Ford Ranger / B-Series :: 2000 - Harmonic Balancer Removal?
I have a 2000 2.5 and need to remove the harmonic balancer. Are the threads righty tighty or lefty loosey.I'm replacing the timing belt and pulley
View 1 RepliesFord Ranger / B-Series :: 1997 - Harmonic Balancer Seems To Be Stuck?
I have been stuck at the tail end of the head gasket job on my 97 B2300. I have been working every day, so I haven't been able to get to this until today. The harmonic balancer seems to be stuck and I can't get it off. Regular 3 jaw pullers won't work (tried 4, rented one from the parts store that didn't work either) and tapping it from the back side while rotating the engine isn't working either. The pullers keep slipping off because the of the pulley's front ridge being slightly larger in diameter than the rest of the balancer.
Is there some kind of special puller that I don't know about? I don't want to be too rough with it as it seems no one carries this particular balancer if I happen to break it. Side question..... I was told that the crank/cam seals will also work on the oil pump as they are the same size. True? I happen to have 3 seals and wouldn't mind changing the oil pump seal as a precaution. (note this is a later 2.3 with a timing belt driven oil pump)
Neon :: Need TDC For Harmonic Balancer?
I'm about to change out my harmonic balancer and have been reading some sites that tell you have to put it at TDC and other sites say "no" unless your messing with the timing belt. I have a 2002 dodge neon.
View 1 RepliesIntrepid :: 3.5 How To Get Harmonic Balancer Off
on the 3.5 how do I get the harmonic balancer off? I know that you need to use a 3 arm puller. I have a 3 arm puller but I cant seem to figure it out.
View 9 RepliesFord - Tempo :: 1993 - Rattle Came Back After Changing Harmonic Balancer
I changed the harmonic balancer in my 93 ford tempo but the rattle came back!! Last night we tightened the bolt on it with 700 psi but it's still rattling! Could it be a bad balancer or another part that is lose? It rattles at idle and goes away while driving. It just started again the day before yesterday (I thought my husband was just looking to play with the car more) and by last night it got really loud. It's a deeper rattle then the rattle it had before we changed the balancer. Could there be something way out of balance that is causing the balancer to do this?
View 1 RepliesFord Ranger / B-Series :: Hop In The Truck And Belt Starts Squealing - Harmonic Balancer Came Apart
Couple days ago, hop in the truck to go to work and belt starts squealing. Belt was old and it had been raining, so I figured it was a little wet. Turned on the defrost, and squeal gets worse. I then smell a burning. Opened the hood and saw the belt dragging on the a/c pulley, so I figure the compressor clutch is shot.
Looked at it today. I was wrong. Took off the belt and the a/c pulley spins fine. I can turn it's front hub by hand as well. I look around and see the crankshaft pulley isn't lined up. It looks like the outer pulley portion separated from the rubber. This caused the belt the jump and ride on the rubber part, cutting grooves in it.
Here's some pics:
From top driver's side:
From top passenger's side:
From bottom passenger's side:
Ford 6.0L Power Stroke Diesel :: Crank Pulley / Harmonic Balancer Bolts - Replacement?
I am reviewing the ford assembly instructions before I put my engine back together and noted that it indicates that the balancer bolts are torque to yield. I thought it odd but is it really necessary to replace these? Is it done in practice?
View 1 RepliesGolf V R32 :: Rear Harmonic Balancer Degrading?
The MK6 GoRf seems to have a problem with the Rear Harmonic Balancer on the Driveshaft to Haladex Coupler. I will have a look under the car this weekend just to check it out. By the way, I have no driveline vibration under acceleration. Wonder if the problem is with more power/torque on the turbo engines. But we have plenty of boosted VR6 engines, and I wonder if there are problems with the part.
[URL]
Buick :: 1947 - Harmonic Balancer Removal From Engine
How to remove a harmonic balancer from a straight 8 Buick engine. There are no bolt holes on the balancer to use a standard balancer removal tool. I was able to remove the center bolt. I removed the center bolt then threaded it back in a couple of threads and tried using my hydraulic gear puller with the center of the puller on the bolt. I got it to move off about 3/16" but then it stopped. Right now I have the hydraulic puller still on under tension and am periodically spraying it with screw loose hoping it may pop off. I need to know if this will work or if I am fighting against the puller now.My 42 to 47 Buick manual does't give any info on removing the balancer.
View 5 RepliesSanta FE SM (2001-06) :: 2004 - How To Replace Harmonic Balancer
I have a wobbly crank pulley and I am wondering how ofter the harmonic balancer should be replaced? I have about 125000miles on my 2004 Santa Fe 2.7 V6 and I have heard this is an issue around 100000. Also wondering how much it would cost to replace?
View 10 RepliesMercury - Mountaineer :: 2000 - Squeak In One Of The Pulley Wheels
I have a 2000 Mercury Mountaineer 5.0L V8. Recently it has developed a squeak in one of the pulley wheels. I think it is the middle one but it may be the alternator. My question is can I change these pulleys or do I even need to? My mechanic said its nothing to worry about but I am of the opinion that bad news does not get better with age. A squeak indicates that something is not right.
View 3 RepliesFord - F150 :: 2003 - Bird Chirp Like Squeak Whenever Hit Bumps In The Road
I have a 2003 f150 with a 4.2 v6 2wd and about 116 on the clock.
It has this annoying, faint squeek whenever i hit bumps in the road. Sort of sounds like bird chirps. I cannot reproduce it if I bounce on it while parked.
One rainy day I tried to show a friend and it would not make the sound it seemed. Therefore I think its exterior, although it almost sounds inside.
Today I sprayed down all the rubber joints under the front end with silicone spray. It still squeaked while driving afterwards.
I should note that a ford dealer claimed the ball joints were worn and needed to be replaced. Although, would a ball joint make bird chirp type squeaks while driving at most speeds (20mph - highway speeds)? It does not intensify or change at any particular speed.
My understanding is that a bad ball joint would grind when turning the wheel or clunk while traveling over speed bumps or something similar.
Ford Ranger / B-Series :: 1996 - Squeak / Chirp On Takeoff - Not At Idle
There's a small but clearly audible chirping/squeak coming from my truck whenever I pull out. It goes away after the truck gets hot, but for the first 10 minutes or so, it squeaks only when moving. Not at idle. It is worse at low RPM's in 1st gear. And it's particularly bad in the mornings. I was thinking it is something in the idler pulley or the belt tensioner.
View 7 RepliesFord - F150 :: 2003 - Faint Bird Chirp Squeak Whenever Hit Bumps In The Road
I have a 2003 f150 with a 4.2 v6 2wd and about 116 on the clock.
It has this annoying, faint squeak whenever i hit bumps in the road. Sort've sounds like bird chirps. I cannot reproduce it if I bounce on it while parked.
One rainy day I tried to show a friend and it would not make the sound it seemed. Therefore I think its exterior, although it almost sounds inside.
Today I sprayed down all the rubber joints under the front end with silicone spray. It still squeaked while driving afterwards. How else can I go about diagnosing this?
I should note that a ford dealer claimed the ball joints were worn and needed to be replaced. Although, would a ball joint make bird chirp type squeaks while driving at most speeds (20mph - highway speeds)? It does not intensify or change at any particular speed.
My understanding is that a bad ball joint would grind when turning the wheel or clunk while traveling over speed bumps or something similar.
Ford 6.7L Power Stroke Diesel :: 2011 F350 - Squeak / Chirp From Front
2011 Ford F350, 69K miles... Just started, at about 30mph. I am hearing a Chirp from the front, speeds up when I speed up and goes away with brakes or slow below 30.
Friend thinks its the brake warning telling me its time for new. Bugging me. Just started. Never changed brakes.
Golf VI R :: Squeak / Chirp Once Every 30 Seconds Or So From Engine Bay
So last night I washed the R, pulled it out of the garage to squeegee the floor, and brought it back in. Then I heard this weird squeak chirp sound... tracked it to of all places, the engine compartment of my R! Thought I had a mouse in there.. didn't find anything.
So tonight I took the wife out for supper. Got home, parked the R, same sound, but only faster! Here's a video of the sound, sounds like it's coming from the engine bay for sure. Weird, right? I did some googling and didn't find anything else. Seems like it must slow down when it's colder. Because last night it was once every 30 seconds or so.
Prius (2004-09) :: Brakes Squeak Or Chirp When Pressed Hard
I've noticed that when I'm stopped, or in park, and I push on the brake pedal hard I hear a squeak or chirp that sounds like it's coming from the wheels. It might even sound like someone is honking at you as if you were not going when the light turned green. I have not been outside the car when this occurs, so I don't know exactly where the sound is coming from.
View 11 RepliesGolf/GTI VI :: Chirp / Squeak Under Hood - Bad Serpentine Belt Tensioner?
So my mk6 developed what initially sounded initially like a bad serpentine belt tensioner. Only under anything more than load, and sounded like a bird chattering under the hood. Got outside today, fired car up, watched tensioner and it sat there steady as a rail. The noise is coming from the opposite side of the engine. Not really mechanical/metallic at all and tracks under load with the RPMs. Why i initially thought what i did. Not I'm sort of baffled.
View 3 RepliesGolf V R32 :: Squeak Or Chirp Sound Whenever Hit A Bump Or Rough Road
Ever since i bought my .:R (3weeks ago) there has been this 'squeak' or 'chirp' sound whenever i hit a bump or rough road. Car only has 22k miles on it so this is way too early for any noises to be coming up. I've spoken to a few friends and they think it might be the bushings or my suspension was installed incorrectly. What it may be?
View 20 Replies