Ford Escape / Hybrid :: AC Working Intermittently
Get a set of real gauges if you want to do diagnostics. 110 psi on the low side indicates that the system isn't running at the time and that the underhood temp is around 100 F.
View 1 RepliesFord Escape / Hybrid :: 2015 - Nothing On Dash Working?
My wife just picked up the 2015 Escape 3 weeks ago. This is now the 3rd time back to the dealership with it where nothig on the dash is working. No information center, no speedometer, no tach, no fuel gauge, no temp gauge, and even the entire media screen is powerless. So in turn, a lot of the temp controls and radio are gone.
The first time was on a weekend, I pulled the fuse that powers the entire dash to check it, it was fine and upon putting it back in, everything worked. Still had it to the dealer and they couldn't find anything wrong with it. The 2nd time was this past weekend, we decided to leave it so the service team could see what we were talking about. They again, reset the fuse (still wasn't blown), tightened a couple connections, but really couldn't find anything wrong with it.
The 3rd time was just this morning and the vehicle is currently with Ford now. Obviously warrantied, but did their dealership find what the issue was? We really love the Escape, when everything works right.
Ford Escape / Hybrid :: 2001 - Cruise Control Not Working
The cruise control has not worked on my 2001 escape since i bought it a few weeks back. i checked the usual culprits and everything is good. i plugged my scanner in and got a control module code.
c1945- park switch indicates park with vehicle moving.
I did do some live data testing and it does infact show park when in gear. the display on the dash shows the proper position.
I am almost certain this is the issue with my cruise. Where this sensor is? Doing a parts lookup isn't showing much.
Ford Escape / Hybrid :: A/C And Heater Fan Not Working Properly / No Air Comes Out On 1 - 3 Speeds
I am having an issue with my 2008 Ford Escape XLT. It seems that my A/C and Heater fan isnt working properly. Basically, air only comes out when i put the fan speed to 4. With 1-3, no air comes out. If the A/C or Heat is on, I can feel cold air or heat coming out but the actual fan isn't running. It only runs when it is set to 4. What the problem could be?
View 7 RepliesFord Escape / Hybrid :: 2010 - A/C Not Working - Compressor Won't Start
She has a 2010 Escape 4-cyl and the A/C isn't working. It's miserable hot and she has small kids.
The compressor won't start. I put a gage set on the low pressure side and it's sky high, so it should be coming on at least. I also used a Launch scan tool on the OBD port and the HVAC control is commanding the compressor to start, so it's not that - which leaves the $300 compressor or the $9 a/c relay as the next steps. Unfortunately, I only see this car occasionally so I haven't really been able to get under it to check for voltage at the a/c compressor or see if it's a ground issue, etc.
I'd like to go after the relay next but can't find a a diagram I trust as to which one it is. I've heard mention that it's the WOT relay and also that there's an A/C Clutch relay. Any reliable schematic of the underhood fuse block and which position it's in? I took the cover off and they're numbered but there's no map. Also, what p/n is the relay? I'd like to just pop in a new one and see if it takes care of it.
Ford Escape / Hybrid :: 2002 - Tranny Not Working Properly - OD Light Flashing?
I thought my tranny shift points had gone a little nutty. This afternoon, it suddenly seemed as if it were starting off in 2nd gear...then the OD light started flashing. Now, when you put it in 1st gear manually, or reverse, it's like it's in park. Can't push the truck or anything...put it in drive or 2nd, and it starts off slowly. Once it picks up speed, all seems well. Definitely not starting off in 1st or going into reverse at all. Have y'all seen this problem before?
View 9 RepliesFord Escape / Hybrid :: Passenger Door Locked Now Power Lock Not Working?
The passenger door on my 2002 Escape is locked and the power lock is not working on that door. The door is closed, how to get it open.
View 14 RepliesFord Escape / Hybrid :: 2010 - HVAC Blower Motor Only Seems To Be Working On 3 And 4 Position?
Blower motor only seems to be working on the 3 & 4 position? Resistor bad? What is the location?
View 1 RepliesFord Escape / Hybrid :: 2002 - Overdrive Deselect Button Stopped Working
2002 Escape. The over drive deselect button stopped working on my wife's escape. Is their a fuse other than the box under the hood? Transmission was rebuilt not too long aga and has been running fine till the other day.
View 2 RepliesFord Escape / Hybrid :: 2004 4wd Not Working / Dash Light Came On But Rear Wheels Dead
Couple weeks ago, was in a spot that needed 4wd. Turned the switch, the 4x4 dash light came on, but rear wheels didn't do anything. Lucky that we were able to get out with ft wheels only. Has 3.0, xlt version.
View 13 RepliesFord Escape / Hybrid :: 2006 XLT 4 Cyl - Cranks But Won't Start
I am having a problem starting my Escape. It ran fine when i parked it. Now it turns over but wont start.
It turns, almost catches, then turns slower. White smoke comes out of the exhaust, which means it is getting fuel i think. When I crank it all the dash warning lights go off. I tried the spare key. I tried pushing the gas pedal. No codes on the scanner. I switched the fuel relay (r3) with the fan relay (r4). I tilted the column a few times. Coils and wiring do not show any damage or wear. I opened the air filter with no change.
The only change i notice is that when turning the key has some resistance. It does not feel like it used to turn. This year I had to install a new battery and alternator. At 90k miles i gave it a tune up (plugs, boots and coils). It has 116k on it now.
Ford Escape / Hybrid :: 2006 XLT - Very Low Airflow From Vents
I'm getting very low airflow out of all of the cabin vents. I've already checked and cleaned/replaced the air filter and cabin blower fan and the ducting between the two, there's no obvious debris at the intake. The blower and resistor are working fine - when removed but left connected to the electrical, it starts up fine, is quiet, and changes speed appropriately when the fan speed in changed. I think there's either debris or something buggered in the system that controls the vents, but I'm not sure how to check that.
View 4 RepliesFord Escape / Hybrid :: 2006 - Ignition Key Sticking?
My wife's 08 Escape has an issue with the ignition key actually sticking in spots when turning to the start position, then we almost have to turn it back to the run position, it doesn't spring back like it used to, and should do. It's an 08 Escape, XLT V6 AWD, auto transmission.
View 4 RepliesFord Escape / Hybrid :: 2006 Mariner Frequently Cuts Out
Friend just got a mariner hybrid car, Its quite nice but it keeps cutting out on them on the freeway, a message will flash saying pull over as soon as possible. they turn the key off then back on and it's fine for awhile. It's happened 3 times to them today and once in awhile before that. no codes have been thrown, the CEL light is not illuminated. they are Flummoxed on this issue as I am. Also, is there a way the door key pad code can be read? they did not get it with the car and they'd like to use it. Message shows as 'Stop Safely Now' .....
View 4 RepliesFord Escape / Hybrid :: 2006 - How To Remove Steering Wheel
Looking for info on how to remove the steering wheel on 2006 escape to get to cruise control switches and is there a self test you can do for cruise control functions like holding on button while you turning switch on as in other models ???
View 6 RepliesFord Escape / Hybrid :: 2006 - O/D Light Come On - Code P0741
I have a Mazda Tribute 2006 2.3. The O/D light would come on, drove it to a friends to scan the check engine light code, and the car almost made it there and then wouldn't remove in reverse, forward, or anything. Turn it off then start it up still wouldn't, then turned it off let it cool and it worked again for a little while.
The code was P0741, just the one code. Took it to a shop to have further tests, they seemed to think it was the clutch was worn and when the fluid heated it lost friction.
Pulled the transmission and thought why not do a Transmission rebuild? I have never done one but there was an awesome video on youtube of the guy doing it so I figured it couldn't be too hard and was just going to try my first rebuild.
According to the guy in the video you always need all new bushing, and we will get a rebuild kit with new clutch packs and the other stuff that comes with those, and sounds like it's a good idea to replace the torque converter.
The car is only at 85K and it looks like the transmission was rebuilt once before he got it at 80K. Maybe a bad rebuild?
Here are some pictures .....
The Input Sprag bearing was shredded and the bushing looks terrible. Can I just replace the bearing and the bushing? Is there any other damage I should be looking for because of this?
The forward planet you can so some eaten metal on the edge and 2 gears spin super smooth and the other 2 you have to push pretty hard to get them to turn. So new forward planet?
The shell's corners look a little rounded I wasn't sure how much was to much, can you tell from the picture if it looks like too much?
Input Sprag
Forward Planet
Sun Gear Shell
Ford Escape / Hybrid :: 2006 - Instrument Panel Goes Out Randomly
I have a 2006 escape 4cyl. 2 wheel drive. The instrument panel goes out randomly...
View 1 RepliesFord Escape / Hybrid :: 2006 - Rear End Came Loose From Rusted Frame
The rear sub frame fell out of her 06 Escape Hybrid. She found the recall for the 01-04's, was the problem fixed in 2004, or are later models subject to the recall and repair also?
View 2 RepliesFord Escape / Hybrid :: 2006 - Cruise Control Will Power On But Does Not Appear To Engage
I recently purchased the 2006 Mazda Tribute and the previous owner has confirmed the cruise was not working. What I have looked at:
Checked fuses
checked cable and connections
check connections at unit
What I have is the cruise will power on (light on dash comes on) but it does not appear to engage. I tried to use the diagnostics built into the car, where you hold the off button and turn the key on. I get a flash for off, and on, but do not get a flash when I push the resume button.