Ford 6.0L Power Stroke Diesel :: Truck Started Surging Then Stalled
Last night pulled in at rest stop and truck started surging then stalled put dieselkleen in and topped off tank but no luck eventually would not run at all. Had it towed to ford and this morning started right up running fine. Having them change fuel filters. Not sure what to do got to get back to drive?
View 11 RepliesFord 6.0L Power Stroke Diesel :: 2006 F250 Started Surging At Idle
Just bought a 2006 F250 with 6.0. A week or so ago, it surged once at idle at a light. Sort of felt like someone bumped into your rear. It has gotten more frequent over the last week or so. Now it does it often. It tends to rev up and then back down again over and over. Then it will clear up again. My brother said his 7.3 used to have a similar problem (as did quite a few others apprently) and it was the Cam positioning sensor (CPS). Where is it located?
View 14 RepliesFord 6.0L Power Stroke Diesel :: Will EGR Delete Turn On Check Engine Light?
If doing a EGR delete on a early 2004 6.0 will turn on the check engine light? I was going to leave the valve in place and harness connected, I was just looking to add durability to the truck so don't want to use a tuner but also don't want the engine light on, I seen conflicting reports that it may or may not turn on the light!
View 3 RepliesFord 6.0L Power Stroke Diesel :: EGR Delete - Gas Engine Exhaust Rumble / White Smoke
After a couple of setbacks, including forgetting to install 3 out of the 4 orings on the oil cooler, I got the IPR Gen2 delete installed. I have a couple of issues since getting it started. I have low boost, I know the up pipe for the turbo is seated well, really surprised about that. However, the exhaust pipe may have a slight leak, but not positive. Finally, the last on this issue, I have a ripped MAP hose that I'm going to replace.
Next issue is that I hear what almost sounds like a gas engine exhaust rumble from the front of the truck. What it could be? I had white smoke initially coming out of the exhaust, but it cleared up after getting everything up to temp and taking it for a ride down the road. On a side note, the leak that I had from my previous thread seems to be gone now.
Ford 6.0L Power Stroke Diesel :: Subtle Engine Sound Changes While Driving At Highway Speeds - Surging
I've been noticing some weird, very subtle engine sound changes while driving at highway speeds lately. Something almost like surging, but not. I don't know how to describe it. I might try to make an audio recording next time I take it out so I can explain it.
Anyway, I don't know why but ICP popped into my head. Maybe, for some reason, the engine was varying ICP causing the surging sounds.
So I hooked up AE and did a test. I've attached a screen shot.
With my idle speed actuated as high as it will go, and ICP actuated as high as it can go, I can only get a pressure of about 1450 PSI. I always thought ICP should go higher than that. I seem to recall reading somewhere around 3600 PSI.
So am I misinformed, am I reading the data wrong or do I have a problem? How high should Injector Control Pressure go? I missed it in the screen shot, but ICP is actuated to 100%.
Ford 6.0L Power Stroke Diesel :: 2004 - Delete EGR On Not?
New to me truck, 2004 250, bought in Aug, 110K on it.
First thing out of the gate the FICM wiring Harness was bad, so I will have to replace that, I was thinking that since I'm that far into it why not just go a little farther and have a look see at the EGR Cooler and the HPOP...
I don't get white smoke on start or any other time, seems to run fine, haven't got a scanguage yet, so no data.
Thinking about doing the EGR Delete, but not really sure on all the pro's/cons of it.
Being an 04 truck It won't throw any codes if I put in the delete, and its far more economical to do the delete, however I have heard that new ECM program/updates could cause the truck to throw a code...
Looked at BPD and their EGR oil cooler, but that is just plainly out of the budget for now.
SOOOO If I delete am I looking at a potential check engine light (god I hate those) in the future, and or issues when I go in for emissions, can they really tell its been deleted?
Ford 6.0L Power Stroke Diesel :: Passing Emissions With EGR Delete?
Looking at an EGR delete in the very near future. Any problems passing emissions with a full delete?
View 14 RepliesFord 6.7L Power Stroke Diesel :: How To Delete Traction Control
How to completely turn it off, I got nothing so far. I cant do it with my H&S, I have access to ford IDS which is also unable to turn it off. The only thing I have found to work is unplugging a wheel speed sensor, which sets off dash lights... Im thinking of finding a body control module without advancetrac.
View 14 RepliesFord 6.0L Power Stroke Diesel :: Lower Boost After EGR Delete
Some people say it's normal to lose some boost after the delete, some say it's not and you need a tuner. Before the delete, I could regularly see around 28-29 psi on the factory gauge if I jumped on it. Now, I see about a max of 20-21. I have no leaks that I can find and the truck runs just as it did before. I still have my EGR plugged in laying on top of the engine and don't have a check engine light-yet. Is there a definitive answer as to how to fix this or is it really considered normal to lose that much boost after a delete? I don't really want a tuner because I'm not looking to add HP, but if that's what it takes, then I need to save up. I also read somewhere it can depend on the strategy.
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2004 - IPR EGR Delete Done / Correct ID
I am going to have an IPR EGR delete done. Having a hard time telling whether I have the round or square EGR. Looking on the passenger side anywhere to look specifically so I make the correct ID. Want to order the correct one. They said build date is not a good way to ID.
View 9 RepliesFord 6.7L Power Stroke Diesel :: 2013 - Should EGR Delete Kit Or Unplug?
I am looking into getting the full deletes on my 2013 F250 6.7 and using the H&S Mini Maxx Race Tuner unlocked. I was told by my local Diesel Performance Shop I should just unplug the EGR and turn it off by the Tuner rather than investing in the delete kit.
He advised me it would be easier to plug it back in and turn it back on in case I need to take it back to the Dealer for any warranty work He advised me no advantages any way and works the same way. I will be putting on the H&S race tuner, S&B CAI, FLo Pro 5" down pipe back w/ no muffler and UREA delete.
Ford 6.0L Power Stroke Diesel :: 2006 - Stealth EGR Delete?
I am planning on doing a stealth egr delete on a 2006 6.0. What is the proper procedure? Is there a scoop in Y pipe that needs to be eliminated? Am I going to see a CEL? Am I going to need a tuner to clear CEL and codes?
View 10 RepliesFord 6.0L Power Stroke Diesel :: SCT EGR Delete And CEL Light - Code P1000
I'm brand new 6.0 owner. I am going to be performing many of the bullet proofing steps including plugging off of or a complete delete of the EGR cooler. I've read that the SCT tuner will turn off the CEL light and stop the ECM from operating EGR function.
What I can't find for sure is will I get a code P1000 (drive cycle not completed) with EGR turned off. Here in Seattle if you have a code P1000 stored you will not be allowed to complete emissions testing to get your tabs renewed. I'm guessing it does not set P1000.
Ford 6.0L Power Stroke Diesel :: 2003 F250 - No Start After EGR Delete
Just did an egr delete, oil cooler, icp sensor and exhaust on an 03 f250 6.0l. got it all back together and it cranked up and ran for about 30 seconds then stumbled and died. read to pull out the ipr sensor and check it and it had a piece of debris on it covering the screen. took of the debris and still no start.
View 6 RepliesFord 6.0L Power Stroke Diesel :: After EGR Delete Now Got Five Exults Codes And Running Bad?
Truck ran good for about a week now it has five exults codes and runs like crap I know I need a programmer but do you think I messed something up.
View 1 RepliesFord 6.0L Power Stroke Diesel :: 2005 Excursion Started Vibrating When Getting On The Highway
So, on my way home from checking out a house all of a sudden the truck started vibrating when getting on the highway. Then it got worse quickly. So I pulled off at the next exit and pulled into a parking lot, the truck shuddering badly any time I pressed the fuel pedal. Had it towed to my local Ford dealer. I'm thinking torque converter/transmission, but I freely admit I don't know. Here's what I think is pertinent info-
1. I bought it at 84k miles, now 122k. Oil changed every 5k, fuel filters every 10k, coolant every 20k, trans fluid every 20k. Don't kmow what was done first 84k miles before I bought it.
2. Driveshaft rebuilt one year ago. Both fr and rr diff fluids changed a few months ago, along with transfer case fluid.
3. When in park or neutral engine revs perfectly smooth. When placed in gear and fuel is added it starts to shudder, getting worse as revs go up. Does not vary with road speed, only with engine speed and load into transmission.
4. There are no codes at all. All temps were normal. Engine oil and trans fluid level normal.
5. A few months ago when coming home from a trip I suddenly had the same symptoms about 3 miles from home, but not as bad as today. Made it home taking it easy and went to bed. I was exhausted from a long day of driving and when I test drove the truck the next morning to check it out it was smooth as could be, so I thought maybe I imagined it. Symptoms did not reappear until today, a few months and several thousand miles later.
Ford 6.0L Power Stroke Diesel :: How To Change Boot Or Hose On Egr Delete Tube
How to get the boot or hose off the egr delete tube without having to tear everything apart? mines leaking i have new hose to replace just not sure how to get the old one off...
View 7 RepliesFord 6.0L Power Stroke Diesel :: Error Code P0400 After Doing Stealth Egr Delete
I just did a test drive with my 04 6 liter, I did the stealth egr delete. I had a P0400 error code any concern?
View 14 RepliesFord 6.0L Power Stroke Diesel :: Coolant Leak - EGR Delete Hose Replacement
Had a coolant leak I finally traced to the rubber hose on an egr delete (previous owner installed, not sure of brand). Looks like the jackwagon who installed it cranked the clamps way too tight and they eventually split the hose. I have a piece of heater hose that looks like the right diameter and cut to size should fit fine. I guess I am just looking for some reassurance that it would be ok to use in that situation...
View 3 Replies