Aurora :: 1995 - High Mount Brake Light Not Working
Someone mentioned to me this week that my high mount brake light was not working. No big deal, just a burned out bulb I assumed. Well, I replaced the bulbs (two bulbs) and it still does not work. The sockets look fine, no corrosion. The wiring that I can see looks good. I used a volt meter & found I'm getting no juice at the socket . . ? Is there an in line fuse or something else simple I should check. I'm thinking this should be an easy fix & am frustrated I can't figure it out. By the way, my lower brake lights are working fine.
View 3 RepliesFord Aerostar :: 1995 - ABS And Brake Light On
I have a '95 Aerostar where the two lights are always on. I'd like to pull the codes if i can. Does this year has the RABS or the RABS II module. Or is the diagnostic connector the same?
View 14 RepliesFord Wiring/Electrical :: 2010 - No Brake / High Mount Brake Light / Rear Turn Signals?
2010 F-250 14,000 miles, gas engine with Knapheide utility bed. Tilt wheel has been kept in the up position from day 1.
The problem:
No rear brake lights.
No high mount brake light.
No rear turn signals.
No rear hazard flashing lights.
All trailer lights work.
All other truck lights work.
Things checked: Fuses all OK. Visual inspection of multi-function switch. Looks clean. Brake switch at brake pedal has power on one wire. Jumpered the other wire-no brake lights.
I need to haul my trailer and am nervous when I see a Savannah, GA metro police car.
Passat (B5) :: High Mount Center Brake Light
Can this be changed easily by a non-dealer? The local Autozone doesn't list any replacement bulbs or assemblies, and I can't see a simple way of accessing the light assembly from the trunk.
View 1 RepliesLexus ES 2007-12 :: 2010 ES350 - High Mount Third Brake Light Removal?
My wife's 2010 ES 350 third brake light has an intermittent LED issue. The last 3 LEDs on the pass side flash on/off when the brake is depressed. My understanding is there may be a broken solder joint. My problem is I can't seem to get the assembly out. How the high mount assembly is mounted and how to remove it?
View 2 RepliesCamry :: 2002 - High Mount Brake Light On Spoiler Half Burnt Out
Just bought an 02' camry and the high mount brake light on the spoiler is half burnt out. Tried removing what I'm guessing is an LED assembly but the screws are stuck and the angle is really awkward. Am I going to have to replace the whole LED bar?
View 2 RepliesSanta FE SM (2001-06) :: High Mount Stop Light Glow Even Without The Brake Applied
Recently I noticed that three LEDs in my 05 SantaFe's high mount stop light glow even without the brake applied. When the brake pedal is depressed, the entire light glows as it should. But only the three LEDs glow at all times.
View 13 RepliesAvalon 2005-12 :: 2007 - High Mount Brake Light Works Sporadically
My high mount break light works sporadically. When I break, sometimes you can see it as bright as it can be, other times it is dim, and then sometimes no light comes on. The dealership could not even figure out how to get to the led unit.
View 8 RepliesLexus SC430 :: High Mount Brake Light Assembly - Intermittent Connection?
Lexus has diagnosed a ground fault with an intermittent connection.... I am not sure how to proceed ... Could it be a light bulb connection... or does it even have these? Can the part be serviced in place... or must I replace the whole assembly?
View 4 RepliesFord Aerostar :: 1995 - 4WD Warning Light Flashes Intermittently?
4wd warning light flashes 3 times intermittently. Which error this means.
View 4 RepliesFord Aerostar :: 1994 - 3rd Brake Light Stuck On - Can't Change Bulbs
About two years ago I sold my 1994 Aero (transmission was going, and other stuff) and bought a 1997 that was in much better shape. But one flaw it has is that it was used somewhere with high corrosion, so a lot of stuff is stuck or rusty. I haven't changed the rear bulbs since I got it, but this week, 2 out of three bulbs went. Actually, I only noticed the 2nd one because the blinker went too, and started blinking fast. The 3rd Brake light on top might have been out a while already.
Anyway, to my frustration, I cannot open the 3rd Brake Light to change the bulbs. Even after I removed the 2 screws, the lens won't budge. I tried gentle prying, but I can hear the plastic starting to crack. I figure there are 2 possibilities.
a) It somehow got fused to the gasket over time. or
b) It was crazy-glued shut by some insane maniac (a long-shot?). In which case I can try Acetone.
For starters, once the screws are removed, does just the red lens come out, or does the black frame around it come out with it? I tried prying on both, but one of them is surely wrong. Worst case scenario is that I break it, and have to glue it back on or get another one from a junk yard. But that is not good... Meanwhile I am living ok with just 2 brake lights.
Ford Aerostar :: 1995 - Won't Shift From 1st To 2nd / 2nd To Third?
This van has the A4LD transmission. I know nothing about transmissions, so, when it wouldn't shift from 1st to 2nd, or, 2nd to third, I researched it on here and found a lot of bad reviews. I also found out that it was likely the modulator gone bad, and how to replace it. I replaced it, and although the new one was restricted and the old one wasn't, shifting was back to normal. So, I was thinking, that was easy enough, pretty good for the original tranny which has 297,623 miles on it, and hasn't been serviced since the first 1k!
Well, that lasted about 75 miles. Now it won't go forward or backward. Everything is still in place, no leaks, fluid level is full. I didn't change the fluid or do anything other than change the modulator. (My friend can't afford to service it properly. Now it may need replacing!) I have only seen problems shifting between gears and OD, TC lockup, etc., but, nothing about not moving at all. What might be the problem? Is the tranny history?
Ford Aerostar :: 1995 Won't Shift Out Of Park
I just picked up Aerostar #6 and am in the process of transferring parts etc. Got this one cheap as it was badly abused and has issues. Big problem, the shifter takes a lot of wiggling etc to get out of park. Is the interlock easy to disable? If so how? Or would a good column from my 93 be an easy plug and play proposition?
View 1 RepliesFord Aerostar :: 1995 - Control Arm Bushings?
can you replace the upper control arm bushings (pass side) with the arm still in the truck?
View 8 RepliesFord Aerostar :: 1995 - Outer Tie Rod Replacement
I was wondering how do i replace the outer tie rod on a 95 ford aerostar awd 4.0L. I have enough for the parts but not extra tools. Need a tutorial on how to do it?
View 6 RepliesFord Aerostar :: 1995 - Stalling When Hit The Brakes Hard
When I hit the brakes hard like seating the brakes the Aero would stall....
View 12 RepliesFord Aerostar :: 1995 - Sloppy And Loose Shifter?
My mom's 95 shifter is slowly getting worse. Right now it's at the point where we have to hunt for gears just to put it into park or reverse or d/od. It's not stiff like the rest of ours, hers is all sloppy and loose. She says it's been doing this for a while, but i think it got worse when i pulled her cluster out to change the light bulbs. I say this because i couldn't get the needle cable un done, so i just let the cluster rest on it while i was changing the bulbs, which put a little bit of tension on it.
View 14 RepliesFord Aerostar :: 1995 - Hard To Shift Out Of Park
I have a 95 Aerostar that when in park it is hard to shift into reverse, drive etc. It is an automatic, 3.0 liter.
View 7 RepliesFord Aerostar :: 1995 - Easiest Way To Change Belt?
Whats the easiest procedure
View 3 Replies