Accent LC (2000-05) :: 2003 - Loud Belt Squealing Noises
Since the weather got colder I've been getting really loud, squealing belt noises. They happen mostly when I turn on the car. They sound like when I had an old Altima and turned on the A/C the belt would squeal. But the sound happens even with no air turned on or defogger turned on. And it happens sometimes when I make a really sharp turn around when I first start the car. After it's warmed up I generally don't hear it. Also, sometimes having my foot on the brake will change how long the sound lasts for. I'd like to know what belt this would be and if just WD-40 should be used for now (or some type of belt dressing) OR if it's detrimental not to get work done on it. Also let me know if I'm able to tighten it myself or if that's better left. I replaced a valve cover gasket a few months ago so that's about the extent of my abilities at this point.
It's a 2003 Hyundai Accent Automatic...
Ford - Ranger - Noises :: 2003 - Mystery Scraping Sound Going Uphill
My 2003 Ford Ranger started making a scraping noise a couple months ago - just a sort of quick metallic rasp that lasts no more than a second. It doesn't sound like a grinding noise - it's definitely a scrape, like if you dragged the edge of a shovel along some pavement. The sound comes from the rear of the truck. For a few weeks it only happened when I was driving uphill and making a sharp right turn at the same time. (My morning commute has one such right-turning hill, so I was hearing the sound every day at the same spot.)
A couple weeks ago, when the roads started getting really really terrible with potholes and frost heaves, the sound suddenly started happening more frequently. That same quick little metallic scrape happens almost any time I go over a big bump, and sometimes it seems to just be happening at random, even when the road isn't that bad!
What I picture when I hear the noise is that something in the undercarriage is loose, is briefly hitting the ground during sharp turns or jostles, scraping against the pavement and then bouncing back up. I've looked under the truck but I don't see anything that looks loose or dangly. My undercarriage is badly rusted, however, so it's not hard to imagine that something is swinging around that I just don't see when stationary. This could also be something in the wheels... but I don't know what.
Accent LC (2000-05) :: Scraping Noise Coming From Driver Side
The other day I replace the front brake pads and rotors on my daughter's '03 Accent. On the test drive I noticed a scraping noise coming from the driver's side. Got it home and didn't see anything obvious, but for fun I removed the pads and swapped the shims around. It was better, and afterwards I put the new brakes through a few heat cycles. The scraping noise became less noticeable so I figured she should just drive it for a few days. Well today I'm informed that the noise is "really bad".
View 1 RepliesAccent LC (2000-05) :: Bad Noises After Oil Change
I did an oil change recently, as I have done many times in the past, but this is the first time different noise like this could be heard.
I had synthetic in there before (mobil 1 + mobil 1 filter) because it was on sale for a ridiculous price, and I figured I would try it out. I now have Shell oil in the engine and it is the same weight (10w-30) as always. It is dino oil, supposedly with synth blend or something, and I also installed another synth filter.
I now have some minor valvetrain noise, a little louder than normal, and a tick that is loud - which is the part that really worries me.
Should I go back to synthetic, or should I look at the top end? I opened the valve cover, but nothing looks wrong at a quick glance.
Ford Brakes/Suspension :: 2000 2WD - Front Brake Scraping While Driving
2000 Explorer 2WD. I had tons of front end issues that I have been working through. So far I have done upper control arms, upper and lower ball joints, tie rod ends, got an alignment. The steering/suspension system is in good shape now.
Now the only thing left is a scraping/grinding sound coming from the driver's side brakes. I mostly hear it at low speeds (taking off from lights, etc).
When I was doing all of the other work, I observed that the rotor is in great shape, brake pads look great. I am wondering if it is a caliper issue, maybe the caliper isn't releasing enough or something. What to check?
Accent LC (2000-05) :: 2004 1.6L 5 Speed - Whining And Jingling Noises
I have a 2004 Accent with 150,000km on it. I've done a number of jobs on it, and I find it to be a relatively DIY-friendly vehicle. A little while ago I had an issue where it would die after warming up, sometimes at a stoplight. Otherwise, it would intermittently fail to start after it had been parked for a very short time. This was fairly obviously the crank position sensor, which I replaced. At this time, I haven't had the same issue again.
Since that small repair, however, I have been noticing other issues. From inside the cabin I can hear a distinct whine that climbs 1:1 with the engine RPM, whether or not the clutch is engaged. Once the RPMs hit the power-band(ha-ha), the whine is joined by a metallic jingle. From outside the car, both whine and jingle are audible through the entire RPM range. It sounds to me like a clear case of bearing noise coming from the belt and pulley system.
Since this whine started, the car has been giving lazier starts, requiring slightly longer to fire up. The noise changes significantly when the AC/defrost system are engaged, although I'm not sure if this is because the faulty part is connected to that system, or because the RPMs drop once it's engaged, both, or neither.
I will be doing a timing belt and water pump change before the snow flies, and I would love to find the parts that I need to treat the jingle at the same time as the rest of the belt system replacements.
Ford 7.3L Power Stroke (1999-2003) :: Higher Pitched Scraping While Driving?
I've got this loud higher pitched scraping/rattling/clanking noise while moving. Neutral or drive makes no difference. I have a problem with my coast clutch not working and will be having the tranny shop (warranty) take a look at what's going on. Could this sound be from that? I hope it's noticeable on the video. I need to do my swaybar link bushings, but it's not a suspension clunk it's definitely a rotating noise.
View 9 RepliesFord Super Duty (1999-2016) :: 2000 F250 V10 - 4R100 Making Noises Audible While Driving Especially In Third And OD
Troubleshooting on my wonderful transmission. I have a 2000 F-250 CC Lariat with the V-10. When I start the truck, I hear a high pitch noise. It's like a high pitch whine. It changes frequency as you rev the engine in park. Put the transmission into gear. Either forward or reverse, and the noise is lower pitch. As you accelerate, the noise will change frequency. If the tranny is manually shifted, the noise will go away, and then come back a short time later. The noise is audible while driving especially in third and OD. The truck has 93,000 and is dead reliable except for this. I have been under the truck, and I can tell it's coming from the tranny. Not sure if it's the converter or what.
View 10 RepliesFord - Explorer - Noises - Transmissions :: 2003 - Rattling When Vehicle Is At 2000 RPMs?
My 2003 Ford Explorer, Eddie Bauer 4WD is making noises when the vehicle is at 2000RPMs. Below or above 2k RPM's no noise. Sounds like a very angry rattle snake. I seem to drive at speeds that require it to be at 2k RPM all the time. So needless to say as fall is approaching and I have the windows open, my hair is now falling out and not blowing in the fall air. I want to get it looked at, but don't know what to tell the mechanic to look for.
View 2 RepliesAccent LC (2000-05) :: GL Dies While Driving Then Will Not Restart
I am having with my 2000 Accent GL. It keeps dying while I'm driving it then will not restart. After sitting for awhile it will start but then after a short time dies again. The first thing I did was replace the fuel filter but that did not work. Did a diagnostic scan and it threw a code for the CPS sensor. Replaced THAT and it STILL did not fix it. I reset the computer but it didn't work. The scanner didn't pick up any other codes. Next I checked the relays and they all seem to be fine. Finally, I replaced the fuel filter but the problem did not go away.
View 3 RepliesAccent LC (2000-05) :: Bounce Like Motion When Driving
My car, a 00 accent 1.5 gs with about 87,000 miles, manual trans, feels like its bouncing or like the ground is uneven when its not. This happens when I'm driving. It accelerates normal but when I put it in third gear it has a bounce like motion. It even happens when I am coasting and actually in all gears. I know my shocks and maybe my springs are no good but I don't think that's the problem. I have no clue what it is. It was happening before but i have been noticing it more often. I wonder if its the axle on the left side due to a ripped cv boot.
View 6 RepliesAccent LC (2000-05) :: Grinding Noise While Driving
So I have a 2000 Hyundai Accent, 1.5L with an automatic transmission. I'm hearing a grinding noise when I'm driving. It gets faster as the car goes faster, but the engine RPM has no effect only the speed of the car.
I got new tires, changed the CV axle shaft on both sides, and I also changed the front struts as I was told that one of the struts was bad the last time I took the car for an alignment. None of that has had any effect on the grinding noise.
Then I jacked the car up on both sides and let the wheels spin, and the grinding noise is present that way as well. Then I jacked up just one side at a time. When the driver's side wheel is spinning, the noise is audible, but not when just the passenger side is spinning.
I then disconnected the brake caliper from the driver's side and held it up with a tie wrap to keep it out of the way. The noise is still audible when the wheel is spinning, so it's not the pads or a clip or anything like that.
So now I'm down to a couple of ideas.
1) Wheel bearings
2) Something is hosed in the differential or transmission. I'm guessing that the differential is more likely, as the transmission should effect both sides the same, right?
I'm going to check the wheel bearings now, though to me it seems unlikely to be the problem.
Accent LC (2000-05) :: When Driving On Interstate Car Died Now Will Not Start
I have a 2004 Accent. When driving on the interstate yesterday, I turned the turn signal on and my car died for a moment. After I parked it, it would not start. It did not turn over. Took the battery out to get checked. It was good. Put back in and then the car started. Drove home. The radio and clock would flicker intermittently but made it home. Today it will not start at all. Nothing comes on.
View 14 RepliesAccent LC (2000-05) :: Missing In 3rd Gear After Driving A While Under Load
I have a 2000 hyundai accent 5 speed with 76k and a 1.5. the spark plug boots arc on all 4 plugs and can see a light blue line down the center of the wires also. But while idling you see nothing till u snap the throttle. Also driving while its under load you can really feel the miss in 3rd gear. Ok here"s what I've done I cleaned up all my grounds on motor and body ,also cleaned spark plug threads. i replaced wires with 5 different brands including factory wires and same thing. I've tried all kinds of different plugs from regular coppers to iridium and changing plug gaps with no change. the coil was replaced,crank sensor changed and does same thing.
View 11 RepliesAccent LC (2000-05) :: Engine Quit When Driving Down The Highway
Driving down the highway today, my car just all of a sudden quit. I had it towed home, and checked the spark and fuel pump. It turns over fine, there's plenty of spark, and the fuel pump works great, but I don't think fuel is getting all the way to the engine. Could the fuel line be blocked or something? Maybe the injectors?
View 3 RepliesAccent LC (2000-05) :: Hyundai Consistently Stalls While Driving
Have a Hyundai accent 2000 manual. The vehicle inconsistently stalls while driving. One day it will drive all day without stopping. The next it will stall while driving 10 or more times.
I`ll pull over, turn ignition off. Turn the key 1-2 times. It starts. Drive sometimes 5-10 minutes will stall again, sometimes will stall an hour later. Some days not at all.
What I should be checking and how to go about it. Have the car booked in to get it put on the computer, but would rather do it myself especially if its just a sensor that needs replacing.
Accent LC (2000-05) :: Decrease Noise In Cabin While Driving?
Any way to make my Accent quieter whilst driving. It is not overly noisy in any way, but it is certainly louder than most cars in the cabin. Is there any sort of solution to this?
View 1 RepliesAccent LC (2000-05) :: While Driving At Slow Speed RPM Gage Goes Down
2005 hyundai accent, I've noticed something unusual with my trans, whenever I start driving at lower speeds ( which I do all the time to save gas) the transmission shifts into 2nd and 3rd just fine, but in 3rd gear ( at around 2.5 rpm ) the RPM gage goes down a little bit ( about 2.1 rmp), it almost feels like it went into 4th gear and it happens really smooth, it almost feels like its supposed to do that, the car later shifts into 4rd at around 3 rpm, there's no jerking, stalling or sounds at all, this does NOT happen when I take off at a higher speed and acceleration. This transmission has 55.000 miles on it and besides this it works perfectly fine.
View 1 RepliesAccent LC (2000-05) :: Just Stopped In The Middle Of Driving - Not Turning Back On
Had no problems until a month ago the car just stopped in the middle of driving it. It hasn't turned back on since. It cranks and sounds great, just won't turn over.
Here's everything we've changed so far:
spark plugs
ignition coils
fuel filter
fuel pump
fuel pump relay
crank shaft sensor
added gas
If there's something we're missing.