Ford - Mountaineer :: 2008 - Blower Motor Runs On Full Blast / Does Not Change Speeds
I have a 2008 mountaineer that the blower motor runs on full blast no matter what. The switch bars go up and down but blower motor does not change speeds. also upon opening the hood I found 2 large mouse nests ,1 on passenger side fender and 1 center of engine towards the back. Are these related or could it be a switch issue. How to remove switch and test it.
View 11 RepliesFord Excursion :: Blower Motor Only Blows On High?
Well my blower motor only blows on high which IMO points to the resistor, went and bought one and still only blows on high. Tried to test the plug that goes to the resistor but couldn't get anything, shouldn't there be 12v going to the plug and then step down to the resistor until high is selected then 12v bypasses the resistor all together? Blows strong and cold, too cold actually since we cant turn the blower down so we have to turn it off for a few minutes.
View 9 RepliesFord Excursion :: 2005 - Blower Motor Control Module
I have a 2005 Eddie Bauer 4X4 with the 6.0 and Automatic Temperature Control. I need a new blower motor control module, and have been confused by what I have been able to find online. What is the full Motorcraft part number, or other information so I can get one.
View 2 RepliesFord Excursion :: Drain On Battery Overnight?
What the approx current drain on the battery in an over night situation. Mine now is approx 340 mA and need to confirm this as correct!
View 9 RepliesFord Excursion :: Blower Motor Wouldn't Turn Off By Itself When Truck Was Turned Off
It started with the blower motor that wouldn't turn off by itself when the truck was turned off. I forgot to turn the fan off one night and woke up to a dead battery. Got my dad to come give me a boost and it would turn but not start and the anti theft light in the dash was blinking fast.
Later in the day I got another boost and it started right up.
This was yesterday... after the last boost and startup I went and got a few things, stopped to get gas... started back up fine each time.
Last night I was greasing zerks and making sure everything in the front end was nice and tight when the abs module started clicking... and the anti theft started blinking and truck wouldn't start. Left it alone and went to bed.
This morning I boosted it and it started fine. Later in the day it wouldn't start again because of the anti theft. Gave it 5 minutes and it started. Stopped to get gas... wouldn't start (anti theft)... started after about 5 minutes.
On the way back home... it's been making this 5 beep, pause, 5 beeps, pause sequence so I pulled it into the garage and turned it off now the locks are locking/unlocking by themselves randomly, the beeping is on and off, anti theft light blinks for a few minutes then goes away only to come back...
I've been told to remove the fuse box under the hood and check to make sure all connections are clean... I've searched and seen possible solutions ranging from a dirty connection to needing a new GEM module and apparently sometimes just a low voltage situation will cause our trucks to act nuts...
Ford Aerostar :: 1997 - Rear AC Stopped Working / Blower Runs Fine
97 aerostar rear ac stopped working. Blower runs fine. Checked solenoid has power and clicks when plug pulled and refitted.
Liquid line is hot to solenoid and somewhat warm after the solenoid. Return line from evap is at room temp.
Front is 40f at register. Am I looking at bad solenoid or blocked orifice tube. Solenoid is nla. Orifice not so. Still on original evaps comp etc.
Ford A/C :: New Blower Motor But No Effect On Fan Speed?
I have an '02 F150 XL. 200k miles. My a/c blows cold, and I have every fan speed, but it just doesn't blow very hard. I replaced the blower motor thinking that would work, but that did nothing. I've been told to clean the evaporator core, but I don't know where that is. How to do that, as well as any other part causing the problem.
View 14 RepliesFord Super Duty (1999-2016) :: F350 - Heater Blower Runs When Ignition Switch Is Off
The heater blower in my 1999 F350 continues to run after the switch is turned off. I checked the relay and it is working properly. Looking for a wiring diagram showing the control circuit for the blower?
Do the heater switch controls power to the relay coil or if the switch grounds the coil to pick up the relay?
Ford A/C :: Blower Motor Stopped Working - No Power
I have a Full Size 93, 5.8L Van. The blower motor has stopped working. I have checked the fuzes, ok. I have checked the Power Distrubution Box, ok. I do have power to my Aux (rear) blower. I have hot wired my blower motor, it works. I have no power to the blower motor, thermal limiter, or to the fan control switch on the dash. (Like I said, the Aux on the dash works). What else is there?
View 14 RepliesFord A/C :: 1992 F150 - Blower Motor Air Output Not Enough
My 92 F-150 my heater blower motor doesn't put out enough air like my 2003 Lightning blower motor does.... So I figured after all these years that I would put a new heater blower motor in, well it's the same hear output and there's no debris in the heating ducts and the cable lever is working fine to close the blend door, so I guess maybe it's normal for these 92-96 F-150 trucks to have mediocre heating output ;-( Is there a bigger motor I could put in to get more heat..... The resistor is fine to, it works on all speeds.....
View 2 RepliesFord A/C :: 1988 - Front Blower Motor Intermittently Works
My mom has a 1988 350 Econoline van chasis that is a motorhome class C.
The front heater/AC blower motor only works when it wants to. It starts very intermittently and then shuts off then you go down the road a little more and it comes back on, it will do the same thing sitting in the driveway just idling. There is no timing it, it just turns on when it wants to and then back off again.
I checked the fuses and the fuses are fine. The blower motor when hooked up directly to the battery blows fine. When it isnt working of course there is no juice going to the blower motor through the hotwire of the blower motor, I have checked this with my volt meter.
I did replace the switch that turns the blower on in the dahs, and it didnt do the trick.
Ford F-150 - 1997-2003 :: Blower Motor Resistor Location
I'm looking for information and possible photo location for the blower motor resistor. My truck has climate control. I've looked under the dash on the passenger side and behind the glove box door and I've been unable to spot the location. Do I have to remove the plastic panel behind the glove box?
View 6 RepliesFord F-150 - 1997-2003 :: Blower Motor Switch Removal?
How to remove the blower motor switch on my 99 F150 without breaking anything.
View 1 RepliesFord F-150 (2009-2014) :: Blower Motor Resistor Overheating
Have a 2009 platinum, 5.4, supercrew with dualzone heating and air. The blower motor resistor block is overheating and melting the connector block. fooled with it way too much, and then put a new resistor and pigtail in it. The new resistor would kick out in about 30 seconds, so used the old resistor on the new pigtail, got hot, melted the new pigtail. What is causing the resistor block to get so hot, and what do I do about it?
View 7 RepliesFord Aerostar :: 1997 - Location Of Blower Fan Motor Relay?
I'm having some trouble with the front blower fan on my 97 Aerostar 3.0, it will only intermittently work, one time we had it running, lifted up the hood on the van, checked the connection to the motor, looked good, dropped the hood and the fan immediately started working again, I'm wonder if the relay might be starting to go bad, the fan in the back works, so I'm not sure. Where the relay is for the blower motor, or what might be wrong?
View 6 RepliesFord A/C :: 1989 E150 - Blower Motor Relay Location
1989 E150 Club Wagon, 5.0, EFI, Autotrans, 61kmiles.
Blower motor acting up.....sometimes on, sometimes off......mostly off now. For a while there whenever I would accelerate heavily, the Blower Motor would cut off, and when I leveled out in speed, it would come back on. I'm thinking maybe the thermal cutout in the Blower Motor Resistor Assembly..... but I also want to check the Blower Motor Relay, which I find on the schematic but have no clue where it is on the Van........ Also, it must go by another name because I can't find it listed in any of the parts stores.
Ford A/C :: After Changing Resistor Blower Motor Started Smoking?
I parked my 2003 f150 about 8wks ago, and at that time the blower had been running only on high then not at all, then only on high again.
As I need it to pull the boat up north next week, I purchased and changed the resistor. When I started it up the blower motor wouldn't run and eventually it started to smoke, so I pulled the wire connector to the motor.
Where I can find a procedure for motor testing, and removal as I think this is probably where I'm headed with this. There seems to be utube videos on everything else but not this. I may just have to go out and purchase a Hains or Chilton manual but I'm Scottish and always look for the free route first.
Ford F-150 (2009-2014) :: Blower Motor Stuck On High
What is the testing procedures for the blower motor controller on my 2009 150 Lariat. In the old days it was called the resistor but now it is computer controlled for the dual climate control. My fan is stuck on high, the fan switch does work(the bars on the display change when I push the fan speed button). The climate control works also, just blasts you with air and the temp is changing a lot due to the fact of the fan on High. I am 99% sure it is the blower motor controller, but I would like to test the controller.
View 14 RepliesFord A/C :: 2008 F250 - Blower Motor Quit / Just Won't Blow
Blower Motor quit, dual zone climate control system. AC will work with Recirculation mode off. Just won't blow.
Turned heater on still won't blow. Pulled and checked the following fuses: 37; 45, 37 & 15 which pulling these 3 reset the system; and pulled 24 in the battery junction box. Still not working.
Next plan is to pull Relay #1 from the battery junction box and apply 12v to see if it clicks - no click & then I'll replace it.