Ford Aerostar :: 1995 - Loss Of Power - Stalling - No Codes?
I have a 95 aerostar with the 4.0. After driving a while it wants to lose power. It only happens after the van has been running for a while, at least 2 hours or more. So of course I have mostly noticed it at higher speeds because I was on the interstate going a long distance when it happened most recently. But it has also happened at lower speeds, after the van had been running/driving for about 4 hours. The van doesn't die right off. It is idling as the van slows down. So I can come to a stop, and the van is still running. I can get out and look at it sometimes, it eventually will cut off. Pushing the gas does nothing, other than perhaps encourage it to stall sooner. It is a complete loss of power but the engine remains running at an idle. If I wait 15 minutes it will go a couple more miles down the road. If I wait about an hour, I can get even further. Let it sit overnight and it seems like it will drive endlessly but not so.
If I try to restart it immediately, sometimes it will run/stutter for a moment. I can wait a few minutes and it will run for a minute then die. After repeated tries to get it to start and stay running it just won't, and then I just wait patiently for an extended amount of time (30 minutes or more). Also on a couple of occasions the exhaust has smelled very rich, and sometimes was black. All of this has been in the last couple of days and 600 miles. It isn't throwing any codes.
Ford Aerostar :: 1995 - Hard To Shift Out Of Park
I have a 95 Aerostar that when in park it is hard to shift into reverse, drive etc. It is an automatic, 3.0 liter.
View 7 RepliesGrand AM :: 1995 Pontiac Stalling While Driving Over Bumps And On Some Hard Turns
I have a 95 Pontiac grand am with a 98 motor. Everything is factory, no modifications. I just recently starting having an issue with the car attempting to stall out while driving over bumps and on some hard turns as well. Haven't replaced anything yet but would like to know what is causing this? I have shook wires, checked for broken ones and found nothing.
View 1 RepliesRodeo :: 1995 Isuzu Stalling When Braked / Stopped - Occasional Hard Starts
My 1995 Isuzu Rodeo began stalling when braked/stopped. The car would continue running only if the gas pedal was lightly pushed, keeping the flow going. I treated it with Seafoam and water remover and the problem went away for week. Now it will stall, then refuse to start for a period of time. When attempting to start the Rodeo a loud 'strangled' sound is sometimes heard, then nothing. Try again a few minutes later and the car starts and the ride home over the next mile is smooth. My untrained guess points to a bad starter. I also believe there were two problems at the same time, one being junk in the fuel line, perhaps a loose battery connection as a contributor, then a starter problem.
View 1 RepliesFord Aerostar :: 1995 - Won't Shift From 1st To 2nd / 2nd To Third?
This van has the A4LD transmission. I know nothing about transmissions, so, when it wouldn't shift from 1st to 2nd, or, 2nd to third, I researched it on here and found a lot of bad reviews. I also found out that it was likely the modulator gone bad, and how to replace it. I replaced it, and although the new one was restricted and the old one wasn't, shifting was back to normal. So, I was thinking, that was easy enough, pretty good for the original tranny which has 297,623 miles on it, and hasn't been serviced since the first 1k!
Well, that lasted about 75 miles. Now it won't go forward or backward. Everything is still in place, no leaks, fluid level is full. I didn't change the fluid or do anything other than change the modulator. (My friend can't afford to service it properly. Now it may need replacing!) I have only seen problems shifting between gears and OD, TC lockup, etc., but, nothing about not moving at all. What might be the problem? Is the tranny history?
Ford Aerostar :: 1995 Won't Shift Out Of Park
I just picked up Aerostar #6 and am in the process of transferring parts etc. Got this one cheap as it was badly abused and has issues. Big problem, the shifter takes a lot of wiggling etc to get out of park. Is the interlock easy to disable? If so how? Or would a good column from my 93 be an easy plug and play proposition?
View 1 RepliesFord Aerostar :: 1995 - Control Arm Bushings?
can you replace the upper control arm bushings (pass side) with the arm still in the truck?
View 8 RepliesFord Aerostar :: 1995 - ABS And Brake Light On
I have a '95 Aerostar where the two lights are always on. I'd like to pull the codes if i can. Does this year has the RABS or the RABS II module. Or is the diagnostic connector the same?
View 14 RepliesFord Aerostar :: 1995 - Outer Tie Rod Replacement
I was wondering how do i replace the outer tie rod on a 95 ford aerostar awd 4.0L. I have enough for the parts but not extra tools. Need a tutorial on how to do it?
View 6 RepliesFord Aerostar :: 2001 - Headlights Flickering Every Now And Then / Car Randomly Stalling Out
Anyways, My 2001 Windstar has been acting up recently mainly the headlights flickering every now and then, car randomly stalling out on me - after it dies, I pull over and start it up right away and the ABS light came on.
Check engine light is on (presumably due to the car stalling out) but I do not seem to be able to read the codes, the code reader is working fine on my 2001 Expedition but on the Windstar it just sites there at 'connecting to vehicle'. I've tried disconnecting the battery for 10-15 mins and this made no difference, I also checked the fuse for the port was good so now I'm not sure what to check next.
Ford Brakes/Suspension :: 1995 F250 Truck Does Not Stop Fast Enough When Hit The Brakes
My truck sat for 4 years. 1995 F-250. We needed to replace the brake lines. when you hit the brakes the truck does stop but not fast enough and it will not pass inspection this way. So far I've replaced
1. All the brake lines
2. Calipers
3. Brakes all around
4.RABS module
5. Master cylinder
6. Wheel cylinders
Pretty much everything but the brake booster. Lines were bled several times. The brakes still go to the floor. Anything else that I haven't tried? I want my truck back!
Ford Brakes/Suspension :: 1995 F150 XLT 5.8 - Replaced Brake Pads Now Spongy Brakes?
I just replaced the front break pads. I didn't replace the rotors or get them machined, didn't look like they needed them. Once I pushed on the brakes (truck off) I noticed that brake fluid spilled out the brake reservoir. I'm guessing it happened when I compressed the piston into the caliper? I took some of the fluid out of the reservoir and now its at MAX (I didn't bleed them). I've only been only be able to stop and go on the driveway (I'm waiting on a new radius arm bracket). The brakes seems spongy, the brake hits the floor. ABS and Brake lights came on then turned off once I started to pump them when I turned the truck 'on'. Do I just need to actually drive and "break" the breaks in?
View 2 RepliesFord Aerostar :: 1995 - Sloppy And Loose Shifter?
My mom's 95 shifter is slowly getting worse. Right now it's at the point where we have to hunt for gears just to put it into park or reverse or d/od. It's not stiff like the rest of ours, hers is all sloppy and loose. She says it's been doing this for a while, but i think it got worse when i pulled her cluster out to change the light bulbs. I say this because i couldn't get the needle cable un done, so i just let the cluster rest on it while i was changing the bulbs, which put a little bit of tension on it.
View 14 RepliesFord Aerostar :: 1995 - Easiest Way To Change Belt?
Whats the easiest procedure
View 3 RepliesFord - Aerostar :: 1995 - Won't Start / Dirty Spark Plug?
My dad and I are having allot of trouble getting our Aerostar to start up . It is getting fuel and spark , and it won't even run with starter fluid . It was running ruff before this . It is getting an all clear on the OBD codes . We took one spark plug out and it was pretty dirty , could that be our problem? Like I said we are getting spark , when we do a spark test . We are totally out of clues .
View 7 RepliesFord Aerostar :: 1995 - Rough Idle / Jerky Acceleration
Symptoms: (162K miles, last tune up about 70K miles ago) rough idle, and poor acceleration. Occasionally, the car really jerks while accelerating. I read about new plugs/wires, and something called seafoam. I think the highway patrol would pull me over as a gross polluter, but that too seems worth a try. Various sensors and hoses, I'm frankly overwhelmed. Where to start?
Something I learned today: My car was made in 10/95. Apparently, I can scan for trouble codes?!? How and where? Is it OBD I or II or something else? Dumb question: I can't even get the interior engine shroud off. I found three clamps, but it still hangs up near the top. What am I missing?
Ford Aerostar :: 1995 - Back Firing - Difficult To Start
1995 aero, 4.0 auto AWD. wouldn't start about a month ago and got parked. got around to working on it and it would start and run a couple seconds then just crank and crank, I tossed another edis module on it that i had with no change, tried it without the MAF plugged in, had consistent spark while cranking. fuel pump would prime just fine. after a while I was experimenting around and held the throttle WOT and got a couple coughs.
after a while of cranking and trying different stuff I had began to get a few backfires (and by this time i had the spout and the octane plug out) and I was actually trying to see if i could see backfires out the tail pipe cause i couldn't determine if they were intake or exhaust side, it finally started. it ran really rough and coughed and sputtered and backfired a few times, then after about 30 seconds it smoothed out and started idling like normal.
I took it for a drive and it ran normal, so i shut it off and reinstalled the spout and octane plug and took it for another drive and it ran better (assuming the ign advance is working, so it must not be in limp home mode)
When I first started I pulled codes 114 and 118, ACT sensor out of range and ECT voltage high (Note: when I got it started the gauge didn't show it as being very "warmed up" even though it idled about 30 minutes before I drove it about 10 miles). I am gonna let it cool for the night and see how it starts in the morning, then try pulling codes again...
Ford Aerostar :: 1995 - High Mount Third Brake Light
Trying to replace the burnt bulbs. Did the obvious: removed the two screws but in no way could I take the red lens off. I pried hard almost broke it but it's not coming off. It feels like some other mechanism holding it down. It is the one on top of the lift gate. The inside is just a hole with wires going through. What's the trick?
View 12 RepliesFord Aerostar :: 1995 - Oil Leak From Oil Filter Bolts To Block?
My van is leaking oil from where the oil filter extension bolts to the block. Is it an o-ring or a gasket that needs to be replaced? Any unexpexted upsets that I should expect when fixing this?
View 13 Replies