Ford Super Duty (1999-2016) :: Brake Lights Blowing Fuse
I have 1999 ford f250 superduty 5.4 v8 I noticed that my tail lights were not working I replaced the fuse as it was blown break lights worked until i cranked up and applied brakes. I replaced fuse again an checked brake lights they worked fine until i cranked truck and applied the brakes i did notice the wires were hot at brake pedal switch when they worked while not cranked. I replaced the cruise control release switch I was told that may be the problem since cruise didn't work. it fixed the cruise control but as soon as i pressed the brakes fuse blew again.I replaced brake pedal switch didnt fix it.
I then noticed a little smoke under tailgate i looked and the wire coming out of connector was hot while brakes applied and not cranked. i disconnected that wire put a new fuse in and brake lights worked in center light and passenger side without blowing fuse driver side however does not work. Because I disconnected the brake light wire to driver side green wire. When I reconnected the driver side brake light wire fuse blew.
So I have it narrowed down to driver side brake light. here is my problem. I have checked all the wires that i can see for bad or frayed /worn naked places i have found none I can get to the wires beside gas tank running the rail to check but it is doubtful that it is spot as nothing is rubbing along there. Could it be a relay somewhere? can i just run a new wire from brake light? if so where to i connect to? Is there a wiring harness i can just buy and replace the brake light wires from brake light to power source I have ran out of things to check on my own...
Ford Super Duty (1999-2016) :: Fuse 13 Keeps Blowing - Brake Lights / Turn Signals And Hazards Don't Work
Every time I step on the brakes, there is a bright spark in fuse #13. My brake lights, turn signals and hazards don't work. At this point my truck isn't drivable.
According to the owner's manual in my truck, says circuit #13 is for "stop lamps, CHMSL/hazard, trailer tow stop lamp, and speed control."
I'm assuming that the hazard part covers the turn signals as well, but I know the cruise control works even when the fuse is blown. I used it last night on the way home (this was before I realized I didn't have brake lights).
So I know I have a short somewhere. The only mods I've done to the lights are aftermarket headlights, but if the fuse only gets blown when I step on the brakes, I don't see what that would have to do with it. Also, the lights have been installed and working for about a month before this started. The only thing that I did around the same time was install the gauges. I ran the power to them from #5, the customer access circuit.
Are there any other "common" areas for this to happen? I already removed the rear brake lights and it didn't work. I am quickly running out of 20A mini fuses.
Camry :: 2003 - Rear Brake Lights / Fuse Keeps Blowing The Instant When Step On The Brake
I have an electrical problem with the rear brake lights on my 03 Camry. The fuse keeps blowing the instant I step on the brake. I replace it and it blows immediately. So now i can't drive it because I have no brake lights. I'm thinking there is a short somewhere, where to start my troubleshooting?
View 4 RepliesGolf IV / Jetta IV :: Brake Lights Are Out - Fuse Keeps Blowing
First of all, its not a faulty brake light switch. I just found out that my rear brake lights have been out. I went to check the fuse and it was blown. I've replaced it but the second i touch the brake pedal, it pops again. Things I've tried...
I checked the wiring for any exposed wiring and i didn't find anything.
I disconnected the entire light assembly from the connectors on both sides and the fuse still blew.
I'm suspecting a bad ground, (as there was a point when the lights would work, even when i touched the pedal, but as soon as i pop the trunk open, the fuse would blow.
Where the lights are grounded? Is there anything else i should check?
Pics for views....
Accent LC (2000-05) :: Brake Lights Keep Blowing The Fuse
I have a 2003 Accent and I'm having a problem with the brake lights not working. The tail lamps work when the night lights are turned on so it's not a bulb issue. The brake lights keep blowing the fuse. Brake lights will only work with a fresh, new fuse but only works for about a trip, give or take and then its blown.
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Fuse Keeps Blowing Out - No Parking Lights?
i have a 99 f350 psd, my problem is i don't have normal; FONT-SIZE: 100%; COLOR: dark green; FONT-FAMILY: inherit">parking</NOBR> and instrument lights, it blows fuse number 8 as soon as i turn the switch on. i checked all the wiring on my tail lights and the trailer hookups. i even disconnected the wiring harness going my tail lights and trailer hookups and it still blows the switch. #8 fuse is trailer tow electronic brake, illumination, park lamps, trailer tow park lamp relay coil. it also blows #4 fuse which is trailer tow backup lamps, trailer tow park lamps.
View 14 RepliesFord Super Duty (1999-2016) :: 2005 F350 - Reverse Lights Blowing Fuse
My 2005 f350 reverse lights just started to not work . So I checked the fuse and it was blown and every time I put new fuse in it blows, where to check. Sounds like a ground issue am I correct .
View 4 RepliesFord Super Duty (1999-2016) :: 2002 F350 - Fuse Keeps Blowing Every Time When Touch The Brake Pedal
I have a 2002 f350 7.3 PS that every time I touch the brake pedal it blows the #6 fuse(trailer tow brake/turn signal). I need to use my trailer.
View 14 RepliesHonda :: Tail Lights Keep Blowing The Fuse
The tail lights on my car keep blowing the fuse, I can't find a short or anything that suggests a problem in the wiring, it's a 7.5A fuse, it blew a 10A but seems to be working on a 15A. How much trouble is that 15A gonna bring me!!
View 3 RepliesPassat (B6) :: Fuse For Interior Lights Keeps Blowing Out
My interior lights, including mirror lights and overhead interior light keep blowing my fuse. This is the 3rd fuse that's gone in a month. I am out of warranty finally. Would it be safe to upgrade the 5 amp to a 7 or 10 amp fuse. I am not about to chase down a possible short through my headliner/dash...
View 14 RepliesFord Super Duty (1999-2016) :: 1995 F250 - No Turn Signals - Brake / Rear Running Lights - Fuse Ok?
I have a 1995 Ford f250 Powerstroke and i do not have turn signals, rear running lights, brake lights or reverse lights. i checked the fuses and they seem to be good but i dont want to tear everything out to check the harness if it could be a bad ground. any insight?
View 1 RepliesFord Ranger / B-Series :: Reverse Lights Fuse 26 Blowing
Since last summer my truck keeps blowing fuse 26 and then I have no reverse lights. If I replace the fust its ok for a bit but blows again the same day sometime. The book says its the fuse for revers and overdrive. The overdrive button on the tree shifter stops working too but the truck does not seem to be revving any higher so I think the overdrive itself is fine. I can't find the short but its got to be shorting somewhere...
View 14 RepliesFord Ranger / B-Series :: 1986 - Brake Light Fuse Keeps Blowing
I've got an 86 ranger sport and I'm having trouble with the lights. The turn signals work, and ALL 4 bulbs in the back are new. The brake light fuse keeps blowing, and the fuse for the tail lights is good but they won't come on at all. I was told there was a direct short somewhere, does that sound about right? And is there a common place where they tend to short out?
View 2 RepliesElectrical-wiring - Brakes - Suzuki - Grandvitara :: 2001 - Brake Light Fuse Keeps Blowing
I'm having brake light issues with a 2001 Suzuki Grand Vitara. The brake light fuse keeps blowing. The last time driven with me following the driver side brake light was dimmer than the passenger side. At one stop the driver side brake light pulsed brighter for a split second then went back to dim. A few stops later it became as bright as the passenger side and stayed that way for the rest of the trip. The driver put in a breaker fuse and it was in during the observed trip. I'm not sure of the brake light visual symptoms without the breaker fuse in other than that the fuse keeps blowing which prevents the vehicle from being shifted out of park. What the problem could be? Bad ground?
View 4 RepliesCorolla / Matrix 2009-13 :: Lock And Interior Lights Don't Work - Dome Light Fuse Blowing Off
I got Corolla 2012. Dome light fuse 10 amp is blowing off as soon as you put it in. Light bulbs checked seems it is not a problem. Maybe relay?
View 11 RepliesPrius (2010-12) :: Tail / License And Rear Turn Signal Lights Not Working - Fuse Blowing
This issue came on suddenly. I unplugged the license plate lights- fuse still blew. I don't know where the wire harness is for this group of wires going to these lights to check for frayed or melted wires. I don't see any damage any where. I am severely limited for funds for a mechanic so I need to try and figure this out first myself. Looking for pictures of how I can traces the wires through the car?
View 1 RepliesGolf IV / Jetta IV :: No Brake Lights / Fuse Is Okay
I have a 2002 Jetta Wagon 1.8 t I got pulled over the other day for no brake lights, and I figured it was just a fuse, but I had a look and it isn't that. the middle light thing in the top of the window comes on, so I know the switch works. (is is mechanical on the pedal, or hydraulic pressure?) Both taillights come on, but neither brake light. What's going on here?
View 11 RepliesToyota - Sienna :: 1999 - DOME Fuse Keep Blowing
My 1999 Toyota Sienna DOME fuse keep blowing and don't know how to find the short. At first, it happens once in a while and I replaced the fuse for few time. Now, it happen permanently (in the way, this is good, I think) so no clock or remote control key cannot be used anymore. Where the short could be?
View 3 RepliesFord - Explorer :: 1991 - No Brake Lights - Fuse Ok?
I just got a '91 Explorer. It has no brake lights at all. I've checked all the fuses and everything's fine there.
What's the next thing to look at? I can't say I've seen this problem before.