Accent LC (2000-05) :: 2000 - Misfiring Upon Acceleration And Engine Revving
I have a 2000 accent. Automatic tranny with 167000 miles. My current problem is the car is misfiring upon acceleration and engine revving. I have to accelerate very slowly to minimize this but i once the engine revs up enough I can give it more gas and it will rev normally with plenty of power. I have had to unplug the maf to keep it driveable. Ive never had a car stay running after disconnecting the maf so this is strange to me. My accent barely stays running with the maf connected. I just got the car from my dad and he had it fixed and it ran good for awhile with the maf connected so I don't think it is the maf. But the same problem came about and we had to disconnect the maf again. And he cant remember or is not sure what was exactly fixed on the car. I've read up about the purge control valve and havent had a chance to check it out but some of the symptoms fit.
View 21 RepliesAccent LC (2000-05) :: Taking 5 Turns To Start - Engine Noise And Car Revving Itself
I have a 2000 model accent manual trans its just recently clocked 200 000 km I know the car has had problems but they are getting worse. Occasionally I have Problems starting the car in the past but it usually takes no more than 5 turns to get started but this is getting worse the other day it took about 5 min maybe more to get the car started I am guessing my starter motor probably Needs to be changed.
Next problem yesterday after I put a full tank of Premium 98 in the car its starts to rev itself changing the sound and note of the motor running constantly it has done this in the past but not so severely and It only seem to do so after putting petrol Especially when I put fuel From a servo I don't usually go to the car would have stalled more than once but didn't only because I tried to keep the revs up when it sounded like it was gunna die also I am pretty sure my fan was making some weird noises but the car has had no engine Light show and no Overheating.
Accent LC (2000-05) :: Engine Occasionally Cut Out
What may be wrong with my 2001 Accent? The engine has occasionally cut out in the past and the Engine Management light has come on, but the car has always restarted and the light gone out.
On the most recent occasion though, the engine would not re-start and when I turn the ignition key to the first position there is no Engine Management Light or ABS Light - I have normally seen these in the past when the ignition is on and they went out when the engine was started but now they just don't light up at all.
There is no power at the diagnostic plug, all fuses seem OK tested with a multimeter (unless there is another hidden away somewhere for the ecu?), all of the electrical earths/ grounds that I can see seem OK. Is it likely that the ecu has failed or may there be a simple fix.
Accent LC (2000-05) :: Revving With Poor Acceleration With New Clutch
I have just changed my clutch and machined my flywheel on my 1.5ltr 16v dohc 2000 lc accent. I used all the correct trans fluid and refilled and bled the clutch fluid. It takes of from lights like a new car but if you put your foot down around 40kph it revs out a bit and does so through all gears untill you reach a bit of speed. What is going on?
View 11 RepliesAccent LC (2000-05) :: White Smoke Coming Out Particularly When Revving
I recently changed my Hyundai Accent 2004 rings and top cylinder. a day after I left the mechanic garage, the car started bringing out white smokes particularly when I rev.
View 2 RepliesAccent LC (2000-05) :: 2001 Almost Dies When Let Off Accelerator After Revving
I have replaced the MAF sensor, TPS sensor, and fuel filter. Like the title says...if I rev the engine ...as soon as I let off the accelerator the engine stumbles and almost dies...then settles back down. I initially pulled codes PO121 so I replaced the TPS. PO103 so I replaced the MAF sensor. PO112..did not address directly as I assumed the MAF was causing. PO1123...again I hoped the parts I replaced would solve the problem. Initially the engine would just drop out while driving just for an instant and then be fine...also I had the 4 codes mentioned above. The only code that has returned is the PO121. I just got done replacing the fuel filter and things seem to be worse.
View 1 RepliesAccent LC (2000-05) :: Gears Started Slipping - RPMs Kept On Revving Up
Just the other day I was driving my car till I've noticed the gears started slipping. At first it was having some issues shifting through the gears (automatic transmission btw). As soon as I got off the highway, I parked in a parking lot just to check underneath the hood. Everything looked fine, went to pull out of the parking lot, no reverse. The gears started to slip up really bad. I noticed that the RPM's kept on reving up and wouldn't go any faster than 20mph. I went to an advance auto parts to get automatic transmission fluid. Still having the same issue and no reverse either. I had to park the car at a location to get it towed back to my house. Some people are saying my transmission is bad, some say it could be a real simple fix. Where to start diagnosing this issue. The car was driving normally until last Monday. My question is where should I start to check and what can I do to see if the transmission is completely shot??
View 33 RepliesAccent LC (2000-05) :: 2001 GL Started Revving When Driving During Traffic Hour - Transmission Slipping?
I have a 2001 Accent GL 1.6L Automatic.
Yesterday it started acting up on the freeway. I was driving about 50 during traffic hour when it started revving. I got off the freeway and moved to 35mph on surface streets, the revving continued at lower speeds but much worse (4-5k rpms going 10-15mpg). Doesn't seem to do it in idle or park. If i shut the car off it'll drive fine for a while then start acting up but when I was driving, after awhile, it did return to normal.
What could cause the problem? TPS? Transmission? Sensor of some sort?
Accent LC (2000-05) :: 2002 - Engine Cranks Just Not Firing
Been having issues the past month with the car taking a couple times to start. It's very sporadic. Sometimes I'll only have this issues once a week. Sometimes once every other day.
Engine cranks it's just not firing. Almost like what would happen if you were out of gas. Sometimes it takes 2-3 times. Just yesterday it took about 5-6 times. Once started though the car seems fine. Drives fine, haven't really noticed any hesitation nor has it died while driving.
1.6 automatic
130,000 miles
no CEL on
new plugs at 100,000 miles
Changed the fuel filter when i noticed it happening and ran some fuel treatment cleaner in it.
We took it into the shop and of course every time they checked it out it started up fine. even left the car there for 2 days and started up fine for them. They said they couldn't really diagnose it as it seems ok to them.
Fuel pump going bad? Fuel pressure regulator going bad? Crankshaft position sensor going bad?
Accent LC (2000-05) :: 2002 - Engine Vibrates Harsh At Idle
I just replaced the front and back motor mounts on my 02, 1.6 automatic accent. The front replacement mount was 1/2 inch too wide at where the bolt goes through, but made do. Now, the idle, but that's it. Before, it was vibrating somewhat at idle and lots of steering wheel vibration at highway speed. Now, I have no vibration of the wheel at highway speed, so it's like I eliminated one problem and made the other worse. I am hoping that the mount being too wide is the problem as I ordered the correct one. While taking it apart, I also noted the bolt through the front motor mount is incredibly small compared to the hole and this was true on both the original and the too big replacement. Why is this? Assuming that I swap out the too big mount for the proper and it still vibrates, than what?
View 1 RepliesAccent LC (2000-05) :: Sticky 1st Gear Occasionally
I have a 52 Reg Accent MVi and, occasionally when changing down into 1st gear, My gear stick sometimes doesn't want to go into place, or it will go into place but the car will still be in neutral.
Also, sometimes, when it feels like it hasn't quite gone in right, and i lift off the clutch, the car gets stuck somewhere in between gears and cant move, and i have to yank the gear stick (quite hard) back into neutral.
Accent RB (2012+) :: Engine Revving Itself Higher The Second After Push The Clutch In
Today I started my car (in the garage so it wasn't too cold) and everything was fine. The car warmed up in a couple minutes and I was off.
As i was driving, I noticed that my shifting was horrible. It felt like i was burning the clutch and not releasing the clutch smoothly in general.
I then noticed that when i pressed in the clutch ready to take the next gear, the engine would raise the rpm's about 500-1000 revs before coming down.
I started to wait till the revs came down to shift and that seems to work.
Why would the engine be revving itself higher the second after i push the clutch in. My dealer can't take me until Wednesday so I don't know what to do.
Accent MC (2006-11) :: CEL Came On - Noise When Starting / Revving The Engine And Getting Up To Speed
So yesterday during a work lunch my CEL light came on. my car only has 20,700 miles on it. and I bought it brand new. So obviously I was very nervous. I took the car straight to the dealership and dropped it off, seeing as I was only 3 blocks away from the dealership.
They ran the diagnostic and it said there was issue with a cylinder misfire. And after some more tests it led them to replace the engine coil. They drove it 5 miles and believed it corrected the issue. That evening after work when the shuttle came to pick me up, I drove the car home and no issues what so ever. Car actually seemed to be getting up to speed better than before. (car is automatic).
The issue, this morning when starting the car and getting ready for work, I hear a weird noise when starting the car, revving the engine, and getting up to speed. It is not a ticking noise, I would describe it more as a rattle but that doesn't even describe it real well.
They also did an oil change. I bought the car brand new, and have never had any issues and religiously get oil changed by dealership every 3 months.
Accent LC (2000-05) :: Transmission Shifting Irregularly And Then Getting Stuck In 3rd Gear Occasionally
I have a 2001 Hyundai Accent with 120,000 miles on it. Up until a few months ago, its been a great little car. The transmission started acting funny by shifting irregularly and then getting stuck in 3rd gear occasionally. I took it to the dealer and they told me that the tranny is shot. The estimate for the repair is $2000.00.
I just can't see putting that much money into this car. It needs Struts, Shocks and a timing belt. Basically what it needs is what its worth if it were running well.
How hard it is to replace the transmission in this car? I have the 1.6L DOHC with the Automatic transmission.
Accent LC (2000-05) :: Oil Pressure Light Occasionally Flicker At Idle / Car Will Not Rev Past 5k
I picked up an 02' accent, 1.5l that i've been intending to use as a commuter car. Drove fairly well on the way back home, but it seems it's got some low oil pressure issues once it's good an hot. As the oil pressure light will occasionally flicker at idle, mind you the car is near dying too.
Or so I thought, it was also misfiring/stumbling fairly badly,
Pulled all connections, cleaned, dielectric grease on them, fixed some of it. And it turns out the fellow who did the timing belt last didn't exactly remember to put the bolts back on the fuel rail.... Okay, that's fixed now.
Put in a little heavier oil, and no more issues with the light coming on, but I do have some lifter noise it seems like.
As well, the car will not rev past 5k in neutral or under load. Air filter is new, and no obstructions through to the intake manifold.
I'd guess based on the missing bolts here and there, the guy was a bit of a hackjob mechanic and i'm guessing has the belt out a tooth or so.... I can't see anywhere to stick a timing light on to verify ignition timing, how to check the timing belt is straight up? It's a bit of a dog compared to the other accent i've been in. The power band is like 2000-3500 and it just won't climb anywhere past that.
Accord :: 2000 - Bad Vibration At Idle - Revving The Engine Smooths It Out At Certain RPM
I have a 2000 Accord with a 2.3L 4 cylinder and manual transmission. I just changed the timing belt, balancer belt, water pump, tensioner wheels and other external belts. I now get a bad engine vibration at idle and when backing up and pulling forward. The vibration is quite noticeable in the steering wheel. Revving the engine smooths it out at certain RPM's. I know this isn't right and its got to be limited to something I just did. I followed the instructions in the Honda service manual and thought that everything went back to gather correctly. I double checked the timing and balancer alignments. The motor mount on the drivers side is simple and all went back together correctly. Is there a way to verify correct timing belt and balancer belt alignments without tearing it all down again?
View 13 RepliesCelica :: High Idle - Stay Revving At About 2000 RPM And Check Engine Light Is On
I've just done an engine swap to my 2000 GTS Celica. The new engine seems to run nice and tight and smooth and everything but I can't seem to bring the idle down. It stays revving at about 2000 RPM and the check engine light is on. The engine is from Japan and only has 35,000 kms. on it.
View 14 RepliesGolf/GTI VI :: Rattle Noise From 1800 To 2000 RPMs While Stopped And Revving Engine
Might be a long shot here, but I JUST had this noise/rattle pop up in my '12 GTI 6MT w/ 13k miles.
Turns out I found someone who posted a video with basically the same noise:
Another one:
I hear the same noise while stopped and revving the engine as well as when driving if I let off the throttle and let the RPM's sweep down past the same rev range (1,800-2,000). Sounds like it's coming from the passenger side area.
I'm under warranty so I'm going to take it to the dealership...but I know how they can be with rattles.
Accent LC (2000-05) :: 2002 GL Transmission Only Slips While OD Is On
My tcm is reading codes p707, p734, p732, p745, p1529. Little information ive gathered is that my transmission only slips while OD is on and it only slips the first time it tries to reach 2nd and 4th gears after it slips the rest of the drive it shifts fine it also feels sluggish in OD as far as acceleration. I'd like to solve it with out replacing the tranny cause.
View 4 Replies