Ford Ranger / B-Series :: 2000 - Harmonic Balancer Removal?

I have a 2000 2.5 and need to remove the harmonic balancer. Are the threads righty tighty or lefty loosey.I'm replacing the timing belt and pulley

View 1 Replies

Neon :: Need TDC For Harmonic Balancer?

I'm about to change out my harmonic balancer and have been reading some sites that tell you have to put it at TDC and other sites say "no" unless your messing with the timing belt. I have a 2002 dodge neon.

View 1 Replies

Intrepid :: 3.5 How To Get Harmonic Balancer Off

on the 3.5 how do I get the harmonic balancer off? I know that you need to use a 3 arm puller. I have a 3 arm puller but I cant seem to figure it out.

View 9 Replies

Golf V R32 :: Rear Harmonic Balancer Degrading?

The MK6 GoRf seems to have a problem with the Rear Harmonic Balancer on the Driveshaft to Haladex Coupler. I will have a look under the car this weekend just to check it out. By the way, I have no driveline vibration under acceleration. Wonder if the problem is with more power/torque on the turbo engines. But we have plenty of boosted VR6 engines, and I wonder if there are problems with the part.

[URL]

View 7 Replies

Santa FE SM (2001-06) :: 2004 - How To Replace Harmonic Balancer

I have a wobbly crank pulley and I am wondering how ofter the harmonic balancer should be replaced? I have about 125000miles on my 2004 Santa Fe 2.7 V6 and I have heard this is an issue around 100000. Also wondering how much it would cost to replace?

View 10 Replies

Ford Ranger / B-Series :: 1997 - Harmonic Balancer Seems To Be Stuck?

I have been stuck at the tail end of the head gasket job on my 97 B2300. I have been working every day, so I haven't been able to get to this until today. The harmonic balancer seems to be stuck and I can't get it off. Regular 3 jaw pullers won't work (tried 4, rented one from the parts store that didn't work either) and tapping it from the back side while rotating the engine isn't working either. The pullers keep slipping off because the of the pulley's front ridge being slightly larger in diameter than the rest of the balancer.

Is there some kind of special puller that I don't know about? I don't want to be too rough with it as it seems no one carries this particular balancer if I happen to break it. Side question..... I was told that the crank/cam seals will also work on the oil pump as they are the same size. True? I happen to have 3 seals and wouldn't mind changing the oil pump seal as a precaution. (note this is a later 2.3 with a timing belt driven oil pump)

View 2 Replies

Ford - Tempo :: 1993 - Rattle Came Back After Changing Harmonic Balancer

I changed the harmonic balancer in my 93 ford tempo but the rattle came back!! Last night we tightened the bolt on it with 700 psi but it's still rattling! Could it be a bad balancer or another part that is lose? It rattles at idle and goes away while driving. It just started again the day before yesterday (I thought my husband was just looking to play with the car more) and by last night it got really loud. It's a deeper rattle then the rattle it had before we changed the balancer. Could there be something way out of balance that is causing the balancer to do this?

View 1 Replies

Ford - Mountaineer :: 2000 - Chirp / Squeak When Cold - Harmonic Balancer Noise?

I have a 2000 mountaineer 5.0 that has a chirp/squeak when its cold and goes away once warmed up good occasionally. I have replaced the belt, alternator and manually spun all the idler pullies, water pump, ac and tensioner. Nothing squeaks. Is it possible for the harmonic balancer to make this noise?

View 14 Replies

Ford Ranger / B-Series :: Hop In The Truck And Belt Starts Squealing - Harmonic Balancer Came Apart

Couple days ago, hop in the truck to go to work and belt starts squealing. Belt was old and it had been raining, so I figured it was a little wet. Turned on the defrost, and squeal gets worse. I then smell a burning. Opened the hood and saw the belt dragging on the a/c pulley, so I figure the compressor clutch is shot.

Looked at it today. I was wrong. Took off the belt and the a/c pulley spins fine. I can turn it's front hub by hand as well. I look around and see the crankshaft pulley isn't lined up. It looks like the outer pulley portion separated from the rubber. This caused the belt the jump and ride on the rubber part, cutting grooves in it.

Here's some pics:

From top driver's side:

From top passenger's side:

From bottom passenger's side:

View 1 Replies

Ford 6.0L Power Stroke Diesel :: Crank Pulley / Harmonic Balancer Bolts - Replacement?

I am reviewing the ford assembly instructions before I put my engine back together and noted that it indicates that the balancer bolts are torque to yield. I thought it odd but is it really necessary to replace these? Is it done in practice?

View 1 Replies

Golf VI R :: Noisy Rear Differential / Balancer?

Any troubleshooting tips on determining where the noise is coming from at the rear of the car? There is a pretty audible hum at 55 mph coming from the rear of the car and I am not sure if its the balancer or the diff. I'm reading horror stories of improperly serviced rear diffs causing the diff to fail and starting to freak out.

View 10 Replies

Camry :: How To Time A 2004 2.4 Ltr Counter Balancer On The Crankshaft

cannot find instructions on how to time a 2004 2.4 ltr counter balancer on the crankshaft.

View 2 Replies

Suzuki :: 2008 - Harmonic Noise Upon Reaching 50 To 60 Mph

2008 Suzuki Grand Vitari V6 4WD. What could be causing a harmonic noise upon reaching 50 to 60 mph? It is intermittent and can last for hours on a long trip. It doesn't matter if AC is on. It sounds like a piece of plastic is stuck in the air vents, a high pitch.

View 1 Replies

Golf VI R :: Harmonic Vibration Started At Around 65 Mph On Wet Pavement

The other day, as I got up to speed on the interstate on moderately wet asphalt, a harmonic vibration started at around 65mph. Felt it in the seat of my pants more than in the steering wheel...the entire chassis was vibrating. So bad that when I called a friend to ask him what he thought, he could hear the vibration in my voice. Clutch in, engaged, under power, under back pressure - nothing affected the pitch or harmonics. Below 65 changed the intensity, but had to slow to 50 to make it stop. Took it all the way to 90, but no difference. This kept up for the entire 70 mile trip.


Now for the weird part. On my way back, 2 hours later, the rain had stopped and the interstate was now dry. No vibration. Just as smooth as glass all the way home. I had it in for service recently, because it happened once before...no codes, no clue from tech as to what brought this on. And just to be sure, I had them balance the wheels...very minor weight adjustment. I called the dealer on the way back to tell them it happened again, and all the tech could suggest was to stop by next time it was raining so they could road test it.

Even more weird is the fact that this has only happened twice and I drive the interstate in the rain all the time.

View 17 Replies

Golf IV R32 :: 2011 - Harmonic Dampener On Driveshaft Need Replacement At 104K?

Not driving the R as much now that I got a 2011 Triumph Street Triple R. I use as my primary transportation. But I had the car into the dealer this week for service and they said there is a rubber dampener on the driveshaft that is starting to crack and get loose.

I didn't get time to check out the car on the lift and have not had any problems with this shop in the past nor the mechanic who has ONLY worked on my car since new. The R now has 104K on it.

View 2 Replies

Prius (2010-12) :: Hums At Slow Roll - Metallic Harmonic Vibration

I just replaced a 2005 with a 2012. The 2005 was dead quite during slow movement and parking while the 2012 hums. At first I thought the hum was a rubbing noise but on closer listen it sounds like a metallic harmonic vibration. It reminds me of the sound of rubbed crystal glass except lower in tone with metallic undertones. It is audible from outside the car or when the windows are down. It does not appear to be associated with movement as it comes and goes during the three point manuever required to park under the carport. Is this is normal or I am heading back to the dealer?

View 19 Replies

Ford 6.0L Power Stroke Diesel :: Coolant Leak Coming From Harmonic Dampener

I noticed I was a bit low on coolant and started looking around. Found a drip on the serpentine belt and harmonic dampener. The T-stat is dry and was replaced 1.5 yrs ago with a full flush. Both hoses are fine and there is no coolant near the steering assembly.

I am figuring it is coming from the water pump. I am planning to put in that Bulletproof water pump and Mishimoto silicon hoses. Anything else I should consider before I dive in. I'll put a new T-stat on since the coolant is drained and it is cheap $20 insurance. BTW hoses and water pump are original (7/05 build date).

Additional information - no spots on driveway (from coolant anyway) and single drop on the dampener. No mess anywhere else and I am down about 1/2 gallon - degas is almost empty.

View 6 Replies

Santa FE SM (2001-06) :: 2005 - Ticking Noise / Blue Spark Occurring At Random Intervals On The Balancer

2005, 2.7l. FWD automatic, with 180,000+ miles.

A week ago it started making a random ticking noise I've never heard before. Today was the first chance I got to try and find it and I'm stumped on what could cause this.

The sound is a static or low voltage electrical discharge coming off the harmonic balancer. I can actually see the blue spark occurring at random intervals and locations on the balancer as the car is running.

Do i need to be looking for a bad engine ground? I'm having no other electrical problems. The car runs like a champ other than a minor oil and power steering fluid leak.

View 8 Replies

Celica :: 96 ST 7afe - Engine Removal / Replacement

I an taking out a 7afe engine (1.8L) from my 96 Celica ST to replace it. I have everything off the engine and all bolts removed from the engine to the transmission and there is no room to remove the engine. Does the transmission have to come out with the engine? I pulled them apart with what little room that there is and the clutch/pressure plate is stuck to the flywheel (the flywheel would clear by itself). This is a manual tranny.

View 2 Replies