Celica :: 1990 - Key Won't Turn In Ignition Switch
When I put my key in the ignition, I cannot turn the key. I tried putting a small amount of WD40 in the ignition and turning the wheel back and forth while trying to start, but all that did was make my key greasy and my wheel lock up. I've tried getting a new key made from Lowes and Home Depot, but their keys are too wide and will not fit in the keyholes. The only thing I am down to is replacing the ignition switch completely but I'd rather do that as a last resort because my car has had a big problem every week (alternator gone, new wheels, new master cylinder, new rotors/brakes). I haven't explored yet? And also, if it comes down to replacing the ignition switch, how would I do that without being able to turn the key?
View 2 RepliesGolf IV / Jetta IV :: Key Won't Turn After Ignition Switch Replacement
I am having a little issue with the ignition in my car. I had the typical no headlights/wipers/heater etc. so I ordered up a new ignition switch and when I went to replace it, the switch fit perfectly and had the correct part number but when I put my key in to try and start the car I couldn't even turn the key but when I put the old switch back in it would turn just fine. Also when I removed the old switch I noticed the red wire going to the switch was slightly burnt right at the terminal.
Here is the basic procedure I did:
-Unhook negative battery cable
-remove lower dash/ center console
-remove switch
-install new switch
Whats this little metal piece? I did not see that when I did mine...
Toyota - Sequoia :: 2001 - Ignition Switch Replacement Causes Blinker Failure
I just had the ignition switch replaced on my 2001 Toyota Sequioa. Now my blinkers work but will not shut off after I complete the turn. Additionally, the blinker "stick" is very hard to move in either direction. I plan to take my car back to the dealer and politely request this blinker repair be warranty work.
View 1 RepliesGrand Prix :: Ignition Switch Replacement - Location Of Hole To Release Key Cylinder?
I have a 97 grand prix GTP that I am replacing the ignition switch on. I am having trouble locating the small hole on the key cylinder that I put an allen wrench into to release the key cylinder.
View 2 RepliesFord F-150 - 1997-2003 :: Short In Steering Column - Ignition Switch Replacement?
I have a 1997 F150 that I have taken to a mechanic twice and it is still not right. I had a igination switch replaced and now when the humidity is really high
(I am Guessing), I can have the key in the house and my truck lights flash the radio is on and it sounds like it is trying to start. How hard is it to replace the igination switch myself. I believe it has a short someone in the steering column.
Celica :: 94 - Key Sticks In The Ignition
Before I go replacing stuff and taking stuff apart. My 94 Celica key sticks in the ignition. It will turn to accessory and run and starts just fine. The key won't turn back to release. Unless the battery is unhooked.I figured this out after killing my battery then recharging it. The steering wheel also doesn't lock. I am unsure if they are related but unhooking my battery to get my key out is annoying.
View 6 RepliesCelica :: 1987 - Oil Pan Replacement?
How do I replace the oil pan in my Celica? I have a crossmember directly below it.
View 2 RepliesCelica :: 1985 Switch Will Lower Power Window But Not Raise It
I purchased a 1985 celica GTS, convertible, rear wheel drive. I am having a problem with the drivers side power window. I can raise and lower the window with a direct 12v battery hook up to either the lift motor or from the terminals that connect to the switch. The switch will lower the motor but not raise it. When activated to raise the window you can hear the motor enterguise but will not lift. I check the voltage at the switch and I am getting 12 volts. What should I check next?
View 3 RepliesCelica :: 1992 ST Only Intermittently Starts - Have To Hit Ignition Multiple Times
For some time I've thought my starter is going bad because I'll have to hit the ignition multiple times for it to actually start...I've even had to resort to push-starting it a couple of times. How can I tell if this is a bad starter or something else like the main relay?
View 4 RepliesCelica :: 1995 GT Wouldn't Catch Ignition After Long Tries - No Spark
Car was parked nose slightly uphill. would turn over strong, but wouldn't catch ignition after long tries. I dinked around for 5 under the hood for 10 minutes in the 30 degree weather, and then after a medium long try, it started and ran. started fine after a 45 minute stop with the nose pointed slightly downhill. Then after 10 miles the engine shut off suddenly at 40mph with no warning. there was never any diminution of power in the acceleration. would not start again after many tries with plenty of revolutions. It did seem the cab lights were a little finicky/dim, but I couldn't tell if that was electrical weakness or just old car cab light switches. didn't behave the way a battery related ignition problem would. no check engine light.
Cop pulled up and wanted it off the busy road, and long story short it wound up at this shop I don't know anything about. the guy there said it started and ran fine for the 45 minutes or so he had it in the garage, but then it shut off. it wouldn't ignite when he sprayed throttle body cleaner into it while cranking the key. I think he said he did something else to confirm there was no spark. he's got his theories about what is wrong, but doesn't want to commit to anything unless he can burn some $100/hr time diagnosing.
I'm hoping it is not the ignition control module, ECM or especially the crankshaft position sensor.
95 GT Convertible - 5sfe
Celica :: 1995 - Engine Not Starting / Ignition Not Creating A Spark
I have a 1995 Celica that I've owned about 6 months. Great car until it broke down last week. It's an automatic and it spluttered to a stop as I was pulling into a car park (how polite). I've traced the problem to the ignition not creating a spark (removed and observed spark plug while engine turning over), but cannot find root cause. I replaced the engine management system this morning to no avail. A passerby mentioned that the 'igniter' which is built into the distributor casing might be the root cause of the problem.
View 4 RepliesCelica :: 2000 GTS - TPS Replacement On Engine
Where is the TPS on the 2ZZGE engine? I bought an OE part from bap geon and i cant find it on the car to save my life.
View 2 RepliesCelica :: 1992 - Fan Switch Blows Gauge Fuse / Drains Battery?
I have a 92 st, all stock. It was given to me by a friend that moved. The car was in very good shape before sitting for about two months (I had to go pick it up an hr and a half away, then replace the battery and starter).
The only issue it's had is the heater fan control will blow the circuit when turned on, which will kill my gauges, not to mention no fan. I removed the blower fan and bench tested it, seems fine. And with the fan unplugged, I can turn the switch on without blowing the fuse (it's possible that this plug is the only wiring from that switch, not sure).
My question is, is it possible this switch is short circuited and that's what is causing the fuse to blow? And is it possible this switch could be the source of my battery drain?
I was thinking maybe this was an ongoing thing, because the switch hasn't worked in a year and a half, before I got it. Perhaps this was draining the battery, but wasn't showing up because the car was being driven daily. I'm not sure what to do next but don't want to guess and start buying parts.
Camry :: Replace Ignition With Switch?
Is there any way to replace the keyed ignition with a simple momentary switch of some sort? Or is the built in security features too intertangled in the whole design? IE I suspect I'd have to disable tronsponder, keyed ignition, security system, steering column lock, some computer features? I definitely no expert but wondering if it's possible.
View 1 RepliesGolf V R32 :: How To Replace Ignition Switch
Replacing the ignition switch? I heard it possibly needs some VAG COM changes related to the immobilizer?
View 3 RepliesCelica :: 96 ST 7afe - Engine Removal / Replacement
I an taking out a 7afe engine (1.8L) from my 96 Celica ST to replace it. I have everything off the engine and all bolts removed from the engine to the transmission and there is no room to remove the engine. Does the transmission have to come out with the engine? I pulled them apart with what little room that there is and the clutch/pressure plate is stuck to the flywheel (the flywheel would clear by itself). This is a manual tranny.
View 2 Replies93 Ford Escort - Ignition Switch Won't Start Car
I've got a problem with my 93 ford escort. About a month ago things in it began to stop working. 1st the wipers and then the heater. and now the ignition won't start my car. It will allow it to turn over but it doesn't turn on the engine light before it starts to kick in. Bad key assembly or the whole switch? Or a relay ?
View 2 RepliesEscort :: Ignition Switch Replaced And Car Won't Turn Over
Had to replace the ignition switch. after I went to crank it after switching it out, there was a buzzing around the relay control module. Thought that maybe somehow the ignition tripped something in it so bought a new one. IT is still buzzing and car won't turn over. everything lights up on dash. tried to see if there were any codes and the scanner just reads "fail".
View 5 RepliesTouareg :: 1997 - Ignition Switch / Car Won't Turn Over
I was having all the tell tale signs of the almighty ignition switch. No lights, wipers, heater fan. But I didn't have time to change it. The other day went to start it and nothing. I changed the switch I have headlights wipers blower fan now which is sweet. But the car still wont turn over.
View 2 Replies