Camry :: 2003 - Rear Brake Lights / Fuse Keeps Blowing The Instant When Step On The Brake
I have an electrical problem with the rear brake lights on my 03 Camry. The fuse keeps blowing the instant I step on the brake. I replace it and it blows immediately. So now i can't drive it because I have no brake lights. I'm thinking there is a short somewhere, where to start my troubleshooting?
View 4 RepliesAccent LC (2000-05) :: ECU 1 Fuse Keeps Blowing - System Voltage Low Code
I have a 2005 accent that keeps blowing the ecu 1 fuse. It is also showing a code for "system voltage low", and the battery is wet around both posts. I read somewhere else that the alternator could be surging and blowing this fuse. Had both alternator and battery checked at autozone, battery is said to be on the way out and alternator shows its fine. Battery does not show any problems, start car just fine.
View 7 RepliesGolf IV / Jetta IV :: Brake Lights Are Out - Fuse Keeps Blowing
First of all, its not a faulty brake light switch. I just found out that my rear brake lights have been out. I went to check the fuse and it was blown. I've replaced it but the second i touch the brake pedal, it pops again. Things I've tried...
I checked the wiring for any exposed wiring and i didn't find anything.
I disconnected the entire light assembly from the connectors on both sides and the fuse still blew.
I'm suspecting a bad ground, (as there was a point when the lights would work, even when i touched the pedal, but as soon as i pop the trunk open, the fuse would blow.
Where the lights are grounded? Is there anything else i should check?
Pics for views....
Mercury :: 1999 Brake Lights Fuse Keeps Blowing
1999 Mercury Villager Estate. The brake light wouldn't illuminate. Found that the brake light fuse (20A) was blown. Put another in and it blew as I was inserting it. Figure there's a short somewhere, so I've disconnected both brake/tail light units in the back, the towing light connection, and have even completely disconnect the 3 brake light switches under the dash (yes, 3.... 2 directly attached to the brake pedal and one attached to the e-brake). Still, when I insert a 20A fuse (which is what is called for), it immediately blows.
Since I've disconnected the brake light switches, it seems to me the short can't be past that on the way to the back of the vehicle. Maybe I'm wrong though. It seems the short must be either between the switches and the fuse box, or somewhere between the fuse box and the battery. Unsure if the wiring routes through any relays under the hood, but I'd think it would at least have to go through one of the relay boxes since that's what eventually gets directly connected to the battery. I've tried using my multimeter to measure the voltage and resistance on either side of the space where that fuse goes, but I'm unsure what to expect from a reading like that, so those results are inconclusive.
Ford Super Duty (1999-2016) :: Brake Lights Blowing Fuse
I have 1999 ford f250 superduty 5.4 v8 I noticed that my tail lights were not working I replaced the fuse as it was blown break lights worked until i cranked up and applied brakes. I replaced fuse again an checked brake lights they worked fine until i cranked truck and applied the brakes i did notice the wires were hot at brake pedal switch when they worked while not cranked. I replaced the cruise control release switch I was told that may be the problem since cruise didn't work. it fixed the cruise control but as soon as i pressed the brakes fuse blew again.I replaced brake pedal switch didnt fix it.
I then noticed a little smoke under tailgate i looked and the wire coming out of connector was hot while brakes applied and not cranked. i disconnected that wire put a new fuse in and brake lights worked in center light and passenger side without blowing fuse driver side however does not work. Because I disconnected the brake light wire to driver side green wire. When I reconnected the driver side brake light wire fuse blew.
So I have it narrowed down to driver side brake light. here is my problem. I have checked all the wires that i can see for bad or frayed /worn naked places i have found none I can get to the wires beside gas tank running the rail to check but it is doubtful that it is spot as nothing is rubbing along there. Could it be a relay somewhere? can i just run a new wire from brake light? if so where to i connect to? Is there a wiring harness i can just buy and replace the brake light wires from brake light to power source I have ran out of things to check on my own...
Accent LC (2000-05) :: Lights On Driver Side Won't Work - It Is Fuse?
All my lights on the driver side don't work, replaced brake light and then nothing. Would it be a fuse? if so which one or wiring and how would I go about finding the fault.
View 1 RepliesFord Super Duty (1999-2016) :: Fuse 13 Keeps Blowing - Brake Lights / Turn Signals And Hazards Don't Work
Every time I step on the brakes, there is a bright spark in fuse #13. My brake lights, turn signals and hazards don't work. At this point my truck isn't drivable.
According to the owner's manual in my truck, says circuit #13 is for "stop lamps, CHMSL/hazard, trailer tow stop lamp, and speed control."
I'm assuming that the hazard part covers the turn signals as well, but I know the cruise control works even when the fuse is blown. I used it last night on the way home (this was before I realized I didn't have brake lights).
So I know I have a short somewhere. The only mods I've done to the lights are aftermarket headlights, but if the fuse only gets blown when I step on the brakes, I don't see what that would have to do with it. Also, the lights have been installed and working for about a month before this started. The only thing that I did around the same time was install the gauges. I ran the power to them from #5, the customer access circuit.
Are there any other "common" areas for this to happen? I already removed the rear brake lights and it didn't work. I am quickly running out of 20A mini fuses.
Accent LC (2000-05) :: Brake Lights Are Always On
My brake lights are always on. When i turn my lights on the brake lights are on as if i am pressing the brakes. Very annoying for people behind me obviously, especially at night. If my lights are turned off and i press the brakes all the dash lights come on.. depress the brakes they go off. I've tried changing the brake switch above the pedal.. changed fuses.. can't figure it out.
View 3 RepliesAccent LC (2000-05) :: 2002 - Brake Lights Will Not Come On At All
The car is a 2002 Accent GL LC ...
Here's my problem, The brake lights will not come on at all.
I've checked all the fuses, they're fine. Same with all the globes. I can't source a wiring diagram anywhere so I just started looking for faults.
I started with the pedal switch. There is no power getting to it at all but it earths fine. I thought the feed from the battery could be severed so I fed 12v straight to it. The switch works, but the lights are still not getting power.
To follow any of the wires in either direction from the switch, it looks like I'll have to remove the dash and that's really something I don't want to attempt without a good reason.
Passat (B5) :: 2000 - Fuse 15 Keeps Blowing
My 2000 Passat 1.8T is being evil again. Fuse 15 keeps blowing and I can't seem to find where the short is... however, its stuck at my work. Its a pretty big short, the fuse sparks as soon as I put the fuse near it. BIG SPARKS. Any way to start it without that fuse in?
View 1 RepliesHonda :: Tail Lights Keep Blowing The Fuse
The tail lights on my car keep blowing the fuse, I can't find a short or anything that suggests a problem in the wiring, it's a 7.5A fuse, it blew a 10A but seems to be working on a 15A. How much trouble is that 15A gonna bring me!!
View 3 RepliesPassat (B6) :: Fuse For Interior Lights Keeps Blowing Out
My interior lights, including mirror lights and overhead interior light keep blowing my fuse. This is the 3rd fuse that's gone in a month. I am out of warranty finally. Would it be safe to upgrade the 5 amp to a 7 or 10 amp fuse. I am not about to chase down a possible short through my headliner/dash...
View 14 RepliesFord Ranger / B-Series :: 2000 - Fuse Keeps Blowing On
2000 Model, The fuse keeps blowing on this. I thought it was the cruise control fuse because the cruise kept not working and when I replaced fuse it would work. Only for a little though, then I looked at manual and it says the fuse is for the brake position switch. I am presuming this is just like the old days and that is the brake light switch under the dash. They use to have two wires now there is like five. Anyways I do not see any bare wires or anything that would blow a fuse, is it common for these switches to go out or what??
View 13 RepliesFord Ranger / B-Series :: Reverse Lights Fuse 26 Blowing
Since last summer my truck keeps blowing fuse 26 and then I have no reverse lights. If I replace the fust its ok for a bit but blows again the same day sometime. The book says its the fuse for revers and overdrive. The overdrive button on the tree shifter stops working too but the truck does not seem to be revving any higher so I think the overdrive itself is fine. I can't find the short but its got to be shorting somewhere...
View 14 RepliesFord Ranger / B-Series :: 1986 - Brake Light Fuse Keeps Blowing
I've got an 86 ranger sport and I'm having trouble with the lights. The turn signals work, and ALL 4 bulbs in the back are new. The brake light fuse keeps blowing, and the fuse for the tail lights is good but they won't come on at all. I was told there was a direct short somewhere, does that sound about right? And is there a common place where they tend to short out?
View 2 RepliesCamry :: 2000 4Cyl Std Tranny Keeps Blowing Out Fuse And Car Shutting Down
Every 3 or 4 days my 2000 Camry 4Cyl Std Tranny keeps blowing out the 30A Buss Fuse in the under hood fuse box. What this fuse runs and what could be the problem. I don't think my Fan Motors are running could this cause the Fuse to pop.
View 11 RepliesFord Excursion :: 2000 V10 - Fuse 19 Keep Blowing - All Gauges And Speedometer Die?
I have a 2000 Excursion V10, I keep blowing the #19 10A miniature fuse while I am going down the road. All gauges and speedometer all of sudden die but the vehicle keeps running until I turn it off. When I try to restart she won't fire until I put a new fuse in.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Fuse Keeps Blowing Out - No Parking Lights?
i have a 99 f350 psd, my problem is i don't have normal; FONT-SIZE: 100%; COLOR: dark green; FONT-FAMILY: inherit">parking</NOBR> and instrument lights, it blows fuse number 8 as soon as i turn the switch on. i checked all the wiring on my tail lights and the trailer hookups. i even disconnected the wiring harness going my tail lights and trailer hookups and it still blows the switch. #8 fuse is trailer tow electronic brake, illumination, park lamps, trailer tow park lamp relay coil. it also blows #4 fuse which is trailer tow backup lamps, trailer tow park lamps.
View 14 RepliesElectrical-wiring - Brakes - Suzuki - Grandvitara :: 2001 - Brake Light Fuse Keeps Blowing
I'm having brake light issues with a 2001 Suzuki Grand Vitara. The brake light fuse keeps blowing. The last time driven with me following the driver side brake light was dimmer than the passenger side. At one stop the driver side brake light pulsed brighter for a split second then went back to dim. A few stops later it became as bright as the passenger side and stayed that way for the rest of the trip. The driver put in a breaker fuse and it was in during the observed trip. I'm not sure of the brake light visual symptoms without the breaker fuse in other than that the fuse keeps blowing which prevents the vehicle from being shifted out of park. What the problem could be? Bad ground?
View 4 Replies