Ford F-150 - 1997-2003 :: Slight Clicking In Steering Column
Recently noticed when driving, I'll hear and feel a slight clicking noise coming from my steering column. I can be going straight or turning. it is intermittent. I've look underneath and nothing seems obvious. when the truck is in park, I've tried to manhandle the steering wheel, the steering wheel is solid. the truck is a 1998 f150xl v6.
View 1 RepliesFord F-150 - 1997-2003 :: 2001 - Steering Column Wobbling A Little When Hit Bumps
I just recently picked up a 2001 F-150 4x4 super crew. The steering column is wobbling a little when I hit bumps. I accessed the column and there are two white plastic "bushings" that hold the casted portion of the column tight against the studs with the star ends. This is above where the reinforcement bracket is bolted on. One of them is worn and won't tighten down to hold the column tight. What these are called so I can't find them to order them, I used a large washer for the time being but would really like to replace with new ones.
View 1 RepliesFord F-150 - 1997-2003 :: Ignition Switch Won't Turn
I'm having a problem with my ignition switch. It won't turn and I have to turn the steering wheel for it to finally work.
View 4 RepliesFord F-150 - 1997-2003 :: 4X4 Selector Switch Replacement?
I am needing to replace the selector switch for my 4x4 on my 2003 F150 Lariat FX4... I already have the new switch. Whats the best way to get in there to remove and replace the switch?
View 7 RepliesFord Excursion :: Steering Column / Ignition Locked Up
Started truck and turned the wheel far to the right and shut the truck off to get better access to the grease zerks. Now the entire column, ignition is locked up tight. I can't turn the key, remove it, anything? Thoughts? I'm stuck
View 14 RepliesFord F-150 - 1997-2003 :: 2002 - Ignition Cylinder Replacement Without Key
My boss gave me a 2002 f150 if i can get it started. No key and no paper work in order to get locksmith to replace key. The only way i have noticed to get it started is to drill through cylinder to get it out. Need to know how to get it going?
View 4 RepliesFord Escape / Hybrid :: Steering Column Replacement?
Steering column recall ? The ford sites don't have much info yet. What is involved steering column replacement ? Computer reprogramming to sove the issue of the steering ?
View 1 RepliesFord Aerostar :: 1988 - Steering Column Replacement
My `88 Aerostar needs a replacement steering column. I believe everything can be swapped over therefore color of steering wheel does not matter. Cruise control buttons and tilt are a must. I would like to find one that is tight(er) and not sloppy floppy like mine is slowly becoming (143k miles).
View 1 RepliesFord F-150 - 1997-2003 :: PAT Module Communicates Wirelessly To Key Module Under Steering Column
Took my 99 XLT super cab to a Ford dealer to have a new key made (I have only one so can't do it myself). I was told the PAT (Passive Anti-Theft) module wouldn't communicate with their system.....
As I understand it, the PAT module communicates wirelessly to the key module under the steering column. Since the PAT module is obviously working (the truck cranks, starts and runs fine). What are they talking about?
Ford F-150 - 1997-2003 :: Steering Wheel Replacement - Puller?
I want to replace my steering wheel. Will this puller work for that job?
View 5 RepliesGolf VI R :: 2012 - When Turn Ignition Key Car Won't Start After Changing Steering Column
I am working on a salvage car that I bought recently. It was stolen, they cut the wire harness to the GPS system and messed up the steering column. I replaced the steering column with a 2012 GTI steering column and steering wheel. I bought a RNS 315 but I dont have any luck finding a wiring connector for it. After I installed the steering column, when I turn the ignition key nothing comes on in the gauge cluster. I know the car wont start till the key is programmed. My question is do I need to fix the wire harness so that when I turn the key ON the cluster will light up? Where I can find the connector for RNS 315. Regarding the airbag, will a GTI airbag work on a Golf TDI?
View 1 RepliesPassat (B5) :: 2002 - Can Faulty Switch From Fuse Panel Short Out Steering Wheel?
I took my '02 Passat in a couple weeks ago when the steering wheel controls and horn stopped working. They replaced a fuse. About 10 days later, I experienced the same problem. That time, they said that the steering wheel was all shorted out and needed to be replaced. Five days later, again the same problem. Now the dealer says it's some faulty switch from the fuse panel, which caused the short of the old steering wheel. Since that wasn't replaced, that's why I experienced the problem again. Could that have been the only problem? Or could that really have fried the steering wheel, too. Am I being taken, and do I need to fight to get some of that money back? Or is this legit? How can I verify that what they said was the problem actually was, and that I'm not left paying for their mistaken diagnosis?
View 3 RepliesFord F-150 - 1997-2003 :: 2000 - Power Steering HP Line Replacement
I am replacing the high pressure power steering line on my 2000 Lightning and have a question about the fitting that goes into the steering gear. The new hose came with a black rubber o-ring that the instructions seem to indicate goes on the end of the steering gear fitting. The problem is that I did not see any o-ring on the original hose end or in the steering gear itself and the hose did not leak there (it was leaking on the pump fitting). Should there be an o-ring at the end of the fitting or does the fitting go on without it and uses a metal to metal seal? If replace this hose, did you use the o-ring or leave it out? Does it go on like this? Or like this?
View 4 RepliesCamry :: Ignition Locked - How To Unlock Steering Column Of Hybrid Push Button
How to unlock the steering column of a hybrid push button camry?? Im so confused and can't find any information.
View 4 RepliesCelica :: Ignition Switch Replacement Possible Without Key?
Is it possible to change the ignition switch without the key. Problem is my old key broke so im replacing the whole switch.
View 1 RepliesSonata NF (2006-10) :: Radio Stays On And Steering Column Does Not Lock After Ignition Turned Off And Key Removed
This started today, when I turn off the ignition and remove the key the radio stays on and the steering column does not lock. The guy at the dealership suggested spraying wd 40 into the ignition. No go.
2008 sonata.
Ford F-150 - 1997-2003 :: Headlights Sometimes Working And Turn Signals Not Working - Multi Function Switch Replacement?
Well now I have to replace the multi function switch due to moving my steering wheel and the headlights sometimes working and turning signals not working. I saw a great video on youtube about changing a Multi Function Switch and it shows where the air bag needs to be removed. I was hoping that since my truck is an older 1997 F250 LD I wouldn't have to remove the airbag. Is there a way to do this w/out messing with the airbag on the 1997?
View 1 RepliesGolf IV / Jetta IV :: Key Won't Turn After Ignition Switch Replacement
I am having a little issue with the ignition in my car. I had the typical no headlights/wipers/heater etc. so I ordered up a new ignition switch and when I went to replace it, the switch fit perfectly and had the correct part number but when I put my key in to try and start the car I couldn't even turn the key but when I put the old switch back in it would turn just fine. Also when I removed the old switch I noticed the red wire going to the switch was slightly burnt right at the terminal.
Here is the basic procedure I did:
-Unhook negative battery cable
-remove lower dash/ center console
-remove switch
-install new switch
Whats this little metal piece? I did not see that when I did mine...
Ford - Ranger :: 1989 - Stuck Steering Wheel / Ignition Switch
So, I have an 89 Ford Ranger 4-wheel drive and the steering wheel is locked up (along with the ignition switch), neither of which will turn or budge. I've been told to shake steering wheel from side to side while trying to turn key--but after fifteen minutes of that (quite a workout) bupkis, nada, nothing. So, other than taking a sledge hammer to the whole truck? Is there a way to simply break loose the mechanism (I don't need the security aspect of the locking wheel/ignition, since I only use this for "farm use". But I really need it fixed.
View 9 Replies