Ford - Taurus :: 1996 - Sputter When Stop At Red Light - Check Engine Light Start Blinking
I changed my plugs a few days ago on my 96' Taurus GL 3.0LI checked under my hood to check the recommended gap size and it said .42 to .46.. I went with .46. after putting them in i started the car up just fine, but later in the day i noticed when I came to a stop at a red light my car would sputter and my check engine light would start blinking. When I'd accelerate and drive it again everything would clear up and the light would stop blinking. I didn't change the wires, just the plugs in case you were wondering but I am unsure of how much that would influence my problem. Today after work i had a little trouble starting my car. After a few tries it started and my exhaust smelt rich in gasoline. Did i gap them too much? Should i get new plugs again and regap them? should i buy new wires also?Is my ignition coil going bad?
View 19 RepliesTaurus :: 1996 Ford - Headlights Stay On When Ignition Off And Key Out
I have a 1996 Ford Taurus. With the headlight in the OFF position and the ignition off, key OUT, the headlights stay on. All other lights are off. The highbeam indicator in the cluster stays on also. I've disconnected the headlight switch (completely removed from vehicle), and the headlights still stay ON! I know absolutely nothing about this car.
View 7 RepliesFord - Taurus :: 1999 - Headlights Starter Reset
My son's 99 Taurus didn't want to start. At first thought it was a dead battery because of something left on, but jumping it didn't work. It starter was clicking like the solenoid was going out. Finally it did start and turned over fast like there wasn't a problem. I shut it off and restarted it again, no problem. Tried it a 3rd time and it wouldn't start again. Sometimes it clicked when I turned the key and sometimes it wouldn't do anything. Finally I had the wife turn on the headlights and turn the key while I stood in front to see if the headlights dimmed. The first time she tried it, the headlights went completely out. Not just dim, but completely off. The car started just fine after that and has been starting just fine ever since. Why this is?
View 3 RepliesFord - Taurus :: 1997 - Headlights Stay On All The Time And Battery Getting Down
The headlights stay on all the time & wear the battery down. I've replaced the DRL module with two new modules & neither fixed the problem. I even examined the headlight switch (some burn up at the switch), but this headlight switch & wiring look new. I even took the headlight switch out & the headlights still stayed on. I made sure that the new modules were grounded to the chasis properly.
View 11 RepliesTaurus :: 2011 Ford - Check Engine Light On But Car Runs Fine
The check engine light came on again after coming on about a week ago and then shutting of by itself. Everything seems to run normal with the car so I don't know if I should ignore the light and just keep driving or what. What would you do? My car is a 2011 Ford Taurus.
View 1 RepliesFord - Taurus :: Check Engine Light Flashes When Start The Car And It Idles
I have a 2001 ford taurus. just changed the engine with a used engine has 130k, did tuneup changing all spark plugs, wires and distributor cap. Also changed the 02 sensor upstream. And the check engine light remains on. if i start the car and it idles the check engine light flashes. but once i drive it, it just remains on. brought to the mechanic and he put on the machine and it reads that the problem is the 02 sensor upstream and the spark plugs misfiring. my mechanic is lost not sure what the problem is. someone told me it could be the manifold gaskets and pedlum gasket.
View 1 RepliesFord - Taurus :: 2000 - Check Engine Light Came One - Misfire In Cylinders 1 And 3
I have an old 2000 Ford Taurus that has been having some misfire issues. I replaced the wires and plugs about a year ago and hooray! it worked... until about a month ago when the check engine light came one. Misfire in cylinders 1 and 3... again. I ran some SeaFoam through and it did okay until this week, when the warning/flashing check engine light came back.
It is idling very hard (expected) and feels like it is trying to stall, even before the misfire came back (also to be expected??). So here is the question: is this a coil pack issue, or something more sinister (and expensive)?
Ford :: 2004 Taurus - Check Engine Light On After Torque Converter Replaced
This car has been giving me quite a bit of trouble lately. 04 Ford Taurus SES, about 97,000 miles on it. Just last weekend, it broke down on the highway. Found out the torque converter failed and needed to be replaced. I was suspecting that something was wrong with the transmission for a while now, because it would stutter sometimes when accelerating, and sometimes start shaking in the front when I turned it on. (It still stutters after having the torque converter replaced.)
Well now, a day after shelling out quite a bit of money to the dealer for this torque converter, the check engine light is on. I went to Autozone to check the codes, and they found P0300, P0305 (cylinder misfire) and P0316 ("crank sensor condition"). Is it possible the transmission is failing?? I found a bunch of complaints online about the transmission failing on the 04 Taurus. I'm trying to avoid more expensive repairs, but I don't want the car to break down on me again....
Also, a couple months ago, the check engine light went on a few times, but always went off within a day or two. Never did get it checked out because it didn't stay on long enough.
Ford - Taurus :: 2001 - Engine Light Flashing With Car Shaking And Dying When Idles
I have 104k miles on car, had tune up back in 09, new die hard battery from sears spring '10, just today my car started to shake when in idling, check engine light flashing. It seems to shake itself even while driving, when in idle it will then kill or die. Had radiator flushed January 2nd, 2011 due to heat not pumping through, still doesn't work (I know heater core) like it should. Finally the other problem is when I start & turn the car on it won't turn over-it wants to but takes a few tries like turning key each click like as if it were alternator, does sound like it would if it did turnover but like I said it takes a while & maybe will fire/catch. What the heck is going on? 2001 flex fuel as well but I only once put it in.
View 10 RepliesFord - Taurus :: Oil Pressure Light Comes On When Engine Heats Up And RPM Fall Below 1500 Or At Idle
I have a 2000 Ford Taurus V6 DOHC w/170K miles. When engine heats up, oil pressure light comes on, but only when RPM fall below 1500 or at idle. There is a burnt smell sometimes after driving the car. I do not see froth or coolant in the oil. Car burns a little oil, but no more than it has been for the last 50K miles. Just had oil and filter changed 300 miles ago; I was using 10W-30 but I believe the mechanic used 5W-30. (Also, if I drive more than 45 minutes, the "low coolant" light comes on-- however, the engine is not overheating, and the radiator/reservoir are full.) What part(s) I should order first? Oil pressure sensor? Oil pump? (If at all possible, I need to repair myself, as I simply cannot afford my mechanic's hourly rates right now.)
View 7 RepliesFord - Taurus :: 1998 - Check Engine Light Is On And Code Reads P0411
98 Taurus, 6cyl, 3.0L OHV, 184K miles. Check engine light is on and code reads "P0411 - secondary air injection system - incorrect flow". This is my son's hand me down car and has a rather large exhaust leak that I plan on fixing. Could this code be related ?? I found out that the CEL has been on for quite sometime now and the car is due for emissions testing (state inspection) in October.
View 3 RepliesFord - Taurus :: Check Engine Light Keep Flashing - Code PO302 Cylinder 2 Misfiring
I have a 1996 ford taurus lx v6 3.0 dohm..my check engine light flashing. then it stop flashing..i did replace spark plug,wires,coil pack..when it start to flash i put it gear the car start to shake and sputter.i really don't know why its doing that the car has about 150000 miles on it..i do get a code p0302 Cylinder #2 Misfire..the new plugs and wires and coil pack is about 2 weeks old..
View 11 RepliesFord Wiring/Electrical :: 1981 - Headlights / Dash Lights And Charging Light Will Flicker At Same Time
I have a 1981 F100, lately when I've been driving at night I notice my headlights, dash lights, and charging light will flicker at the same time, and even sometimes my headlights will flash on and off by themselves.
View 2 RepliesCamry :: 2003 - Fog Lights Not Connected / Wires Dangling In Front Bumper
I see some wires dangling in the front bumper which looks like fog lights plugs but I don't get it so is it just plug and play buy a new bumper with fog lights or something? My car doesn't have fog lights but it looks like there is wires for fog lights.
View 10 RepliesGolf IV / Jetta IV :: Battery Draining Too Much - When Connected With Negative Cable Lit Lights With Car Off?
My car has been having an issue with battery draw. when I don't drive it for 2-3 days the battery is drained enough for me to need my jump pack to start it. I have done a wire tuck on the motor and also have air ride. I hooked a wire up between the battery and the negative cable with a light connected and it lights up with the car off. What I have done so far is to pull each fuse in the door fuse panel individually and the light stayed on the entire time. Next I pulled the power feed to my air ride system out and the light flashes and I can hear what sounds like a relay clicking. If the issue were the air ride I would think disconnecting it would make the light go out.
I need to pull the fuse panel that was on top of the battery and pull those fuses out too. Should I try pulling the relays as well?
Honda - Cr-v :: Headlights And Tail Lights Do Not Turn On After Engine Repair
1998 Honda CRV ... Had my engine repaired....Everything seems to work but discovered my headlights and taillights won't turn on. The signal lights work fine.
The mechanic says the lights are not burnt out ... so the light switch must be damaged. He did not mention any fuses or other causes. So I buy another light switch (the light switch/signal light combination stick on left side of the steering column) and install it but they still don't work. It seems really unlikely that all 4 fuses (2 x each head lights + 2 x each taillights) would blow all at the same time.
What could be causing this? It seems really simple like they forgot to connect some wiring harness somewhere but the mechanic didn't mention it the first time I took it in for the problem.
Taurus :: 2002 SES Check Engine Light On And Code P1451
Check engine light on and code is P1451. I have been told its one or all four things:
1. Gas cap,
2. Evap Canister vent solenoid,
3. Evap purge solenoid,
4. Evap canister.
I am trying to fix this problem on the Taurus. I have changed the Gas cap and this did not solve the problem. The other three things on the list: Are these three separate things? Or are they part of the same thing?
Passat (B7) :: Custom Light Switch For Headlights That Turns Off All Lights Including DRL
I saw somewhere that Passat owners could get a special light switch for the headlights that had more options. I hate that when I am just sitting in my car waiting for a friend, that the DRL's are always running. In bad neighborhoods, I don't want to attract attention to myself or my car. I wish the off position would actually turn them off.
View 17 RepliesToyota - Sienna :: 2005 - Brake Lights Not Working After Emissions Testing Connected To Dataport
So I've got the exact same issue as the person who posted this: [URL] ....
Brake lights not working on Toyota Sienna 2005 XLE after emissions testing connected to the dataport. Went to the Toyota dealership this afternoon and it looks like a wiring issue. Also found out when the left blinker is engaged, it blows the 10A STOP fuse which then causes the ABS and VCS(?) lights to illuminate. What a mess....
Is the easiest way to fix this just to run a new wire to the affected area? The folks at the dealership seemed to suggest they were going to need to rip out all the interior to find the break in the circuit. Timing-wise, this problem starting happening right after I went to get emissions checked and they plugged a cable into the data port to pull emissions(?) and other data.
My hunch is that these two events are directly related but I don't have much knowledge of how things are wired up , what might have caused this problem.