Sonata NF (2006-10) :: Check Engine Light Came Up - P0660 Error Code
I recently bought a 2007 Hyundai Sonata Limited from a private seller. This car has been perfect for the few weeks I've had it. Now, my check engine light came up and the error code "P0660 Intake Manifold Tuning Valve Control Circuit / Open Bank 1" popped up. I'm not really sure what piece to look for, or which connectors to check.
View 3 RepliesSanta Fe (CM - 2007-12) :: 2011 GL V6 Speedometer Reading Is Way Too High
My New (weeks old) 2011 SF GL V6 speedometer reading is way to high. I've confirmed this with my GPS. My last 2 cars were Honda`s - one with a digital speedo (Civic) amd they were both bang on with the GPS.
So, my issue is why is the speedo so far out - 10%. I have to drive 110 km/h for a 100km/h on the GPS. On the positive side - I'll never get a speeding ticket.
But to all of you that claim to drive at 75mph and get 25mpg - I'm guessing your really traveling way slower. What can be done. In this day and age a calibrated speedometer isn't asking for much.
Santa Fe (CM - 2007-12) :: Fuel Gauge Not Reading Correctly And Check Engine Light On
I have a 2007 Sante Fe with the 3.3 engine. Having a problem with the Fuel gauge not reading correctly and a check engine light. The engine code indicated that the problem was with the sending unit in the tank on the "A" side (behind the driver). I checked with Hyundai and with a tech line service and they indicated that it was a common problem and I needed to replace both the "A" & "B" units to correct the problem. I did that and cleared the codes and it set another code indicating that the "B" unit was the source of the code. I pulled the "B" unit again and checked the wiring and the problem still was there. I switched out the units on the "B" side again with the old unit and the problem is still there.
View 4 RepliesSanta Fe (CM - 2007-12) :: CEL, But No Code?
Like it says, 2007 Ltd. Recently swapped the alternator and changed the fuel sending units. Had a CEL previous for the fuel gauge not working. Fuel gauge works fine now. Had a CEL with no code being thrown? What could it possibly be? I need to get her past smog here soon.
View 10 RepliesSanta Fe (CM - 2007-12) :: CEL On - Fault Code P0204?
New car showing fault code, bought privately no guarantee.... Checked using TORQUE-for android. showing fault code P0204, which is apparently injector or wiring circuit malfunction in cyl 4. Apparently , the injector was replaced when I bought it.... Is this a common fault?
View 22 RepliesSanta Fe (CM - 2007-12) :: Invalid VIN Error Code Shown
Check engine light is on, when I went to get my car inspected it was showing an invalid vin code. How do get this off so I can get my emissions done?
2007 Santa Fe SE
Santa Fe (CM - 2007-12) :: Code PO455 - No Odor Of Gas Fumes
2007 santa fe Had the engine replaced run very well . Every couple of days i get the PO455 code. Replaced the gas cap. Try to use my sense of smell to find the location of the leak . No odor of gas fumes. Spent an hour trying to find it. Will consider smoke test but wondering if it might be the vapor pressure sensor. Is it at the top of the gas tank, how do i get it it? Its the only code that comes up.
View 18 RepliesSanta FE SM (2001-06) :: Reading Lights At Mirror Are Out
Reading lights are not working, not sure why and would like to know why.
Also the high beam light is not coming on.
Santa Fe (CM - 2007-12) :: Check Engine Light With Code P0456
At roughly 140,000 miles, my wife's '07 Santa Fe GLS has thrown a P0456 code. Does this code on a Santa Fe common?
It is "evaporative emission system leak detected (very small leak)." The good news, I guess, is that it is 'very small.' However, being small may make it more difficult to detect.
Santa Fe (CM - 2007-12) :: Misfires Along With Error Code P0341 / P2189
I have a 2008 model 2.7 v6 with 80000 Km, and I would like to share my experience with several issues:
- Random misfire: brought the car to Hyundai, very bad response. I bought online the wiring of the spark plugs (according to them that was the reason of the misfire) and they installed it, did not improve. The car was still showing error code after clearing, and the fuel consumption at an average of 23L/100km.
- I then decided to change all the 6 spark plugs, no difference. The workshop told me the coils were in perfect condition. Still having a message like this: "ignition error on 2 or more spark plugs".
- I did a complete cleaning with contact spray of the MAF sensor.
- I bought online a couple of ignition coils, being original Hyundai ones, and changed them. When installing them i realized the existing ones were not original Hyundai and had a small marking, making me think they were recycled or chinese stuff.
- Having done that, the OBDII shown two more error codes: P341: error on camshaft position sensor, P2189: fuel idle (too much air, maybe caused by the first one). Changed both camshaft position sensors and then big change in the behaviour, more response, throttle, better gear switching.
- I so concluded that the 4 remaining coils have to be changed and ordered another time 4 of them online. OBDII showing now only one error code: random misfire. The engine going much better than all i got before.
- I have decided to take advantage of this order and also ordered a new TPS (seeing here that it was a common problem) and a Crankshaft position sensor (in order to prevent any other issue).
- I also changed previously 2 downstream o2 sensors that were giving an error related to emission. Emission here are not strictly controled so it is not a big issue.
My question is, what in all that sensors can more likely make my car burn 23L/100km??? Asian cities are quite similar to american cities, lots of highways. This consumption compared to what you describe is way over the normal one isn't it? I was assuming the ignition problem was the responsible, am i right?
Santa Fe (CM - 2007-12) :: Check Engine Light Lit Up - Code P1405
I've recently bought used Hyundai SantaFe 2007 and the engine check light lit up. I've bought EML327 OBD2 scanner, it showed P1405 meaning "EGR tempereature sensor incorrect". Some of my friends says it has something to do with CPF filter and EGR valve. They think, i should clean both CPF and EGR. Car service told me that DPF (not CPF) filter cleaning costs arround 350eu and one service told me to simply take it out and reprogram car computer. As far as EGR valve cleaning goes, no service wants to do this. I don't really know much about cars, so my main question is what would be my next step in trying to fix this error.
View 3 RepliesSanta Fe (CM - 2007-12) :: Check Engine Light On - Code Is P200A
My 2010 Santa Fe is only 2 month old and has 2000km now the check engine light is on. Went to the dealer and found out the code is P200A -Intake manifold runner performance. And they just clear the code. What does this code mean?
View 22 RepliesSanta Fe (CM - 2007-12) :: Error Code P0057 - O2 Sensor Replacement
I need to replace O2 Sensor which is Bank 2 Sensor 2 which needs to be replaced.
Where is this located on a 2009 Hyundai Santa Fe 3.3L
Santa Fe (CM - 2007-12) :: CEL Code P0441 - Fuel Gauge Inconsistent?
2009 Santa Fe GLS 2.7L ~63,000 miles .... Check engine light came on, scanner gave code P0441, but check engine light shut off later the same day. Since then the fuel gauge has been moving around inconsistently. Took it in to mechanic, he said he replaced a leaking hose. Next day, fuel gauge is still a moving target.
View 1 RepliesSanta Fe (CM - 2007-12) :: 2011 - PO198 Code / Oil Temperature Sensor?
I took my 2011 Santa Fe, 3.5 liter, in for the tail light water thing, and a cracked fitting down near the thermostat (all warranty). I bought a rad flush while they were in there.
I picked up the car, drove for 1/2 hour and got a CEL. Plugged in my code reader and got three PO198's, oil temperature sensor. The dealer was closed by then, so I left it in their lot and will call them tomorrow. Their repair performance to date has been poor, and that's being polite. How a rad flush could cause a PO198? Could they have forgot to plug the sensor in? Is it located anywhere near the thermostat housing? Did they not get the air out of the rad, and maybe the engine did get hot?
Santa Fe (CM - 2007-12) :: Error Code C1627 - ESP Light Is On And 4WD Blinking
I have an issue in my car (Santa fe 2011) and it occurred since it was new (ODO 3000 KM , ESP light is on and the 4WD Blinking) . the agency could not resolve the issue. and my car up to now been in and out from the workshop for more than 6 times . and more the error code ( C1627 ) that appears in the GDS(Global Diagnostic System) does not exist in the system (troubleshoot manual) .
View 5 RepliesSanta Fe (CM - 2007-12) :: Code P1586 - Engine Is Hesitating Between 1500 And 2000 Rpm
Fault code : P1586 MT/AT codification, no check engine light, the glow light is blinking when I give ignition but if I turn off and turn the ignition on again the light it will go off. What I noticed is between 1500rpm and 2000rpm the engine is hesitating, like not getting enough fuel.
View 8 RepliesSanta Fe (CM - 2007-12) :: 2008 - CEL Code P0441 / Purge Valve Location
Engine light came on a week ago, finally made it in to get the code pulled yesterday : P0441
From reading on this site, thinking its a faulty purge valve.
I have found pics of its location on an 04, but cant seem to find it on my 08 2.7L.
Santa Fe (CM - 2007-12) :: 2009 - Small Leak EVAP Code P0456
2009 santa fe 67000 miles. Replaced fuel senders approx a month ago. All was fine. On about the 3rd fill up the cel came on. Code was for small leak evap. checked the gas cap, no problems. Replaced the purge valve and disconnected the battery while doing so. Cel light went off and stayed off thru one tank of gas. Filled up again and thought I detected a little fuel smell shortly after and cel came on again. I only smell fuel when its full and down to just before 3/4's. The light came on right before 3/4's. My husband is beyond frustrated and wants to smash the car lol. Once I get him calmed down where should we be looking for a leak and how to fix it? We can't afford a dealership bill right now and of course it's due for inspection next month.
Code was p0456
The only answer I got in the DIY section is to check around the fuel senders again but I'm leery to do it as I can't see how there would be a leak there, the covers go on SO hard even with that tool.