Toyota - Sienna :: 2000 - Check Engine Light Would Come At Times And Go Away / Multiple Error Codes
I have a 2000 Toyota Sienna that has had a check engine light for a while. The light would come at times, and go away at others, with prolonged intervals (days, weeks, months) with or without the light.
Suddenly it started losing power, especially on hills (even a small hill). The codes I read are (I include code interpretations from internet search):
P0300: Random or multiple misfire.
P0301: Cylinder 1 misfire.
P0304: Cylinder 4 misfire.
P1130: Air fuel sensor
P1150: I have not found a problem definition for this code.
Might these codes be indicative of a particular problem, or is each problem more likely a problem with its own cause?
Toyota - Camry :: 2000 - Check Engine Light Codes
I had my 2000 Toyota Camry with 133,921 miles on it seen because of the check engine light.The codes obtained at the repair shop were:
P0136: Oxygen Sensor CKT Malfunction Bank 1 Sensor 2
P0446: Evap Control system Vent CKT Malfunction
They then ran a smoke test and found that the charcoal canister was leaking and needed replacement. The mechanic said that not doing the above would not affect the car's performance or its safety but it would not pass inspection with the check engine light on and with those codes.
Camry :: 2000 - Check Engine Light On And Codes Are P0446 And P0401
My camry 2000 recently the engine light's on and the codes are P0446 and P0401
P0401:The PCM has determined that there is insufficient flow in the exhaust gas recirculation system.
P0446: The PCM has determined that a malfunction exits in the electrical circuit fo the vent control in the evaporative emission control system.
Prius C :: Check Engine Light Came On / Error Codes Are P0441 And P0445
Just tried to leave for work and my check engine light came on. Luckily I just got a scangauge and the error codes are P0441 and P0445. I checked online and for regular Prius is says it could be the fuel system, fuel cap, etc. I'm scared to drive it now and wonder if I should call Toyota Care to tow my car to service.
View 6 RepliesFord - Explorer :: Check Engine Light Came On But No Error Codes - How To Reset
My 1998 Explorer with 120,000 mile on it. The check light just came on. I have had several auto part stores plug in the scan tool and there were no error codes. I'm looking for the reset button location. I am also wondering should there be something missed by the scan tools, will the light activate should there be a real problem.
View 9 RepliesGolf IV / Jetta IV :: Check Engine Light With Error Codes 17748, P1340
I'm having some problems with my 05 1.8T GTI. I've had a check engine light for about 3 months and finally got a diagnostic tool (VAG V-checker). Right now I have one code 17748.P1340 Camshaft position sensor-G40/engine speed sensor -G28: incorrect allocation.
I researched a little bit and talked with some of the guys at the local VW dealership. From what I learned this could be related to (obviously) faulty camshaft position sensor and/or faulty engine speed sensor. So I've replaced both of these sensors and even cleaned the Mass Airflow sensor.
I cleared the code and after driving about 5 minutes the code came back. Also I recently had a P0300 and P0304 cylinder 4 misfire default code. So I've changed all of the ignition coils too since I heard they were recalled a while back.
Santa Fe (CM - 2007-12) :: Check Engine Light Went On - Error Codes P0021 And P0022
2 error codes? Car runs fine - nothing seems wrong - the check engine light went on, so I pulled out the scanner which came up with the 2 codes: P0021 and P0022.
View 8 RepliesFord F-150 - 1997-2003 :: Misfire Error Codes And Check Engine Light
So I have been having some troubles with my 2003 F150 4.6L ... Truck has been running rough and the check engine light was on so I decided to get the codes read and I got back P0302 and P0304, which from what I understand is a misfire on cylinders 3 & 4. At the same time I got Ford to do a little diagnostic and this is what they wrote for me:
"The connector for the number 2 coil is broken and will not stay plugged on to the coil and the number 2 coil is not working / replaced the wire for the coil still running rough removed the coil and plug. the plug was very badly fuel soaked started the vehicle to see if there was spark at the plug. OK. Suspect either a injector issue or a compression issue cleaned the plug seems better. "
So of course they quoted me for the works. They say I should replace the coils, plugs, and injectors??? I am pretty mechanically inclined and think I could change these things myself since I am on a budget. One tech told me is that the plugs can seize in these engines often and could scrap the whole thing??? Seems a little weird. If that happens though what could I do?
Volvo - S40 :: Check Engine Light On - Error Codes For Timing Belt And Temperature Sensor
2001 volvo s40. Diagnostics performed. Error codes for the timing belt and temperature sensor. These were replaced. The check engine light still comes on/stays on.
View 6 RepliesCamry :: 2009 - Check Engine Light On / Error P0500
Currently I haven't been tweaking anything to my car after driving to go and home I left to go get something to eat and after driving for a few min out of nowhere the engine light, brake and abs comes up. So I freak out a pull over to the nearest gas station and turn my engine off for 2 min and turn it back on and this time only the engine light come up. So I drove to autozone to get it scan and error p0500 comes up. Which means short circuit, vss and poor electricity something I am not exact but is it serious? Like I am freaking out right now.
View 1 RepliesVolvo - S70 :: 2000 - Check Engine Light Is On With Three Codes
The Check Engine Light is on. Diagnostic Codes: P0722, P1618, and P1633. Do these mean the output speed sensor/connector wires should be replaced? Is this a DIY job?
View 1 RepliesAccent LC (2000-05) :: 2001 GSI - Check Engine Light / Mysterious P0300 Error Code
Mystery issue with my 2001 Accent GSI (5-speed manual, 1.6 L). I'm getting a P0300 error code and the Check Engine light (the light is like an old friend, I miss it when it's not on). This happened four months ago and I replaced the ignition coil - seemed to fix things - but now the light and the error is back with a vengeance. Car stumbles and runs rough. Changed the plugs and plug wires, but no difference.
BTW, there's a small pin hole in the upper part of the gas tank (just enough to give it a gassy smell when the tank is full) but I don't think the hole would be big enough at this stage to cause the check engine light to come on in the same way it does if you leave the gas cap off or loose.
Toyota - Camry :: 2002 - Check Engine Light Went Out / No Codes
Car: Toyota Camry 2002 .. Mileage: 150K
Symptom:Check Engine light went on a few days ago.
Checked codes and got these (3):
1) P0420
2) P1310 and
3) P0420 P ("Pending" ?)
I also checked I/M Readiness and got these suspicious-looking values:CAT: NOT RDYEVAP: NOT RDYO2S: NOT RDYH02S: NOT RDY
NOTE all the other I/M values were N/A
Researching the Codes, it sounded like Ignition, and possibly the O2 sensor on the Catalytic Convertor. I had just had some engine work done by the dealer -- actually, replaced spark plugs -- so I figured to go back and bitch him out for screwing up my car.
A few days later, before I could engage my Rage, I went back and re-scanned. First I noticed the CEL was now OFF. Scanning, I now I get "NO CODES", and all the I/M values are now N/A; No more "NOT RDY".
What do you all make of this? Should I be concerned now that the CEL is Off, and I get No Codes with a scan?Or maybe I should take it to AutoZone for their free CEL diagnosis -- would their machine be more thorough than mine (Autel MaxioScan 300)??
Camry :: Check VSC Warning On The Dash - Error Codes U0100 And U0101
I have a 2008 Aurion (NZ/AU version of the Camry V6), and I am frequently getting the Check VSC warning on the dash. So then I bought a bluetooth OBD2 adapter, plugged it in and it returned the error codes U0100 and U0101 which is apparently a network issue though I don't know exactly what that pertains to.
View 14 RepliesAccent LC (2000-05) :: Check Engine Light Error Code P1128 / Too Lean Intake System
This is the infamous error code many Accent owners might have experienced it. The code refers to "Too lean intake system". People try to replace all kinds of parts like ECM, MAF, O2 Sensor, TPS, Fuel Pump, Fuel Filter, etc. according to my research. I just bought a 2001 Accent and the P2188 light came on. I wrote an email to Hyundai Corp. Asking what would be the most likely part that will cause the (P2188) check engine light to come on.
View 3 RepliesCamry 2012+ :: Check Engine Light On - Codes For EVAP Emission Control System
So mad today. Check engine light came on, plugged in my scanner, got P0441 EVAP Emission Control system Purge Flow Fault and P0455 EVAP Emission Control System Leak (Large).
8-month old '13 TCH XLE is getting a check engine light already.
Toyota - Camry :: 2000 - Check Engine Light Never Comes On
I have a 2000 Toyota Camry that has a unique problem. The Check Engine light NEVER comes on even when first starting the car. I have access to a scanner and know that the car periodically throws a catalyst code but the light never comes on. I just assumed that the bulb was burned out.
Today while solving a non-working clock issue I had to take the instrument cluster to get to the clock. While I had it out I decided to check the Check Engine Light bulb. It looked fine so I took I replaced it with a bulb that I knew worked fine. Again, nothing. The bulb doesn't light at all. About 4 weeks ago my timing belt broke while driving (non-interference motor) and it threw a code for the camshaft position sensor but again the light never came on.
Why the light never comes on?
Toyota - Camry :: 2000 - Loud Noise And Check Engine Light On
I have a 2000 Toyota Camry with about 136,000 miles on it. Recently because it was making a loud noise and because the check engine light was on we got the exhaust system changed at Coles and this made the car silent as before.The mechanic there checked the check engine light code and reset it and he said it was an Evap code.He checked the fuel cap and found it to be OK. He said that if it comes back again I have to get it checked by some one who has a smoke machine to detect the leak and this could cost me about $100/- to set it right.The check engine light has come back again.
View 4 RepliesLexus GS 2006-11 :: Check VSC Error Code P0300 With Check Engine And Traction Light On
A few days ago my "Check VSC" warning came on along with the check engine and traction lights being on. I left my car in a parking garage for a week when I was on vacation and the lights came on once I started the car after getting back from my trip.
I have had the "Check VSC" warning before and I fixed it by replacing my gas cap. My gas cap seems fine this time around so I got my codes scanned and the only one that came up was P0300. Having this issue with the 2007 Lexus GS 350? I still feel like it's my gas cap because I bought a cheap replacement last time around.