Chrysler - PTCruiser :: 2005 - Getting Engine Error Code P0016?
I just wanted to post this due to the problem I was having with this code. I recently replaced a broken timing belt on my 2005 pt cruiser (non-turbo). Everything went back together, minus the hours trying to get the timing marks lined up by myself. After getting the engine buttoned up, the car would crank and idle, but only after 2000 rpm and the engine code P0016 would show up. I went back into the engine, reset the timing belt, and cranked it before putting everything back together. Worked fine, so buttoned it back up and took it for a test drive.
Bam, same engine code pops up again, only this time the car acted like it wanted to go into limp mode for half a second after driving for a few miles when I was turning around to come back to the house. It straightened up and drove fine. I could drive the car fine even after that, made a few test drives into town. The car would kind of fight limp mode after first cranking the car and accelerating, but then straighten up.
After a couple of months of research and talking to a friend who is a pretty good mechanic, I decided this was an electrical problem. I checked, and sure enough, after looking at the wiring at the cam shaft sensor connector, it was frayed. I spliced it and still had some issues with the code. I had just put a new sensor on it when the belt broke thinking it might be the sensor, so I put the old sensor back on it and now it runs fine, no more light. So, after months of thinking the timing or tone rings might be off, it was just a wiring/sensor issue.
Chrysler - Ptcruiser :: P0304 Error Code - Cylinder Number Four Misfire
2006 PT Cruiser Touring Ed. The engine light came on 2 days ago, had it looked at today and the error code p0304 "cylinder number four misfire" was diagnosed. What causes that and what would need to be done to fix that problem?
View 9 RepliesChrysler - Transmissions - Ptcruiser :: Code P0700 / Hard To Shift Past Second Gear
My 2005 PT Cruiser (not turbo) is giving me a very frustrating P0700 code and a weird problem. First thing in the cold, autumn, the car drives perfectly fine (through still with the engine code on). Once the day warms up a little, the transmission decides that shifting past second gear is for punks and won't do it, so 30 mph has the engine revving at 3K rpm.
My morning commute is 20 minutes, and in that time, I go up to 50 mph with no issues. Driving home, or any other time of day, becomes the issue. What in the world could possibly be going wrong? I've been trying to hit up the junkyard for a PCM to see if switching that out would work, but it's been too rainy and cold to get out there.
Chrysler - Ptcruiser :: 2001 - Acceleration Seized Over 15 MPH And Would Not Reverse
I was driving the car down the freeway, hear a loud bang from underneath the engine, immeadiately ceased accelerating over 15 MPH and would not reverse.
As it stands now the car will start up, but not reverse, or accelerate over 15 MPH without the RPMs revving like mad. Think it might be tranny-related...
Chrysler - Ptcruiser :: 2001 - Turn Signals Not Blinking
I just changed the multi-function switch on my 2001 PT Cruiser, because someone suggested it since my turn signals were not blinking or clicking. The turn signals come on, but do not blink or make that clicking sound at all. They just stay on. The hazards do not blink or click either. Lights and all work fine. It's just the turn signals and hazards that do not. What else controls the clicking and blinking of the turn signals and flashers. Could it be the relay that's inside the multi-function switch? I'm almost 100% sure we checked all the fuses, but I could be missing something.
View 1 RepliesChrysler - Ptcruiser :: 2001 - Coolant Steadily Dripped Onto The Ground?
My 2001 PT Cruiser began to over heat today. By the time I immediately pulled off the road and smoke began to come out from under the hood. Once I stopped I heard a bubbling noise and watched as all my coolant steadily dripped onto the ground (almost a pour). What does this mean?
View 19 RepliesChrysler - Ptcruiser :: 2001 - Gauge Is Overheating - Head Gasket?
My 83 year old mom has a 2001 pt cruiser. The gauge is overheating. Some water was leaking from the radiator, not a lot. 3 mechanics have given estimates. The first said it was the water pump. The second said per computer is was not the water pump from his experience it was the head gasket. Third thought it was the radiator cap then said no. A hose was somewhat loose but that did not cause the problem. It heats up going down the hill and not up a hill. Water pump is okay must be the head gasket. Both said it held 15 lbs of pressure. She is too upset to handle this and it is left up to me. Do you think it is the head gasket?
View 3 RepliesChrysler - Ptcruiser :: 2001 - Stalls Then Starts After 10 Minutes And Repeat
drives nice for mile or 2, stalls. turns and turns for 10 minutes, then starts. drives great for mile or 2, stalls. wait 10 minutes, starts. repeat, repeat!!
View 1 RepliesChrysler - Ptcruiser :: Shimmy At 70 MPH
My son's wife has a PT Cruiser, she told me last night that it has a shimmy at 70 mph. What are the causes of this ?
View 10 RepliesChrysler - Ptcruiser :: Wobbling While Going At 55-60 Mi/h
My PT has a vibration, I've replaced rear drums, rear hub assemblies, front brakes and front rotors and all four tires.The vibration is only while going 55 to 60 MPH each time I've replaced the different parts (rotated the tires and rear drums) the wobble seems to go away for about a few miles and then comes back!I'm going to replace the front hubs and bearings now, but why would the wobble change each time I changed I've changed all these parts around. Could it be a bent rim? or just the front bearings?
View 5 RepliesChrysler - Ptcruiser :: CEL Cause The Car To Buck Or Stall
I have a 2004 PT Cruiser with 111,000 miles on it. A summer or two ago, whenever it got hot out, the check engine light would start to come on. Usually, it didn't affect the car's driveability - but sometimes, it would cause the car to buck and/or stall, sometimes to the point of stalling completely out. Brought it into the shop again and again. Camshaft sensor. O2 sensor. Crankshaft sensor. Replaced. Checked. P0304 misfire code came up in diagnostics again and again. Re-wiring of camshaft sensor wires. And on and on. And yet again, intermittently, the check engine light would come back on and the whole thing would start all over again. Sometimes you'd drive it, stop somewhere, start it again, and the check engine light would be gone. Sometimes it would stay on for days. Weeks. Sometimes with no other driving symptoms - it just depends on how the car is feeling? I thought the problem was limited to the hot months of summer, but now it's the dead of January in Minnesota and it's happening again. Yesterday, it stalled out completely and I had to get it towed to the shop - decided to try a new shop, they said maybe the problem was that the old shop did a bad wiring job. OK. But then, got the car back, no check engine light on first drive, stopped somewhere for 5 minutes, get back in, start it again, check engine light back on. But at least the car started and didn't buck/stall. Now it's back in the shop, but I'm ready to give up.
View 5 RepliesChrysler - Ptcruiser :: 2002 - Car Won't Start At All Just Clicking
I have a 2002 chrysler pt cruiser. For the past week when I start to crank it it will just click one or two times then crank. Today it won't start at all just clicking.
View 2 RepliesChrysler - Ptcruiser :: 2005 - Rough Idle When Let Off The Gas
I have an 05 pt cruiser that idles rough sporadically. Sometimes it idles smooth, sometimes it is rough but will calm down when i shift into gear, and sometimes it is rough when i let off the gas and come to a stop sign. When i first crank the car, the idle is rough and will act like it wants to cut out when i first back out of the driveway, but it clears up and drives better after getting gas. I have changed the plugs and wires, which did work, but there is something else still causing some problems. When at cruising speed, you can't detect any stutters or other problems. I looked at the vacuum lines and have a bottle of injector cleaner on 3 tanks of gas back to back with no apparent change. I did put a PCM on it a few years back, is it possible it has gone bad? The gas mileage also has seem to be suffering. I also checked the air filter as a possible problem, but it is very clean.
View 6 RepliesChrysler - Ptcruiser :: 2007 - Tries To Stall When Stopped
I have a 2007 PT Cruiser that's just about to hit the 100,000-mile mark. My problem is when stopped, the car feels like it wants to stall, but only when the AC/Heater/Defrost is on. Also, when it starts to act up, the heater stops working, leaving only the fan to blow air around. It doesn't happen all the time, but enough to make me turn off the heater or whatever I'm using when I come to a red light. It just started doing this and I just wanted to have a rough idea as to what it was before I took it to a mechanic.
View 6 RepliesChrysler - Ptcruiser :: Overheating And Temperature Light Comes On
After running for a while traveling to and from the store, my temperature gauge on my 2005 PT cruiser rises to hot and the temperature light comes on. However,when I get out and raise the hood. The engine doesn't seem to be overly hot. No boiling or hissing sound and no steam coming from the engine.
View 3 RepliesChrysler - Ptcruiser :: 2005 - No Electrical Power
I drove the car to town this morning, and then to work without problems. I go to get in the car and the car has no electrical power what so ever. I am going to check the voltage and battery terminals, but is there a fuse that sends power to everything in the car, including lights, horn, etc? There is NO power at all.
View 5 RepliesChrysler - PTCruiser :: 2006 - Won't Shift Into Park?
Recently my PT Cruiser was having trouble shifting into park so the car could not be started or the key could not be removed. I had to force it into park a few times and then something popped and broke. The car thinks it's in drive so it will no longer crank. I took a look under the hood and the shifter cable looks to be fine and connected properly but what I found under the center console seems to be the problem. The entire cable and plastic mechanism move freely. To me it seems as if the plastic piece holding the cable aligned is quite stuck. The metal rod looks like it's supposed to move inside the casing? Here are some photos of what we're dealing with.
View 5 RepliesChrysler - Ptcruiser :: 2009 - A/C Does Not Work At Idle
A/C works fine when moving. At idle, it doesn't work. Fan is not spinning. Is it definitely a bad fan or is it a possible fuse/switch/module? How difficult it would be for a novice to replace the fan?
View 2 RepliesChrysler - Ptcruiser :: 2005 - Carbon Buildup And Clogged
Our 2005 PT Cruiser has a 2.4 liter turbo. We had to replace the turbo at 78K miles due to “carbon buildup and clogged” so said the dealer. I can not get any local mechanic to tell me why this happened or if it is normal. My wife claims it is because I have been using the cheap, mid-grade gas. I tell her, no, it was because of the cheap oil I was using. I am now using synthetic oil. One mechanic said the turbo needs to be “blown out” occasionally, by either high speed driving or fast take offs. Bottom line: What would make the turbo carbon up so badly that it must be replaced? What can I do to have this not happen again around 156K? Must I always use premium gas?
View 19 Replies