Camry 2012+ :: How To Reverse Polarity While Wires In Connector
I bought new HID bulbs from TRS but how do I reverse polarity while wires in connector. How do I remove it?!
View 14 RepliesCamry 2012+ :: LED Daytime Running Lights Wires - ACC?
I got my LED DRL kit today, the harness has 3 wires red(+), black(-), and white(for connect to (+) of headlight so when headlight on the drl will go off). So I will connect black wire to negative of battery or ground, red wire to ACC or ign. So my question is how can I find ACC and how can I connect white wire to (+) of headlights? My led drl kit is similar with the kit in the link: [URL] ...
View 1 RepliesCamry 2012+ :: JBL System - Which Harness Is For Speaker Wires
i have a 2012 toyota camry with the 10 speaker JBL system, i am trying to find which harness is the one for the speaker wires. i saw on youtube it says there are two sockets for the speaker wires (one for rear and one for the front) i think this is for the regular radio.
I don't see that on my camry. There is one long socket though, but there's TWO wires of red, and two of purple, so I don't know which one to go with.
Camry 2012+ :: Unused Door Plugs / Wires?
While I was installing my side mirror turn signals I noticed there were two plugs tucked away in plastic not connected to anything. One is towards the outside of the door. As if it was to be connected to the door handle sensor that comes with the push button start package. The other one was towards the inside of the door, as if it is used with the lane assist or even side mirror turn signals. I never really messed with them as I was following the DYI. I should've checked to see if they were wired to the turn signals so I wouldn't have had to run the wires all the way to the fuse block. Below are the pictures of what I'm talking about.
Front/Inside of door
Rear/Outside of door
Camry 2012+ :: Connect Map Lights In The Way So They Both Turn On When Doors Open
Tried finding any possible way to connect the map lights to the done so they both turn on when doors open...??? I have a se with no sunroof.
View 5 RepliesCamry 2012+ :: 2014 - JBL Stereo Takes Too Much Time To Connect
I have the jbl stereo and when I start the car it literally takes 2 solid minutes or so to connect sometimes i have to turn the radio off and then back on to get it to connect always has done it. Tried with other phones also i use a iphone 6.
View 7 RepliesCamry 2012+ :: Fog Lights HID Installation On 2013 SE
I just bought HID for my fog lights. I was looking all over the internet for how to install them, but i couldn't find any. I have a 2013 Camry SE. It came with stock fog lights. Also there is a lip cover on the bottom of my bumper. I was wondering how to install HID fog lights successfully?
View 4 RepliesCamry 2012+ :: OEM QI Charger Installation Into 2015 XLE
Who has installed the OEM Qi charger into their 2015 XLE yet? My phone has it, so I am looking to do this when I can find the parts.
View 14 RepliesCamry 2012+ :: Installation Of Entune System With Navigation
I have a 2012 Camry SE. I want to get the navigation in my car. Anything specific I need to be aware of to get the Entune stereo with navigation?
View 2 RepliesCamry 2012+ :: After Installation Of DDM HID Kit Passenger Side Didn't Come On?
I installed a DDM HID Kit for about two weeks week this morning the passenger side didn't come on. I have to turn off the light and turn it back on for the passenger side to come on and went it did it was slowly turning on took like 15 second to fully turn on. I have a relay harness. Do I have a bad bulb or a ballast should i try switching the bulbs?
View 9 RepliesCamry 2012+ :: Intuitive Parking Assist Installation In 2015 XLE
How to install the Toyota Intuitive Parking Assist system in a US 2015 Camry XLE? Apparently, this system is sold with the 2015 Camrys elsewhere (I checked in TIS, and it is included in the 2015 Camry service manual), but not in the US.
I would dearly love to have this system in my car, because I find it difficult to judge how close I am in front to another car or other obstacle.
Prius Plug-in 2012-15 :: How To Connect EVSE Without Charging
How to connect the EVSE without charging? I'm planning to be away for a couple of days and I want to leave it plugged in but keeping the battery empty. Then I want to start the charging remotely so that when I get back, I can immediately drive off with a full charge. Unfortunately, I haven't been able to figure out a way to connect the EVSE w/o charging.
View 7 RepliesPrius (Gen 3) :: How To Connect Power Inverter To 2012 Vehicle
I'm looking to run a refrigerator, a laptop and a lamp during a power outage. What inverter I would need and how to connect it.
View 10 RepliesPrius Plug-in 2012-15 :: Safety Connect Doesn't Work When Car Is Off?
I thought I would start a new thread on this issue. I recently had my car lose power and all warning lights on, I was able to coast to the shoulder and once safe I turned the car off, hoping that cycling the power would fix this odd problem. No such luck, the car was completely dead and unresponsive except for the door locks and the hazard lights.
So I hit the "SOS" safety connect button to get someone to come tow me. NO luck -- oops, I guess the car is *really* dead. I had my cell phone and the rest of the story is in another post.
Now here is my question: Is Safety Connect supposed to work when the car is off? It seems way less useful in case of an accident or malfunction if I can only call if I can turn the car on.
Camry :: How To Connect Amp To Eonon D5106 HU
How to connect an amp to Eonon d5106 HU. The amp wiring kit I have is this one: [URL]…..
Now, I've managed to route the amp wires from the battery to the amp. Also routed the RCA and the power remote wire. I just don't know where I plug the RCA cable and the remote turn on lead.
Heres a pic of what the back of my HU looks like: (Its the middle pic)
Some guy was telling me to get a multi meter and check the power cable to find out which wire is putting out 12V. Once I find that I can just splice the wire and connect the remote wire to the wire putting out 12V.
Camry :: 2010 / 2.5L - Where To Find The ECU Wires
Where is "Plug A" and "Plug B". Is it near the OBD port or behind the controls for the A/C, etc? I will be splicing in a URD MAF calibrator.
View 3 RepliesCamry :: How To Wire The RCA And The Remote Wires To Headunit
I have a 2004 camry LE with a stock factory head unit. I recently bought 2 10" Kicker CVR subs with 300w rms each and a 1000w rms class D hifonics amp. I also have a wiring kit and was wondering on how to wire the RCA and the remote wires to my headunit. The ground wire and the power cable are already installed and those were easy. The only thing i do not know how to do is install the RCA cable and remote wire to the headunit. I know it requires an in line converter and i have one,.
View 7 RepliesCamry :: Unable To Find 2005 Plug Wires?
My 2005 Camry LE four cylinder is past due for plug wires. I have tried Googling the correct part number for either NGK or Denso. The newest ones I can find are from 2001. What are the proper part numbers? My local parts store claims NGK and Denso does not make them for my car. I have a hard time believing they don't make plug wires for my car. If nothing else what is the correct Toyota part number?
View 3 RepliesCamry :: XM Antenna - How To Get Wires Through The Trunk And Into Back Seat On 07 XLE
I mounted my XM antenna and got in around the window rubber into the trunk. I then pulled the side panel and went in thru what I think is what the dealer told me a pass thru hole. There is a triangle shaped hole that lines up with the center of the rear headrest, I rolled up my wires and put them thru.
I can't feel the wires when I shove my hand thru the crack in the upper/lower rear seat, so I assume that I need to pull the rear seat bottom. I did a search and saw to push in and pull up on the seat base, so far no good. The outer corner of the seat is pretty loose, but nothing gives me access to the wires that I shoved thru.