Accent LC (2000-05) :: 2001 GL Started Revving When Driving During Traffic Hour - Transmission Slipping?
I have a 2001 Accent GL 1.6L Automatic.
Yesterday it started acting up on the freeway. I was driving about 50 during traffic hour when it started revving. I got off the freeway and moved to 35mph on surface streets, the revving continued at lower speeds but much worse (4-5k rpms going 10-15mpg). Doesn't seem to do it in idle or park. If i shut the car off it'll drive fine for a while then start acting up but when I was driving, after awhile, it did return to normal.
What could cause the problem? TPS? Transmission? Sensor of some sort?
Accent LC (2000-05) :: 2004 - Automatic Transmission All Of A Sudden Started Slipping While Driving
My 2004 Accent transmission with 145k miles all of a sudden started slipping while driving. It would be fine until i needed to slow down and then step on the gas again. It wouldn't catch right and it would slip. At first the pull of the slip was very slight and at times now it is very rough. My check engine light does not turn on when it slips slightly, but only when it has a really rough slip will it turn on. I had it checked at the local advance auto parts and i was told it has a 4th gear ratio that is off. The only thing that confuses me is that when i turn the car off and on it resets and works fine, that is until it slips again. If i drive carefully it usually wont slip. Could it be an electrical problem?? I changed my speed sensor when my car had about 132k miles because it went out, i replaced my ignition coils, new spark plugs/wires, tranny oil change, and filter change.
View 2 RepliesSubaru - Impreza - Transmissions :: Clutch Started Slipping / No Power / Engine Revving Up
I'll start out by stating that I failed to get new transmission fluid, which definitely caused the issue. So let's go back to December 26th. Check engine light came on, and I assumed it was for the oil (which has never happened before, suspicious). So I changed the oil, and took it for a test spin. Well, a mile later, I was going up a hill, and the clutch started slipping. Yes, I know, it's an auto, but I know the feeling of a clutch slipping... no power, engine revving up, jolting forward when slip stops. At this point, I drive it home without much incident, a few slips and I part it but don't drive it again. Checked the engine, and transmission fluid was out. Filled it back up, seemed to take care of the problem of slipping, but now there's a new problem...
The new problem is the following. Every once in a while, going uphill or applying full power in first gear, the clutch will slip. Also, this happens 99% of the time, first gear to second gear is a bit of a jolt, not much more than normal, but it's noticeable. And the transmission is kind of loud too, first gear sometimes sounds like there's a marble in there. Is this a rebuild? Will it work itself out?
F Series :: Truck Started Slipping Gears
I was driving home from work and out of the blue my truck started slipping gears so wen I got home I looked under my truck at the transmission and drive shaft and from the picture I attached that is what I saw...
View 4 RepliesMitsubishi - Galant :: Revving Engine / RPMs Started To Pulse Up And Down
On my way to the grocery store my car's RPMs started to pulse up and down (between 1 and 2) when driving. While stopped at the red light it would vibrate very hard. When i put it in park the RPMs would rise fast before i shut it off. It did the same things on the way back home plus the check engine light came on. A few hours later i put a little oil in it and drove it around my neighborhood and it didn't do any of the things it did that morning.
View 5 RepliesFord Ranger / B-Series :: Started Revving Real High (about 4000 RPMs) And Getting No Power (20 MPH)
Two days ago, I was driving on a North GA steep, windy, mountain road in my 2002 v6 4.0 Ranger. All of a sudden, i started revving real high (about 4000rpms) and getting no power (20mph). I pulled over immediately and transmission fluid was pouring, by the quart, out of my truck. I didnt get to look exactly where it was coming from, since i backed away once i saw a small flame coming from the leak. i then called a tow truck (assuming it was a seal or a hose break) and had it towed to my house.
I started investigating the possible problems and didn't really see anything noticeable under the truck (not that I was expecting to). So what I did was put three quarts of transmission fluid in the dipstick hole and put in gear to see if I could spot a leak. nothing. then I drove it around the block to get it warmed up and put a little pressure on the transmission by driving up a semi-steep hill to see if that would spark the leak again. still no sign of the a leak.
And finally, when I went to go check the dipstick after my test drive, it read to be above the cross hatched area, hence being overfull. What my next step should be?
Accent LC (2000-05) :: 2000 - Misfiring Upon Acceleration And Engine Revving
I have a 2000 accent. Automatic tranny with 167000 miles. My current problem is the car is misfiring upon acceleration and engine revving. I have to accelerate very slowly to minimize this but i once the engine revs up enough I can give it more gas and it will rev normally with plenty of power. I have had to unplug the maf to keep it driveable. Ive never had a car stay running after disconnecting the maf so this is strange to me. My accent barely stays running with the maf connected. I just got the car from my dad and he had it fixed and it ran good for awhile with the maf connected so I don't think it is the maf. But the same problem came about and we had to disconnect the maf again. And he cant remember or is not sure what was exactly fixed on the car. I've read up about the purge control valve and havent had a chance to check it out but some of the symptoms fit.
View 21 RepliesGolf/GTI VI :: Rattle Noise From 1800 To 2000 RPMs While Stopped And Revving Engine
Might be a long shot here, but I JUST had this noise/rattle pop up in my '12 GTI 6MT w/ 13k miles.
Turns out I found someone who posted a video with basically the same noise:
Another one:
I hear the same noise while stopped and revving the engine as well as when driving if I let off the throttle and let the RPM's sweep down past the same rev range (1,800-2,000). Sounds like it's coming from the passenger side area.
I'm under warranty so I'm going to take it to the dealership...but I know how they can be with rattles.
Buick - LeSabre :: 1994 - Revving Up To 2000 RPM At Idle When Car Started
My Buick has started acting weird and I've had a hard time figuring out what's going on. As I understand it 94' was the transition year for the OBD1 and OBD2 sensors, therefore auto zone and o'reilly haven't been able to pull codes on my car. It runs off of OBD1 codes but has 16 point OBD2 sensor pins.
Here's the problem: When the car is started it revs up to 2000rpm at idle, when shifted into neutral the rpm jumps up to 3500. In drive and reverse it goes back down to 2000rpm. While driving the car is hard to stop and surges when I take my foot off the break, it also gains speed on flat ground without touching the gas pedal. After driving the car when I put it back in park it revs back up to 3500rpm and is quite noisy.
I've replaced the mass airflow sensor, cleaned out the entire throttle body (there was a little carbon build up but not too bad), replaced all the vacuum hoses(that put a stop to it for about a week), and I'm still having the same problems. I recently replaced the a/c pump because the bearings went bad but I don't think that would cause any problems like this.
I have a very, very slight gasket leak on my valve covers but it's been like that for the last few months and the car was acting fine. The car has done this before but it usually stops after you drive it somewhere. The hotter it's gotten out the more often it started happening and now it's not stopping like it did before.
Accent LC (2000-05) :: 2002 - Engine Revving On Its Own Occasionally
I got a 2002 accent 1.3 si, engine warning light comes on but doesn't seem to affect cars running, no misfires, no stalling, still good acceleration and mpg, occasional engine revving on its own, changed tps sensor and engine revving on its own was worse. Was told by hyundai mechanic to disconnect battery for 30 seconds and if light went out it was either faulty tps sensor or an intermittent non constant fault reading, light did go out for some time but is now back on.
View 1 RepliesAccent LC (2000-05) :: Revving With Poor Acceleration With New Clutch
I have just changed my clutch and machined my flywheel on my 1.5ltr 16v dohc 2000 lc accent. I used all the correct trans fluid and refilled and bled the clutch fluid. It takes of from lights like a new car but if you put your foot down around 40kph it revs out a bit and does so through all gears untill you reach a bit of speed. What is going on?
View 11 RepliesAccent LC (2000-05) :: White Smoke Coming Out Particularly When Revving
I recently changed my Hyundai Accent 2004 rings and top cylinder. a day after I left the mechanic garage, the car started bringing out white smokes particularly when I rev.
View 2 RepliesAccent LC (2000-05) :: 2001 Almost Dies When Let Off Accelerator After Revving
I have replaced the MAF sensor, TPS sensor, and fuel filter. Like the title says...if I rev the engine ...as soon as I let off the accelerator the engine stumbles and almost dies...then settles back down. I initially pulled codes PO121 so I replaced the TPS. PO103 so I replaced the MAF sensor. PO112..did not address directly as I assumed the MAF was causing. PO1123...again I hoped the parts I replaced would solve the problem. Initially the engine would just drop out while driving just for an instant and then be fine...also I had the 4 codes mentioned above. The only code that has returned is the PO121. I just got done replacing the fuel filter and things seem to be worse.
View 1 RepliesHonda - Fit :: 2008 - Transmission Is Slipping Between 2000 And 25000 RPMs
I'm the original owner of a 2008 Honda Fit Sport, Manual Transmission it has 134k miles original clutch. It feels like the transmission is slipping between 2,000 and 2,5000 RPM in 3rd,4th, and 5th gear. If I set it on cruise control with the RPM's between 2k~2.5k the car runs smooth and normal, but if I disengage the cruise control and accelerate, the transmission feels like it's slipping between 2k~2.5k RPM. Once it goes above 2,500 RPM the car accelerates normally.
So is this the transmission, the clutch or the engine? The car has been running fine and it suddenly started doing on Friday, my initial thought was that it needed a new clutch, however, the clutch is engaging fine and the feel that the transmission is slipping only occurs in 3rd, 4th and 5th gear between 2k ~ 2.5k RPM
If the transmission is bad, how much does it cost to repair?
Accent LC (2000-05) :: Taking 5 Turns To Start - Engine Noise And Car Revving Itself
I have a 2000 model accent manual trans its just recently clocked 200 000 km I know the car has had problems but they are getting worse. Occasionally I have Problems starting the car in the past but it usually takes no more than 5 turns to get started but this is getting worse the other day it took about 5 min maybe more to get the car started I am guessing my starter motor probably Needs to be changed.
Next problem yesterday after I put a full tank of Premium 98 in the car its starts to rev itself changing the sound and note of the motor running constantly it has done this in the past but not so severely and It only seem to do so after putting petrol Especially when I put fuel From a servo I don't usually go to the car would have stalled more than once but didn't only because I tried to keep the revs up when it sounded like it was gunna die also I am pretty sure my fan was making some weird noises but the car has had no engine Light show and no Overheating.
Celica :: 2000 GT 5 Speed 1zz Toyota Clunking And Started Slipping
I was driving my 2000 celica gt and it started making an awful sound. It was clunking and started slipping. The rpm's held constant but the car was going slower. I had it towed home. I have driven it a few times and the noise is still present once the car was going down the road in third gear and the front wheels locked up and the car screeched to a halt. it can be put into gear and driven at slow speeds. I assume that the transmission has failed. If it is in fact the transmission there is a gt-s with a 6 speed at the local junk yard. From what i read the swap is direct bolt in. Is that true and does the shifter need to be changed?
View 1 RepliesAccent LC (2000-05) :: Transmission Slipping - Code P0734
So I bought a 2000 Hyundai Accent for my 16 year old daughter and the guy sold me a car that has a slipping trans. So I went to the Autozone and had the codes pulled and it was a P0734 code. I replaced the trans fluid and replaced the internal bearing and shim with the 42220LK kit from whatever it takes transmission parts store. Trans still slips. What else or should I just unload it?
View 3 RepliesAccent LC (2000-05) :: Trans Slipping Out Of 5th Gear / Drops Out To Neutral
It does not like to stay in 5th gear, drops out to neutral. 2001 Accent Hatchback. 1.5l 5-speed
The other day it started slipping out of 5th gear on the expressway. Held good for the first 10 to 20 minutes. Afterwards I had to hold it in 5th for it to stay in gear. While holding I noticed it pushed on the shifter when applying throttle, and let up some when I let of the gas.
I inspected the pivots at the transmission. The forward / back bushing was not installed properly by the previous owner. I rigged it up better with a fender washer and cotterpin. It previously had just a pin and the bushing had expanded out. This removed the play from shifting I had previously noticed. It also halfway fixed the popping out of gear. It stays in gear a little longer, and when I put it back into 5th it stays there for a while most of the time.
I have not inspected the lubricant level yet. Where to check next?
Accent LC (2000-05) :: Transmission Won't Engage Gears
own a 2005 Hyundai accent 1.6L engine. I replace the engine today. The previous engine had internal damage. The transmission I left alone. I didn't disconnect the wiring. I only removed the engine. The transmission worked flawless. When I turned on the car the engine sounds great and the transmission sshifted gears and the wheels were moving. The speedometer worked so then I turned the engine off and lowered the car down from the Jack stands and tired it shine but this time the transmission did not shift gears. I lifted the car back up and did still did not shift gears. The transmission does nothing. The checked the guild level and it's full. What can cause a transmission to suddenly stopped engaging gear?
View 2 Replies