Volkswagen - Beetle - Clutches :: 2000 - Manual Transmission Noises - Stuck Between Gears?
I have a 2000 VW beetle with a fairly new clutch (2 yrs old). My boyfriend is new to a manual transmission and I can't say I know much about how it works either. A few times when he was driving he will reverse out of a parking spot and then shift to first and the car will make a deep rumbling noise. We turn off the car and turn it back on and its fine. Is the car stuck between gears? Why does it make this noise?
View 4 RepliesBmw - Noises - Clutches - 328 :: Screeching When Shifting (manual Transmission)
I've got a 1996 BMW 328i manual. It has 175k miles. I purchased the car about a year ago. Several weeks ago, I began hearing a screeching noise when shifting when the car is cold. The screeching happens when you let the clutch out when going into gear. It happens much more frequently when very little throttle is used. If you shift it harder, it is less likely to make the noise. If it starts making the noise, you have to shift several times for it to go away. It'll still make the noise while in gear at that point. When the car is driven for about 10 minutes, it never makes the noise afterward, until the car cools down completely overnight. The clutch does not appear to be slipping at all, and once a gear is engaged, it does not have any issues staying in gear. What is my car's issue?
View 1 RepliesFord - Ranger :: Clutch Pedal Feels Normal But No Resistance When Shifting Gears
I have a 5-speed transmission pickup (’04 Ford Ranger EDGE SuperCab). Clutch pedal feels "normal", No resistance when shifting gears. Will go into gear with ease, except for 2nd gear (grinding noise), must push clutch to the floor and still grinds; but only 2nd gear. In 1st gear, my truck will slowly creep forward as if unable to engage and not having any kind of pulling power. Even when shifting to 2nd, 3rd, 4th and 5th gears, it barely maxes out at 30MPH (top speed unless vehicle is on a slope or slight decline then I can get up to and over 40MPH. Checked brake fluid level, it’s ok. The fluid’s at max. Clutch is relatively new (April 2014), with only about 13,000 miles on it, if that. It must be cylinder issue. Is there any way to tell whether it's the clutch master cylinder or slave cylinder?
View 5 RepliesFord Ranger / B-Series :: Truck Idles With Very High RPMs When Driving And Shifting Gears
1999 ranger, 2.55 speed. truck idles with very high rpm's when driving and shifting gears. have changed the AIC, mass air sensor. Throttle position sensor and still does it. the AIC has been changed 5-6 times in 6-8 months as parts store kept telling me it was that. What can i look at, check, etc...
View 6 RepliesSaab - 9-5 :: 2002 - Difficulty Shifting Into Reverse?
I have a 2002 Saab 9-5 sedan with a manual 5-speed transmission. It runs like a champ until recently. I've been having a lot of difficulty shifting into reverse. I've taken off the gaitor and looked down into the shifter to make sure everything is ok - looking for broken plastic, etc. Nothing out of the ordinary. Clutch fluid is full. It all of a sudden started doing this. The car shifts through all 5 forward gears with no issues. I can eventually get it into reverse if I'm patient enought and other times it goes right in with out issue. Any clues? A saab dealer says its the transmission, but I'm not so sure.
View 4 RepliesHonda - Clutches :: Cannot Shift Easily Between Gears On Hot Days
Clutch won't shift on a HOT day. When its hot I can't shift very easy between gears. However, the clutch is newer and so it works just fine. When its cold its sometimes tough but not as hard at all. Could it be a clutch master cylinder or slave cylinder? Do I need to bleed it?
View 1 RepliesFord Ranger / B-Series :: 1992 - A/C Compressor Did Not Have Any Clutches On It
My compressor on my 92 Ranger did not have any clutches on it. Where they went. I got a compressor off of a 94 at the pick and pull. It was charged and the compressor turned fine. Brought it home and tried to install it. My hoses in the back of mine(92) are different than the 94. I went back and got the hoses, condenser and evaporator off of the 94. Put it all together. The high pressure hose on the 94 has some sort of switch on the high pressure side. What is this switch for and how can I wire it in to the electrical system on the 92? I assume it is some sort of pressure switch that allows the system to flow. I'm getting 30 pounds on the low side and 150-200 ponds on the high side. Also, when I increase the RPM's, the compressor kicks on and off. It's not like it would or should normally but fast.
View 7 RepliesSaturn - Clutches - Sc :: 1996 - Grinding Sound When Shifting From 2nd To 3rd
We got the clutch replaced on our 1996 Saturn several weeks ago and ever since we get grinding when shifting from 2nd to 3rd. The mechanic said the synch ring was shot and it wasn't their fault...this problem did not exist before the replacement. Whether this sounds plausible and what we can do to rectify i
View 18 RepliesSubaru - Clutches :: 2003 - While Shifting There Is Creeking / Grinding Noise
I have a Subaru Baja 2003 with only 48,000 miles. It is a manual transmission.
My question has to do with the clutch (I think). If I am driving with the windows down and have something beside me that reflects noise ( a big hill, a wall, etc.) when I shift from first into second or second into third I sometimes here a "Creek" sort of grinding noise. I do not have to be moving the shift hence why I assuming it is the clutch. The noise is not bad, as I said I can only hear it occasionally and when I am next to something that reflects sound.
My questions are: Is it the clutch? Is it something I should have fixed or should I wait until it gets worse? I am not sure if fixing a clutch is expensive period or if there are some interim steps to a repair that prolongs the clutch and saves money.
Ford F-150 - 1997-2003 :: Manual Transmission - No Gears
My truck is an XL V8. Transmission is Manual 5-Speed Mazda M5OD-R2.
I bought this truck literally two days ago. It seemed a little hard to shift, but no other problems. The truck had been sitting a short while, the guy said he took it on local trips, but nothing more. I noticed the oil and coolant levels were crazy low, so maybe it had been sitting longer or the guy was neglectful, I'm not sure...
I was driving it home and it seems like what can be described as: the gear ratio went completely out.
For example, 4th gear acted like 1st gear, 5th gear like somewhere between 1st and 2nd gear, so when I'm at 20mph, in 5th gear, the rpms are really high like im going 20mph in first gear (not 5th).
Today none of the gears engage at all... I dropped off a trailer at uhaul, and I got stuck there! (The truck is still there, I walked 4 miles home)
The shifter works fine, all gears sound like neutral (including reverse) when accelerator is pressed. Car won't move at all, nothing is engaging.
Underneath the car, there is a leak from the transmission assembly, maybe around the fill plug? It's only a small puddle. Maybe fluid, shift forks, bushes? or all?
Mazda :: Manual Transmission - Can Change Gears But Car Only Revs
So my brother "learned" how to drive manual and asked if he could take my car for a spin. As we were driving he went from fifth gear (which he had prematurely switched to) to first. This occurred at about 35 or 40 mph. The car kind of jerked and a mechanical clicking could be heard. The clutch feels fine, and I can switch to all gears it seems, but when I let out the clutch, the gears won't engage, and the car can only be revved. This comes with a clanking noise.
View 10 RepliesFord Transmission :: 1995 F350 Truck Quit Working / No Manual Shifting Into 1st And 2nd
I bought a friends 95 f350 7.3 powerstroke with an E4OD. The truck quit driving.the OD light is not blinking. I confirmed the OD light does light up.The trans fluid is full , red and does not smell burnt. I have tried to manually shift 1st and second nothing happens. No reverse. Where should I look for the problem? Solenoid pack, loose valve body, bad relay?
View 1 RepliesSanta FE SM (2001-06) :: Hard To Shift Gears (Manual Transmission)
I have a 2004 manual transmission Santa Fe. I've maintained it very well since new.
About 6 months ago I noticed it was getting difficult to manually shift gears. It wasn't grinding or anything, just "hard" to get it to go into the various gears while driving. Before, I could shift into any gear with just 2 fingers on the gearshift and it was smooth as silk.
I went in and had the gear oil changed. This was something I didn't even know needed to be changed and the guy said most people never do. They showed me the oil they took out and it looked more like black water than oil and smelled kinda funky. They changed the gear oil out, but still no difference, and in fact it's getting worse.
The best way to describe it is the only way I can really shift gears now is to find that "sweet spot speed" where the gears will change on their own (so to speak). I find it particularly difficult going from 1st to 2nd, such as when starting from a stop light. People almost rear-end me now as it takes me longer to get it into 2nd gear.
Once in gear it runs perfectly, no problems. The clutch seems to be working normally, except perhaps while stopped in 1st gear, it sometime seems to jerk a bit, and I find this most noticeable if I'm stuck in very slow moving heavy traffic with the constant stopping and then moving forward slightly and such.
It is almost impossible to "gear down" into a lower gear unless I'm at the speed where it would normally go into that lower gear on it's own. The best way to describe it is how it is possible to drive a standard transmission car WITHOUT a clutch if you shift at just the right time/speed. But I DO use my clutch, but if I'm not close to "that speed" it's really, really difficult to force it into another gear, and the few times I do try and force it, I'll often get a bit of grinding.
Honda - Manual-transmissions - Accord :: Clack When Change Gears
I bought a 2004 Honda Accord over the summer. Now the the weather is cooler, I drive with the windows down, and I have noticed there is a "clack" sound when I change gears. It is hard to describe the sound, but it sounds like someone hitting a plate of metal with a hammer. I only hear this sound in first, second and third gear. The engine gets too loud in fourth and fifth gear, so it may just be drowning out the "clack".
I never remember hearing such a sound when I drove a manual transmission back in the late 90s. Is this sound an indicator of a problem? Do I need to take the car into a shop to have them take a look at it?
Additional Information:
Mileage: 106,000I am not the original owner, I purchased it at CarMax, and there was only one owner for the entire life of the car until CarMax bought it. The car looks like it was really cared for by the original owner. CarMax said that the clutch was fine, but...you never know with salesmen.
Jetta - Volkswagen :: Manual Transmission - Hard To Shift Between Gears
I went on vacation for a week and left my car at my parents house. I came back and now it has become extremely difficult to shift between gears. It's nearly impossible to get the car into reverse, extremely difficult to get it into first, makes a thud when pulling it out of first, is semi difficult to get into 2nd, but only a mild nuisance to get into 3rd through 6th.
For more information, the car is a 2012 Volkswagen GLI with just shy of 40,000 miles. The car ran just fine before I went on vacation and the car was not moved while I was on vacation. I did notice that a little ticking kind of sound when I had the car in neutral with no clutch. So the throw out bearing was starting to wear, but it was a very slight. But I haven't had any other problems.
Tiguan :: Noise Like Changing Gears In Manual Car Without Clutch Completely Depressed
I have a 2011 Tiguan 125TSI with the 7 speed DSG. When it starts cold, you can hear a noise that sounds like a bad gear change when going from 3th to 4th, and 4th to 5th. It almost sounds like changing gears in a manual car without clutch completely depressed. It has been there since I got the car brand new, but recently it seems to be getting worse.
Once the engine gets warm, the sound goes away and gear changes are smooth.
I've asked the VW dealer about the sound and they tell me it is normal. Is this right? The problem is it is very hard to demonstrate to VW the issue since it may happen only once when the engine is cold. I've left it with the dealer overnight and they were able to reproduce it in the morning... but again, they tell me this is normal.
Civic - Honda :: 1999 - Manual Transmission Stalls When Changing Gears
I have a 1999 Honda Civic DX hatchback with a 5-gear manual transmission that I have been driving since the day it left the dealership. This morning, on my way to work, I was shifting from third gear to fourth gear and the car stalled. This has happened three times in the last month or so. I recently had my transmission fluid flushed. I'm 95 percent sure this started after the transmission fluid was flushed.
View 8 RepliesFord - Explorer :: Weird Rattle Before Shifting In Certain Gears
I have a weird rattle right before shifting (in certain gears) and when revving it between 4-6k. I had it checked out by a tranny guy and he said everything was fine. It was the same guy that rebuilt it after blowing through gears 2 and 3. So I checked the heat shield and its on there solid but I did notice something.
Now I'm no mechanic or anything so Im not even sure if this is right or not but it looks like there a thin cover over the side of my tranny held on by two bolts, the metal has snapped clear off the bolt on one side and I believe that is causing the rattle. Here is the picture (this may or not be the tranny, like i said, I am no mechanic and rarely do work on my engine or anything.)
That black bolt on the bottom is what holds it on, but the metal before the bolt is snapped off, Could that be my rattle?
Ford Transmission :: 1991 - Delayed And Hard Shifting Between Gears?
I have a 1991 bronco with a 351w and the e4od trans.. The transmission is shifting late and hard and sometimes when i let off of the gas to slow down it shifts between gears up and down by itself... The only lights on the dash that are on is the Rear Anti-lock brake light and the speedometer is not working either.. Where to start the trouble shooting to fix it?
View 3 Replies