Avalon 2005-12 :: P0051 Code - Hidden Sensor Replacement On Firewall Side
So, my '06 XL just popped up a P0051 code, which is the bank 2, sensor 1 (the upstream A/F sensor that you can easily view upon opening the hood in the front exhaust manifold. Easy enough of a replacement on that one, but what about bank 1, sensor 1 (the upstream A/F ratio sensor on the firewall side of the engine)? I changed my oil today and I can access three of the four oxy/A/F sensors, but the upstream rear looks like a bitch! Out of curiosity, I called a local Toyota dealer and they said it would be 300.00 total to replace the hidden sensor on the firewall side. Does this amount seem realistic? I know that there is a TSB for this sensor that states to replace the exhaust manifold/cat assembly. I def. can't afford no 1700.00 crap right now!!
View 3 RepliesLexus SC430 :: Code P0051 Together With VSC And VSC Off Lights
P0051 together with VSC and VSC Off Lights
Over the weekend I had multiple P0051 and VSC and VSC Off Lights CELs
I have reset them using my OBDII scanner. It keeps on coming back.
This means the BANK 2 SENSOR 1 (just before the CAT) is reading low temps and therefore throwing a code. I get this.
Question is why do the VSC lights go "ON" too?
This started when I installed my ScanGage e this weekend. This is a change point.
Before I go purchase a Denso sensor, I would like to perform a series of tests:
1.Remove the ScanGage e. Test drive if any of the CELs (P0051 and VSC) come back.
2.If the same set comes back, clear the VSC lights code using our home made device.
If the VSC lights disappear and the P0051 comes back, I will replace the BANK 2 SENSOR 1 Oxygen sensor. Prior to replacing, I will check for wiring issues on this sensor.
Lexus ES 2007-12 :: Code P0051 After Running Through Deep Water On Road
I have recently run through a large pool of water on the road and this shortly after tuned on the engine warning light and the " ! " light. Everything seems to feel Ok but had the OBD code read and it shows P0051 and also showed VSC. What to look for?
View 5 RepliesLexus ES 2007-12 :: Code P0368 - Camshaft Position Sensor Error
2007 Lexus ES350 with 177k miles. Getting a P0368 (Camshaft Position Sensor B Circuit High Bank 1) Error. I can't seem to find online where this sensor is located at.
View 2 RepliesPrius (2004-09) :: Getting OBD2 Error Code P1100 - BARO Sensor?
An OBD tester is reporting error code P1100. Checking online I have discovered that it is in reference to a Barometric sensor that is reading out of range. However, I cannot find any identification of the Toyota part number, its location, and whether or not it is a DIY replacement
View 1 RepliesGolf IV / Jetta IV :: 2004 - Camshaft Position Sensor Error Code
I have a 2004 MK4 Golf 2.0l that's been throwing a CPS error code. My brother was going to come down to visit for a weekend. He had done some diagnostic work and had me order a timing kit and a camshaft position sensor from ECS.
So, with my assembled parts, I brought the car in to a reputable shop. Anyway, the guy does the work and now the car is ready and saying that the CPS took nearly 4 hours more of work.
Lexus GX 2004-09 :: Error Code C1336 On GX470
I used Maxidas for scanning my GX470 05 and I have error code C1336 ... How to resolve it ?
View 8 RepliesLexus GX 2004-09 :: Error Code PO420 And PO430 On GX470
Since 1 year i have this error code in my GX 470. I have replace all oxygen sensor but after 1 day the error code is coming back. How to resolve it ?
View 14 RepliesLexus RX 2004-09 :: Service Engine Light Is On - P0446 Error Code
My service engine light is on and the tech at Quick Lube said this is the error code that is reporting. "P0446 EVAP Control System Vent Control Circuit Malfunction". Is the car safe to drive?
View 10 RepliesLexus RX 2004-09 :: P0355 Error Code And Potential Misfire Codes On All Cylinders
I am getting P0355 error code and potential misfire codes on all cylinders. Engine light and VSC stays on now. Idle is unstable and power is a little jerky at times. I bought a Denso direct ignition coil to replace, however, Cyl 5 looks difficult to access.
View 3 RepliesCamry :: O2 Sensor And Error Code P0137
Had my Check Engine light come on so I went by a local AutoZone to see if they could read the code. He said it was P0137, but what his reader can't tell is which one it is.
A co-worker pointed out where it was on my 2006 2.4, but I'm not sure if it's the sensor in the engine bay or the one closest to the catalytic converter. The engine bay looks easy to change out but I'm in no condition to be crawling around underneath.
Which sensor the P0137 is referring to?
Lexus RX 2004-09 :: Error Code P0015 / Camshaft Position - Timing Over Retarded (Bank 1)
A week ago I was traveling in my wife's 2009 RX350 at freeways speeds and outside ambient temperatures around 80 degrees. After traveling about 2 hours and stopping for about half-hour for lunch, I started the vehicle and went around a mile and the Check Engine light came on, the VSC was flashing and the traction control indicator was illuminated. I stopped quickly in a gas station and checked the manual for what the warning lights meant. Nothing of any value was found; I filled the car up and headed for home, about 4 more hours at highway speeds. The warning lights stayed on and the VSC flashed the entire way home. The vehicle ran perfectly with no problems at all.
The next morning I started the car and the lights were out. Still worried, I purchased an OBD2 scanner and pulled a P0015 code, Camshaft Position - Timing Over-Retarded (Bank 1). I erased the code and the car has been fine ever since. Finally to the question, is this something I need to worry about? I travel this trip about once a month and don't want to get stranded along the road. The car has 54K on it and if it is a sensor in the engine, it should be covered by the powertrain warranty, but more importantly, will it cause damage to the engine? I read that the camshaft position sensor would only be replaced under warranty if it was inspected and causing a loud ticking noise, which I do not hear. If it throws the same error code again, I will take it in to the dealer and let them look into it.
Lexus RX 2004-09 :: Low Oil Pressure Warning Light Blinking Then Stays On - Error Code P0346
I have a Low Oil Pressure warning light on. When it first came on, I stopped and check the oil level. It was low. I had to replace the oil 2 or 3 months ago, but then I had na accident (rollover) and just this past week i received the car and forgot to replace the oil. So that's what i did. Replaced the oil and filter.
The lights still comes on after driving about 3 or 4 miles. It starts by coming On and OFF a few times. Sometimes just blinking, than it stays ON until I shut of the engine. What it could be?
After the referred rollover, the engine shut off, but I turned it on less than 30 seconds after this (I know I shouldn't have done that) and drove for about a mile. Do you know if that would damage the engine or oil pump in 132,000 miles RX330?
I checked and found this error code P0346 (Camshaft position sensor). Would it be related?
Lexus GX 2004-09 :: Reset Error Code On 2007 GX470 Tire Pressure Monitoring System
How to reset and remove the error code on the tire pressure monitoring system?
View 5 RepliesElantra XD (2001-06) :: Camshaft Sensor Error Code After Tune Up
I just had a ton of maintenance done on my 2003 Elantra. Spark plugs & wires, timing belt, drive belts, water pump, replaced coolant and replaced the transmission fluid. The spark plugs are NGK platinum as recommended in my handbook. As soon as the mechanic started the car after the tuneup, the engine light came on with a cam shaft sensor code. He said it went off on its own.
The engine light came back on when I started the car. There's also a major loss of power after coming to a stop. I have to floor it to get it to go anywhere above 20 mph after a stop.
The mechanic said that when he replaced my water pump the liquid splashed all over everything and he thinks he might have gotten something wet that shouldn't have gotten wet and that all will be fine after it dries.
Santa Fe (CM - 2007-12) :: Error Code P0057 - O2 Sensor Replacement
I need to replace O2 Sensor which is Bank 2 Sensor 2 which needs to be replaced.
Where is this located on a 2009 Hyundai Santa Fe 3.3L
Passat (B5) :: Getting Error Code P3081 - Coolant Temp Sensor?
P3081. What the hell is this code. I think it is a coolant temp. sensor issue.
View 3 RepliesFord - Explorer :: 1993 - Error Code For A Low Voltage MAF Sensor
1993 ford explorer sport... I got an error code for a low voltage MAF sensor. how would i go about fixing it? Do i need to get a new MAF sensor?
View 1 RepliesLexus RX 2004-09 :: Check Engine And VSC Lights Come On - O2 Sensor Code P0157
went to have an oil change. Standard procedure. Wife drives the 330 away and the check engine and VSC lights come on. I figure it's the maintenance indicator needing reset, but no..... the reset didn't work. Went back to my local mechanic who changed the oil to run codes and see what the problem is. Code P0157 = bad O2 sensor.
Now, I questioned him as to why these lights would come on DIRECTLY after they changed my oil. Is there any correlation there? NO, he says. No reason why these lights would come on immediately after the oil change and we've never seen these two lights come on at the same time before.
I've read every post and thread I can, but it seems like every issue is different. Some times it's a loose gas cap or gas cap that needs replacing. I have to drive 60 miles to the dealer some time soon to have a recall performed, but until then should I worry about this O2 sensor and these lights staying on?