Camry 2012+ :: LED Daytime Running Lights Wires - ACC?
I got my LED DRL kit today, the harness has 3 wires red(+), black(-), and white(for connect to (+) of headlight so when headlight on the drl will go off). So I will connect black wire to negative of battery or ground, red wire to ACC or ign. So my question is how can I find ACC and how can I connect white wire to (+) of headlights? My led drl kit is similar with the kit in the link: [URL] ...
View 1 RepliesCamry :: Installing XLE Bumper On LE For Fog Lights?
Is it easy, I see that LE Camrys are pre-wired for fogs.
View 14 RepliesCorolla / Matrix 2009-13 :: Rattling Sound Like Something Dangling In Front Of Radiator
So while I was driving I thought I heard a rattling. I checked under my front bumper and there is this piece dangling kind of on the driver's side in front of the radiator. What is this piece? It is initially connected towards the front bumper.
View 2 RepliesFord Excursion :: Front End Noise - Inner Seal Dangling On Stub Shaft
For what it's worth I have been feeling a bit of a tug for 3 weeks. That's about 150 miles or 5 times driving. Installed new sway bar damper.
Pulling into the driveway the heard a ting, and look to find the inner seal of the hub spinning on the stub shaft!
An exploded view of this front end hub/bearing/brake assembly?
Tiguan :: Signal Lights On The Front Bumper Are Not Working?
So I am looking at the signal lights (?) on my front bumper (2012 Tiguan SE). I see there are bulbs inside them but they are not functional. Is there any coding that needs to be done for this to work?
View 4 RepliesCamry :: 2009 LE / Get The Front Lower Bumper From The SE?
i was looking to get the front lower bumper (fascia) from the SE
i have a 09 LE,
my question was does it just attach clean onto the LE? or do i need a se front bumper.
[URL]
Camry 2012+ :: SE V6 - Front Bumper Cover Loose
I have a 2012 SE v6 with 1600 miles on it. About a week ago, I noticed my bumper cover pulled away from the corner of the headlight and there was a noticeable gap. I pushed on it, and heard a click. The bumper stayed in place. After a couple days driving, it came loose again. I didnt touch it so the Service Writer would see it first hand. Of course, his first instinct was to puch on it, but I got loud quickly, so he kept his hands to himself, and heard me out. I knew if he clicked it back into place I would be SOL. He admitted something needed to be done, not just click it back.
When I picked it up, he said it was a known issue, and there is a TSB on it. He claimed they replaced a bracket. The invoice reads, "ADDED FELT TO TIGHTEN FIT". Yeah, Im sure that will hold just long enough for them to wash their hands of it.
Camry :: 2013 - Front Bumper Detaching From The Clips
The front bumper keeps detaching from the clips on the side. Toyota has attempted to fix it 3 times with no success. The clips are not broken or cracked. The clips are the same on late 2012 Camry.
View 3 RepliesLexus ES 2013+ :: Water / Moisture In Fog Lights After Reinstalling New Front Bumper
Dealer did repair work on front bumper. Now, after reinstalling a new front bumper, I noticed water starting to form inside the fog light assembly after it has rained. Dealer says this is normal due to our tropical weather. This has never happened prior to the repair work that was done.
View 12 RepliesPrius V :: 2016 - Front Bumper LED Accent Lights Stay On With Low Beams
How to modify this light so that it can stay on with the low beams? This light only works in "auto" mode.
View 1 RepliesCamry 2012+ :: Wiring Up Some LED Lights On The Bumper / Easy Place To Tap Ignition Power?
I bought a pair of LED strips that I would like to run instead of the DRLs. I want them to be on whenever the car is on. I don't have a wiring diagram, and I'm not sure where I can tap some power or wire up a relay to have them come on only when the car is on.
View 8 RepliesCamry 2012+ :: SE - Part Number For Screws That Hold Front Bumper?
I took apart my front bumper for my 2012 Camry SE a while back and swapped it when I hit a cone on the freeway.
I accidentally lost one of those metal nuts that goes underneath the bumper - its like a hexagon if I remember correctly. - I had to use a torque wrench to open them and there was like 8 or 10 total.
Camry 2012+ :: 2014 SE - Front Bumper Chrome Trim Removal
How to remove the chrome trim around the fog lights and the chrome bars beside them I have a 2014 SE
View 2 RepliesCamry :: 2012 Avalon - Extensive Scratches At The Front / Right Corner Of Bumper
I have a rental 2012 Avalon for two weeks. Yesterday I noticed extensive scratches at the front/right corner of the front bumper. The scratches could be covered with two hands. Some scratches are as deep as the primer, but not on the plastic.
I am pretty sure that they are not there until last one or two days ( it has been raining, they would not be very visible when wet). The scratches looks kind of old, could it be that they were fixed in a substandard way so that they are washed off in the rain and became visible?
Ford Super Duty (1999-2016) :: Small Diameter Rubber Hose Dangling From Front Driver Side Brake Housing Area
I was just under my 2000 F250 7.3l crew cab truck and noticed a small diameter rubber hose dangling from my front drivers side brake housing area. It is attached near two other cables which are similar to cables on the passenger side. I don't see a similar hose on the passenger side. The hose is completely deteriorated and broke off up higher towards the engine. I cannot see where it goes. What it may be?
View 4 RepliesCamry :: Remove / Replace Rear Bumper Cover On 2003 Vehicle?
How to remove and possibly replace the rear bumper cover on a 2003 camry?
View 4 RepliesFord Super Duty (1999-2016) :: 2003 F350 - Wire Color For Reverse Lights At Rear Bumper
Installing a back up camera and need to locate reverse lights on driver's side at rear bumper. What color wire is for the reverse lights on a 2003 F-350 (truck in my sig)?
View 4 RepliesFord - Taurus - Lights :: How Engine Light And Headlights Are Connected
How are they connected?
View 8 RepliesPrius C :: Adding LED Driving Lights - Getting Wires Through Firewall
I'm thinking of adding LED driving lights, any way to get the power wires from inside the car through the firewall to the engine compartment? I really don't want to punch holes in the wiring harness rubber seal. Been trying to think of a way to do this elegantly.
View 16 Replies