Camry :: 1998 - Brake Lights Will Not Come On When Step On Pedal
I recently installed an aftermarket rear spoiler with third light. While searching and testing for a hot brake wire to hook up to, I somehow accidentally shorted out the brake lights. They will not come on when i step on the brake pedal.
I checked the corresponding fuse and it is still intact. The brake light symbol on the dash is "on" so I know the "brake light out" sensor is still working....is there something im missing in getting the brake lights to work again ?
Golf IV / Jetta IV :: Brake Lights Are Out - Fuse Keeps Blowing
First of all, its not a faulty brake light switch. I just found out that my rear brake lights have been out. I went to check the fuse and it was blown. I've replaced it but the second i touch the brake pedal, it pops again. Things I've tried...
I checked the wiring for any exposed wiring and i didn't find anything.
I disconnected the entire light assembly from the connectors on both sides and the fuse still blew.
I'm suspecting a bad ground, (as there was a point when the lights would work, even when i touched the pedal, but as soon as i pop the trunk open, the fuse would blow.
Where the lights are grounded? Is there anything else i should check?
Pics for views....
Mercury :: 1999 Brake Lights Fuse Keeps Blowing
1999 Mercury Villager Estate. The brake light wouldn't illuminate. Found that the brake light fuse (20A) was blown. Put another in and it blew as I was inserting it. Figure there's a short somewhere, so I've disconnected both brake/tail light units in the back, the towing light connection, and have even completely disconnect the 3 brake light switches under the dash (yes, 3.... 2 directly attached to the brake pedal and one attached to the e-brake). Still, when I insert a 20A fuse (which is what is called for), it immediately blows.
Since I've disconnected the brake light switches, it seems to me the short can't be past that on the way to the back of the vehicle. Maybe I'm wrong though. It seems the short must be either between the switches and the fuse box, or somewhere between the fuse box and the battery. Unsure if the wiring routes through any relays under the hood, but I'd think it would at least have to go through one of the relay boxes since that's what eventually gets directly connected to the battery. I've tried using my multimeter to measure the voltage and resistance on either side of the space where that fuse goes, but I'm unsure what to expect from a reading like that, so those results are inconclusive.
Accent LC (2000-05) :: Brake Lights Keep Blowing The Fuse
I have a 2003 Accent and I'm having a problem with the brake lights not working. The tail lamps work when the night lights are turned on so it's not a bulb issue. The brake lights keep blowing the fuse. Brake lights will only work with a fresh, new fuse but only works for about a trip, give or take and then its blown.
View 1 RepliesFord Super Duty (1999-2016) :: Brake Lights Blowing Fuse
I have 1999 ford f250 superduty 5.4 v8 I noticed that my tail lights were not working I replaced the fuse as it was blown break lights worked until i cranked up and applied brakes. I replaced fuse again an checked brake lights they worked fine until i cranked truck and applied the brakes i did notice the wires were hot at brake pedal switch when they worked while not cranked. I replaced the cruise control release switch I was told that may be the problem since cruise didn't work. it fixed the cruise control but as soon as i pressed the brakes fuse blew again.I replaced brake pedal switch didnt fix it.
I then noticed a little smoke under tailgate i looked and the wire coming out of connector was hot while brakes applied and not cranked. i disconnected that wire put a new fuse in and brake lights worked in center light and passenger side without blowing fuse driver side however does not work. Because I disconnected the brake light wire to driver side green wire. When I reconnected the driver side brake light wire fuse blew.
So I have it narrowed down to driver side brake light. here is my problem. I have checked all the wires that i can see for bad or frayed /worn naked places i have found none I can get to the wires beside gas tank running the rail to check but it is doubtful that it is spot as nothing is rubbing along there. Could it be a relay somewhere? can i just run a new wire from brake light? if so where to i connect to? Is there a wiring harness i can just buy and replace the brake light wires from brake light to power source I have ran out of things to check on my own...
Metro :: 1996 Geo - Ignition Fuse Keeps Blowing The Instant Key Is Turned
I have a 1996 geo metro that I have been working on for the last couple days. The problem that I have been running into is the ignition fuse keeps blowing the instant that the key is turned.
This kills the power to the fuel pump as well as the power to the ECM. (killing all the idiot lights). The engine still cranks over and all the accessories still work.
I have tried disconnecting the fuel pump wires as well as the ECM and the ignition module to try and narrow down the problem but the fuse still blows about 2 seconds after I turn the key.
Ford Super Duty (1999-2016) :: Fuse 13 Keeps Blowing - Brake Lights / Turn Signals And Hazards Don't Work
Every time I step on the brakes, there is a bright spark in fuse #13. My brake lights, turn signals and hazards don't work. At this point my truck isn't drivable.
According to the owner's manual in my truck, says circuit #13 is for "stop lamps, CHMSL/hazard, trailer tow stop lamp, and speed control."
I'm assuming that the hazard part covers the turn signals as well, but I know the cruise control works even when the fuse is blown. I used it last night on the way home (this was before I realized I didn't have brake lights).
So I know I have a short somewhere. The only mods I've done to the lights are aftermarket headlights, but if the fuse only gets blown when I step on the brakes, I don't see what that would have to do with it. Also, the lights have been installed and working for about a month before this started. The only thing that I did around the same time was install the gauges. I ran the power to them from #5, the customer access circuit.
Are there any other "common" areas for this to happen? I already removed the rear brake lights and it didn't work. I am quickly running out of 20A mini fuses.
Honda - Odyssey :: Every Time Step On Brake Pedal, STOP Fuse Blows Out Under The Hood
I have a 2003 Honda Odyssey and every time I step on the brake pedal, it blows my STOP fuse under the hood (which takes out my ability to shift out of park, use my horn and the brake lights also go out.) When I replace my fuse, the horn does not blow the fuse, it is stepping on the brake pedal one time, even when in park before turning the key over.
Things I have tried: Changing all of my bulbs and inspecting the socket areas, inspecting most of the wiring and taping areas that seemed fine but might have been touching metal, replacing my brake light switch.
What could be doing this?! I have figured out that I can manually shift out of park using the override slot, but no brake lights is not good.
Ford 7.3L Power Stroke (1999-2003) :: 2002 F250 - Rear View Camera In Head Unit Comes On When Step On The Brake
2002 F250 diesel ... I found these two plastic pieces yesterday on the floor near the 4X4 shifter. I noticed the other day when i step on the brake the rear view camera in the head unit comes on, so i am thinking they are either a part of the brake switch on the pedal assembly, or something to do with the shift tube.
View 2 RepliesCamry :: 2008 - Brake And ABS Panel Lights Comes On / AC Starts Blowing Hot Air
My 2008 Camry sometimes when I am driving the brake and ABS panel lights comes on and the A/C starts blowing hot air, also all the panel starts behaving crazy. We put the scanner and it does not show any issues, otherwise the car runs smooth.
View 2 RepliesFord Super Duty (1999-2016) :: 1995 F250 - No Turn Signals - Brake / Rear Running Lights - Fuse Ok?
I have a 1995 Ford f250 Powerstroke and i do not have turn signals, rear running lights, brake lights or reverse lights. i checked the fuses and they seem to be good but i dont want to tear everything out to check the harness if it could be a bad ground. any insight?
View 1 RepliesCamry :: Rear Brake Lights Don't Work
Both rear brack lights don't work. It's not the bulb because when I press the alarm both of those bulbs lights up. The middle brake light in the back window works works. What can be the issue? I already check the fuse box but all was good ...
View 5 RepliesFord - Ranger :: Right Rear Turn Signal Dim And Will Not Flash When Step On Brake
I have a 1994 ford ranger .the problem is with the right rear turn signal. it works fine except when i step on the brake. At that time, it turns dim and will not flash. All of the other turn signals are not affected like this.i have checked the bulbs and they are all good. I mean the three in the rear tail lite.
View 3 RepliesSonata NF (2006-10) :: All 3 Brake Lights Activate Then Start To Blink When Step On Pedal
I just noticed it this morning. When I step on my brake pedal, all 3 brake lights activate, then they start to sporadically blink, I don't think it's a fuse problem, since the 3rd brake light also blinks, and I believe it runs independent of the regular brake lights.
What to check.. No codes are being listed, checked that with my Scangauge II already. (2006 GLS)
Ford Ranger / B-Series :: 1986 - Brake Light Fuse Keeps Blowing
I've got an 86 ranger sport and I'm having trouble with the lights. The turn signals work, and ALL 4 bulbs in the back are new. The brake light fuse keeps blowing, and the fuse for the tail lights is good but they won't come on at all. I was told there was a direct short somewhere, does that sound about right? And is there a common place where they tend to short out?
View 2 RepliesCamry :: Gen 5.5 Rear Brake Drums And Parking Brake - Lubrication?
Gen 5.5 (2006 LE (57K miles), Rear brake drums and parking brake.
I want to get my parking brake lubricated and rear drums cleaned and adjusted. Is is difficult to lubricate the parking brake?
I plan on getting this done with a Mobile One oil change at a local garage.
Electrical-wiring - Brakes - Suzuki - Grandvitara :: 2001 - Brake Light Fuse Keeps Blowing
I'm having brake light issues with a 2001 Suzuki Grand Vitara. The brake light fuse keeps blowing. The last time driven with me following the driver side brake light was dimmer than the passenger side. At one stop the driver side brake light pulsed brighter for a split second then went back to dim. A few stops later it became as bright as the passenger side and stayed that way for the rest of the trip. The driver put in a breaker fuse and it was in during the observed trip. I'm not sure of the brake light visual symptoms without the breaker fuse in other than that the fuse keeps blowing which prevents the vehicle from being shifted out of park. What the problem could be? Bad ground?
View 4 RepliesCamry :: 2003 - Rear Brake Replacement
2003 LE Camry i want to replace Rear brakes. Is there a DIY for it. I know it is challenging...
View 10 RepliesGolf IV / Jetta IV :: No Brake Lights / Fuse Is Okay
I have a 2002 Jetta Wagon 1.8 t I got pulled over the other day for no brake lights, and I figured it was just a fuse, but I had a look and it isn't that. the middle light thing in the top of the window comes on, so I know the switch works. (is is mechanical on the pedal, or hydraulic pressure?) Both taillights come on, but neither brake light. What's going on here?
View 11 Replies