Chrysler - Transmissions :: Hard To Shift Into Gear After Reversing
I've been have been having a problem with my car. It initially started at Christmas when I went up to MI for a visit. It would have problems shifting into gear after reversing. At first I just thought it was because it wasn't used to the really cold weather as we live in AL.When I returned it still did it, I would try the other gears available on the auto transmission and it still seemed to have a problem shifting from 1 to 2. It would slow down and you could rev the engine and it still would not shift.
All of a sudden it would kick and shift and you could drive. This only happened the first time you drove it that day. It would also kick very slightly when you went below 30mph. It doesn't do that anymore.I went for another visit up north and while I was there it started kicking whenever I was over 60mph. When i got back to AL I took it into the dealership as the check engine light came on. It now kicks all the time regardless of speed, though does it less at lower speeds, but if there is exertion on the engine like a hill, it kicks, kicks, kicks. When it kicks the rpm goes down and up.The dealer said that the things that needed to be changed are:- front assembly trans pump- crank sensor- gasket- oil pan.
I've tried taking it to a transmission place to have just the pump changed for less and all they wanted to do was give me a whole new transmission. This car is on it's third transmission as far as I know and a new/rebuilt one was just put in 2 years ago.After talking with my father (who was a engineer) he told me a way to check if the crank sensor a problem was to have the car in neutral and rev the engine. He said that it would still do the same problems if it was the crank sensor. I did this and it did not kick at all.Is there any real way of knowing if it is really the pump that is causing all these problems or if it really needs a new transmission or something else.
Chrysler Town and Country, 2003, 134K ...
Jetta - Volkswagen - Transmissions :: 2002 - Won't Shift Past 3rd Gear?
I have the above referenced car with about 65k miles on it. Today I took it for a drive, switched it to tip-tronic manual and found that the car would not shift past 3rd gear. When I switched to automatic, the transmission stayed on tip-tronic (the display indicated I was on 3rd gear). I had to fully stop the car, place it on park and only then did the transmission switch to automatic.
View 1 RepliesHyundai - Transmissions - Santafe :: 2004 - Hard / Lurching Shift Into 3rd Gear
For the past 3 months, upon shifting from 2nd to 3rd gear, the car lurches forward in a hard shift. Sometimes, it is nothing more than a benign "clunk", and other times it is violent, as if hitting a wall. This does not happen every time it shifts and even under identical acceleration, the results vary from none to violent. The number of violent shifts vs. small jolts has increased over time, and all other transmission functions and shifts are fine/normal. After much time researching the inter-blogs, I have come to no consensus on what is causing this or how to fix it.
Some say it is the adaptive shifting program and it just needs updating and others say it's the tranny and a rebuilt tranny replacement is the only thing that eventually fixed this problem (though one posting on the Hyundai forum is of the same exact problem, but the solution is worrisome -- contact negative battery terminal to positive, let sit for 10 min, reconnect, then drive at 1/3 throttle, shifting through all gears a dozen times. Poster says this resets adaptive shifting program and worked for him).
Finally, today, I took it in for a diagnostic with a local transmission specialist, and they could only replicate the hard shift once, but when that happened, he said the car went into limp mode and read two codes: P1193 and P2127. The car has never gone into limp mode (P1193) nor shown an signs of suppressed RPMs associated with this mode. Also, he seemed to focus his attention on the low voltage to the pedal position sensor (P2127) as being the major issue that is causing the hard shift. I also called a past dealer that worked on a similar issue with the car when I bought it used 4 years ago and they recommended updating the adaptive shifting program as they did last time; though I don't recall if the shifting issue was the exact same problem I am having now. So, a few things:
Does this sound like a computer issue or a tranny issue? Could the pedal position sensor having low voltage cause a shifting problem like this? Any merit to the connecting the battery terminals idea? Should I be wary of the mechanic that did the diagnostic today?
Lexus GS 2006-11 :: Gear Won't Shift Past Third - Code P0751 Stuck Solenoid
I bought the car with 117k and never since my possession bothered to service it. Why? I kept putting it off well at 165k I said heck ill do it. Currently at 170k my gear wont shift past third and its reoccurring almost daily. When I first bought it it was intermittent. I think the late service messed it up. Here's the thing, aamco will open up my pan and look at my solenoids which is 250ish.
View 14 RepliesChrysler - PTCruiser :: 2006 - Won't Shift Into Park?
Recently my PT Cruiser was having trouble shifting into park so the car could not be started or the key could not be removed. I had to force it into park a few times and then something popped and broke. The car thinks it's in drive so it will no longer crank. I took a look under the hood and the shifter cable looks to be fine and connected properly but what I found under the center console seems to be the problem. The entire cable and plastic mechanism move freely. To me it seems as if the plastic piece holding the cable aligned is quite stuck. The metal rod looks like it's supposed to move inside the casing? Here are some photos of what we're dealing with.
View 5 RepliesChrysler - Ptcruiser :: 2001 - ABS Code 18?
What is ABS code 18 2001 PT Cruiser???
View 14 RepliesChrysler - PTCruiser :: 2005 - Getting Engine Error Code P0016?
I just wanted to post this due to the problem I was having with this code. I recently replaced a broken timing belt on my 2005 pt cruiser (non-turbo). Everything went back together, minus the hours trying to get the timing marks lined up by myself. After getting the engine buttoned up, the car would crank and idle, but only after 2000 rpm and the engine code P0016 would show up. I went back into the engine, reset the timing belt, and cranked it before putting everything back together. Worked fine, so buttoned it back up and took it for a test drive.
Bam, same engine code pops up again, only this time the car acted like it wanted to go into limp mode for half a second after driving for a few miles when I was turning around to come back to the house. It straightened up and drove fine. I could drive the car fine even after that, made a few test drives into town. The car would kind of fight limp mode after first cranking the car and accelerating, but then straighten up.
After a couple of months of research and talking to a friend who is a pretty good mechanic, I decided this was an electrical problem. I checked, and sure enough, after looking at the wiring at the cam shaft sensor connector, it was frayed. I spliced it and still had some issues with the code. I had just put a new sensor on it when the belt broke thinking it might be the sensor, so I put the old sensor back on it and now it runs fine, no more light. So, after months of thinking the timing or tone rings might be off, it was just a wiring/sensor issue.
Chrysler - Ptcruiser :: 2006 - Shakes When Stopped At Idle In Gear And AC Compressor Is On
I have 2006 PT Cruiser Turbo Convertible that violently shakes when I am stopped at idle in gear and the A?C compressor is on. When I turn the A/C compressor off (leaving the fan on) there is a drastic reduction in the vibration. If I put it in park and turn the fan off, there is an additional lessening of the vibration.
I have taken it to three different mechanics and had the following done: spark plugs and spark plug wires changed, fuel injection system cleaned, the 'whatchamacallit' in the fuel system cleaned out, the two main motor mounts changed.
None of the above maintenance has lessened the vibration one bit. Question: What is causing it?
Chrysler - Ptcruiser :: P0304 Error Code - Cylinder Number Four Misfire
2006 PT Cruiser Touring Ed. The engine light came on 2 days ago, had it looked at today and the error code p0304 "cylinder number four misfire" was diagnosed. What causes that and what would need to be done to fix that problem?
View 9 RepliesChrysler - Towncountry :: Won't Go Past Second Gear After Serpentine Belt Replaced
My wife's town and country had its serpentine belt replaced. Now it won't go past second gear and is running 3.5 rpms at 40 mph. What do I do?
View 3 RepliesLS / MKZ :: Code P1788 - Hard To Shift Into 2nd Gear
2000 ls v8 sport shifts normally exept while shifting into 2nd, it kind of pops out but then locks then shifts normally.
View 9 RepliesPassat (B5) :: 1998 - Transmission Will Not Shift Past 2nd Gear
I am considering buying a 98 Passat, it has 140k kms (80,000 miles) on it. It is in mint condition, but the transmission, will not shift past 2nd gear, whether in Auto mode, or manual shifting? (5 speed tiptronic).
The current owner took it to a mechanic, he tested it, replace a sensor in the tranny, but the problem is still there, and the engine light is still on. Is it possible that the computer just needs to be reset with a proper Vag-com?
Jimmy :: 1998 GMC Tranny Does Not Shift Past 2nd Gear
98 Gmc Jimmy 4.3L engine 4X4, they told me when the Abs light would come on will driving the tranny would not shift past 2nd gear, so after a month of not driving it, I took it for a drive Abs light was out vehicle drove fine shifted good even took it on the highway still ran good, two weeks later problem is back Abs light comes on after driving for a few minutes and the tranny goes into limp mode can't shift past 2nd gear plus the speedometer was not working, could it be speed sensor on the tranny causing the Abs light and the tranny from working wright.
View 1 RepliesAccent LC (2000-05) :: Won't Shift Past Third Gear Until Car Is Warm
I have a 2000 Accent that wont shift past third gear until the car is warm. The car has 140k miles. When I turn on the car and pull onto the high way it sticks in 3rd. I then have to slow down and drive through a small town. When I get on the other side of the small town and get back up to speed it will shift. Over drive is on.
View 4 RepliesChevrolet - Transmissions - Montecarlo :: 2002 - Hard To Shift Between Gears
I own a 2002 Monte Carlo SS 3.8 6cyl. I believe it has a 4T65-E transmission.
On a regular basis if I drive 20 miles out of town, on my way back the transmission starts to shift hard (long shift?). From my research online, the 4T65-e is a faulty transmission to begin with. Is it worth replacing the Shift and Pressure solenoids? If I were to buy a new transmission where should I look? What are some model numbers?
Oil, trans fluid, filters are changed on regular basis.New catalytic converter. No Check Engine Light.
Bmw - Transmissions :: 1998 - Clunks When Shift Into The Next Gear
I have a 1998 bmw 528i (e39) with 200k on it. It runs and drives like a dream except for one little thing.... when shifting into the next gear at around 25mph, if I let off the gas just before it shifts it clunks as it shifts into the next gear. However, if I accelerate through the gear change it is smooth as can be and has no problems through the gears.
Secondly and I believe unrelated, I am also looking for the location of a transmission temperature sensor... I have heard they tend to fail and can cause issues with shifting until the car is up to running temp. I experienced an issues with it once not wanting to shift out of 1st gear until it warmed but that was before a filter and fluid change. Since that, I haven't any issues, but I want to be prepared just in case with one on hand ready to go in.
Transmissions :: Car Won't Shift To 3rd Gear Even If Drive For 15 Minutes At 60 MPH
This problem started at the beginning of this winter. So I started to idle for 2 mins and the car was shifting without an issue.
However, now it is completely stuck and wont shift to 3rd gear even if I drive for 15 mins at 60mph.
Mercury - Cougar - Transmissions :: 1999 - Hard To Shift / Engine Codes
i have a 1999 mercury cougar and for almost a year when I drive it on the highway then get off and go to drive again it gives me a hard shift and will continue doing so, but if i turn the car off then back on it doesn't do it, very weird, but i got the codes and not sure what my next step would be to fixing it p1744- TCC system perform p1519 - IMRC stuck closed again this only happened when i drive the car for about 10-15 min on the highway then get off...
View 4 RepliesLexus GS 2006-11 :: 2008 350 AWD -VSC And CEL Came On, Auto Trans Won't Shift Past 4 Gear
My VSC and check engine light have come on. In addition now the auto trans will not shift past 4 gear with in auto or with me doing it manually. My local shop who has worked on this car before and is very good put the computer reader on it and got a P0500 for vehicle speed sensor "A". Today they put it on the real monitor and it reads a different code that says check engine code but does not reveal the code to read.
I really don't want to go to my dealer and get it hard. The car has 175,000 and until now has run great. I tried the gas cap fix to no avail. The shop did a reset when i first got there and it last 75 yards.