Santa FE SM (2001-06) :: 2004 - Hard Thump When Shifting From Reverse Into Drive
Recently my 2004 Santa Fe 2.7 AWD (~86k miles) has started to give a sort of hard thump when shifting from reverse into drive. It's fine going into any other gears and it shifts up and down normally. If I shift from reverse to neutral and then to drive it's fine.
I changed the transmission fluid when we first got the car at 40K miles with Hyundai Liquid Unobtanium SPiii fluid and again at 80k miles with Valvoline's SPiii offering. I just checked the transmission fluid level and it's within the normal range.
I can't tell if this is just drive-line slop or something else inside the tranny.
Golf IV R32 :: Hard To Get In Reverse And Shifting From 1st To 2nd Is Very Rough
Lately my R is acting up, sometimes hard to get in reverse and shifting from 1st to 2nd is very rough. I looked at the cables , the left one towards the engine , the rubber bushings seems to be broken, lots of wiggle in there, is that enough to cause this? Is there any adjustments needed on the cables anyways?
View 9 RepliesGolf/GTI VI :: Hard Shifting Into Reverse When Transmission Is Cold
Noticed that the transmission is cold (ie. sits overnight) it is hard, sometimes impossible, to shift into reverse. Specs on my gti: 14k miles, pretty much stock, manual trans...
View 1 RepliesFord Transmission :: Hard Shift And Clunk When Shifting To Reverse
I just recently bought a 95 F150 with a 351. The truck has high mileage, about 190k, and I am not sure how long the transmission has left. It rides smooth down the road, but when I put the truck into reverse it hesitates for a moment then makes a loud clunking sound(as if a door is being slammed) and then jerks into gear. The reverse works great at the moment though. Should I be worried, is there anything I can do to fix this?
View 11 RepliesAccent LC (2000-05) :: Overheating Constantly - Car Won't Go In Reverse And Has Hard Time Shifting Sometimes
I have a 2003 Accent and it has been over heating constantly for about 5 months. After it started, we replaced the main radiator hose, thermostat, radiator cap AND a head and head gasket. It worked for about 2 weeks and then over heated again. It seems like there is too much pressure somewhere because the lid for my reservoir shoots off and all the coolant comes out. I'm just not sure where to look for a clog since it is coming out of the reservoir. It also recently started having transmission problems(?) or that is what I think it is... It won't go in reverse and has a hard time shifting sometimes. I'm not sure if it could be related or if it is the tranny also.
View 4 RepliesHonda - Fit :: 2008 - Knocking Noise In Engine / Hard Time Shifting Into Reverse
[URL] .... My engine has been making this sound for a while now I am at 125000 miles, what it could be and if i need to be worried about it? also, possibly unrelated, it has a SUPER hard time shifting into reverse, it gets stuck and it feels just super sticky shifting in and out of reverse. Sometimes I can't even get it to go into reverse without letting the car roll a bit. Also, at around 3k rpm the engine sounds a little grinder in any gear. 2008 Honda Fit Sport ...
View 19 RepliesToyota - Echo :: Clunks Into Gear When Driving And Lurches While Shifting
Car starts normally sometimes. Other times it will not start at all (it sounds like the battery is dead) or it will struggle to start and once it does start the electronics in the car seem to not be getting any power.
While driving the car “clunks” into gear and the car lurches while shifting.
Background: I was driving down the freeway and then suddenly, it seemed as I was in forced into neutral. Immediately got off the freeway and examined the situation. The situation was I no longer had reverse, drive or overdrive. I had gears 1 and 2 though.
Brought the car to the local mechanic and had a used transmission installed. After installing the transmission, the car now lurches when it goes into gear, especially when it goes into drive (around 45 mph). The plan was to bring it back to the mechanic as soon as I would have time, however before that happened, my car started to struggle to start. Finally the battery died completely and I had to jump start it. After that it got a little more strange… sometimes I would have to jump start it, sometimes it would start fine, and sometimes it would start, but the car would not have enough electric power to power all the electronics in the car fully. The headlights would be dim, the interior lights would be dim, etc… Oddly enough, I could let the car sit for 30 minutes and it would start normally again.
Before bringing it back to the mechanic I would like to be more informed as to what could possibly be going on. Do I just need a new battery and all will be fine with starting? And the fact the trouble with starting is only coincidental with bringing it to the mechanic? (Note, the battery did die while it was at the mechanic). And what should I make of the transmission problem, do they need to install a different one?
Ford 6.7L Power Stroke Diesel :: 6r140 - Transmission Slams Hard Into Reverse / Shifting From 1 To 3 Is Awful
I'm having problems with my 6r140 in my 2011, the truck is an early build around 8/2010 I believe.
After cold soak when shifting into reverse after allowing engine to warm a bit the transmission almost always slams hard into reverse.
After that shifting from 1-3 is awful, the transmission will try to go into 3rd but downshift to 1st then fail to go back into 3rd multiple times. This situation is extremely dangerous when trying to pull into traffic.
Oh and once the transmission gets into 3rd it will skip 4th and go right into 5th. There is only 94k miles on this transmission/truck.
I just bought this truck about a month ago, does this sound like an issue with the solenoids in the valve body?
I'm very mechanically inclined and can swap them if need be but now we're talking few hundred in solenoids and then getting the trucks pcm flashed right?
Also fluid has been changed and I used mercon lv.
Tiguan :: Transmission Clunks When Moving From Park To Reverse
We brought our 09 SEL 4motion in for service (10K) and i had them look into a clunk when moving from Park to Reverse, it doesn't happen all the time and seems more common in the morning. It almost feels to me that the transmission is trying to engage too fast, like I'm hitting the gas and putting it into reverse. Anyway is this something that has popped up?
Also, they drove the car 40 miles for a 10k service which all I asked was about the terrible Sirius sound quality and that it "links" way too much. XM never seemed to do this in rentals I've had, nor sounded as bad (like a crappy internet MP3).
So I called and their answer is sort of acceptable that they feel they don't drive the cars enough to get the problem to occur, which in the times I've had problems with other car that required driving they didn't, but 40 miles to check the radio? And since it wasn't driven nicely the wife and I noticed the gas was very low.
Ford Transmission :: Clunks When Going Into Reverse Or Drive But Only When Warm
I have a stock 1986 Bronco with a 351w/C6 and towing package. Recently it has started doing some things differently. It clunks when going into reverse or drive, but only when warm. It makes a weird clicking noise at low speeds. There is a severe vibration at around 60 mph when under power, but it goes away when I let off the throttle
This started in the last 500 miles or so of a 3000 miles move across the country. How do I go about diagnosing what exactly is wrong with this? I'm not having much luck with finding others who have had these same symptoms.
Ford - Explorer :: 2006 - Shifting Hard Into Reverse At First Then Stuck In High Gear Or Slipping - OBD2 Codes
Tranny started acting funny recently...shifting hard into reverse at first, then last night it was like it was stuck in high gear or slipping on the way home. Limped it home and took the following codes:
P0743 TORQUE CONVERTER CIRCUIT ELECTRICAL
P0750 SHIFT SOLENOID A MALFUNCTION
P0755 SHIFT SOLENOID B MALFUNCTION
P0760 SHIFT SOLENOID C MALFUNCTION
P0765 SHIFT SOLENOID D MALFUNCTION
P0962 PRESSURE CONTROL SOLENOID A CONTROL CIRCUIT LOW
P0966 PRESSURE CONTROL SOLENOID B CONTROL CIRCUIT LOW
P0970 PRESSURE CONTROL SOLENOID C CONTROL CIRCTUT LOW
Camry 2012+ :: Shifting From Reverse To Drive
Whats the right way to shift the car, when I reverse the car and want to change it drive D, should car be at complete stop OR we can still change it from R to P with with car slowly moving back. I usually apply brake, and let it complete stop, then change the gear shifter. But yesterday I was in hurry and didn't wait for the stop, car was very slow, but I didn't notice any jerks or anything wrong with it.
View 5 RepliesAvalon 2005-12 :: 2007 - Tansmission Clunks Hard Into Low Gear
I'm not impressed with our 2007 Toyota Avalon XL with 65K miles that we bought from my parents 2 years ago with less than 40K miles. It's on it's 3rd set of tires, 3rd set of front brakes, it has a left front clunk that nobody can find, we just replaced the 3 rear coil packs and 6 spark plugs and now the transmission is not shifting properly. It is most noticeable when you come to a stop after driving at a moderate RPM.
The transmission clunks hard into low gear. Other times it will not downshift if you are coming down a long hill. I've checked the fluid level and it is good.
Camry :: 2002 - Loud / Brief Rattle When Shifting From Park To Drive / Reverse
2002 Camry, Automatic Transmission
Have an occasional problem. When shifting from park to drive/reverse, I occasionally get a loud, brief (1 -2 seconds) rattling noise from the engine compartment. It's my daughter's car so not sure yet if this is a cold start only issue or if present after car has been driven, then stopped and re-started. The problem does only occur occasionally. Where to start troubleshooting? I've looked for loose external pasts with nothing found.
Camry :: 2010 Manual Transmission - Hard Shifting Into 2nd Gear
Just curious if there are any other 2010 owners with any difficulty shifting gears in their manual transmission camrys? I noticed during my test drive that I grinded my way into 2nd once... I thought it might have just been my nervousness with a new clutch at the time. However, I've since put 300 miles on the car and I still have trouble putting it into second gear on a daily basis. Sometimes it grinds a bit, and sometimes it catches or a half second before it pops in. All the gears OTHER than 2nd gear go in like butter as you would expect with a new transmission. I'm not new to a clutch... this is at least my 4th car with a stick, so I don't think I'm doing anything out of the ordinary when shifting.
It reminds me of some older (100,000+ mile Nissan) cars I've had in the past... the syncromesh was wearing out and it would grind going into second or third, so I put in some RedLine MTL and got a little more life out of the transmission... but there shouldn't be a need for that kind of thing on a car with less than 1000 miles on it?!
Camry 2012+ :: Hard To Shift Car From Park To Reverse
I am planning to buy this 2012 Camry LE (38k), automatic, I am on the test run and realized that the car's shifting from park to reverse is harder than shifting from reverse to drive. What I mean is, it is really hard to move the selector from Park to Reverse.
View 6 RepliesCamry 2012+ :: Toyota SE V6 / Occasional Hard Shift From Park To Reverse?
My 2012 Toyota Camry SE V6. 37,500 miles. Occasionally when I'm parked shifting down to reverse it's so tight/put effort to shift & it literally thumps the entire car.. I heard to put the E-BRAKE/PARKING BRAKE down BEFORE shifting it to park & it worked but occasionally even with the E-BRAKE/PARKING BRAKE it still jerks the entire car going from PARK to REVERSE.
Also going from REVERSE to NEUTRAL it gives off a little vibration underneath me ALL THE TIME going from REVERSE to NEUTRAL.. I know these are so many questions that are probably a no-brainer answer but I'm looking to see if any one here had/has or heard of a similar or exact problem. Is the trans fluid low or dirty? I saw the CARFAX I didn't see the services he's done it's only been 1 owner on this car I'm the second. Previous owner leased it brand new.
Subaru - Forester :: 2004 - Hard Shifting Into Gears
My 2004 Forester (73000 miles) with 5-speed manual, is sometimes hard shifting into gears. The Subaru agency says that there's 'not much left' on the clutch and I need a new clutch @ $1300. Does hard shifting , no clutch slipping, indicate new clutch is necessary?
View 5 RepliesToyota - Sienna :: 2004 - Code P0793 / Hard Shifting Between 2nd And 3rd Gear In Traffic
I have a 2004 Sienna LE with 169,500 miles. It started to shift hard between 2nd and 3rd gear in traffic (it had previously never had ANY hard shifting). A few minutes later the CEL came on along with the VSC and Traction Control lights. Both Advance Auto and a Toyota dealer confirmed that the codes showed the speed sensors on the rear wheels (both sides) were bad. The Toyota dealer also declared that the low gear solenoid in the transmission was bad and the transmission would need to be replaced soon. I found it strange that the transmission started shifting hard at the exact same time the speed sensors went bad. Is it possible that simply replacing the speed sensors would fix my hard shifting issue? I am a shade tree mechanic that does brake work and other intermediate tasks. Is speed sensor replacement an easy job on this Sienna?
View 6 Replies