Ford Aerostar :: 1989 - Brakes Leaking Distribution Block
My wife's 89 Aerostar is leaking brake fluid from the back side of what is either the distribution block or combination valve. I am not sure which it is but it is the first block you run into following the lines from the master cylinder and it is right below it near the fender well.
The part has been discontinued and is too expensive anyway so I am looking for input as to what this peice is and if / how to rebuild it.
Ford Aerostar :: 1992 - AC Hoses Block Radiator Removal
On my 92 Aero 4.0L with A/C, I need to replace the radiator but I am not sure how to move the A/C hoses out of the way to extract the shroud and the radiator.
I have viewed a video where a guy said to remove the serpentine belt and then unbolt the A/C compressor and move the compressor and hoses out of the way. Hope this means that I don't have to discharge or disconnect AC hoses. Not good for me.....
Well, the video instruction seems simple enough......but there doesn't appear to be enough "play" in the AC hoses to move them far enough to extract the radiator, and not being an AC guy (and the potential danger of releasing freon), I am at a loss.
How to move the AC hoses out of the way (without disconnecting the hoses or discharging the system) ....
Not to mention it would be great to find out what the torque specification is for tightening the AC compressor bolts for proper reassembly. And being the backyard mechanic I am, any drawings, details or diagrams that you can provide would be very useful.
BTW, I have looked in the forum for radiator removal information and none of the threads I read addressed moving the AC hoses (which of course run right over the top of the dang radiator).
If I get past these "hoses" I will also take advantage of the radiator removal to replace the fan and fan clutch and thermostat while I am there, but first things first, if you know what I mean.
Ford Aerostar :: Transmission Has Vibration Damper Mounted To The Lower Side Of Tail Shaft With 3 Bolts?
On my ongoing project, I have a replacement trans out of an Explorer. I have swapped over the bracket and will be changing the shifter shaft, but I noticed that the new trans has what appears to be some sort of vibration damper mounted to the lower side of the tail shaft with 3 bolts.
It is just a bracket that has a cast weight mounted in rubber. It was not a mount of any kind as the only bolt connection is to the trans itself.
The trans I took out did not have one of these, nor can I find any mention of it in the factory manual. The Explorer I pulled the trans from was a 92, my Aerostar is a 91. It doesn't appear that this device will conflict with mounting.
It is possible that the whoever installed the trans that I have removed forgot to install the damper, or it is possible that it is used only on the Explorer but not on the Aerostar.
Ford Aerostar :: 1997 - Location Of Fuel Filter?
Where the fuel filter for a 1997 ford aerostar is located? I have been told it is under the driver side near the front tire. I cannot find it anywhere. Is it near the middle by the transmission? I would like to see a schematic also?
View 4 RepliesFord Aerostar :: 1995 - Won't Shift From 1st To 2nd / 2nd To Third?
This van has the A4LD transmission. I know nothing about transmissions, so, when it wouldn't shift from 1st to 2nd, or, 2nd to third, I researched it on here and found a lot of bad reviews. I also found out that it was likely the modulator gone bad, and how to replace it. I replaced it, and although the new one was restricted and the old one wasn't, shifting was back to normal. So, I was thinking, that was easy enough, pretty good for the original tranny which has 297,623 miles on it, and hasn't been serviced since the first 1k!
Well, that lasted about 75 miles. Now it won't go forward or backward. Everything is still in place, no leaks, fluid level is full. I didn't change the fluid or do anything other than change the modulator. (My friend can't afford to service it properly. Now it may need replacing!) I have only seen problems shifting between gears and OD, TC lockup, etc., but, nothing about not moving at all. What might be the problem? Is the tranny history?
Ford F-150 (2004-2008) :: Manifold Exhaust Leak - Rusted Bolts
Truck has 107 thousand miles; had to take it in for an manifold exhaust leak. Mechanic said bolts are so rusted they break.
1) was there ever a ALERT from ford about these bolt's?
2) Thought i read ford had stainless bolts for this problem...
I've had F150's only since the mid 70's and this 04 has cost me more in repairs than ANY previous F150..
Accord :: 1995 V6 Automatic - Oil Leakage Coming From Between The Block And Plate
'95 Accord with the V-6, automatic. Developed s strange oil leak that appears to be coming from between the block and the plate that the oil filter attaches to. Not leaking from sending unit or filter, leak is on other side of the plate.
Preliminary inspection leads me to believe that I'll have to take the drive belt side of the engine apart to fix properly. No fun, there. Wondering if I can't JB weld it.
Ford Aerostar :: 1995 Won't Shift Out Of Park
I just picked up Aerostar #6 and am in the process of transferring parts etc. Got this one cheap as it was badly abused and has issues. Big problem, the shifter takes a lot of wiggling etc to get out of park. Is the interlock easy to disable? If so how? Or would a good column from my 93 be an easy plug and play proposition?
View 1 RepliesFord Aerostar :: 1995 - Control Arm Bushings?
can you replace the upper control arm bushings (pass side) with the arm still in the truck?
View 8 RepliesFord Aerostar :: 1995 - ABS And Brake Light On
I have a '95 Aerostar where the two lights are always on. I'd like to pull the codes if i can. Does this year has the RABS or the RABS II module. Or is the diagnostic connector the same?
View 14 RepliesFord Aerostar :: 1995 - Outer Tie Rod Replacement
I was wondering how do i replace the outer tie rod on a 95 ford aerostar awd 4.0L. I have enough for the parts but not extra tools. Need a tutorial on how to do it?
View 6 RepliesFord Excursion :: V10 - Huge Coolant Leak Behind The Block On Passenger Side
So broke down today and have no tools, in a city I don't live in. Huge coolant leak behind the block on the passenger side. Luckily we broke down right at a mechanics shop. They need to take off the manifold to get to the rusted out metal piping in back.
I am new to the V10. Looking for information on what could be leaking back there? I know I could do this myself but I need to know what parts I might be dealing with first. And its tight quarters back there.
Ford 6.7L Power Stroke Diesel :: Coolant Leak Near The Back Of The Block?
Seen a coolant leak near the back of the block? I did an oil change and noticed coolant on the bell housing.
View 7 RepliesFord Aerostar :: 1995 - Stalling When Hit The Brakes Hard
When I hit the brakes hard like seating the brakes the Aero would stall....
View 12 RepliesFord Aerostar :: 1995 - Sloppy And Loose Shifter?
My mom's 95 shifter is slowly getting worse. Right now it's at the point where we have to hunt for gears just to put it into park or reverse or d/od. It's not stiff like the rest of ours, hers is all sloppy and loose. She says it's been doing this for a while, but i think it got worse when i pulled her cluster out to change the light bulbs. I say this because i couldn't get the needle cable un done, so i just let the cluster rest on it while i was changing the bulbs, which put a little bit of tension on it.
View 14 RepliesFord Aerostar :: 1995 - Hard To Shift Out Of Park
I have a 95 Aerostar that when in park it is hard to shift into reverse, drive etc. It is an automatic, 3.0 liter.
View 7 RepliesFord Aerostar :: 1995 - Easiest Way To Change Belt?
Whats the easiest procedure
View 3 RepliesFord F-150 - 1997-2003 :: Water Leak At Back Of Engine - Cracked Block?
Just did a tear out and rebuild, installed motor, filled with water. Water is leaking out of the back of the engine somewhere. Leaking as if it were coming out of a 1/4" diameter hole. 1997 V4.6L F150. I guess I have to pull it no matter what. Cracked block? Freeze plugs were all new and installed by machine shop. Initial reason for pulling was water in cylinders and I assumed blow head gasket.
View 1 RepliesFord - Aerostar :: 1995 - Won't Start / Dirty Spark Plug?
My dad and I are having allot of trouble getting our Aerostar to start up . It is getting fuel and spark , and it won't even run with starter fluid . It was running ruff before this . It is getting an all clear on the OBD codes . We took one spark plug out and it was pretty dirty , could that be our problem? Like I said we are getting spark , when we do a spark test . We are totally out of clues .
View 7 Replies