Accent MC (2006-11) :: Clutch Gone Out - Bearing Noise
My daughter was driving to work a couple of nights ago and ran over what she thought was a 2x4 blowing out the R/F tire. The next morning we got a new tire put on. She drive it back to work and when she came home, she said the engine was making a funny noise when she pushed the clutch in. I opened the hood and had her start it. No funny noises. I then had her push the clutch in and as soon as the hydraulic cylinder started to move out, I could hear a bearing noise which I attributed to the throw out bearing. I figured I would need to be putting in a new clutch soon and wondered why I hadn't done it when we put the new engine in last year. The next night, she called me from work and said the clutch didn't work and she coasted into her parking lot space at work. She said she tried to shift it into gear but it wouldn't, either with the engine running or not running. We put it on a trailer and towed it home. I think the running over the board and the possibility of the throw out bearing is just a coincidence but ???? The clutch cylinder does push the rod and throw out bearing fork forward but now no noise. Total failure of the T/O bearing??? This car has really been a test of my patience and wallet.
View 3 RepliesAccent MC (2006-11) :: Whirring Noise That Goes Away When Clutch Is Down
2007 Accent with 86k miles. It's not very noisy but sounds a bit sick. It seems to shift fine.
I checked engine oil and the manual transaxle oil. Do I need a new clutch?
Thunderbird :: High Pitched Squeal Coming From Front Of AC Compressor Whenever Clutch Engages
A high pitched squeal appears to come from the front of the a/c compressor whenever the clutch engages. When the clutch disengages the compressor stops spinning, and the squeal stops. I can watch and listen to this as the system cycles with the a/c switched on. If I turn off the a/c, no squeal. I'm guessing the bearings in the compressor are going out. However, the system still cools normally, so apparently no gas has leaked out.
Does this imply the compressor must be replaced, or could injection of some oil into the system possibly fix it...?
This car only has 73,000 miles on it. I've owned 2 other TB's and a couple classic Mustangs with much higher miles and never seen an a/c compressor bearings fail.
Accent MC (2006-11) :: Clutch Slipping / Revs High While In Gear Without Accelerating Especially In 5th Gear
I've got a 07 accent with 90k miles on it. It has recently started slipping some (revs high, while in gear, without accelerating, especially in 5th gear). It also can be physically hard to move the shifter into gear sometimes (with my hand).
So, does this mean I need a new clutch? Or are there other possibilities? Should I replace/fix anything with the clutch? Sounds like the flywheel should be resurfaced? Will it shift more smoothly after the fix?
Is this something a newb could do himself? I can change the oil, rotate tires. Outside of that I haven't done much. My toolset for now is fairly limited: two jackstands, a trolley jack, torque-wrench and ratchet sets.
Golf/GTI VI :: Engine Revs High On Startup And Release Clutch Noise
I have a MT '12 Golf 2.5L with around 8k miles. I always park with the transmission in neutral. When I first start it up in the morning, the engine revs high, around 1500RPM, so I can clearly hear the engine inside the car. I start it, it revs up and holds, and when I release the clutch I hear what sounds like a rev, but the tach doesn't move.
I believe the GTI doesn't need the clutch depressed for the entire turn over, but the Golf does, so I have to hold it until the engine is running. It may not be a big deal, but I'm just wondering why releasing the clutch in neutral would make a noise. I don't hear it any other time than at start up.
Accent MC (2006-11) :: 2007 - High Pitched Screeching Sound From Belt
I'm getting a very ugly high pitched screeching sound from my belt when the car has been sitting for 3 hours (cold start), or randomly when I turn my steering wheel. Based on that what does it sound like the problem is?
View 21 RepliesAccent RB (2012+) :: High Pitched Whining Noise?
I got in my car today and realized it was making a whining noise, kinda like the whine of a super charger, I don't hear it at idle but when I accelerate or rev it in neutral it gets louder and higher pitched. Friend had this problem in his Mercedes and he said it was a bad belt.
View 3 RepliesAccent MC (2006-11) :: Clutch Gone - How To Replace It
As the title states my clutch is almost gone , been teaching too many people how to drive 5speed and the other day when my girl was driving she burned it real hard and now I can totally notice its engaging very late..
My question is : We just put a stage 1 every clutch in the rx7 and it was amazing but they only make a OEM replacement.
Accent MC (2006-11) :: Noisy Clutch And Brakes
I am getting a lot of noise from the clutch and brakes on my 2008 accent.
First the clutch: the noise is coming from the clutch release cylinder under the hood, at the front of the engine bay. I've tried lubing the cylinder, but it didn't work. Is there something else I can try, or do I need to replace the release cylinder to get back to a quiet clutch? Would a rebuild work? Is it even possible to get a kit to rebuild a clutch release cylinder?
I checked the hmaservice website, but the troubleshooting didn't have any mention of the clutch noise. I've seen plenty of references online to people having similar problems, but I haven't found any specific solutions (besides the standard "take it in and get it fixed" response). I'd love to take care of this problem without going to a garage.
That's been going on for a while, but the brake noise is new. It's a squeak noise that happens only as I release the brakes when the car is standing still. It's fairly quiet now, but I want to make sure that it's not going to lead into a bigger problem down the road.
I've done plenty of disc brakes in the past, but I've never worked on drums before. I'm not even sure if the noise is coming from one brake or all four. My best guess is that it might be the caliper pins that need to be lubed, but that's a complete shot in the dark guess...
What should I be looking for when I try to diagnose and solve this annoying noise. Is it something typical that happens with drums?
Accent MC (2006-11) :: Clutch Engages When The Pedal Is Right At The Top
Just bought a 2009 Accent 5 speed I have 2500 miles on it .The clutch engages when the pedal is right at the top. Is there an adjustment on this vehicle I would prefer it to engage about mid stroke.
View 9 RepliesAccent MC (2006-11) :: Clutch Slipping - Car Will Randomly Seem To Stutter
2010 with 85k miles.
My car will randomly seem to stutter, almost like a very quick cut of power or skip, sometimes multiple times in a row. I feel like it may be the clutch slipping. It happens only at lower rpms (that I've noticed), and in any gear. When it skips, I don't see the tach jump at all and I have no cel. Are there any tests i can do? The car will move from a full stop to rolling just under the power of idle, I don't know if that means anything.
Accent MC (2006-11) :: 2009 - Squeaking Clutch When Depressed
2009 Accent 5 speed 66K miles. This is something which I recently noticed with the onset of winter. When I depress the clutch pedal, I have a very audible squeak. Think old door hinge squeak. So metal is rubbing against metal somewhere inside the bellhousing without enough lubrication.....not good. I pulled off the dust boot on the side of the bellhousing and tried my best to push moly grease around the clutch fork stud, hoping that was the origin. The noise went away for roughly a half a day but is back in full force....funny how cars do that.
Space seems EXTREMELY limited on lubricating the proper area. Or....is this a warning mechanism built into the clutch pressure plate assembly to warn of replacement soon? While I am asking these questions, what is a good time to look into replacing the clutch? The parts for the car seem relatively cheap, if I replace the clutch assembly, I may consider replacing the flywheel and clutch hydraulics as well as a whole system replace/refresh.
That aside, is there anyway to eliminate the squeaking without having to crack open the bell housing?
Accent MC (2006-11) :: Shuddering When Pushing The Clutch In At Low Speed
At low speeds before coming to a stop the clutch shudders somewhat when I push it in. When quickly depressing the clutch when coming to a sudden stop....
View 4 RepliesAccent MC (2006-11) :: Clutch Went Out - No Reverse / Goes Into 1st Gear After Lot Of Coaxing And Grinding
Ok, so I got my car at 60k miles, and the clutch went out almost instantly so I had the entire clutch replaced, and it was working just fine until now. It has been 25k miles since I did the full clutch replacement so it shouldn't be messing up again already. It is not going in to reverse at all, it goes in to 1st gear, but only after a lot of coaxing and grinding, and the clutch feels strange. The clutch is too soft (too easy to push down), but after a while it seems to get better.
2007 Hyundai Accent GS
Manual, hatchback
85k miles
Accent MC (2006-11) :: Brake Pedal Won't Depress - Seized Clutch Bearing
2007 Accent pedal won't depress. Bearing making noise for a few months. Is tranny snout toast or is it fixable?
View 2 RepliesAccent RB (2012+) :: Engine Revs When Clutch Depressed
I bought my Hyundai new in late 2011. No problems with the car (other than no spare tire???) until just out of the warranty (63,000). Had a noticeable drop in power on the highway. No warning lights. Drove another 100 miles with power intermittently dropping. Next day engine light comes on. $800 later I have a new high pressure fuel pump. All seems well. after a few weeks, I notice that the car seems to be revving when I depress the clutch to change gears, like up to 4000 rpm's. If I leave the clutch in for a few seconds it will begin to decrease. But if I shift right into gear as I have done for the last 35 years of driving, it is not smooth, jerky. This seems to happen mostly going into 2,3, and 4th gear, always going up. It never happens when downshifting. I tried tapping the brakes when shifting up, and sometimes it does seems to drop the rpm's. What it might be. It probably is related to the work that was done, but I don't really trust the dealer and want to have a little info going in.
View 1 RepliesAccent RB (2012+) :: Creaking Noise On Releasing Clutch Pedal
On releasing the clutch pedal, a creaking noise can be heard, which:
- sounds and feels like a rusty spring being unloaded
- occurs for the entire range of pedal travel, but worse near the bottom
- is louder outside the car than inside
- happens not only when driving, but also when stationary with the engine off
I don't think anything is wrong with the clutch itself, or any bearings, or major components... It just feels like something needs to be lubed. I've lubed the spring above the pedal inside the car, with no real effect.
Accent RB (2012+) :: Engine Revving Itself Higher The Second After Push The Clutch In
Today I started my car (in the garage so it wasn't too cold) and everything was fine. The car warmed up in a couple minutes and I was off.
As i was driving, I noticed that my shifting was horrible. It felt like i was burning the clutch and not releasing the clutch smoothly in general.
I then noticed that when i pressed in the clutch ready to take the next gear, the engine would raise the rpm's about 500-1000 revs before coming down.
I started to wait till the revs came down to shift and that seems to work.
Why would the engine be revving itself higher the second after i push the clutch in. My dealer can't take me until Wednesday so I don't know what to do.
Accent MC (2006-11) :: Constant Chirping / Cricket Sound - Stops When Touch Clutch Even Slightly
Had the car for less than a week and I'm getting a constant chirping/cricket sound, the moment I touch the clutch even slightly it stops. Sound is gone when clutch is touched in any way or engaged. My first thought is Throw Out Bearing, or perhaps pilot bearing?
2010 GL Sport model.