Santa Fe (CM - 2007-12) :: Engine Running Rough Idle And Hesitation
I have an 07 with the 3.3L and on start up the engine runs really rough and while driving when warm it keeps losing power with a regular rhythm. It almost feels like and injector or ign coil is dropping out. I have no CEL and have recently changed the spark plugs and rear upper O2 sensor.
View 5 RepliesSanta FE SM (2001-06) :: Engine Running Rough When Started / Backfire When Give It Gas
I have a problem with my 01 santa fe. When I start it the engine runs rough and when u try to give it gas it pops or backfire through throttle body and air intake tube? Checked the timing belt its ok hasnt slipped.so im stuck at this point.
View 8 RepliesSanta FE SM (2001-06) :: 2.4L Engine Running Rough / Rich Smell All The Time
When firing up the engine cold it runs really rough, smells very rich all the time, even warmed up. No codes set, fuel trims are within 5-10%. I've replaced the front O2 sensor, swapped crank & cam sensors, Map sensor (have lots of spare parts) & I'm sure there was more things I've changed but can't remember. I have a snap on scanner and everything is within parameters.
I have not checked the EGR valve or solenoids yet. It's a 2006 Santa Fe 2.4l 5 speed, new timing belt & balance belt replaced when I dropped this engine in. Is there a common problem with these that I could begin looking for?
Santa FE SM (2001-06) :: 2004 2.4l Engine With High Idle Speed
2004 2.4l engine has high idle speed aprrox. 1000rpm.
View 2 RepliesSanta FE SM (2001-06) :: 2004 2.4L Engine Running Rough And Shakes After Timing Belt Replacement
I recently replaced timing belt and balance belt on my 2004 santa fe 2.4l and now the engine runs like crap and shakes badly. I went over all timing marks again and again and I am at a loss.
View 9 RepliesSanta FE SM (2001-06) :: Hard To Start After Fill Up - Rough Idle And Engine Shuts Off
Every time i stop for gas..my 01 santa fe is hard to start..it would take 4 to 5 start before she goes, then i have to keep the rpm up, bring her to idle..after that shes ok, till the next fill up.. the only way around this is to keep her running while gassing up..while filling up she run rough idle, some time engine shuts off..then its hard to start..
View 5 RepliesSC/SL/SW :: 2002 Saturn SL1 Won't Start - Running Rough And High Idle
Recently replaced spark plugs and wires on 02 SL1 with 209K miles. Was running rough, rough and high idle, almost died on me driving home one night. After replacing everything, car still wouldn't start. Spent some time on the forums and some suggested a leaking intake manifold gasket, so I changed that out as well as the coolant temperature sensor. Still it won't start. I am getting good spark at the plugs (coil arcs across the posts when plugs wires are off).
Really not sure where to go next with this. I can hear the fuel pump hum when I turn on the ignition, and I get a good spray at the fuel rail. Basically I turn the key and it cranks, sputters, and will almost catch, but then not. What next??
Ford - Explorer :: 1999 - Misfiring / Shaking / Rough Idle - Engine Light Flashing
My 99 Explorer XLT V6 SOHC has been misfiring lately. In idle the RPM needle fluctuates a bit and the vehicle vibrates and shakes. At night when the lights are on I notice them dim a bit as the engine struggles in idle. It doesnt stall very often at all. Accelerating I notice way less power and the engine studders. Thats when the engine light comes on flashing. Then remains on solid afterwards.
I brought it to a mechanic friend who read the code and it was cylinder two misfire as well as O2 censor. I replaced the plugs and leads and censor. Noticed the plug in cylinder two had little to no gapping. Thought I had fixed the problem. Vehicle ran perfect. Three or four days later driving on the hwy same problem came back. Thinking it must be the coil pack I got one for a good price and replaced it.
Again, the truck ran great for four days and now the problem has returned. Same thing, shaking studdering and flashing engine light. I have verified the locations of the wires and plugs a few times so i believe they are all properly installed.
Santa FE SM (2001-06) :: Pops And Sputters After Washing Engine - Misfiring
In my 2003 3.5 awd I successfully got my used transmission in and running great. I made the mistake of washing the engine. Now, it runs like Cr@p. It pops and sputters. At one point the CEL came on with 7 codes mostly misfires. It ran ok prior to the bath but I am getting ready to do the timing belt and wp and plug wires. In the meantime, whats the most likely cause of misfires after a hosing down on these engines? I'm leaning towards plug wires or coils...
View 3 RepliesSanta FE SM (2001-06) :: Lack Of Power / Rough Running
Well today I have moved on to the next project on my 02 v6 4X4 Santa Fe, which is the rough running. When I got the car, it had CEL with codes for misfire #5 and lean condition codes. I noticed the wires were in need of replacement (one had black tape wrapped around it) so changed the plugs and wires. The 2 hoses, one that goes between the valve covers on the pass side and the hose between the valve cover and throttle body on driver side were both cracked so replaced them along with a few other vacuum lines, just because I had access to them. Cleared the codes and it still runs like crap, but after 112 miles, town and highway driving, there are no CEL codes. When its first started it idles at 1500 and sounds like its missing and has very little power going down the road. When it warms up seems to run a bit better but still nowhere close to what it should. Equal compression on all 6 cylinders and has power to all 6 injectors and tested to be sure there was a pulse to them as well. Coil packs all tested well. the exhaust is in bad shape and don't know if that would have any effect on how its running.
View 6 RepliesSanta FE SM (2001-06) :: Code P0431 - Engine Misfiring When Accelerating At Hwy Speeds
My engine doesn't run smoothly (like a misfire) when accelerating at hwy speeds, especially when the outside temp is above 20 degrees... the warmer the temps are, the worse it is.
I have a code P0431 - "warm up cat efficiency below threshold (Bank 2)"
Is it an O2 sensor problem, and if so, which one is it and what is the Hyundai p/n for the sensor? Bank 2 is in the front, correct?
Elantra XD (2001-06) :: AC Appears To Be Running Every Time The Fan Is On
I bought an 05 elantra for my daughter's first car. 47,000 miles.
I noticed every time the fan is on, the a/c appears to be running (as evidenced by cold air, clicking on and off of the air conditioner, draining of the system onto the road after shut down, etc.). Even with the a/c light off, it's clearly running. Could it be the switch or relay?
Santa FE SM (2001-06) :: 2004 - RPMs Running High / Car Seems To Surge
2004 Santa fe. Having issues with RPM running high. When car is started, RPM sits at 1500 for a few mins, then drops to 500. Seems to be having issues either getting into gear or staying. At any mph, car seems to surge and not feel like it's getting either gas or power. While on cruise at 55+ mph, car will also surge with RPM dropping 500, then kicking back in. This goes on every few seconds up to random times.
Had it looked at this past weekend at a dealer, and of course it didn't do it one time, after doing it for a half hour prior on the interstate. Tech found no error codes when he checked it as well. Car was fine for an additional 300 miles, then it started again out of the blue. Pulled out at a red light and I though I was going to stall.
Just got laid off so I'm trying to eliminate before putting a lot of money into it if I don't have to. 132,000 miles.
Santa FE SM (2001-06) :: Rough Running While Driving / 2 Of 4 Cylinders Lost
2001 Santa Fe with 2.4 engine auto FWD 198k miles. When it is started first in the day, the engine sounds good and shifts well. After a few minutes and also after stops, first gear works well but then the following gears do not work well almost as if the engine and the transmission quit talking to each other. Traveling at 60 mph starting up a medium hill, the car downshifted and could not pick a gear. Although I pushed the pedal harder, the car did not respond rather continued to slow down. It acts like I lose 2 of the 4 cylinders in all cases. I replaced the spark plugs and two of them had oil on top of the plugs and also all around the threads. I replaced both coils thinking that one of them was the issue but no change has been observed. I replaced the throttle position sensor; no performance change. I do not believe it is the transmission as I have not notice any clunking, or bad shifting when starting out. While coasting at 40 mph in neutral and my pedal pressed at a certain position, the rpm gauge fluctuated from 3k to 3.6k many times for the duration of 20 seconds.
View 2 RepliesSanta FE SM (2001-06) :: Stalling And Running Rough - Codes P1166 And P1167
My 03 Sante Fe is running a little rough and is stalling. My Mechanic said this P code was going to run me $1300. I'm not very mechanical , but this just seems very high. He said that aftermarket sensors would not work and only Hundai parts for the fix.........
2003 Sante Fe, LX, 3.7 l engine
Audi - A4 :: 2001 - Misfire On All Cylinders And Car Appears To Be Running Lean
I have a 2001 Audi A4 1.8t (AWM engine, B5 platform). When I start the car, I get misfires on all cylinders (very rough idle, sometimes it stalls when the engine is cold) and the car appears to be running lean. Once the CEL comes on, it runs fine (albeit the slight loss of power do the ECU going into limp mode to correct the problem).
So far, I've done the following myself: new O2 sensors, new SAI pump, new EGR valve, new diverter valve, new N75 valve, new vacuum hoses, cleaned the throttle body, new MAF sensor, cleaned the air filter, new plugs, and new coils. When the problem persisted, I had my mechanic change the timing belt, check for vacuum leaks, change the valve cover gasket, replace the fuel pump and filter. None of this has solved the problem! This is driving me nuts.
At this point, there are only two possibilities that I can think of:
1) Catalytic converter is clogged? I pulled out the pre-cat O2 sensor, started the car, but it still misfired. This seems to mean that there's another problem (i.e., if the cat is clogged, it's in addition to something else).
2) Dirty fuel injectors? I've put two bottles of Techron through the car to no avail. From the outside, they look pretty dirty, so I'll definitely try removing them, cleaning them, and replacing the gaskets. Hopefully this solves it.
Is there something I'm missing?
Santa FE SM (2001-06) :: Oil Leak And Rough Idle - CEL On
My 2001 Santa Fe is having some major issues with rough idling, and there is a fairly significant oil leak. The check engine light is not on. In the past year it has had a new fuel pump, fuel filter, valve gasket covers, spark plugs, spark plug cables, and transmission.
View 2 RepliesSanta FE SM (2001-06) :: Rough Idle - Oil Light Flickering
At idle, (600 RPMs, might need to bring it up?) the motor is Real rough, but doesn't stall out, just very "wobbly" Once the car is brought up to the 900-1000 RPM range everything flattens out, and at driving speeds it drives great! Pulled up to 90 mph on the high way, and passed a few cars on some back roads and everything ran great, until I hit idle.
It threw a code for the Cam Position Sensor after I tried to restart the car, and the person who work on this car before me had zip tied the connector into the sensor because he had broken it. Low and behold, you cant buy just the replacement part of the harness.
I tried to get the wires all plugged back in, and the CEL went away, but the idle was still pretty rough. Also, at idle, the oil light flickers just a bit.
Santa FE SM (2001-06) :: 2003 - Rough Idle When Using Brakes
2003 Sante Fe is suddenly having a problem at stop lights or anytime the car is stopped with brakes. It feels as if the car is going to stall - or back fire. Very evident since it pulls on the brake pedal - just had back brakes replaced.
View 1 Replies