Passat (B5) :: 2002 1.8T - Ticking Noise After Replacing Timing Belt
I had the Timing belt, roller, tensioner, belts, etc replaced and I am getting this funny ticking noise after the engine tuns on. It seems to go away after the engine warms up but not all the time. I have the AWM engine and bought the kit from ECS tuning. My mechanic (who is excellent and beyond honest) thinks that I have sludge in the engine. The engine was super quiet before the whole kit was replaced so I doubt that all of a sudden the sludge, if present, would cause this. I have been meticulous with oil changes and always used the appropriate weight and type. Castol Syntec 502. My mechanic told me that the belts and everything looked in great shape at 89000 miles. I wonder if I should have bought OEM parts. Otherwise the car runs perfectly.
View 1 RepliesPassat (B5) :: Oil Leak After Replacing Timing Belt And Water Pump
I replaced a timing belt and related parts on a v 6 atq motor and three weeks later there's a pretty good oil leak, where its from or if oil leak can be related to timing belt replacement... leak seems to be in same area as crank pulley but not sure...
View 2 RepliesPassat (B5) :: 2000 - While Replacing Timing Belt Motor Oil Is Leaking?
I have just bought a 2000 passat 1.8t. The car had broken timing belt so i was just planning to replace the timing belt but there is another issue. When i was disassembling the radiator support I took off the intercooler but there was a lot of motor oil so I am not quite sure what is the problem. And do have to rebuild the engine or replace the cylinder head because of the broken timing timing belt. The belt was actually not broken only belt teeth are gone so I think that piston and valves might crashed.
View 10 RepliesToyota - Sienna :: 2003 - Replacing CA Catalytic Converter
Chk engine light is on. Checked it at Advance Auto and indicated either cat or the O2 sensor (rear). So, I went to replace the O2 sensor and learned the hard way that you can't just unscrew the nut. I torqued off the stud to which the O2 sensor attaches. Muffler shop told me you need to heat up the stud/nut first to remove it. Oh well, lesson learned. So, I'm looking at replacing the pipe with the catalytic converter attached since I can't seem to fix the broken stud (or actually get the one I didn't break off). The problem is, my car is apparently a CA model and has the special cat on it. I live in VA. What sort of problems might I run into if I replaced the cat with a non-CA version? They are significantly less expensive. This is for a 2003 Toyota Siienna
View 1 RepliesHonda - Accord :: 1997 - Still CEL Comes On After Replacing New Catalytic Converter
My wife and I have a 1997 Honda Accord, roughly 260k miles. A few months back the Check Engine light came on, diagnostic came back with P0420, typically indicating the catalytic converter is shot. Who am I to argue, it was an factory part. So we replaced that with an inexpensive Magnaflow converter. (don't have the part number on me); this was 5 days ago. Today my wife takes the car in for inspection. Check Engine is still on with the same code. The guy at the testing station begins laughing at my wife when she says we only spent about 200 in parts and labour on the new converter. I'm inclined to think that since we already replaced the converter that I should be looking somewhere else (O2 sensor maybe). But I also don't want to just start throwing parts at it. Do I have a case here? I would really prefer not to spend $1000 on a car that old with that many miles on it just to pass inspection.
View 4 RepliesCamry :: 2006 SE Lost Electrical Power After Replacing Catalytic Converter
06 Camry SE I4
I had to replace my catalytic converter because of the code I was getting. It wasn't difficult to do, but took me a while because I had to transfer the thread rods to the new CAT. Once the new CAT was installed, I went to test her out, but noticed that the car all of a sudden, has no electrical power. Nothing at all. I checked all fuses and nothing is blown. The only electrical I messed with on the car was the O2 sensor.
Car has a brand new battery from yesterday. The only thing I didn't do is install a support bracket on one side, because it was missing a bolt and one thread rod was stuck in the old CAT, i couldn't remove it.
A friend suggested that the missing bracket may be causing a ground issue. Is this true?
Subaru - Outback :: 2011 - Intermittent Rattle - Replacing Catalytic Converter
Heard a funny intermittent rattle and my mechanic told me that my check engine light should be going on any time now as my cat converter is bad. The part is about a thousand bucks! Looked on line and see some aftermarket ones from walker and some other retailers. My car has 103K miles on it,.
View 17 RepliesSonata NF (2006-10) :: Replacing Valve Cover Gasket On 4 Cylinder 2.4L
Changing the valve cover gasket on the 4 cylinder 2.4l. I was going to change mine's. Didn't know if there are any special tips like sealant to be used, loosening bolt sequence or tightening sequence, torque values.
View 9 RepliesHonda - Accord :: 1994 - Replacing Valve Cover Gasket?
I'm replacing the valve cover gasket on my 94 Honda Accord. I've heard all sorts of crazy opinions on what needs to be done while installing the gasket such as using various sealants or lubricants. Should anything be put on the gasket or should I just drop it in and screw the valve cover back on?
I'm also replacing the spark plugs while I'm at it. Is there anything else I should do while I'm in there?
Acura - Integra :: 1990 - Replacing Timing Belt?
My 1990 Acura Integra is on her 4th timing belt...still going strong after 25 years! Long ago, I was told by the people who worked on my car that it was best to replace the Timing Belt every 60K. My Manual says inspect at 60K but replace at 90K.I typically have changed it at around 65K....and now it is a bit beyond the 65K mark for this timing belt ( also do the water pump, etc) as the car is now at 262,327 miles.I am tempted to wait a bit longer, as it is not even close to the 90K mark.
View 19 RepliesHonda - Accord :: 1999 - Replacing Timing Belt?
I have a 1999 Honda Accord V6 with 101,000 miles - I am the second owner and the car was meticulously maintained and garage kept by the original owners. I need to have the timing belt replaced and am wondering if I should have the water pump and/or other parts replaced during this repair? Economic prudence is of the essence.
View 19 RepliesHonda - Accord :: 1997 - Oil Leak Behind Timing Belt Cover?
I have a 97 Honda Accord with V Tec engine, 2.2L. I have an oil leak that is coming from BEHIND the timing belt cover. I removed the cover and the belts to expose several seals. The oil leak is quite extensive and leaves a good puddle after running the engine, however, it will not leak once I clean up the mess, put the car up on jack stands and disassemble the engine. I cannot tell which seal is leaking and am wondering how to tell which seal is leaking. Is there a way to apply pressure to the engine with air, possibly through the oil dipstick hole to possibly expose the leaking seal?
View 9 RepliesFord - Explorer :: 2003 - Valve Cover Oil Leak / Timing Chain Rattling
My 2003' Explorer XLT (4.0L V6) has an oil leak. I tracked it down to the passenger side, rear, bolt head on the valve cover (back by firewall). I took it to a guy who replaced the valve cover gaskets, but it is still leaking. He claimed when he had the cover off he looked for any cracks on it, but did not see any at the time.
Anyways, I was searching around and found several explorers leaking in or around the same area of the valve cover. And it turned out that there issue stemmed from bad timing chain guides, causing the valve cover to crack.
I do notice that on a cold start, I hear a rattling when I first start it up. It rattles for maybe that first 1-2 seconds when starting. Is this my timing chain rattling around? If that is the case, how much this could set a guy back on repairs?
I guess I don't know whether to just replace the valve cover, or if I should dig into it to see if the real issue is the timing chain guides/tensioner. Mileage is approximately 121,000....
Golf IV / Jetta IV :: Engine Won't Start After Replacing Valve Cover Gasket
My mk4 sat for a while and upon starting up was misfiring. I checked for pvc leaks and didn't see anything but went ahead and cleaned my maf sensor and decided to pull my coils. Cylinder 1 had oil on the tip and around the spark plug which to me spelled out a bad valve cover gasket. I got all the parts to do the inner and outer gaskets and replace the coil and spark plug, however we got a snowstorm and my luck a rabbit got in and ate the wiring on one of my fuel injector connectors.
So went ahead and put on the new gasket, replaced the coil and plug and bought a new Fuel Injector Connector and spliced in onto the Injector "Pigtail'. I double checked everything was reattached properly and let the gasket sealant dry for 24 hours. I went to start it tonight and after trying to turnover it completely cuts out, wont even start up. I'm extremely frustrated at this point and am thinking the rabbit must have gotten to something else unless I did something wrong in the process of repairing.
Toyota - Camry :: 2000 - Replacing Leaking Valve Cover Gaskets
Own a 2000 Camry XLE 6-cyl. Both valve cover gaskets are leaking. Rear one leaks onto the manifold and causes stench. Have been quoted $350. to replace because the job is complicated. Have any of you done this on your own, and if so, would you recommend it or go to a qualified mechanic?
View 9 RepliesToyota - Tundra :: 2000 - Very Low Power After Replacing Valve Cover Gaskets
Truck was running a little rough before valve cover gasket replacement. Replaced gaskets and it ran rougher than before. Found a burned out spark plug coil and replaced coils, plugs, and wire. Runs smoothly now, but there's very, very low power, probably tops out at 35 mph. What gives?
View 19 RepliesLexus GX 2004-09 :: After Replacing Timing Belt - Air Bag Light Remains On
I have a GX470 and just had the timing belt replaced. Now my "airbag light" stays on all the time.
View 12 RepliesGTI 337/20th Anniversary :: Engine Overheating After Replacing Timing Belt
I replace my timing belt and water pump and my engine is now over heating. I notice it's only over heats when the ac is running and the engine is idling. When I start to drive the engine temp goes down.
View 1 RepliesPassat (B5) :: Catalytic Converter Replaced, CEL Came On
I recently had my catalytic converter replaced with a non-OEM cat. The check engine light came on and a different shop (different from the shop that replaced the cat) said that it will keep coming on because I had the cat replaced with a non-OEM cat.
View 3 Replies