Ford 6.0L Power Stroke Diesel :: SCT EGR Delete And CEL Light - Code P1000
I'm brand new 6.0 owner. I am going to be performing many of the bullet proofing steps including plugging off of or a complete delete of the EGR cooler. I've read that the SCT tuner will turn off the CEL light and stop the ECM from operating EGR function.
What I can't find for sure is will I get a code P1000 (drive cycle not completed) with EGR turned off. Here in Seattle if you have a code P1000 stored you will not be allowed to complete emissions testing to get your tabs renewed. I'm guessing it does not set P1000.
Ford 6.0L Power Stroke Diesel :: 2005 - Engine Started Surging - EGR Delete
A few weeks ago I got in my 2005 EX and started for work. As I idled in traffic, the engine started surging (it had never done this before). So I took it right to Ford and dropped it off before it got worse. Of course, they couldnt look at it until Monday (this was a Thursday), so I had to get a rental.
I get the call on Monday that the surging problem was an injector, but covered by my warranty. But, it seems that my EGR cooler was bad, but even more important was my blown head gasket.
WHAT?! My truck did NOT have a blown head gasket when I dropped it off. But thats besides the point. There was much back and forth between Ford and my warranty company, but finally I got them to cover the head gasket.
But, I had to pay for the EGR cooler. So I asked the Ford mechanic if I could supply him with an upgraded cooler, so I wouldn't have this issue in the future. He said no problem. I then told him I was going to buy a Bulletproof and he said no, get a delete kit. He said "I've done a number of these, and its really the best solution.". He even HEAVILY recommended the ADT Delete kit. He even said that since I have a 2005, we can just leave the EGR valve hooked up and I wouldn't have a CEL issue.
Fast forward several days. I picked up my EX last night and... CEL is on. I called and spoke to the mechanic and he told me that I must have an upgraded program, and that my only option is a tuner to turn off the EGR completely. He also told me that I don't need an expensive SCT or Bullydog just for the EGR.
Anyways, with all of the above setting of the stage complete, just wondering what my best option is here... Is there a simple/cheaper tuner I can use to just disable the EGR? Is it worth the money to get a more expensive tuner? For the most part, this is my daily driver and I don't need a performance or towing tune. I wouldn't mind better mileage, though
Ford 6.0L Power Stroke Diesel :: EGR Delete - Gas Engine Exhaust Rumble / White Smoke
After a couple of setbacks, including forgetting to install 3 out of the 4 orings on the oil cooler, I got the IPR Gen2 delete installed. I have a couple of issues since getting it started. I have low boost, I know the up pipe for the turbo is seated well, really surprised about that. However, the exhaust pipe may have a slight leak, but not positive. Finally, the last on this issue, I have a ripped MAP hose that I'm going to replace.
Next issue is that I hear what almost sounds like a gas engine exhaust rumble from the front of the truck. What it could be? I had white smoke initially coming out of the exhaust, but it cleared up after getting everything up to temp and taking it for a ride down the road. On a side note, the leak that I had from my previous thread seems to be gone now.
Ford 6.7L Power Stroke Diesel :: Low Fuel / Power Message Then Check Engine Light On
My low fuel light came on tonight. I drove about 2 miles, stopped and shut the truck off. When I restarted it and began to drive off to the fuel station a notice came on that isaid power reduced then a check engine light came on. I was about a mile or less from the fuel station so I filled up. I cycled the key but the engine light is still on. No low power message tho. The power is fine.
I came home and drained the water drain on the filter, didn't see any water but hoped it would solve the problem. I cycled the key a few times and started the truck but the light is still on. My truck is a 2013 f350 6.7 and has 211500 ish miles on it. I bought it a month ago with 18500 miles and haven't had any issue until tonight. My only thought is maybe the fuel filters need changed. I don't know if or when the previous owner changed them.
Ford 6.7L Power Stroke Diesel :: Check Engine Light Came On / Reduced Power Then Died
I started my '16 6.7 this am and drove it about a mile.
The check engine light came on and at the same time the display said "Reduced Power". I decide to turn around and try to make it back to my shop but shortly after turning around the display said "Low Fuel Pressure" and within a couple of hundred yards it shut down leaving me stranded by the side of the road.....
I called my local dealer who gave me the Ford Cares 800 number. I got a flat bed in about 1.5 hours which I didn't think was too bad considering I live in the country and they brought it to the dealer. The SA said it might be a couple of days before they could look at it as they were pretty busy... What it could be? The engine is stock with 9100 miles on it...
Ford 6.0L Power Stroke Diesel :: 2004 / Check Engine Light Came On
So last night my check engine light came on so I checked by by turbo and seen this hose not sure where it goes?
View 7 RepliesFord 6.7L Power Stroke Diesel :: 2013 - Check Engine Light On
Check engine light is on...not blinking. All fluid levels are good. Mileage is 10,700. No code displayed in engineering mode. Truck seems to be running fine..
View 11 RepliesFord 6.7L Power Stroke Diesel :: Check Engine Light On - EGR Cooler Had No Flow
I found out today that the 2012 6.7 that I have purchased used with 30, 500 Miles on it a month ago has been in previously for warranty work. It appears that the previous owner took it in with a check engine light and after diagnostics found that the EGR cooler had "no Flow". Ford replaced the EGR cooler core under warranty before I bought it. (It now has 31, 950 on it). Normally I would think, GREAT, something I don't have to worry about doing. But being new to the diesel world, I was just wondering if this is something I should be concerned with. Anything else I should be keeping an eye on etc.... Also is this abnormal to occur with such low mileage?
View 14 RepliesFord 6.7L Power Stroke Diesel :: Check Engine Light Came On After Battery Replacement
I just replaced my batteries today on my 2011 F250 because of a no start situation. I guess it was about due since they were original and that gives me 5 + years of service and it happened in my driveway so I definitely am not complaining. However after I replaced them and started the truck the check eng lite came on....
View 8 RepliesFord 6.0L Power Stroke Diesel :: Check Engine Light Go On - OBD2 Error
I had a bad Glow Plug on my 2004 F350 6.0L Diesel causing the check engine light to go on. I replaced the Glow Plug and cleared the OBD2 error. The check engine light is off now, but I can't pass the smog check because EGR Monitor "Not Ready"
I put 100+ miles city/freeway miles on the truck, but I still get EGR Monitor "Not Ready" Even tried "Drive Cycle" with no luck...
Ford 6.0L Power Stroke Diesel :: Check Engine Light Came On - P1335 Code
My check engine light came on today and the code read P1335. What code is that?
View 14 RepliesFord 6.7L Power Stroke Diesel :: Check Engine Light Code P21B0
CEL came on.. hooked up my cheap OBD/CAN scanner.. getting code P21B0..googled it and this is what i find: P21B0 - Reductant Level Sensor C Circuit High. What is this for? I've about had it with this truck..this having to replace a sensor every time I take it on a long trip stuff is getting ridiculous..2 EGT's, air charge cooler sensor, blower motor, and now this...
View 14 RepliesFord 6.0L Power Stroke Diesel :: Low Turbo Boost / Check Engine Light On
Check engine light is on says low turbo boost but gauge says it has a lot of boost. Only happened after I put catalytic back on for smog test. Before that no problem.
View 10 RepliesFord 6.7L Power Stroke Diesel :: 2011 - Check Engine Light On - EGR Cooler
Well another problem with my 11. It was just at the dealer getting the fuel pressure sensor replaced and then it started throwing a different check engine light. Dealer says it needs a new EGR cooler. They said there is a TSB for this. I don't have the exact code it was throwing right now. I haven't heard much about EGR coolers being a problem.
View 4 RepliesFord 6.0L Power Stroke Diesel :: Check Engine Light Codes P0405 And P0404 - Hesitation And Loss Of Power
I have a 06 f250 king ranch with 6.0 . A few days ago my scangauge showed a code P0405
I changed my egr and after it showed two codes : P0405 and P0404
It still has a hesitation and loss of power , although better than before the Change.
Ford 6.7L Power Stroke Diesel :: Check Engine Light And Funky Boost Gauge
Noticed the other day when I went to leave a job site my Check Engine Light came on but the truck started fine and seemed to run normal. while cruising down the highway I noticed that my factory boost gauge was showing 35psi and fluctuating between that and around 10. looking at my H&S it was showing normal boost readings for the current driving condition, when I came to a stop the H&S would show 0psi but the factory one would fluctuate between 0 and 35-40psi..
I can tell the turbo is not spooling at all during this time. if I take off from a stop with the gauge showing 35 the engine sounds louder than normal at first take off compared to when the gauge is reading normal. I haven't gotten a change to get it in my shop yet to look it over but does the dash gauge read from a different sensor that what my H&S is reading? Truck is an '11 F250, deleted both EGR and DPF with H&S tuner. I checked codes and all I have is P06A7. Where to start?
Ford 6.7L Power Stroke Diesel :: Drive To Clean Exhaust Filter And Check Engine Light
I am at 34,600 miles and had the oil changed yesterday afternoon. My son picked the truck up for me and on his way home the "drive to clean exhaust message" came on with the "check engine light" at the same time. I get home from work, re-check owners manual and no mention of the check engine light coming on with the drive to clean message.
I called my service rep and he says drive it as per owners manual, so I head out drive about 45 miles, averaging 60 mph nothing changes, both lights/messages are still on. Truck seems to be running fine and the last cleaning exhaust message was Sunday and I believe I was out long enough for it to do its job. It will go into the shop tomorrow, but was looking for thoughts from the the rest of you pros before I go.
I mention the oil change only because after the last oil change at around 30,000 miles I drive to work 2 days after and my water pump starts leaking.. coincidence I know.. but getting freaked out as I approach 36000 miles..Truck is a 2011 and I bought it new in Jan of 11.
Ford 6.0L Power Stroke Diesel :: 2006 F350 - Check Engine Light That Came On / EGR Volts Weak
Truck had a check engine light that came on. Plugged in scanner while I was still running it, said egr volts were weak, i just cleaned it yesterday.. and earlier today reset the check engine light once but then drove about 30 miles with no reoccurrence of light. Now i pulled over, shut off truck unplugged egr and reconnected. Went back to start my truck and nothing at all. Its like I am trying to start it in park.....been here for about 3 hrs now I've checked fuses nothing is blown. I am just sitting here freezing trying to fig out anything i can on line....... Its a 2006 f350 6.0 ty
View 14 RepliesFord 6.7L Power Stroke Diesel :: 2016 F250 - Check Engine Light - Code P0170
I just bought a 2016 F250 with the diesel and thought I'd share an early ownership experience. At about the 1300 mile mark the check engine light came on and other than the remote start not working the truck continued to run great. I pulled a P0170 code, Fuel Trim Bank 1. And since the truck was still running fine, I considered clearing the code and see if it would come back. But since it's under warranty I decided to bring it to the dealer. They checked it out and diagnosed a bad Fuel Rail Pressure (FRP) sensor. They swapped it out and it seems to be good to go (no more light). While I was in there I asked them to turn on the DPF percentage full screen which they did.
View 3 Replies