Camry :: 2000 - Check Engine Light On But No Error Codes
A couple of weeks ago the check engine light came on and when I had the codes checked it showed a problem with the EGR valve. I replaced it and the light went off. A week later the check engine light came back on but when I had the error codes checked there weren't any. After a few days the light went off but earlier today it came back on. There are still no error codes.
I forgot to mention that it's a 2000 Camry, 6-cyl.
Camry :: 2011 L4 - Check Engine Light On After Trying To Start Car Multiple Times Without Gas
I have a 2011 I4 camry. I recently ran out of gas and decided to keep trying to see maybe if the car would turn on. After all that i gave up cranking the car on and decided to push to a gas station. After putting in gas (93 octane) I realized i have my check engine light on and another light which depicts a car with 2 swiggly lines.What that light means but its to the right of of lcd display which shows your mileage. I am taking the car tomorrow to the dealership but I was wondering is there any way i can check the codes without an obd scanner (the thing that checks for codes). Do you think I ruined my engine after trying to start the car multiple times without gas?
View 5 RepliesToyota - Camry :: 2000 - Check Engine Light Codes
I had my 2000 Toyota Camry with 133,921 miles on it seen because of the check engine light.The codes obtained at the repair shop were:
P0136: Oxygen Sensor CKT Malfunction Bank 1 Sensor 2
P0446: Evap Control system Vent CKT Malfunction
They then ran a smoke test and found that the charcoal canister was leaking and needed replacement. The mechanic said that not doing the above would not affect the car's performance or its safety but it would not pass inspection with the check engine light on and with those codes.
Toyota - Sienna :: Check Engine Light Won't Stay Off
My check engine light won't stay off. My mechanic keeps replacing things. He says its got to be the exhaust system. I was wondering if its something electrical or within the car's computer system. First time he replaced one of the catalytic converters. The light went off then reappeared several days later. He replaced the oxygen sensor. Light off again then back on 2 days later. Then he replaced the other catalytic converter. (I was told there are 3 of them). Once again the engine light went off but reappeared 2 days later.
View 3 RepliesFord - Explorer :: Check Engine Light And Wrench Symbol On With Multiple Codes
I have 2007 explorer 4.0 4x4. Check engine light and wrench symbol on with codes po743 po750 po755 po po765 po966 po966 po970. Feels like it is now stuck in 3rd gear.
View 2 RepliesPrius C :: Check Engine Light Came On / Error Codes Are P0441 And P0445
Just tried to leave for work and my check engine light came on. Luckily I just got a scangauge and the error codes are P0441 and P0445. I checked online and for regular Prius is says it could be the fuel system, fuel cap, etc. I'm scared to drive it now and wonder if I should call Toyota Care to tow my car to service.
View 6 RepliesFord - Explorer :: Check Engine Light Came On But No Error Codes - How To Reset
My 1998 Explorer with 120,000 mile on it. The check light just came on. I have had several auto part stores plug in the scan tool and there were no error codes. I'm looking for the reset button location. I am also wondering should there be something missed by the scan tools, will the light activate should there be a real problem.
View 9 RepliesGolf VI R :: Engine Error Codes - Random / Multiple Cylinder Misfire Detected
I recently found these codes. My car is APR 1+. The car seems to run fine so I'm not sure what is going on. I changed the plugs at ~60K miles and now have 72K miles.
Address 01: Engine (CRZ) Labels: 06F-907-115-CDL.clb
Part No SW: 5K0 907 115 M HW: 8P0 907 115 B
Component: 2.0l R4/4V TFSI 0020
Revision: 5BH20--- Serial number:
Coding: 0403010A180F0160
[Code] ....
Golf IV / Jetta IV :: Check Engine Light With Error Codes 17748, P1340
I'm having some problems with my 05 1.8T GTI. I've had a check engine light for about 3 months and finally got a diagnostic tool (VAG V-checker). Right now I have one code 17748.P1340 Camshaft position sensor-G40/engine speed sensor -G28: incorrect allocation.
I researched a little bit and talked with some of the guys at the local VW dealership. From what I learned this could be related to (obviously) faulty camshaft position sensor and/or faulty engine speed sensor. So I've replaced both of these sensors and even cleaned the Mass Airflow sensor.
I cleared the code and after driving about 5 minutes the code came back. Also I recently had a P0300 and P0304 cylinder 4 misfire default code. So I've changed all of the ignition coils too since I heard they were recalled a while back.
Santa Fe (CM - 2007-12) :: Check Engine Light Went On - Error Codes P0021 And P0022
2 error codes? Car runs fine - nothing seems wrong - the check engine light went on, so I pulled out the scanner which came up with the 2 codes: P0021 and P0022.
View 8 RepliesFord F-150 - 1997-2003 :: Misfire Error Codes And Check Engine Light
So I have been having some troubles with my 2003 F150 4.6L ... Truck has been running rough and the check engine light was on so I decided to get the codes read and I got back P0302 and P0304, which from what I understand is a misfire on cylinders 3 & 4. At the same time I got Ford to do a little diagnostic and this is what they wrote for me:
"The connector for the number 2 coil is broken and will not stay plugged on to the coil and the number 2 coil is not working / replaced the wire for the coil still running rough removed the coil and plug. the plug was very badly fuel soaked started the vehicle to see if there was spark at the plug. OK. Suspect either a injector issue or a compression issue cleaned the plug seems better. "
So of course they quoted me for the works. They say I should replace the coils, plugs, and injectors??? I am pretty mechanically inclined and think I could change these things myself since I am on a budget. One tech told me is that the plugs can seize in these engines often and could scrap the whole thing??? Seems a little weird. If that happens though what could I do?
Volvo - S40 :: Check Engine Light On - Error Codes For Timing Belt And Temperature Sensor
2001 volvo s40. Diagnostics performed. Error codes for the timing belt and temperature sensor. These were replaced. The check engine light still comes on/stays on.
View 6 RepliesBuick :: 2000 / 3.8 Engine Just Quits Multiple Times While Driving
2000 Buick 3.8. stop for gas, red light, etc. engine quits. 1st repair shop said fuel pump bad. Replace filter pressure okay. car starts later, quits multiple times. 2nd repair shop, car quits while there. Mechanic comes out with tester and says "no spark", ignition module bad, also spark plug harness bad. Replace just wires, and car runs for 9 months, no trouble. Now car quits while driving, no sputtering, just quits! Wait awhile, car starts, but 30 miles later, quits. Seems that hot weather has something to do with it, although it quit on a cold rainy fall day and had a hard time starting again. It did start and ran for 300 miles before acting up.
View 4 RepliesToyota - Camry :: 2002 - Check Engine Light Went Out / No Codes
Car: Toyota Camry 2002 .. Mileage: 150K
Symptom:Check Engine light went on a few days ago.
Checked codes and got these (3):
1) P0420
2) P1310 and
3) P0420 P ("Pending" ?)
I also checked I/M Readiness and got these suspicious-looking values:CAT: NOT RDYEVAP: NOT RDYO2S: NOT RDYH02S: NOT RDY
NOTE all the other I/M values were N/A
Researching the Codes, it sounded like Ignition, and possibly the O2 sensor on the Catalytic Convertor. I had just had some engine work done by the dealer -- actually, replaced spark plugs -- so I figured to go back and bitch him out for screwing up my car.
A few days later, before I could engage my Rage, I went back and re-scanned. First I noticed the CEL was now OFF. Scanning, I now I get "NO CODES", and all the I/M values are now N/A; No more "NOT RDY".
What do you all make of this? Should I be concerned now that the CEL is Off, and I get No Codes with a scan?Or maybe I should take it to AutoZone for their free CEL diagnosis -- would their machine be more thorough than mine (Autel MaxioScan 300)??
Volvo - S70 :: 2000 - Check Engine Light Is On With Three Codes
The Check Engine Light is on. Diagnostic Codes: P0722, P1618, and P1633. Do these mean the output speed sensor/connector wires should be replaced? Is this a DIY job?
View 1 RepliesFord - Escape :: 2004 V6 Misses / Bucks And Jumps - Multiple Check Engine Codes
This is a Ford Escape XLT with the 3.0L V6. I get the following codes - P0316 P0300 P0136 P0305 P0306. Sometimes it runs just fine and sometimes it misses and bucks and jumps. It has been taken to a local shop and they said they found a loose ground at the computer. They said they corrected this and it should run fine. It still shows the same codes and runs like it did before they worked on it.
View 10 RepliesAccent LC (2000-05) :: 2001 GSI - Check Engine Light / Mysterious P0300 Error Code
Mystery issue with my 2001 Accent GSI (5-speed manual, 1.6 L). I'm getting a P0300 error code and the Check Engine light (the light is like an old friend, I miss it when it's not on). This happened four months ago and I replaced the ignition coil - seemed to fix things - but now the light and the error is back with a vengeance. Car stumbles and runs rough. Changed the plugs and plug wires, but no difference.
BTW, there's a small pin hole in the upper part of the gas tank (just enough to give it a gassy smell when the tank is full) but I don't think the hole would be big enough at this stage to cause the check engine light to come on in the same way it does if you leave the gas cap off or loose.
Camry :: 2000 - Check Engine Light On And Codes Are P0446 And P0401
My camry 2000 recently the engine light's on and the codes are P0446 and P0401
P0401:The PCM has determined that there is insufficient flow in the exhaust gas recirculation system.
P0446: The PCM has determined that a malfunction exits in the electrical circuit fo the vent control in the evaporative emission control system.
Accent LC (2000-05) :: Check Engine Light Error Code P1128 / Too Lean Intake System
This is the infamous error code many Accent owners might have experienced it. The code refers to "Too lean intake system". People try to replace all kinds of parts like ECM, MAF, O2 Sensor, TPS, Fuel Pump, Fuel Filter, etc. according to my research. I just bought a 2001 Accent and the P2188 light came on. I wrote an email to Hyundai Corp. Asking what would be the most likely part that will cause the (P2188) check engine light to come on.
View 3 Replies