Camry 2012+ :: Installation Of AMP And SUB / How To Connect RCA Wires
From the past couple of days i've been trying to google but nothing. I want to install an amp and sub in my camry I have never done it before so I can run the power and remote wire . My question is how to connect / run the RCA wires.
View 9 RepliesCamry 2012+ :: Connect Map Lights In The Way So They Both Turn On When Doors Open
Tried finding any possible way to connect the map lights to the done so they both turn on when doors open...??? I have a se with no sunroof.
View 5 RepliesCamry 2012+ :: 2014 - JBL Stereo Takes Too Much Time To Connect
I have the jbl stereo and when I start the car it literally takes 2 solid minutes or so to connect sometimes i have to turn the radio off and then back on to get it to connect always has done it. Tried with other phones also i use a iphone 6.
View 7 RepliesCamry :: 2004 - Ignition Coil Connector Broke - Connect Directly?
I replaced my valve cover gasket yesterday on my 2004 Camry. While putting back together, three of the tabs on the connectors for the ignition coil harness snapped off and would not stay together because of tension on the harness. I tried to zip tie them because I read that in another forum post but the clips (alligator clips?) inside the connector did not seem to be making contact with connector on top of ignition coil. The car was mis-firing and running very rough.
After much frustration, I finally removed the wires with the alligator clips from inside the connector and plugged them directly into the top of the ignition coil. Well, the car started and seems to be running/idling fine although now the Check Engine Light is on. Also, I have not driven car yet.
My question: Can I drive the car like this or will the vibration from the engine eventually loosen the connections. I am planning on ordering the connectors but they will not be in for a few days and I need to drive the car.
Camry :: 2006 - Little Keeper Clips Broken On Connector Plugs That Connect To Coil Packs
Changed the spark plugs on my 2006 Camry today. Everything went smoothly and quickly except for the fact that I broke all the little keeper clips on the connector plugs that connect to the coil packs. I called my Toyota dealers and one said I had to replace the entire wire harness. The other found the connector plugs for around $8 each. Will the broken clips be a problem with the connectors eventually coming off from vibration if I don't replace them? I'm not sure how to replace the connectors if I go that route. How to go about replacing the connector plugs?
View 7 RepliesGolf IV R32 :: DEQ Can't Connect To ECU Of Car
So picked my .:R up last week from out of state. Go to register it yesterday and find out DEQ can't connect to the car's ECU. So then I took it to my local VW shop and the owner couldn't get the car to connect using VCDS. My immediate thought is, I wonder if he swapped the stereo at one point OR a fuse was blown. Contacted the previous owner and he told me he never messed with the radio on the car, he left it stock (just like the rest of the car - in immaculate condition) and that he had plugged it in last summer and it worked fine then - the last time he used the OBDII port. Today after work I get home and checked every fuse on the drivers side panel of the dash, by pulling each one out and inspecting. Every fuse was good, not one blown fuse.
Still I'm having issues connecting to the ECU... not linked to the K-wire? My buddy and I pulled the deck out on Monday night, and the previous owner had the OEM 30-pin ipod interface installed and it looks like they tapped a few wires on the factory harness. That interface pigtail replaces the factory pig tail for the changer if equipped in the rear, and goes in the big connector in the back of the OEM deck..
Prius (Gen 2) :: CEL And Triangle Are On / Can't Connect OBD II
I am unable to connect to a 2005 Prius. I have an Actron CP9190/CP9185 Elite Autoscanner. I have used it many times on other cars and many other Prii but it won't connect to this particular car. ( I have a small car lot and keep 8-12 2004-2009 Prii in inventory) I tried 3 other Prii that I have on my lot and they connect immediately and power up but this one won't.
When I first got this car in it had some lights on and I hooked it up and it worked intermittently. I had to hold the connection just right or I would lose connection. This car had some aftermarket Bluetooth or GPS system that was removed before they traded it and I had my mechanic remove the bird's nest of wires next to the OBD connector that weren't connected to anything. This was about a month ago. This car is a 2005 with 129k.
I had the battery rebuilt before I sold it. The new owner has put over 2000 miles on it since. Now the CEL and triangle are on again and I am trying to see what the codes are but can't connect. Is there a fuse that powers the connector? or is one of the pins a power supply?
Passat (B5) :: Car Won't Connect To Any Scanner
I tried connecting to my 99 1.8 Turbo passat with VAG COM, some tool from equu, some other tool from snap-on . All of them are unable to connect (to any module).
View 3 RepliesPassat (B5) :: How To Connect IPod
How do you connect your Ipod? New deck, cable, or wireless?
View 24 RepliesPrius (Gen 1) :: Code Goes Blank / Refuse To Connect
It has the typical Triangle of death, brake light, check engine in the dash, along with the PS, main battery and exclamation on the main screen.
The car won't start. 12V battery is newer.
when I try to check the codes on both my scanners, they go wacko. One refuses to connect and the other goes blank, so I can't get any codes.
Lexus SC430 :: Possible To Connect IPhone To Nav Screen
I was just wondering if it is possible to connect iphone to the Nav screen in a 2002 sc430. Can the VaisTech do this?
View 5 RepliesLexus ES 2013+ :: IPhone 6 Won't Connect Without Restarting
Occasionally when I start my car my phone won't connect and the only way to get a connection is to restart the car. Trying to connect through the system doesn't work.
Sometimes I have to restart the car several times to get a connection.
The phone is an iPhone 6.
Gen 3 Prius (Audio/Electronics) :: IPhone 5 Won't Connect Through USB
iPhone 5 won't connect through USB
View 3 RepliesPrius (2010-12) :: How To Disable Safety Connect
I don't like the idea of Safety Connect, and already have AAA membership. How can I disable Safety Connect? I'm only a few months into a trial membership, do I call toyota to cancel? Or can I just disconnect some fuse?
View 9 RepliesElantra GD (2013+) :: Phone Doesn't Connect On Its Own
My Galaxy S3 would auto connect every time I got in the car; good thing since it was in a holster on my belt. Now I have a Galaxy Note 3 and it's paired to the Elantra but it doesn't connect on it's own. You have to touch "Elantra paired" then it says "connecting" and does. I don't see any settings on the phone that are different. I don't like to have to take it off my belt then out of the holster and manually connect every time.
View 15 RepliesGolf IV R32 :: How To Connect IPod To Stock Stereo
what do i need to start playing my ipod on the stock monsoon stereo? I am looking to charge and play at the same time, what do I need?
View 24 RepliesPassat (B6) :: 2008 - How To Connect IPod To 3.5 Mm Jack
I have a 2008 Passat Lux with an ipod dock in my glove compartment which I would like to turn into an aux input if possible. There is no AUX input under my hand-rest so the ipod connector in my glove compartment seems to be the only way for me to listen to my music from my phone in the car. I have found several cables that convert IPod to 3.5mm jack (and hopeful vice-versa?) Will this work somehow or am I stuck with the ipod connector without any aux input?
[URL].........
Prius Plug-in 2012-15 :: How To Connect EVSE Without Charging
How to connect the EVSE without charging? I'm planning to be away for a couple of days and I want to leave it plugged in but keeping the battery empty. Then I want to start the charging remotely so that when I get back, I can immediately drive off with a full charge. Unfortunately, I haven't been able to figure out a way to connect the EVSE w/o charging.
View 7 RepliesGen 2 Prius :: TS Connects To Cable, Vehicle Shows Cannot Connect To VIM
I have one of the versions of TS and Mini VCI. I've been trying to get this to work for weeks. I've uninstalled, then reinstalled the driver and the software about a dozen times. Figured it must be a faulty cable. So I ordered another cable(BTW, the first cable is an X-Horse, the second cable is a Mongoose.) Same result with the second cable.
I have the X-Horse firmware updater tool installed, so I can check that the cable is indeed recognised by and connected to the computer. When I launch TS, I check the setup, and can see that TS recognises and is connected to the cable. But when I try to connect to vehicle, I get the "Cannot connect to VIM" error.