only blows on high and won't shut off. Both replacement modules were made by Dorman. Could something be killing them or am I just getting crap parts?
View 5 RepliesFord A/C :: 2002 F250 - Compressor Clutch Not Cycling
I have a 2002 F250 on which the AC compressor clutch is not cycling: I have checked and added coolant so low pressure is correct (don't have high pressure gauge). I checked the clutch air gap and it is at 0.030 " as specified in another post. I replaced the low pressure AC cycling switch (on the evaporator/dryer). With the AC on, I disconnected the AC cutoff switch and the clutch disengages. This circuit has the correct (>10V) going to it. I am thinking it could have something to do with the AC relay.
When you switch the ATC to a setting other than AC or Max AC, the clutch disengages fine. I noticed this problem because the AC shuts off when it is really hot, after I have been driving for a long while, about 1 hour or more. If you shut off AC, wait a few minutes, then turn on it works fine.
Ford Excursion :: 2001 - Blower Fan Won't Shut Off
I have a 2001 Ex 5.4 4wd ... I shut down my ex jumped out, locked her up and came out two days later and she was deader than a door nail. Charged battery (charger/starter) started her up and let her run for a while. Came back noticed the abs light was on, shut her down and noticed my blower motor was still running, after I shut the engine down and removed the key. Tried it again, same thing. This is obviously what drained the battery, but what in the wide wide world of sports in going on? the blower motor usually shuts off with the ignition switch when you turn the engine off..
I believe this to be the original battery, would minimal battery power make thing act strange or ????? Ignition switch is tight, never had any problems with it. I have not done any "fixin" of the wiring system so it should be ok. Took it for a drive, radio turns off with ignition as should, blower motor will turn off if I turn the b/m switch to off position before I turn the ignition off. If I leave the B/M on and turn ignition off the b/m continues to operate in any speed and will NOT shut off even if I position the b/m switch to the off position. Turn ignition on turn b/m switch to off the b/m turns off............still perplexed!!!!
Ford Excursion :: Front AC Blower Fan Not Working
My front ac blower fan is not working. I changed the resistor because seemed to be popular answer for fix but nothing I took blower off and straight wired it and it worked so that should rule out blower motor. Right? Swapped relay 103 and nothing...
View 8 RepliesFord Excursion :: HVAC Blower Won't Turn Off
I'm new and have recently bought my first X. its a 2001 XLT with the 5.4. I really couldn't pass it up with the guy asking under 7K with 104,000 miles and not a rust bucket.
I discovered last night that my blower (at least front) continues to blow when key is out and off. I have played with the key to think its a switch but am not sure. Here's the other part, If I turn the selector to off before shutting the truck off it stays off BUT if i turn it on it will not go back off and stays on....
Ford Excursion :: A/C Not Working - Change Blower Resistor?
Ok, I've read about the blower motor resistor, and everyone says you should have HIGH speed on the fan.
2002 Excursion with digital display.
I turn the truck on, then turn on the blower. A small puff of air comes out then shuts off completely. I can hear the direction doors opening when i change between foot and face A/C.
Is this the blower resistor that needs changing?
Ford Excursion :: Wobbling Noise On Settings 2 And 3 Of Blower Fan
My truck started making what I would describe as a wobbling noise on settings 2 and 3 of the blower fan last week. Yesterday I went to leave and started the truck the fan was on 2 and the selector was set to floor, I went to move it to the floor/defrost option and heard what I can only compare to the grind/screech you hear when you try to start a car that's already running, then a pop and it returned to it's normal quiet but slightly wobbly sound.
I am assuming my blower motor is warning me of it's plan to call it quits in the near future. Doesn't look like a big deal at all to change, but my question is - is there any quick/maintenance clean-up type tasks for these or are they just replace when they start issuing warning threats?
Ford Excursion :: Blower Motor Only Blows On High?
Well my blower motor only blows on high which IMO points to the resistor, went and bought one and still only blows on high. Tried to test the plug that goes to the resistor but couldn't get anything, shouldn't there be 12v going to the plug and then step down to the resistor until high is selected then 12v bypasses the resistor all together? Blows strong and cold, too cold actually since we cant turn the blower down so we have to turn it off for a few minutes.
View 9 RepliesFord Excursion :: 2000 - Front Blower Keeps Failing
I'm on my second blower motor and fourth blower motor resistor since purchasing my 2000 Ex approximately 3 months ago. The fan returns after replacing the resistor but ultimately, fails after 2-3 weeks. What can I test, what can I do? The weather is changing quickly here in NOVA and being without a reliable heater is a non-starter for the family vehicle.
View 7 RepliesFord Excursion :: 2000 - Front A/C Blower Not Working
I have a 2000 EX and my front A/C blower wet the bed yesterday. I have checked the fuses under the dash and under the hood. I removed the blower motor and supplied 12vdc directly to it. Works like a champ. I metered the harness connector with the ignition on and the fan speed switch at all speeds, I get a range of 8.1 to 8.9vdc. I metered the fuse terminals as well and get a steady 13.2vdc. Before I rip the dash apart, what is the most common to fail the Blower Resistor, Fan Speed Switch, or Blower Motor. Or, do I have a completely different issue?
View 5 RepliesFord Excursion :: Blower Motor Only Runs With Key Out - Battery Drain?
My blower motor runs with the key out on all speeds in my excursion. Replaced blower relay in hood fuse box. NO FIX. As I move climate selector to off and turn key to acc. and off it will turn off the blower. If I turn the selector to any position such as vent or heat with the key out, blower runs thus drains the battery. Do I have to replace the whole climate pod?
View 8 RepliesFord Excursion :: 2003 - Rear AC Blower Water / Condensation
Condensation from the rear blower drain line coming out normally BUT also have some dampness in the rear carpet just outside the jack/blower door? Possible partially plugged drain?
I'll pull the whole side panel when it cools off out here, but wondered if it was possible to diagnose without pulling the panel. I'll try the window/water trick tomorrow, but the seals look really good and are still supple, so really expecting it to be the rear blower or evaporation back there.
I'm still working through all the small nuances of bringing this old 03 Ex back to perfection mechanically....
Ford Excursion :: 2000 - Blower Resistor Wiring Short?
Bought my 2000 X from a guy a week or so ago, and am now fixing all of its little "quirks". A/C blower would only blow on high, diagnosed it as a faulty blower motor resistor and got a new one. Pulled the old one out and the wiring plug that plugs into it is fried!! 3 of the plugs are stuck in it from the resister itself and there is obvious signs of shorting. What my next step should be? Im considering getting a new plug and splicing the wires back into it, but that just ignores the obvious shorting. How to fix the short?
View 3 RepliesFord Excursion :: AC / Heater Switches From Vents To Defrost When Blower Is On
When the blower is on, it automatically switches from vents to defrost vents on its on. Does it about every 4 minutes.... like it's haunted. Curious if this is something i can tackle or do i need to take it in...
View 7 RepliesFord Excursion :: 2005 V10 - Front AC Blower Cutting Out Randomly
Have an 05 Limited Excursion v10 where the front blower motor will cut out randomly. The rear blower will work without issue even when the front is not working. When the front is working (98% of the time) all speeds seem to work and can adjust to all heating/cooling positions. After searching the forum I thought the likely culprit was the blower motor; which I replaced this pass weekend but coming home from work it cut off again, clearly the issue is not resolved. I know the ford resistor are known to be prone to issues but symptoms do not seem to point that direction. Also it is does not happen with any consistency, happens at idle just as frequently as the expressway. What else to check and how to check before I have to give in and take to dealership...
View 2 RepliesFord Excursion :: 2005 - Blower Motor Control Module
I have a 2005 Eddie Bauer 4X4 with the 6.0 and Automatic Temperature Control. I need a new blower motor control module, and have been confused by what I have been able to find online. What is the full Motorcraft part number, or other information so I can get one.
View 2 RepliesFord Excursion :: Blower Motor Wouldn't Turn Off By Itself When Truck Was Turned Off
It started with the blower motor that wouldn't turn off by itself when the truck was turned off. I forgot to turn the fan off one night and woke up to a dead battery. Got my dad to come give me a boost and it would turn but not start and the anti theft light in the dash was blinking fast.
Later in the day I got another boost and it started right up.
This was yesterday... after the last boost and startup I went and got a few things, stopped to get gas... started back up fine each time.
Last night I was greasing zerks and making sure everything in the front end was nice and tight when the abs module started clicking... and the anti theft started blinking and truck wouldn't start. Left it alone and went to bed.
This morning I boosted it and it started fine. Later in the day it wouldn't start again because of the anti theft. Gave it 5 minutes and it started. Stopped to get gas... wouldn't start (anti theft)... started after about 5 minutes.
On the way back home... it's been making this 5 beep, pause, 5 beeps, pause sequence so I pulled it into the garage and turned it off now the locks are locking/unlocking by themselves randomly, the beeping is on and off, anti theft light blinks for a few minutes then goes away only to come back...
I've been told to remove the fuse box under the hood and check to make sure all connections are clean... I've searched and seen possible solutions ranging from a dirty connection to needing a new GEM module and apparently sometimes just a low voltage situation will cause our trucks to act nuts...
Ford - Explorer :: 2002 - Rear Heat Thump Noise By Blower Motor?
Started up the 2002 EXP today and thought the fuel pump was failing. Get a consistent thump every 1 second. Later today i looked and noted the noise is coming from drivers rear fender well (i think). I took off the small plastic cover of the rear blower motor and thought it was in that area. Disconnected the motor and still thumps. Disconnected the blower motor resistor block and still thumps. Looked at the overhead consol and the rear blower was on HI. Turned the blower down and as you reduce speed the noise volume is lower. Turned the switch off and i thought the noise was gone. Pulled the cup holder above the fender well looking for a relay or something in that area. I cant isolate the noise but seems to be real close to that area. Later i heard the noise, very faint, and the blower switch was off. Turned it to 1-2-3 and it gets much louder. Turned it off and very slight noise. What am i looking for? My hearing is not accurate enough to find it.
View 2 RepliesFord Super Duty (1999-2016) :: 2002 - No Difference In Blower Motor Speed
Currently My AC / Heat blower motor operates but, speed 1 and 2 are the same, 3 and 4 are fine. I replaced the blower rheostat that is located on the firewall, but still no difference in fan speed.. A few years ago the blower only operated on Hi and the rheostat was the problem then.
View 3 Replies