Ford 7.3L Power Stroke (1999-2003) :: High Pitched Squealing / Scraping Sound - Loss Of Power Towing Uphill
Towing a 5th wheel at about 10,000 lbs total. Towards the end of out 9 hour trip home and going upgrade the truck begins to loos power and the engine starts making some bad sounds. Although its hard to hear it starts about 45 seconds in and continues later when going uphill. the truck also made a very high pitched squealing/scraping sound (not a belt) like it may have been coming from the turbo. Oil temp was about 220, trans temp at 170 at the time of the event.
Truck has 216k, stock, upgraded trans cooler, original fuel pump.
Here is the video : YouTube.....
Accent LC (2000-05) :: 2003 - Scraping Noises When Driving
My hubby hit a curb on vacation last weekend and now it sounds like something is grinding and we can both feel vibrations (on both driver and passenger floor) it does not do it when stopped. We had to cut the bottom of the under carriage away from the tires due to it rubbing, thinking that was what the noise was, but its only getting worse.We just changed the CV joint on the driver side in March at the same time. We do know he has a small exhaust leak but it was never making this sound until he hit that curb.. I really don't want to take it to a shop to have it looked at if I don't have to, I normally do all the work myself.
View 1 RepliesFord Ranger / B-Series :: 1995 - Mystery Stall Every 1 To 3 Months
For the last 2 years 1995 ranger 2.3 will run great but every 1-3 months will just stall. Will than try to start it for a couple of minutes and in 1-8 minutes will start back up again as if nothing was wrong and then be fine for another week, month, 2 months etc. It has never happened at first start up in the morning but at times will stall 2 minutes after start (at traffic light of course). At times will turn off to run into store, come outside, no start, try for couple of minutes and then starts up fine. Changed out fuel pump, etc, etc. Biggest problem is no codes and, of course, when mechanic looks at it nothing is wrong.
View 4 RepliesToyota - Corolla :: 2003 - Getting Mystery Noise When Braking
There is an occasional noise that happens only when I am braking my 2003 Corolla. My mechanic has ruled out the brakes and says there is nothing apparent that would make it dangerous to drive the car. The noise has happened on hot days, cold days, dry days, rainy/snowy days. It doesn't happen each time I brake. When it does occur it ranges between a sound like a humpback whale's song to a very loud screech. When it does, it is always right before the car comes to a stop. It happens when I back up and when I am going forward. I cannot reproduce it (I drove with my mechanic all over heck and gone trying to get the car to make the noise, alas, it would not). However, I did capture it at its loudest.
View 3 RepliesFord - Taurus :: 2000 - Scraping / Whirring Sound On Deceleration Only
So, I'm minding my own business pulling out of Starbucks with my gingerbread latte, making a nice and easy right turn when I hear "clunk" ("pop" maybe??). I hear a scraping/whirring sound on deceleration only (once I get past say 30-40 miles per hour). NOT brake related at all, occurs only when I let up on the accelerator. My baby is a 2000 Ford Taurus with 238,000 (yep, you read that right). I'm thinking transmission (and, I really want to be wrong). I've had the transmission flushed every 30,000 miles and serviced at 150,000 per Ford's maintenance schedule. I have taken very good care of my vehicle, but I do put a lot of miles on it every day as I drive 120 miles round trip to work 5 days a week.
View 8 RepliesFord :: Scraping Sound From Rear Of Vehicle When Turning Slow
70's Ford 4x4 truck. I'm getting a very noticeable --- but intermittent, doesn't happen every time -- metallic scraping sound when turning right at slow speeds. Coming from the rear of the vehicle. Like in neighborhood driving. No unusual sounds when going straight. For the past week the problem seems to have gone away, so I'm playing this one by ear. Hopefully whatever it was has gone away. But I'm ever the worrier.
when it happens, it sounds like if I dragged a big sheet of metal on the road behind the truck. I'm sort of suspicious this sound is from the rear limited-slip differential. Could it be the diff clutches are corroded? Coming loose from their moorings? A differential bearing on the fritz?
Ford Excursion :: Metal Scraping / Screeching Sound With The Windows Down
I hear a metal on metal scraping/screeching sound with the windows down and only when i drive by guard rails and other stuff sound reflects off of. I saw the traveling hub zerk thread and that's what made me think of it. I've zerked every fitting I've seen, but this ones new to me. Problem is I can't even tell witch wheel (if any) it's coming from. It's consistent with speed.
View 12 RepliesFord - F150 :: Occasional Vibration When In Gear - Scraping / Squeaking Sound
Vehicle: 1998 F150, 158k mi. MT (M5OD), 4.9l I-6.
Description of problem: About 2 weeks/500 miles ago, truck developed a scraping/squeaking sound. I thought maybe something was rubbing on the driveshaft, but inspection revealed no likely candidate, nor disturbed metal on the shaft.
Over the course of the next 500 miles, it's gotten worse, so that current symptoms exhibit themselves (to one degree or another) 80% of the time. The symptoms are:
- Worst on first drive of day, on first mile.
- Sound produced somewhere between scrape and squeak.
- Vibration noticed throughout cab and through steering wheel ONLY when foot off clutch...smooth as soon as clutch depressed.
- Giving it a little gas (at constant speed) usually smooths out symptoms somewhat.
- Recently had bed loaded to gross. Vibrations went away, to return once bed empty.
- MT fluid found to be full, in good condition, and with 15k mi since change.
So, what's up? Given that a load in the bed improves things, I was thinking U-joints: but the driveshaft spins in neutral, too, so why would pressing the clutch change anything? I also thought about tired clutch bearings, but everything I've read says pressing the clutch makes things worse, not better.
Is it worth examining the tranny-to-engine bolts?
Ford F-150 (2009-2014) :: Scraping Sound On Hard Left Turn
I'm getting a scraping sound on hard left turns. I've only noticed it on a steep hill where I work going under five mph and making a sharp left turn. I got out today and it doesn't look like the tire is hitting anything. The shield in front of the tire is slightly looser than the right side, but can't see it making the noise unless something is hitting it. I've read some previous posts that indicated traction control possibly coming on. I have about 4,000 miles, 20 inch tires, and everything stock.
View 14 RepliesFord - Ranger :: 2001 - Knocking And Smoking When Accelerate Uphill
About 3 weeks after an oil change, my 01 Ford Ranger started knocking and smoking when I accelerated up hills. I checked the oil levels to find that it was completely empty. Refilled the oil, but the problem persisted. Tried gas additive--nothing. Finally limped into the Ford dealership where they kept my car for 6 weeks trying to figure out what the problem was. After new plugs, wires, MAF sensor, coil, and PCM the problem seemed to be fixed...mostly. Knocking and smoking eventually stopped until I checked the oil levels again and it was empty. Added oil which started the symptoms all over again. Mechanic ruled out blown gasket. Claims knocking and smoking are unrelated (even though they happen at the same time 100% of the time). Smoke is white. Knocking (at its worst) sounds like a bolt rattling around in engine. Car does not lose power, and when I gun the engine it seems to go away. Only happens going up hills (of which Tennessee has plenty of).
View 4 RepliesFord Ranger / B-Series :: 1998 - No Power Going Uphill / EGR Valve?
Burnt feedback hoses off and has no power going up hills, changed plugs and wires and did complete tune up still no power will the EGR valve cause it not to have power going up hill? No codes or check engine light on at this time.
View 10 RepliesFord Brakes/Suspension :: 2004 F150 - Grinding / Scraping Sound While Driving
I have a 2004 F150 4x4 Fx4 supercrew with 5.4 engine and 46,000 miles. For the past three weeks now I have a periodic Grinding /scraping sound that seems to be coming from the front passenger's side of the truck. It can come on with light driving and braking in town or start while driving 70 mph down the interstate without even touching my brakes. The thing is I just about always have to come to a complete stop to make it go away. 10 Minutes later it comes again. It's loud enough for everyone around me to start staring at my truck. Sounds like metal scraping concrete and gets deeper as I slow down and when I fully press my brake pedal it goes "curchunk and the sound is gone for a while. I thought maybe my caliper was sticking or maybe the truck is trying to go into 4x4. One friend even suggested me to check the dust cover behind the brake for rocks.
View 12 RepliesFord Ranger / B-Series :: 2003 - Ticking Sound From Heads?
I have an 03 Ranger 3.0 a/t. A little while back I had a clogged cat, so I took out all the cats and since then it has slowly developed a ticking sound from what sounds like the top of the heads. What that might be?
View 6 RepliesFord Ranger / B-Series :: 1999 - While Going Uphill Cuts Back / Looses Power And Jerks?
I have a 99 Ranger 4.0 4x4. When driving on a hill, the truck cuts back and looses power. I can press the pedal and go into passing gear and it will pick up speed but that is the only way the speed will increase and not slow down. The truck jerks when this happens.
Things I have tried:
Replace all plugs and wires
Replaced Coil Pack
Replaced Mass Air Flow sensor
Replaced O2 sensor
Replaced throttle cable
Took truck out of overdrive
Changed to better grade of gas
Changed oil
I had Cat. Converter checked
There are no codes showing. Truck may drive OK on one trip but act up on the return. It seems to use a lot more gas when it is acting up. I now have run out of options that I know about.
Ford Ranger / B-Series :: 1998 - Clicking / Vibration In Gas Pedal When Start To Accelerate Going Uphill
I have a 98 ranger, 4x4, 5spd 3.0 with 88k miles.
While I am driving it, everything is great, but when i start to accelerate, or torque the engine (going up a hill), I get this clicking/vibration in my gas pedal. its extremely noticeable, by feeling and ear.
Its most common around 2k to 2.5k RPM. There is a lot of play in the throttle cable, about an 1" or so give untill you feel pressure. What I need to replace or tighten?
Ford F-150 (2009-2014) :: Sloshing Scraping Thumping Sound Coming From Fuel Tank Under Hard Braking
Hearing a sloshing scraping thumping sound coming from their 36 gallon tank under hard braking accelerating? It's loudest when the tank is between 200 and 150 miles to empty, I checked the spare tire and its tight, haven't had a chance to crawl under and look around yet though, I think something inside came loose. 2013 XLT.
View 2 RepliesFord Ranger / B-Series :: 2003 - Clank Sound When The Truck Shifts From 1st To 2nd
I have an 03' Ranger and I assume it has the BW 1354 tcase. I am getting a "clank" sound when the truck shifts from 1st to 2nd. I am thinking its the rear output yoke on the t case. I can grab it and move it up and down but there is no fluid leaking or anything. Would this be a rear bearing problem?
View 2 RepliesFord Super Duty (1999-2016) :: 2006 - Low Pitched Revolving Dull Scraping Sound When Traveling Slowly
On my 2006 4X4, I noticed a low pitched revolving dull scraping sound when I was traveling slowly. It was more noticeable on a hard left turn. The sound increased in speed as I drove faster and slower when I backed off. My brake pads are fine with 6 month old rotors. I suspect either a bad hub bearing or U-joint on it's way out. I have approx 114k on the clock and attach an 8ft plow for my driveway alone. What's the easiest way to check?
View 4 RepliesFord - Ranger :: 1994 V6 - Clicking Noises When Hauling A Load At Highway Speeds
My 94 ranger 4.0 v-6 makes clicking noises when hauling a load at highway speeds. How do i correct this?
View 4 Replies