Ford - Taurus :: Check Engine Light Flashes When Start The Car And It Idles
I have a 2001 ford taurus. just changed the engine with a used engine has 130k, did tuneup changing all spark plugs, wires and distributor cap. Also changed the 02 sensor upstream. And the check engine light remains on. if i start the car and it idles the check engine light flashes. but once i drive it, it just remains on. brought to the mechanic and he put on the machine and it reads that the problem is the 02 sensor upstream and the spark plugs misfiring. my mechanic is lost not sure what the problem is. someone told me it could be the manifold gaskets and pedlum gasket.
View 1 RepliesFord - Taurus :: Check Engine Light Keep Flashing - Code PO302 Cylinder 2 Misfiring
I have a 1996 ford taurus lx v6 3.0 dohm..my check engine light flashing. then it stop flashing..i did replace spark plug,wires,coil pack..when it start to flash i put it gear the car start to shake and sputter.i really don't know why its doing that the car has about 150000 miles on it..i do get a code p0302 Cylinder #2 Misfire..the new plugs and wires and coil pack is about 2 weeks old..
View 11 RepliesFord - Aerostar :: Check Engine Light Flashing / Acceleration Creates Shaking
My mechanic said one cylinder isnt working though we havent done any checking beyond wires. It's not worth putting money into but I cannot afford to get anything else. Will driving on just the 5 cylinders create increased damage or other issues that will get me stranded? it starts right up, is rough but levels out after a couple minutes It is smooth driving under 40mph, but acceleration above that creates shaking and check engine light flashing, no ominous ticking noises but can tell not firing on all cylinders. Problem is I will have to drive it highway speeds at some point-tried it before and made it-was able to eventually baby it up to the required traffic mph with the shaking diminishing and smoothing out but rattling started up again every time I had to hit the accelerator to increase the speed. What can I expect by continuing to drive it?
View 8 RepliesFord - Explorer :: 1999 - Misfiring / Shaking / Rough Idle - Engine Light Flashing
My 99 Explorer XLT V6 SOHC has been misfiring lately. In idle the RPM needle fluctuates a bit and the vehicle vibrates and shakes. At night when the lights are on I notice them dim a bit as the engine struggles in idle. It doesnt stall very often at all. Accelerating I notice way less power and the engine studders. Thats when the engine light comes on flashing. Then remains on solid afterwards.
I brought it to a mechanic friend who read the code and it was cylinder two misfire as well as O2 censor. I replaced the plugs and leads and censor. Noticed the plug in cylinder two had little to no gapping. Thought I had fixed the problem. Vehicle ran perfect. Three or four days later driving on the hwy same problem came back. Thinking it must be the coil pack I got one for a good price and replaced it.
Again, the truck ran great for four days and now the problem has returned. Same thing, shaking studdering and flashing engine light. I have verified the locations of the wires and plugs a few times so i believe they are all properly installed.
Santa FE SM (2001-06) :: Engine Racing At Idle And Then Dying At Stop Light
Bought a 2001 from a used car dealership about 2 months ago. A week later it started acting funny. It would often race the rpm's about 2000 when at at stop light and then others times would act like I was out of gas when I would take off. Sputtered and then finally run normally. Then other times it wouldn't start and just crank over and over. After 10-15 times it would fire up and then act like nothing was wrong. It was a total crap shoot whether it would start or not each time.
Took it back to dealership and supposedly their mechanic installed a new fuel pump. Ran like a champ for about another two weeks and then exact same symptoms started showing up.
Ford - Taurus :: Overdrive Light Flashing When Get Over 60 Mph
I have a 1996 ford taurus dohc v6 147239 miles..when i get over 60 mph my overdrive light starts flashing and the car still drives find..i did have new transmission fluid and new fillter put in and the light was coming on before i did that and still comes on when i get over 60 mph.
View 3 RepliesFord - Taurus :: 1996 - Overdrive Light Flashing When Get Over 60 Mph
I have a 1996 ford taurus dohc v6 147239 miles..when i get over 60 mph my overdrive light starts flashing and the car still drives find..i did have new transmission fluid and new fillter put in and the light was coming on before i did that and still comes on when i get over 60 mph.
View 1 RepliesGolf IV / Jetta IV :: 2001 Mk4 - Check Engine Light Flashing
So my gf's check engine light on her 01 Golf flashes once in a while, and it misfires. But the thing is, it doesn't stay on, and it's once in a while (like once or twice a week). She has new spark plugs, and new wires. I have a feeling it's the coil pack, but I really don't know if it needs to be replaced until the check engine light actually stays on.
View 14 RepliesGolf IV / Jetta IV :: 2001 GTI VR6 - Check Engine Light Flashing
Just a few days ago I was driving and I noticed as I went over 35 mph my car would stutter and the check engine light would start flashing. And when I slowed back down the car drove fine. I'm wondering what the problem could be? Feels like the car is losing power. Car is currently at 119k miles.
View 1 RepliesPrius (2001-03) :: 2002 - Occasional Check Engine Light Flashing
I have had a 2002 Prius since December of 2012, and it has been running fine since I got it; while it was in a wreck in May 2013 that has rendered both passenger-side doors and windows unusable, I have not seen that incident cause any other problems, and the car still runs perfectly fine. I am supposed to be driving from my current home state for a job soon, but about a week ago while I was driving on the interstate, the check engine light started flashing.
I was changing lanes and putting a good bit of pressure on the gas in order to pass someone that was going below the speed limit, putting my speed at around 80 mph when the check engine light started flashing. I started getting off of the interstate to find a place to stop and inspect things, but the light stopped flashing when I got down to around 45 mph on the exit ramp, and I was able to drive the rest of the way on the interstate without any trouble, even when I got in the 75 mph range again. The span of time between the light starting to flash and turning off again was probably about a minute or so.
Elantra XD (2001-06) :: 2005 Hesitates To Start / Check Engine Light Flashing
This issue has only happened twice to me.
I go out to start the car, it cranks and cranks and cranks. I stop turning the key. I then try again and it hesitates to starts. I give it a little gas and it starts. When it does this, the car begins running very rough and idling rough. When I give it a little gas while it's parked, the check engine light begins flashing at me.
I turned the car off and came back to it the next morning (maybe 10 hours apart). It started right up no problem, no CEL either.
2001 Chrysler Concorde - Check Engine Light Start Flashing When Put Pedal Down To Floor
When I put the pedal down to the floor for a little fun my check engine light will start flashing. I'm not sure how many times or for how long but it worries me.. The check engine light has been on but the car does have 233,000 miles on it but new engine was put in 100,000 ago
View 1 RepliesElantra XD (2001-06) :: Rough Running With Low Power And Flashing Engine Light - Cylinder Sparks
I have a 2001 elantra 2.0 gls. It is running rough with low power and flashing engine light. It may have a bad 02 sensor but when checked for spark only the 2 and 3 cylinders were sparking. I can confirm this because when I unplugged the 1 and 4 spark plugs it made no difference in the way it was running. Next I tested the resistance on the coil packs. Both were an even 1.5 ohms. How can it be that the coil packs are good yet the plugs aren't firing? I also have moved plug wires around and have had no success.
View 8 RepliesToyota Corolla :: 1999 - Engine Shaking / CEL Flashing (Error Codes)
1999 Toyota Corolla
Error codes: P0301 ... P0304 ... P0300 ... P0420
Symptoms: Car had short touch of the shakes in the morning, parked it for 8 hrs, drove half a mile, and it got the shakes bad and seems like it wants to stall out and the check engine started flashing. After a minute it went back to normal, and then the whole thing happened off and on the last half mile home.
Background: I was told the catalytic converter was in bad shape last time I took her in so I'm assuming that's it. Friend of mine suggested driving it hard to burn out impurities in the cat, but I'm worried about damaging the engine. Going to replace the sparks and spark wires (they're about due anyways).
Ford - Taurus :: 2001 - Transmission Went Out As Started From Stop Light
I have 2001 ford taurus the transmission went out on me -as i started from stop light the transmission sounded like it was going into gear all the way I let off the gas and it went into gear this happened a few more times until i got on interstate and when i interstate no problems at all with transmission then I pulled off to go home and mre stop lights it acted same way then after a few more lights i gave it the gas from stop light and no forward gears i do have reverse is a sensor bad ...
View 15 RepliesFord - Taurus :: 2003 - Shaking Back And Forth At 55 MPH
My 2003 shakes/jerks back and forth at 55 mph. Took to a mechanic, they found nothing...car did not jerk. Check engine light on (although it has been on for years)... Checked transmission codes and found nothing...could be oxygen sensor?
View 3 RepliesFord Ranger / B-Series :: 2003 - Valve Cover Leak / Exhaust Smell Then Started Bogging / Dying And Shaking
I have a 2003 ford ranger 2.3 vin d 5 speed, this truck originally... Took it in for wires plugs front brakes fuel filter battery and added a small cold air intake. We discovered a valve cover leak and while repairing guy drops a screw into a valve and when finished he started it lodged the screw between the valve, shearing off a cam sprocket bolt. Throwing the timing. 2 valves on the exhaust side were bent and replaced. no damage to the head.
Timing was reset and the truck was running. 2 days later truck is running/had a hint of exhaust smell then started bogging dying and shaking, at which time we got an 02 bank2 lean code and fixed that. it cleared code and didn't fix it. From there we replaced coil, imrc intake bc of a crack, tried and check all vacuum, reset the timing. Timing would slip before but no longer than 10 minutes every time truck started.
Found the hole in the timing cover that holds the bolt to torque? to harmonic balancer was broke. replaced along with the diamond washers and cam sprocket bolts. timing finally held crank sensor was adjusted. truck came home for one day running good, we had removed the cold air intake and replaced the factory air intake. next day it was so slow outta first gear, you must baby the throttle, if you floor It, it sputters and kinda pops, truck stays slow all the way to about 10 mph and 2000rpm then it begins grabbing speed, 3000rpm is where this truck shifts the best, 2nd is better, third better than that.
As rpm increase the truck runs better, it idles steady at 1100-1200rpm at stops with an audible miss and then struggles again on takeoff. Here what im wondering, the truck has an abs sensor that just came on, but no codes showing now.tomorrow I wil run matko determinator 3.0 on it. and test the catalytic converter. first how do I check the timing belt to see if it stretched? do these trucks store the p.i.d.s. koer or kams that could cause one, all, or any of this and if so do I have to have it flashed from ford or can you manually do this without a drive cycle test.
Ford - Taurus :: 1996 - Sputter When Stop At Red Light - Check Engine Light Start Blinking
I changed my plugs a few days ago on my 96' Taurus GL 3.0LI checked under my hood to check the recommended gap size and it said .42 to .46.. I went with .46. after putting them in i started the car up just fine, but later in the day i noticed when I came to a stop at a red light my car would sputter and my check engine light would start blinking. When I'd accelerate and drive it again everything would clear up and the light would stop blinking. I didn't change the wires, just the plugs in case you were wondering but I am unsure of how much that would influence my problem. Today after work i had a little trouble starting my car. After a few tries it started and my exhaust smelt rich in gasoline. Did i gap them too much? Should i get new plugs again and regap them? should i buy new wires also?Is my ignition coil going bad?
View 19 RepliesFord - Taurus :: 2001 - 3.0 Engine Misfire Consistently / Code P0301
I had a consistent misfire on this car and finally got a P0301 trouble code. I installed new Autolite AP 104 plugs and wires. Now, when I start the engine. it runs perfectly. But when I put it in gear, it misfires. After a minute or so, the misfire clears and the engine runs perfectly. I have not received another trouble code. One thing I did notice is that the plugs I took out (Motorcraft AWSF 32P) had a much larger gap than the .044 the associate at AutoZone set the new plugs to.
View 7 Replies