Golf IV R32 :: Brake Pedal Making Slight Grind / Clicking Noise?
Ok so I have done a complete brake overhaul with rebuilt calipers, new pads and rotors and a new master cylinder. Brakes stop on a dime and are solid when pressed firmly. When coming to a stop at a slow speed (5 mph) pedal gives in with slight clicking grinding noise. I have exhausted searches on google and here with no soild answers any clue what causes this or how to fix it?
View 24 RepliesAccent MC (2006-11) :: Brake Pedal Making Creaking Noise When Depressed
My brake pedal is making a creaking noise when depressed and can also be heard when letting off the pedal. The noise is not coming from the brakes themselves (front/back are like new) but the pedal area or somewhere behind it. This noise doesn't start until I've driven the car for a little while. The brakes work fine for the most part but sometimes feel a bit spongy if making a sudden or hard stop. The fluid levels are fine.
I'm taking it in on Friday and hoping that the brakes just need to be bled a little or maybe the pedal just needs lube, but I'm worried it might be the booster or master cylinder---if it is one of these?
Accent LC (2000-05) :: Clicking Noise When Rolling In Neutral With / Without Brake Applied
I have an 2002 Hyundai Auto.
My car has the clicking noise under the following situations:
1) rolling in neutral with/without brake applied
2) rolling/decelerating without gas pedal pressed (I guess the same as rolling in neutral) with/without brake applied
The noise is the most noticeable when going at around 20 to 30mph, and would be gone under very low speed <5-10 mph. The weird thing is when I press the gas pedal and the car is accelerating, the noise is gone too.
My mechanics said it is because the wheel cylinder which is noisy. But I don't quite understand why the noise is gone when the car is accelerating.
Toyota - Corolla :: 2007 - Brake Pedal Making Clicking Sound
My brake pedal clicks when depressed, only at the start of pressing down on it. (This is a 2007 Corolla CE.) It only does this when the car is cold and started doing this during the very cold below freezing weather. The brake lights are all working, nothing else seems to be a problem -- brakes work fine, no vibration, etc. Brakes were checked out two months ago.
View 4 RepliesFord Super Duty (1999-2016) :: Clicking Noise In Park Or Brake Pedal Press Down - Brake Switch Noise?
The truck in my sig. makes a clicking noise when it's in the park and I press the brake pedal down. The click is coming from somewhere up high in the steering column. It doesn't make the clicking noise in any other gear only in park. Might be normal but I don't remember hearing it before?
View 9 RepliesAccent LC (2000-05) :: Squeak When Releasing Brake Pedal
2004 Accent 1.6L 5spd
Purchased this car used with 64k miles on it. I am in the process of performing the 60k miles service items and going through typical replacement of worn parts.
I have noticed that my rear passenger brake drum assembly squeaks when I let off the brake pedal. Note that this is not noise when applying brake pressue, but after releasing the brakes. Additionally, the drum happens to be rusted very badly. It took a good amount of brute force to remove the drum in order to inspect the brake assembly. There was a lot of brake dust built up and I thought that cleaning that out would get rid of the noise.
I suspect it could be one of the springs but I cannot be for certain. The squeak does not occur when I release the parking brake.
Passat (B7) :: Brake Pedal Making Noise When Depressed?
But when I take my foot off the brake pedal , its just seems rather noisy (clunky). As if VW forgot to put some rubber or something to prevent this clunky sound. (it just sounds cheap)
My jetta and tiguan never seemed like this. Have to stick my head under there and see whats up
Caprice :: New Suspension Making Clicking Noise When Apply The Brake
I recently did all new suspension on my caprice...new springs all around...new shocks all around....all new ball joints and all the tie rods brand new too and new sway bar... after installing everything i took the car to the shop and they did alignment and said they checked everything out and said i was good to go. The reason i did all new suspension in the first place was because a noise i was getting which i believed to be a bad ball joint so i just went ahead and did everything since i had to pull the control arms and what not. after everything is said and done the car is still making the same noise....its like a clicking noise which only happens when i apply the brake and the car lurches forward it sounds like a popping like something isn't tight and the car is moving forward on the frame or something....it doesn't happen in reverse and happens at all speeds sometimes one click sometimes 3 consecutive...
View 14 RepliesAccent LC (2000-05) :: Rear Brake Squeak On Pedal Release
The squeak is most pronounced when the brake pedal is released, but it still makes a quieter squeak when the pedal is depressed. I can't tell which side it is coming from; my guess is the middle of the rear or the left rear. I can't tell because I have to be in the car to release the brake (I guess I could tie a string around a brick and pull on it when I'm by the rear wheels). I should mention that all three of the belts are due for a change. Which part is causing the brake system squeak? The brakes work; replacing the squeaking part or parts is going to be lower on the project queue than the CD player/radio errors and replacing the belts, pulleys, etc. in the engine compartment (I've posted elsewhere on the forums about those issues).
View 5 RepliesAccent LC (2000-05) :: Brake Pedal Went Down Half Way Before Engaging And Hardening
Picked up an 02 Accent with 97K for local use. The brake pedal went down half way before engaging and hardening. Front brakes were good. Rear shoes were worn and had a leaking wheel cylinder on the right side. Changed the shoes and both wheel cylinders. Bled the rear brakes with the engine off by pumping the pedal slowly and opening the bleed to make sure I got no air in. Pedal got hard just off the top and the shoes hold the brake drum tight.
Now, turn the engine on and the pedal goes all the way down before it grabs and gets hard. I was going to bleed again with the engine on to see if that makes any difference. Can't see that it's the master cylinder and the car has no abs.
Lexus RX 2010-15 :: RX450H Making Noise When Brake Pedal Is Pushed
My less than 7000 miles RX started making noise when I pushed the brake pedal. Evidently it sounded like the "LS brake squawk" according to service foreman. Not sure if the actuator is same in all RXs.
View 3 RepliesPassat (B5) :: Shaking And Making Thumping Noise When Brake Pedal Half Way Down
Lately my cars been shaking pretty bad and making a thumping noise when i have the brake pedal about halfway down. Doesn't seem good. What it could be? also it makes a pretty loud whining type noise when the cars on think its a pulley or water pump but not too sure.
View 3 RepliesCivic - Honda :: Brake Making Squeaking Noise When Pedal Released
A mechanic recently replaced the pads of the front brakes. After the service, the break makes squeaking noise when I release the break pedal. According to the mechanic, it is normal, and I better ignore the noise. Is it true?
View 1 RepliesHyundai - Accent :: 2000 - Brake Pedal Pressure Changing After Cylinders Replaced
I own a 2000 Hyundai Accent with 85,000 miles on it. I recently took my car into a local shop because the pressure on my brake pedal was extremely low. I was almost pushing it to the floor. On my first trip to the shop, they replaced the rear wheel cylinders because they were leaking. This replacement didn't fix my problem.
On the second trip to the shop, they replaced my master cylinder. I did call around to other shops to do a price comparison and the price was reasonable on both jobs. This work was done about two weeks ago.
At first, this seemed to fix my problem, the pressure was perfect. Since then I've been having an intermittent problem with the brake pedal pressure changing. It would get a little hard during driving, but would correct itself after a few moments. I don't drive that often or very far, so I was waiting to see if the problem would get worse.
Last night it did. I went out and when I tried to drive my car home my pedal was extremely hard. I could barely push it. While I was driving my car home (I was close to home), it felt like I was driving with my brakes on. My car would stop as soon as I took my foot off the gas pedal, I could not coast. When I got out, I could feel heat coming from the front tires, which I didn't even have work done on. There was also a smell that I've never smelled before. It almost smelled like something burning.
I was told I should have my car towed back to the shop on a lifted bed and not rolled there and that they should fix my car at no charge because they did something wrong.
My ultimate question is did the shop do something wrong and should I take it back to them if they did? Should they be responsible for this new repair? I don't want to go demanding anything if it's possible this is a whole new problem and not their fault. Even though it does seem like an awfully big coincidence. My next question is: what could be possibly wrong with my car? I would like to know what I'm getting myself into.
Accent LC (2000-05) :: Auto Door Lock Is Not Functioning Even When Press The Brake Pedal
I'm having Hyundai Accent GLS Model 2005. Since yesterday, My tail lamp and Third Brake light is still switched on even I turn off the light & I notice that my Auto door lock is not functioning even I press the Brake Pedal. I tried to disconnect the battery & the Fuse and place it back but it doesn't works. Currently, I just pull out the fuse.
View 6 RepliesAccent LC (2000-05) :: A/C Compressor Making Noise When Cuts Out
Since it's "auto repair season" in my driveway, I was working on my daughter's car (2001 Accent, 1.6 GSi) and noticed that the air conditioning compressor makes a noise (like a cross between a burble and a shriek) when it cuts out. I'm assuming it's the head unloader and was wondering if it's supposed to make a noise that's quite that loud or if maybe it's getting low on refrigerant - the compressor runs quietly when it's turning and the clutch doesn't make any strange noises.
View 3 RepliesAccent LC (2000-05) :: Engine Is Making A Ticking Noise
My engine is making a ticking noise. Louder when I start it and not as intense after it warms up but its still there. I first thought it was one of my pulleys making noise but I brought it to a friend who knows a lot more then I do and he says to check the engine valves. Did some searching online and thinking it might be the valve lash adjuster but not sure.
Anyway whats the best way to go about this? What type of oil should I be using and I also read I should be only buying Hyundai oil filters?
Accent MC (2006-11) :: Rear Brake Making Grinding Noise When Applied
My right rear brake is making a grinding noise when the brakes are applied. I took the drum off a couple weeks ago and the shoes are just a bit worn. Just getting into the numbers printed on the side of the shoe material.
I could not see any thing that would be making the metal on metal sound. Are there any wear indicators on the OEM shoes?
Lexus LS 2007+ :: 2008 - Brake Pedal Clicking Noise When Pedals Are Cold?
I have a 2008 LS460. I have a clicking noise coming from the brake pedal area. It happens in the morning when the brakes are cold. I had the same problem when the car was new, and Lexus put in a new actuator. It was ok for about 6 months, and started clicking again. Maybe 3 or 4 soft clicks when I push lightly on the brake pedal. Every time I take it in to Lexus, they say it has the new actuator, and the noise is so soft that they act like they can't hear it. The car is so quiet otherwise, that to me the clicking is very annoying. I have called Lexus corporate, to no avail. Sounds to me that they have a problem they don't want to admit.
View 9 Replies