Lexus RC 2015+ :: Clicking Noise Coming From Front Suspension When Making Left / Right Turn
Took my car in for 10k mile service and let them know there has been some clicking noise coming from the front suspension when making a left/right turn...
I dropped off my car on September 21st and they have yet to complete my car... I've called them every single day since but, I don't get a good explanation from the dealer...
Accent LC (2000-05) :: Brake Pedal Making Noise Like Clicking
My daughter has bought a 2003 4 door accent and on the way to work she lost most of the brakes. I could not see any fluid leaking and the level was ok. I did try pushing on the brake pedal with my hand and it was making a noise like a clicking? I was thinking it was just the brake light switch but not sure. The place she bought it from put new brakes on it when the driver side was getting really hot. I am thinking maybe air in the system? It sounded like a caliper was sticking when I test drove it but only a couple of times. You would have some brakes but you had to pump the peddle.It is in a parking lot right now but I can work on it unless it is some sort of different? I am going to try to bleed it in a little bit but was thinking I should ask around. I read that the piston could be sticking but can you just rebuild the master cylinder to fix it if that is what it is? I could pull the pedal back a little bit. I only looked at for 4 or 5 minutes kinda dark and no tools with me.
View 10 RepliesGolf IV R32 :: Brake Pedal Making Slight Grind / Clicking Noise?
Ok so I have done a complete brake overhaul with rebuilt calipers, new pads and rotors and a new master cylinder. Brakes stop on a dime and are solid when pressed firmly. When coming to a stop at a slow speed (5 mph) pedal gives in with slight clicking grinding noise. I have exhausted searches on google and here with no soild answers any clue what causes this or how to fix it?
View 24 RepliesCaprice :: A/C Compressor Clutch Making Lots Of Noise When Working
Pretty sure the a/c clutch on my LT1 is going - making lots of noise when working and also when not.
I've heard on some forums that this could be a bearing? Is it advisable for me to replace the entire clutch or just this bearing?
Either way, I assume I'll have to pull the clutch for which I think I'll need two special tools:
(1) clutch holder tool to break nut loose.
(2) pulley puller.
Civic - Honda :: 2007 - Grinding / Crunching Noise When Apply The Brake In Reverse
I have a 2007 Honda Civic with about 46,000 miles on it. I purchased the car "certified used" about 1 1/1 years ago. For the past several months I've been experiencing a grinding/crunching noise when I apply the brake in reverse. I've taken it to a Honda dealer and they more or less told me that it sounds like something could have been wrong with the brakes. They ended up telling me they couldn't find anything wrong and that my brakes are fine. I've called the dealer to see if they could look at it again, but now my car isn't under warranty and they'll charge me to look at it. What could be causing this noise? At this point in time it's more annoying than anything - I'm afraid if I let it go it might end up hurting something in the long run.
View 1 RepliesElantra MD (2010-15) :: Click Noise When Apply Brake To Stop From Either A Very Low Or High Speed
I think something is wrong with my brake. I only have less than 3k miles on my 2012 Elantra GLS. But now, when I apply brake to stop from either a very low speed or high speed, I always hear a clear click (only one) sound which probably comes from under the car or brake pad (front driver's side). It sounds like metals collision. When idling, applying brake does not make any sound.
View 12 RepliesPassat (B5) :: Driver Side Wheel Shakes And Rattle Noise When Slightly Apply The Brake
Ok everyone the good weather is back, so the drivers side window is down and, I am back to diagnosing an issue that I've been having for some time now. BTW were dealing with my DD 02 1.8t wagon. So all the time over any little bumps in the road or anything that i roll over that "shakes" the drivers side wheel I get this terrible rattle noise. I mean it sounds like I am a dump truck bombing down the road with a bunch of shovels in it......well not that extreme but that sort of shake noise. Anyway the noise however does not occur over any bumps when i even just slightly apply the brake. So I know that it has got to have something to do with the brake rotor or caliper or something on that wheel. Any common issues with brakes? I mean i doubt it is hurting the performance of the vehicle but it is extremely annoying and i feel like something isn't stable that should be until i apply my brakes.
View 11 RepliesNissan - Sentra :: 2000 - Hammering Noise On Front Passenger Side Wheel When Apply Brake
I have Nissan Sentra GXE year 2000 model and it has 143K miles on it. I get a hammering noise on the front passenger side wheel when I apply brake. I did replace caliper, brake master cylinder, rotors, brake pads and brake shims but no luck. The noise is like "ta ta ta ta.." and it gets louder based on speed of car. Brake pads and rotors been replaced 3 times in last 2 years to get rid of noise and been seen by 4 mechanics so far no one could find the exact problem. I also took the car to Nissan dealership they also recommend changing brake pad and rotors which I already did thrice.
View 5 RepliesToyota - Corolla :: 2007 - Brake Pedal Making Clicking Sound
My brake pedal clicks when depressed, only at the start of pressing down on it. (This is a 2007 Corolla CE.) It only does this when the car is cold and started doing this during the very cold below freezing weather. The brake lights are all working, nothing else seems to be a problem -- brakes work fine, no vibration, etc. Brakes were checked out two months ago.
View 4 RepliesFord Super Duty (1999-2016) :: Clicking Noise In Park Or Brake Pedal Press Down - Brake Switch Noise?
The truck in my sig. makes a clicking noise when it's in the park and I press the brake pedal down. The click is coming from somewhere up high in the steering column. It doesn't make the clicking noise in any other gear only in park. Might be normal but I don't remember hearing it before?
View 9 RepliesTouareg :: Air Suspension Pump Making Noise
I removed the long plastic cover under the right side of the car to expose the air pump. Switched the car on and looked for any obvious signs where the noise came from. Mine showed a missing nut and some play in the bushes. Some strategically placed cable ties, foam and a new nut and the air pump is silent again. Now who said these cars need deep pockets to maintain?
View 1 RepliesTiguan :: Front Right Suspension Is Making Rattling Noise
Any 'rattle' from their front suspension when going over high-frequency, low speed bumps (manhole covers, potholes etc)?Sounds like a loose strut mount or shock. It's not a creaking sound - a definite rattle - so I don't think it's the engine mount issue that I've read about elsewhere. Car is brand new and is going in for a 60 day courtesy check in a couple of weeks.
View 24 RepliesAccent RB (2012+) :: Suspension Spring Making Noise?
Having problem with accent suspension spring making noise? I had 5 people inside the car with some stuff in the trunk. As soon as I drove I could hear the squeak coming from the spring. I doubt that I went over the load limit. Any car should hold up 5 people with some weight in the trunk... right?
View 10 RepliesGolf V R32 :: Front Suspension Clicking Noise At Low Speed
So I've recently dropped the car with ST coils and during the install, I had the mechanic installed NEW strut mounts and strut bearings because I've heard people having noises if they only do the coils.
However, even with the new strut bearings/mounts, I would hear clicking noises at low speed going in a out the parking spot or parallel parking (not every time but getting close). Therefore, my questions are:
1. If strut bearings/mounts are new and put in at the same time as the coils, what other reasons could there be that's causing this clicking noise?
2. If the noise doesn't bother me and I can live with it, would there be any negative effects for not having this issue taking care of?
Mazda - Mazda3 :: 2005 Making Clicking Noise
I have a mazda 3 and i just tried to start it but its just making a clicking noise. The radio works so does that rule battery out....
View 4 RepliesLexus GS 2006-11 :: Nav DVD Won't Go Back In / Just Making Clicking Noise
Accidently ejected my map dvd...located just under my Nav screen under a piece that has Lexus on it. It slides right up and the dvd came out. Cant get it to stay in now. Only makes clicking sound! So frustrated. How do I get the dvd player out? Removing the dashboard? My dvd player isn't in the dashboard though!
View 1 RepliesSonata NF (2006-10) :: Rear Suspension Bushes Making Squeaking Noise In Bumps
My car's rear suspension bushes are getting torn and are making squeaking noise in bumps. I am able to get bush for trailing arm and stabiliser bar. My dealer says that i have to replace the whole knuckle assembly as the bush for that part are not available separately. Is this true or the dealer is trying to earn some quick bucks?
View 2 RepliesSierra :: 1991 GMC 1500 Won't Start - Not Making A Clicking Noise
I'm working on getting my GMC seirra 1500 5.0 L running. Last fall When I was making a trip to another town, it broke down. When it broke down it smelt like plastic was burning, I was unable to figure out what the smell was.
First I though it was a bad battery connection, or that the starter had went.
I changed the Battery, made sure the cables were good. changed the starter and it still doesn't work.
I know the battery is working for sure because There is power to the lights so I can turn on the brights. There is no power to anywhere else on the dash though other then the icon that shows the brights are on.
When I try to turn the engine over, nothing happens at all. Doesn't even make a clicking noise.
Lexus LS 2007+ :: Brakes Making Clicking Noise While In Reverse
The other day I had my windows open while backing up and noticed that the brakes make a clicking noise when I initially apply them while in reverse.
This happens every time I'm in reverse and I apply the brakes.
The clicking is only when I first step on the brake, but it happens every time I first step on the brake in reverse.
Maybe this is unique to the LS600hL (2008)? Are brakes on my LS different from brakes on LS460 / LS460L?