Santa FE SM (2001-06) :: 2.4L Engine Running So Hot
This little engine runs very hot. To make matters worst the radiator fan comes on high on the gauge temperature reading unlike other cars I have had in the past. What else to do to run the engine cooler without affecting fuel economy? I wish there was a way to make the radiator fan come on at a lower temperature.
View 5 RepliesSanta FE SM (2001-06) :: When Key Is Turned Off Engine Keeps Running Like Normal
I have a 2002 Santa fe that will not stop running. When the key is turned off the engine keeps running like normal. I changed the ignition switch yesterday. still have same problem.
View 21 RepliesSanta FE SM (2001-06) :: 2002 - Engine Running Flat Under Load
Those are the codes I'm getting. P0340, P1166 and P1167
Here's the story. Engine running flat under load. Easy acceleration is ok, but merging onto the turnpike causes a noticeable loss of power. Replaced the cam sensor, cleared the codes, ran ok for a day. Same codes came back, same flat performance.
Returned the cam sensor with another new one to make sure it wasn't a dud out of the box. Advance Auto Parts is awesome - replaced it no questions asked.
Installed the new cam sensor, cleared the codes. Ran great for a day, then the same symptoms came back, with the same codes. I'm thinking it might be the ECU? If it is, how expensive are they? And do they have to be programmed by the dealer?
This is a 2002 Santa Fe 2.7l automatic with around 147k miles on it.
Santa FE SM (2001-06) :: Engine Running Rough When Started / Backfire When Give It Gas
I have a problem with my 01 santa fe. When I start it the engine runs rough and when u try to give it gas it pops or backfire through throttle body and air intake tube? Checked the timing belt its ok hasnt slipped.so im stuck at this point.
View 8 RepliesSanta FE SM (2001-06) :: Consistent Snapping Noise Coming From The Engine While Running
I have an odd one; there's a noise that sounds like an consistent electrical snapping noise coming from the engine while running. Everything seems fine otherwise. Just looking for possible things to check.
2002 Santa Fe V6 GLS 173K
Santa FE SM (2001-06) :: 2.4L Engine Running Rough / Rich Smell All The Time
When firing up the engine cold it runs really rough, smells very rich all the time, even warmed up. No codes set, fuel trims are within 5-10%. I've replaced the front O2 sensor, swapped crank & cam sensors, Map sensor (have lots of spare parts) & I'm sure there was more things I've changed but can't remember. I have a snap on scanner and everything is within parameters.
I have not checked the EGR valve or solenoids yet. It's a 2006 Santa Fe 2.4l 5 speed, new timing belt & balance belt replaced when I dropped this engine in. Is there a common problem with these that I could begin looking for?
Santa FE SM (2001-06) :: Engine Running Rough At Idle / High RPM And Appears To Be Misfiring
Recently replaced plugs/wires on soon-to-be 10 year old '04 SF 3.5L (157K mi.) for the first time.
Plugs were OE Champion Platinum and all 6 looked identical except for excessive gap of .010 +/- due to all the miles. Replaced plugs with same as OE. Old plug wires looked good, but replaced them with aftermarket wires ( fit was as good as OE). Also replaced plenum gasket.
Problem is: engine runs rough at idle and high rpm and appears to be mis-firing. CEL is off and code reader shows no Trouble Codes stored.
Santa FE SM (2001-06) :: 2004 2.4L Engine Running Rough And Shakes After Timing Belt Replacement
I recently replaced timing belt and balance belt on my 2004 santa fe 2.4l and now the engine runs like crap and shakes badly. I went over all timing marks again and again and I am at a loss.
View 9 RepliesMazda - 626 :: 2001 - Running Rough / Huge Jerk When Move From 1st To Second
Our 2001 mazda 626 has begun to run rough(shaking the car) when idling at a stop sign or stop light and once that begins when we push on the gas to move from 1st to second there is a huge jerk. If the air conditioning is on it is worse. It is an automatic.
View 3 RepliesSanta FE SM (2001-06) :: Transmission Won't Move Car / RPMs Went Up
The other day I was driving my Santa Fe. I noticed the RPMs went up and then the car started slowing down, so I pulled over. Since then the car won't drive. Engine starts up but the car won't move at all. When I push the gas pedal I hear the engine revving, but no movement in drive or reverse. No check engine light, and I checked the transmission fluid, looks and smells good. I checked and it has no transmission pressure. I verified by removing the transmission cooler lines and shifted the truck in all gears. Nada. Could it be the filter, a sensor or the torque converter? Or am I looking at having to replace the whole transmission?
View 21 RepliesSanta FE SM (2001-06) :: 2003 - Won't Move And Front Right Smoking
I have a 2003 Santa Fe and it's been running fine except I just replaced my oil pan from damage from ice and just did front brake pads 2 days ago.( oil went onto the pads and caused a weird grinding sound) ...
After the brake pads were done it drove fine. I came home and the next morning I go to reverse and the truck will not move at all. I can go to any gear but it just will not move. I thought it could be the brakes were frozen because the front right was smoking after the pads were installed and had the guy who did them check it out. he figured it was a caliper on the driver's side and replaced it, but it will still not move. I am praying this is not a trans problem.
Santa FE SM (2001-06) :: Auto Transmission Will Not Move In Reverse Or Drive
I just did a motor swap on a 2003 with 3.5 auto tranny and awd. engine runs great and every thing is running fine. Only problem is that the trans will not create any power. With no drive shafts on it still wont move the splines. With that said the trans was driving/running great b4 the swap.
View 2 RepliesSanta FE SM (2001-06) :: Transmission Go Into Reverse Just Fine But Would Not Move In Any Forward Gears
I recently bought a 2001 Sante Fe 4X4, (my first Hyundai), that has transmission issues. It has about 135,000 miles on it. It will start easily, and go into Reverse just fine, but would not move in any forward gears. It would occasionally shudder a bit when put in 'drive', but only move forward a few inches. Recently, my mechanic backed it around, then decided to try it in forward again. This time it went forward a couple hundred feet, then quit moving forward. Do I need a new transmission, and if so, what vehicles use this same transmission? Or is there a sensor or valve that could be defective?
View 5 RepliesSanta FE SM (2001-06) :: Gear Shifter Very Hard To Move And Doesn't Really Go In Park?
This morning as I get in to drive my kid to school (2005 2.7 2 wd auto) as I go to put it in reverse I noticeably have to pull it with some force. I have never had to "force it" before, it had always switched gears with ease. This time it felt very stiff but had no issues going into gear. After I dropped my son off at school I went through the gears up and down and it felt very stiff (at this point i have no issues with starting it or P).
At lunch I go out to get something to eat and when I go to start it up it won't start. I try and try and nothing. All the lights came on, it's not a battery issue at all (brand new). But after 10 tries it starts, so I'm pretty happy. Then I go to put it in gear (reverse) I can not press in the button on the side of the gear shift. It will not go in. I press with all my might and it wont budge. But again, after about 10 good tries at it goes in and I can then select my gear but still feels very stiff.
After stopping again I didn't shut off the engine and dicked around with the shifter basically figured out that my car is not recognizing Park. On the instrument panel each gear lights up but not P. It gets very stiff when trying to put it in P but it doesn't actually go into P. If I put it in P (or really the further up it will go) and shut off the car, it won't start again. I can start it up in N and only N.
Santa FE SM (2001-06) :: Loose Rearview Mirror / Road Vibration Causes It To Slowly Move Downward
I've got an 02 Santa Fe with the auto-dimming mirror. The tension that keeps the mirror in position has gotten loose, so the vibration from the road causes it to slowly move downward while driving.
Is there a way to tighten this up? Do I need to remove the mirror from the windshield to do this? (because, I can't even seem to figure out how to do that!)
Santa Fe (CM - 2007-12) :: 2.7 Engine - When Put Trans In Gear Car Won't Move And Has Grinding Sound
I put the trans in gear it won't move and has a grinding sound and rolls unless I use the emergency brake. I bought this used from a friend at 80k miles, now it has 130k miles and has been factory serviced regularly.
View 1 RepliesSanta FE SM (2001-06) :: 2004 Won't Stay Running
Came out of my house and my 04 Sante Fe will not stay running. It worked fine on the way home form work won't stay started now. You can give it gas and everything but it just dies out after a few moments. I checked most of the basics...
-Fuel pump runs when key is on
-Added gas, over 1/4 tank
-Checked engine fuses
-removed air filters and hoses
-removed mass air intake unit
-down to throttle body and such,
-to keep running by spraying gas directly into engine?
-removed fuel pump under seat
-checked mesh filter and connections
-clean no build up no visual problems with pump or filter
-checked cut off switch, not activated
-removed gas line from injector rail getting good "squirting" from rail
I have asked everyone and most think it is some kind of sensor but I have no light on and I have put it on the OBII and no error codes are found unless I un plug one of the many sensors, which i have done to a few to check them (air mass intake).
Santa FE SM (2001-06) :: No Cooling From AC / Compressor Not Running
03 Santa Fe, 2.7 L engine. No cooling happening. Compressor not running. Jumpered both sides of the triple pressure switch. Jumpering Low/high side resulted in slight increase in engine rpm, Jumpering medium side and something turned on (didn't get a chance to investigate) but still no clutch operation on compressor. Wondering what to try next other than disconnecting and dropping compressor ?? Checked AC relay on the bench and the coil operates and contacts close, so that's good. Also10A fuse before relay contacts is OK.
View 12 RepliesSanta FE SM (2001-06) :: Blower Fan Running Even After AC Switch Is Off
I have strange issue with my a/c fan, its running continues even will the a/c switch is off.
I cant stop it. So I have to remove the fuse to stop it. My ac panel is automatic.