Celica :: 1995 - Engine Not Starting / Ignition Not Creating A Spark
I have a 1995 Celica that I've owned about 6 months. Great car until it broke down last week. It's an automatic and it spluttered to a stop as I was pulling into a car park (how polite). I've traced the problem to the ignition not creating a spark (removed and observed spark plug while engine turning over), but cannot find root cause. I replaced the engine management system this morning to no avail. A passerby mentioned that the 'igniter' which is built into the distributor casing might be the root cause of the problem.
View 4 RepliesSubaru - Forester :: Stall And Then Catch Itself At A Long Light
Car: 2010 Forester
Situation: Occasionally (3x a week or so) the car when recently started will, at a long light, start to stall and then catch itself. The last time rpms got so low the dashboard lights lit up for a fraction of a second before the engine caught itself and revved up to a normal 650-750 rpm.
I have taken to the dealer 3 times; one time they kept it for 3 days, they can't reproduce it. Took it home and the next day the gremlin was back.
Subaru - Legacy :: 1995 - Starter Turns Over But The Engine Does Not Catch
The car has 175,000 miles on it and is having issues starting but only sometimes. The starter turns over but the engine doesn't catch. Usually if I open the hood, pretend to know what I'm doing, and wait a bit, it will start within 10 minutes or less (sometimes it takes a few tries.) I hear a click when the starter is going and the engine isn't catching, very much like the click I hear if I'm driving with the AC on and the AC needs to draw power. I've recently had a tune-up including new fuel filter, spark plugs and wires. The mechanic can't figure out what's wrong (doesn't seem to be the battery or the battery terminals). The car even started up FINE at 40 below. I can't really see a pattern to it.
View 3 RepliesNissan - Altima :: Engine Refused To Turn Over And Catch When Turned The Ignition
My 2005 Nissan Altima has been fairly reliable up until the past two years, as it seems several aspects of the cars performance are starting to decline rapidly. I recently changed a headlight bulb, and upon reconnecting the battery, the engine refused to turn over and catch when I turned the ignition. After several tries, the car started and I noticed the check engine light has come on. I took it to AutoZone to get a read out, and the told me that I got two error codes: one for crankshaft position sensor and one for engine speed sensor. It's been a while since I got the readout, and I lost the paper with that I wrote the codes on, but I think the codes may have been P0335 for the crankshaft position sensor and P0725 for the engine speed sensor.
I changed the crankshaft position sensor and camshaft position sensors on my car, and the problem changed from a major problem to a moderate problem. The car performance now:
1) The check engine light is still on
2) When starting my car, I turn the ignition to connect the battery, wait a few seconds, turn to start the engine, and it takes about 3 turnover attempts before the engine catches and the car starts (inserting the key and turning it straight over to try and turn on the car often results in turnover attempts with no start).
3) When driving, the car now shifts hard at times and seems to be changing gears at higher RPMs than expected.
4) When going up a steep incline, as I press on the gas, the car RPMs go up but the car does not accelerate like it used to. It eventually shifts very hard into the lower gear and then I can accelerate up the incline at a much higher RPM rate than expected
I was reading wear these issues may be caused by a clogged fuel system, but I wanted to check with some of you guys to see what you think it may be before I go trying a fix on anything.
In terms of car care, I would say I'm fairly responsible. I get the oil changed regularly, and have always gotten scheduled maintenance taken care of as well as any maintenance at the recommendations of the mechanics I trust.
Accent MC (2006-11) :: When Turned The Ignition On It Sounded Like Starting But Didn't Catch
I have a 2008 Accent, automatic, with 167,000 mostly city kilometers on it. 3 times, yesterday and today, when I turned the ignition on it sounded like it was going to start but didn't catch. When I tried again the second time it started. At first, I thought I just didn't turn the key to the right long enough but with it happening 3 times, I am not so sure.
I called my mechanic and he thought it might be the fuel pump. He suggested I turn it to the right then back 2 times, then start it the third time. I have spent a lot on it lately, new tires in April, transmission fluid, also had to replace the tie rod on one front wheel and bearings on the other. If it is the fuel pump, what happens if I don't replace it soon?
Chevrolet - Hhr :: Ignition Key Wouldn't Turn
Last 6th of Jan. my son parked his car, a 2008 Chevy HHR, and 3 hours later it wouldnt start. Not only wouldn't start, the Ignition key wouldn't turn, and he couldn't remove it. Checked ECM fuse, Good: Checked Batt. No voltage on the Batt. No corrosion, no loose connections. Put jumper on it, started right up. Took it to Advance Auto, Batt showed a CCA of 660 Amps., Alternator putting out 15 Volts.
View 2 RepliesCelica :: 94 ST Starts And Run But Not For Long
This is the 1.8, manual trans. Was involved in a moderate front collision. Car starts and runs, but not for long. What to check?
View 1 RepliesSanta FE SM (2001-06) :: Car Won't Start - Key Wouldn't Turn In Ignition
I have a 2003 Santa Fe with AWD, automatic, and 3.5L engine. Saturday I went to get in and key wouldn't turn. Tried to mess with shifter and steering wheel but no go, Wife got it to turn after I went to work. Won't start. Waited for a new ignition lock cylinder then replaced today. Still won't start. There is no chip in the key as far as I know and the kill switch thing is still plugged in. Jumping does nothing. Doesn't even try to start or do anything when I turn the key all the way. What am I missing here?
View 5 RepliesLexus RX 2004-09 :: Battery Dead - Ignition Wouldn't Acknowledge The Key
My battery went dead in my 2004 rx330. We tried jumping it but the horn continually went off and the ignition wouldn't acknowledge the key. We have replaced it and only the dash lights up, and locks work, but wont start...
View 1 RepliesCelica :: 2002 - Car Has Long Crank After Sitting For Hours
I have a 2002 celica after sitting for a hour or so car has very long crank....
View 1 RepliesCelica :: 1990 GTS Not Getting Any Spark
I have a 90 gts celica, which the motor went in it, so i put a 93 5sfe into it. I took the old distributor out of the 90 5sfe and put it into the new motor. I wasn't getting any spark. So i replaced the distributor with a known good one. No spark. replaced the coil and igniter, no spark still.
View 10 RepliesCelica :: 1991 Vehicle Cannot Get Any Spark
I have a 91 celica with a 4afe engine and i cant get any spark. i replaced the distributor today and still no spark what else should be replaced...
View 14 RepliesFord F-150 (2004-2008) :: Truck Wouldn't Start Now Won't Shut Off When Pulled Key Out Of Ignition
What happened is I went to get in the truck I opened the door and the gauges and blower motor came on by itself like the ignition is in the on position. I put the key in the ignition and the truck didn't do anything. No crank or anything and I did notice the anti theft light blinking really fast. I unplugged the battery and plugged it back up then the truck started but I went to shut it off and pulled the key out the ignition and truck stayed running. But also the blower in the truck and the gauges are still staying on. People keep saying it's my key but why would the stuff cut on by itself inside the truck when I just opened the door?
View 9 RepliesCelica :: 1996 GT Won't Start - No Spark On Any Cylinder
This has the 2.2 engine with the ignition coil mounted on the firewall, not inside the distributor.
Original not start condition seemed to be fuel related because it tried to sputter on time after it died in the middle of the intersection.
Changed fuel filter, primed and no start.
Checked for spark at the plug wire using a solid wire and touching a ground - no spark on any cylinder.
Tested for voltage at the center distributor cap - have 12 volts - replaced distributor - no spark
Replace ignition coil and ignitor - no spark
The wires all test with the right ohms so I'm not sure what is left to replace.
Celica :: Low RPM Misfire Then Dead - No Spark During Cranking
As described in the title, my car started to misfire in the 1500 rpm rpm during acceleration, It did this for about 3 days in a row before it completely died. The car is a 1994 Celica GT-S with a 5S-FE motor. Prior to this issue the car ran perfectly. My kids want me to revive it but this issue getting the best of me.
Symptoms: No spark during cranking
* Fuel is getting to the cylinders
* Primary coil resistance is within spec
* Secondary coil resistance is within spec
* Pick-up coil resistance within spec
* Signal Rotor spacing within spec
* Ignition capacitor tested good (using the multimeter Ohm > Voltage method)
* Igniter module tested using the light bulb across the coil method. The 12VDC light blinked while cranking the engine
* Engine ground tested positive
* Spark plug tested good on another vehicle
I'm running out of options. My next attempt will be to swap out the coil but I need to order one because nobody in my area has any stock.
Toyota - Start - Celica :: 1987 GTS 2.0 Has No Spark
1987 Toyota Celica GTS 2.0 manual Transmission The Problem ... The power cable to alternator sparked on the side of the engine when I was connecting it. I did not think the battery cable was connected at the time but it was.. Now I have NO SPARK I have changed all the fuses at the battery could not find any that were blown but still changed them and checked all the fuses under kick panels none were blown. What should I look for now?
View 4 RepliesCelica :: 1990 - No Fire / Spark Out Of Coil
My Celica is running great, I drove about 30 miles and the car started hesitating to run, I was in heavy traffic, I could hear rattling sounds which appeared as though they were coming from the heater. I stopped at a stop light and I could tell something was burning out. I have lots of power, car is very fast. I went to the next stop light and the car died, it started and I went to the next stop light with plenty of speed and the car died and would not start again. I tried starting the car for 3 hours, no fire from the coil.
I have no spark out of the coil. I am confident the coil is good. I have 2 coils. I went to the salvage lot and purchased an "igniter" (ignition module). I installed it on my Celica, still no fire out of the coil. I have a relay under the glove box that clicks when I crank over the engine. The engine cranks over very well for over 3 hours. I have an after market alarm. Why do I not have spark out of my coil?
Celica :: 1997 - Engine Swap And Started Once But Now No Spark
I replaced my 7AFE engine in my Celica 1997 1.8 with another 7AFE engine. The replacement engine had a different wiring harness, so I kept my original wiring harness.
After the swap, I started the engine and it stopped by itself after about 30-60 seconds.
Now it wont start. I have fuel, but no spark. I have tried three different distributors.
I have tried to read the fault codes, with connecting TE1 and E1, but no engine light lights up in the dash.
Celica :: Car Started Idling And Stalling - Now Cranks But No Spark
Car started idling funny and stalling. Finally wouldn't start. Changed crusty spark plugs, started up once, then stalled and wont start again. Checked for spark, no spark. Changed crust dist cap and rotor and ignition coil and still no spark. Checked ignitor activity and appears to be working.
What else is there? There's a little doofer next to the coil that looks like it has two wires come out of it, looks magnetic (has metal shavings on it, probably from old rotor)... Could the ignition switch be the problem? It cranks, but no spark.